Xingwang Wang

In high-temperature and high-salinity reservoirs, HPAM is prone to thermal degradation, salt-induced chain shrinkage and shear instability, which weakens its mobility-control ability. In view of the above problems, this paper prepared bifunctional modified nano-SiO₂ (KH570@SiO₂-AMPS/ODMA, DF-SiO₂), and constructed a composite gel system with HPAM. Its performance was evaluated by structural and rheological characterization, aging and shear recovery, and heterogeneous core displacement. At 90 °C and about 20,000 mg/L salinity, the viscosity retention rate exceeded 70% after 90 days of aging, and recovered to 94.6% of the initial value after 72 h of standing following shearing. Core displacement shows that the system can improve the flow distribution of heterogeneous reservoirs, and the recovery of high and low permeability layers is 6.95 and 4.41 percentage points higher than that of HPAM, respectively. DF-SiO₂ constructs a dynamic network through interfacial interaction and hydrophobic association to improve the stability and structural recovery ability of the system, which provides a new idea for the application of high-temperature and high-salinity heterogeneous reservoirs.

Modern energy internets and large-scale industrial systems are becoming increasingly complex. Consequently, the rapid response capability of energy infrastructure during sudden failures has become a core element to ensure the stable operation of the social economy. Emergency repair path planning (ERPP) is a complex nonlinear combinatorial optimization problem. It is characterized by dynamic uncertainties, such as fluctuating task durations and variable traffic accessibility. This paper proposes a cross-regional emergency repair path planning (CR-ERPP) optimization model considering dynamic path conditions. The model takes into account jurisdiction ownership, cross-regional dispatch costs, path weights (congestion coefficient, grade coefficient, quality coefficient) and accident risk levels. The primary objective of this model is to minimize the total repair cost. Furthermore, an Adaptive Bitterling Fish Optimization with Evolutionary Game Theory (ABFO-EGT) is developed. It introduces adaptive mechanisms, evolutionary game theory, and a symmetric mutation strategy. These enhancements are designed to overcome the inherent limitations of traditional swarm intelligence algorithms, namely unbalanced search behavior and premature convergence to local optima. Performance analysis demonstrates that the ABFO-EGT algorithm exhibits superior convergence stability and global search capability. Case study results show that the proposed method significantly reduces the total repair cost. Specifically, the cost is reduced by 33.2% compared to manual decision-making, 27.6% compared to the GWO algorithm, and 9.1% compared to both the ACO and PSO algorithms. This study provides an efficient and reliable decision support tool for emergency management of large-scale energy systems.

The stable maintenance effect of a chemical oil displacement agent on a foam liquid film usually creates problems with the oilfields surface system. To achieve comprehensive insights into the influence mechanism of these chemical agent components on the foam liquid film, an “SDBS/HPAM/OH⁻” water-based foam simulation system and corresponding control systems were constructed by adjusting the categories and quantities of component molecules by molecular dynamics (MD) simulation. The simulated results indicated that the foam stability follows the order of “SDBS/HPAM/OH⁻” system > “SDBS/HPAM” system > “SDBS” system. The smaller the inclination angle of the SDBS molecular tail chain, the greater the tendency of the SDBS molecular configuration to be “upright” at the gas−liquid interface, which is not conducive to preventing the aggregation and penetration of gas molecules at the gas−liquid interface. Although the presence of HPAM molecules can significantly enhance the stability of the liquid film by restricting the liquid film’s drainage and the diffusion of gas molecules, the addition of HPAM molecules would weaken the formation ability of the foam liquid film. Through decreasing the aggregation of cations around the co-adsorption layer, OH⁻ not only enhances the interfacial activity of SDBS molecules, but also reduces the electrostatic repulsion between –COO⁻ groups on the HPAM molecular chain, which makes the foam more stable. With an increase in the pH, SDBS concentration, and HPAM concentration, the stability of foam liquid film was strengthened. These results are helpful in facilitating new insights into the formation and stabilization mechanism of water-based foams. In particular, they provide support for the development and application of new defoaming technologies.

Polymer flooding enhances oil recovery, but during the application of this technology, it also creates a large amount of polymer-contained produced water that poses a threat to the environment. The current processing is mainly focused on being able to meet the re-injection requirements. However, many processes face the challenges of purifying effect, facilities pollution, and economical justification in the field practice. In the present work, to fully understand the structure and principle of the oil field filter tank, and based on geometric similarity and similar flow, a set of self-designed filtration simulation devices is used to study the treatment of polymer-contained produced water in order to facilitate the satisfaction of the water injection requirements for medium- and low-permeability reservoirs. The results show that, due to the existence of polymers in oil field produced water, a stable colloidal system is formed on the surface of the filter medium, which reduces the adsorption of oil droplets and suspended solids by the filter medium. The existence of the polymers also increases the viscosity of water, promotes the emulsification of oil pollution, and increases the difficulty of filtration and separation. As filtration progresses, the adsorption of the polymers by the filter medium bed reaches saturation, and the polymers and oil pollution contents in the filtered water increase gradually. The concentration and particle size of the suspended solids eventually exceed the permissible standards for filtered water quality; this is mainly due to the unreasonable size of the particle in relation to the filter medium gradation and the competitive adsorption between the polymers and the suspended solids on the surface of the filter medium. The oil concentration of the filtered water also exceeds the allowable standards and results from the polymers replace the oil droplets in the pores and on the surfaces of the filter medium. Moreover, the suspended particles of the biomass, composed of dead bacteria, hyphae, and spores, have strong attachment and carrying ability with respect to oil droplets, which cause the suspended solids in the filtered water to exceed the permissible standards and oil droplets to be retained in the filtered effluent at the same time.