Dimitri Pinel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dimitri Pinel has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Christian Andre Andresen
Resman
3 shared publications Dana Reulein
NTNU—Norwegian University of Science and Technology, Trondheim, Norway
2 shared publications- Espen Flo Bødal
SINTEF Energy Research Trondheim Norway
2 shared publications - Julian Straus
SINTEF Energi, Trondheim Norway
2 shared publications - Lars Hellemo
SINTEF Industry, Postboks 4760 Torgarden, 7465 Trondheim
2 shared publications - Sigmund Eggen Holm
SINTEF Energy Research Postboks 4761 Torgarden 7465 Trondheim
2 shared publications
Latest Publications
- Open Access
- 7 May 2026
- Published by IOP Publishing in Environmental Research: Energy
- Vol. 3 (2)
Analyzing the impact of the ostend declaration stated offshore wind targets on the European energy system
The Ostend Declaration commits North Sea countries to installing 300GW of Offshore Wind (OW) capacity by 2050, a development that will reshape Europe’s decarbonised energy system. This study assesses how such large-scale OW deployment affects the European energy mix, transmission needs, and OW project profitability. Using the open energy system model GENeSYS-MOD with a 47-node spatial resolution, including 19 offshore nodes, we evaluate scenarios with different offshore grid layouts and OW investment requirements, and conduct a sensitivity analysis on OW capital costs. Results show that meeting the Ostend targets increases total system costs by only about 1%, while OW primarily displaces onshore wind, solar PV, and nuclear power. Achieving the targeted OW levels endogenously requires roughly a 50% reduction in OW CAPEX. The choice of offshore grid layout has little impact on overall system cost or average OW Return on Investment (ROI), but it does shift the geographic distribution of investments; notably, radial grid layouts reduce the need for onshore wind in Norway. Enforcing early OW buildout raises OW profitability due to higher electricity prices in earlier periods. The findings highlight trade-offs between cost efficiency, infrastructure design, and regional policy priorities for North Sea energy development.
- 7 May 2026
- Published by IOP Publishing in Environmental Research: Energy
- Vol. 3 (2)
Open AccessAnalyzing the impact of the ostend declaration stated offshore wind targets on the European energy system
The Ostend Declaration commits North Sea countries to installing 300GW of Offshore Wind (OW) capacity by 2050, a development that will reshape Europe’s decarbonised energy system. This study assesses how such large-scale OW deployment affects the European energy mix, transmission needs, and OW project profitability. Using the open energy system model GENeSYS-MOD with a 47-node spatial resolution, including 19 offshore nodes, we evaluate scenarios with different offshore grid layouts and OW investment requirements, and conduct a sensitivity analysis on OW capital costs. Results show that meeting the Ostend targets increases total system costs by only about 1%, while OW primarily displaces onshore wind, solar PV, and nuclear power. Achieving the targeted OW levels endogenously requires roughly a 50% reduction in OW CAPEX. The choice of offshore grid layout has little impact on overall system cost or average OW Return on Investment (ROI), but it does shift the geographic distribution of investments; notably, radial grid layouts reduce the need for onshore wind in Norway. Enforcing early OW buildout raises OW profitability due to higher electricity prices in earlier periods. The findings highlight trade-offs between cost efficiency, infrastructure design, and regional policy priorities for North Sea energy development.
- Open Access
- 19 December 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 99, 697-706
The representation of hydrogen in open-source capacity expansion models
- 19 December 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 99, 697-706
Open AccessThe representation of hydrogen in open-source capacity expansion models
- Open Access
- 17 May 2024
- Published by The Open Journal in Journal of Open Source Software
- Vol. 9 (97) , 6619
EnergyModelsX: Flexible Energy Systems Modelling with Multiple Dispatch
EnergyModelsX is a multi-nodal energy system modelling framework written in Julia (Bezanson et al., 2017), based on the mathematical programming DSL JuMP (Lubin et al., 2023). The framework is designed to be flexible and easy to extend, for instance all resources, both energy carriers and materials, may be defined by the user. Furthermore, EnergyModelsX follows a modular design to facilitate extensions through additional packages. EnergyModelsX was developed at the Norwegian research organization SINTEF at the institutes SINTEF Energi and SINTEF Industri. The framework consists of the package EnergyModelsBase
- 17 May 2024
- Published by The Open Journal in Journal of Open Source Software
- Vol. 9 (97) , 6619
Open AccessEnergyModelsX: Flexible Energy Systems Modelling with Multiple Dispatch
EnergyModelsX is a multi-nodal energy system modelling framework written in Julia (Bezanson et al., 2017), based on the mathematical programming DSL JuMP (Lubin et al., 2023). The framework is designed to be flexible and easy to extend, for instance all resources, both energy carriers and materials, may be defined by the user. Furthermore, EnergyModelsX follows a modular design to facilitate extensions through additional packages. EnergyModelsX was developed at the Norwegian research organization SINTEF at the institutes SINTEF Energi and SINTEF Industri. The framework consists of the package EnergyModelsBase
- Open Access
- 16 December 2023
- Published by Elsevier in Applied Energy
- Vol. 357
Hydrogen for harvesting the potential of offshore wind: A North Sea case study
- 16 December 2023
- Published by Elsevier in Applied Energy
- Vol. 357
Open AccessHydrogen for harvesting the potential of offshore wind: A North Sea case study
- Open Access
- 16 February 2021
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 238, 06001
Optimal investment in the energy system of Zero Emission Neighborhoods considering the refurbishment of the building stock
To increase the impact that Zero Emission Neighbourhoods (ZEN) can have in the effort to decrease CO2 emissions, the refurbishment of the existing building stock is a parameter that should be considered. The existing literature contains work on optimization models for the energy system of neighbourhoods taking into account emissions but fails to account for the refurbishment of buildings. This paper addresses this option and presents an optimization model for designing a cost-optimal energy system of a ZEN in the context of existing buildings. The model is presented and used in a case study in Norway and compared to a case with linearized binaries. A sensitivity analysis is performed on the cost of refurbishment. With the original refurbishment cost assumptions, it is not chosen by the optimization, contrary to the hydronic. The system relies mainly on PV, solar thermal collectors (ST), a biogas engine, a battery and heat pumps (HP) and heat storage. From 50% of the original refurbishment cost, it is chosen, and the system does not have a biogas engine and a heating grid anymore, but a much bigger battery and more heating technologies inside the buildings. With linearized binaries, the investments are similar to the case with 50% refurbishment cost, but the value of the linearized binaries cannot be used to indicate the share of building to refurbish.
- 16 February 2021
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 238, 06001
Open AccessOptimal investment in the energy system of Zero Emission Neighborhoods considering the refurbishment of the building stock
To increase the impact that Zero Emission Neighbourhoods (ZEN) can have in the effort to decrease CO2 emissions, the refurbishment of the existing building stock is a parameter that should be considered. The existing literature contains work on optimization models for the energy system of neighbourhoods taking into account emissions but fails to account for the refurbishment of buildings. This paper addresses this option and presents an optimization model for designing a cost-optimal energy system of a ZEN in the context of existing buildings. The model is presented and used in a case study in Norway and compared to a case with linearized binaries. A sensitivity analysis is performed on the cost of refurbishment. With the original refurbishment cost assumptions, it is not chosen by the optimization, contrary to the hydronic. The system relies mainly on PV, solar thermal collectors (ST), a biogas engine, a battery and heat pumps (HP) and heat storage. From 50% of the original refurbishment cost, it is chosen, and the system does not have a biogas engine and a heating grid anymore, but a much bigger battery and more heating technologies inside the buildings. With linearized binaries, the investments are similar to the case with 50% refurbishment cost, but the value of the linearized binaries cannot be used to indicate the share of building to refurbish.
- Open Access
- 1 January 2021
- Published by Elsevier in Building and Environment
- Vol. 187
Impact of the factor of electricity and the external compensation price on zero emission neighborhoods’ energy system design- 1 January 2021
- Published by Elsevier in Building and Environment
- Vol. 187
Open AccessImpact of the factor of electricity and the external compensation price on zero emission neighborhoods’ energy system design - Open Access
Clustering Methods Assessment for Investment in Zero Emission Neighborhoods Energy System
This paper investigates the use of clustering in the context of designing the energy system of Zero Emission Neighborhoods (ZEN). ZENs are neighborhoods who aim to have net zero emissions during their lifetime. While previous work has used and studied clustering for designing the energy system of neighborhoods, no article dealt with neighborhoods such as ZEN, which have high requirements for the solar irradiance time series, include a CO2 factor time series and have a zero emission balance limiting the possibilities. To this end several methods are used and their results compared. The results are on the one hand the performances of the clustering itself and on the other hand, the performances of each method in the optimization model where the data is used. Various aspects related to the clustering methods are tested. The different aspects studied are: the goal (clustering to obtain days or hours), the algorithm (k-means or k-medoids), the normalization method (based on the standard deviation or range of values) and the use of heuristic. The results highlight that k-means offers better results than k-medoids and that k-means was systematically underestimating the objective value while k-medoids was constantly overestimating it. When the choice between clustering days and hours is possible, it appears that clustering days offers the best precision and solving time. The choice depends on the formulation used for the optimization model and the need to model seasonal storage. The choice of the normalization method has the least impact, but the range of values method show some advantages in terms of solving time. When a good representation of the solar irradiance time series is needed, a higher number of days or using hours is necessary. The choice depends on what solving time is acceptable.
Open AccessClustering Methods Assessment for Investment in Zero Emission Neighborhoods Energy System
This paper investigates the use of clustering in the context of designing the energy system of Zero Emission Neighborhoods (ZEN). ZENs are neighborhoods who aim to have net zero emissions during their lifetime. While previous work has used and studied clustering for designing the energy system of neighborhoods, no article dealt with neighborhoods such as ZEN, which have high requirements for the solar irradiance time series, include a CO2 factor time series and have a zero emission balance limiting the possibilities. To this end several methods are used and their results compared. The results are on the one hand the performances of the clustering itself and on the other hand, the performances of each method in the optimization model where the data is used. Various aspects related to the clustering methods are tested. The different aspects studied are: the goal (clustering to obtain days or hours), the algorithm (k-means or k-medoids), the normalization method (based on the standard deviation or range of values) and the use of heuristic. The results highlight that k-means offers better results than k-medoids and that k-means was systematically underestimating the objective value while k-medoids was constantly overestimating it. When the choice between clustering days and hours is possible, it appears that clustering days offers the best precision and solving time. The choice depends on the formulation used for the optimization model and the need to model seasonal storage. The choice of the normalization method has the least impact, but the range of values method show some advantages in terms of solving time. When a good representation of the solar irradiance time series is needed, a higher number of days or using hours is necessary. The choice depends on what solving time is acceptable.
- Open Access
- 4 December 2019
- Published by Springer Nature
- p. 145-163
Cost Optimal Design of Zero Emission Neighborhoods’ (ZENs) Energy System
- 4 December 2019
- Published by Springer Nature
- p. 145-163
Open AccessCost Optimal Design of Zero Emission Neighborhoods’ (ZENs) Energy System