Lotfi Mostefai
Lotfi Mostefai has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Bouhamdi Merzoug
Dept. of electronis, University of sciences and Technology Mohamed Boudiaf, Oran, Oran, Algeria
2 shared publications - Amine Bab
Satellite Development Center, ASAL
1 shared publication Benouis Mohamed
University of M'sila: Universite de M'sila
1 shared publication- Boualem Nasri
Satellite Development Center, ASAL
1 shared publication Bouhamdi Merzoug
University of Science and Technology of Oran Mohamed Boudiaf: Universite des Sciences et de la Technologie d'Oran Mohamed Boudiaf
1 shared publicationChekroun Soufyane
Univ Mustapha Stambouli Mascara, Dept Elect Engn, BP 305,Route El Mamounia, Mascara 29000, Algeria
1 shared publication
Latest Publications
- 25 May 2026
- Published by Cambridge University Press (CUP) in The Aeronautical Journal
- Vol. 130 (1350) , 2373-2393
Intelligent fault-tolerant control for the auto-tracking system of LEO satellites using machine learning
This paper presents an approach based on an intelligent fault-tolerant (FT) mechanism for enhancing a monopulse auto-tracking architecture through the integration of machine learning (ML) techniques. This approach is applied for the case of Oran ground station (GS) communicating in the S/X band frequency range to ensure system robustness during faulty events. The latter are due to the degradation or sudden failure of neuralgic radio frequency (RF) components, with an emphasis on the low-noise amplifier (LNA). To address these vulnerabilities, a probabilistic likelihood function is defined, and its statistical parameters are optimised using the grey wolf optimiser (GWO) in order to provide a means of automatic switchover to the ML tracking signal receiver (ML-TSR) control mode upon anomaly detection. Three ML algorithms, namely eXtreme Gradient Boosting (XGBoost), decision trees, and K-nearest neighbors (KNN), were implemented and evaluated using a database spanning eight years (2017–2024), including the operational parameters of the ALSAT-1B GS. The experimental results show that the KNN model achieves higher accuracy than the other approaches. A validation process was then conducted during an actual satellite pass encompassing a nominal phase followed by a GS LNA failure phase. During the nominal phase, a root mean square error (RMSE) of only 0.46° in azimuth and 0.64° in elevation was observed. Activation of our recovery mechanism during the second phase demonstrated that the robustness of the likelihood function, combined with the accuracy of the ML-TSR controller, ensures mission continuity without data loss, leading to four successful image downloads.
- 25 May 2026
- Published by Cambridge University Press (CUP) in The Aeronautical Journal
- Vol. 130 (1350) , 2373-2393
Intelligent fault-tolerant control for the auto-tracking system of LEO satellites using machine learning
This paper presents an approach based on an intelligent fault-tolerant (FT) mechanism for enhancing a monopulse auto-tracking architecture through the integration of machine learning (ML) techniques. This approach is applied for the case of Oran ground station (GS) communicating in the S/X band frequency range to ensure system robustness during faulty events. The latter are due to the degradation or sudden failure of neuralgic radio frequency (RF) components, with an emphasis on the low-noise amplifier (LNA). To address these vulnerabilities, a probabilistic likelihood function is defined, and its statistical parameters are optimised using the grey wolf optimiser (GWO) in order to provide a means of automatic switchover to the ML tracking signal receiver (ML-TSR) control mode upon anomaly detection. Three ML algorithms, namely eXtreme Gradient Boosting (XGBoost), decision trees, and K-nearest neighbors (KNN), were implemented and evaluated using a database spanning eight years (2017–2024), including the operational parameters of the ALSAT-1B GS. The experimental results show that the KNN model achieves higher accuracy than the other approaches. A validation process was then conducted during an actual satellite pass encompassing a nominal phase followed by a GS LNA failure phase. During the nominal phase, a root mean square error (RMSE) of only 0.46° in azimuth and 0.64° in elevation was observed. Activation of our recovery mechanism during the second phase demonstrated that the robustness of the likelihood function, combined with the accuracy of the ML-TSR controller, ensures mission continuity without data loss, leading to four successful image downloads.
- 12 June 2025
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 84 (37) , 45683-45711
Enhanced local patterns using deep learning techniques for ECG based identity recognition system
- 12 June 2025
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 84 (37) , 45683-45711
Enhanced local patterns using deep learning techniques for ECG based identity recognition system
- 4 April 2022
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 81 (20) , 29477-29503
Comparative study of 1D-local descriptors for ear biometric system
- 4 April 2022
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 81 (20) , 29477-29503
Comparative study of 1D-local descriptors for ear biometric system
- Open Access
- 4 March 2022
- Published by MDPI AG in Engineering Proceedings
- Vol. 14 (1) , 23
Evaluation of Dimensionality Reduction Using PCA on EMG-Based Signal Pattern Classification
In this paper, we present a new low-cost system for surface electromyogram (sEMG) acquisition. developed and designed for rehabilitation application purposes. The noninvasive device delivers four-channel EMG bio-signals describing the electrical activity for the right upper limb muscles. The recorded EMG signals obtained from several healthy subjects were exploited to build a database for movement detection and to evaluate the mechanical properties of the upper limb muscles. The proposed study focuses mainly on the influence of the use of the principal component analysis (PCA) method on the movement classification performance based on the sEMG extracted signals. Several tests were conducted, and the simulation results clearly showed the positive impact of PCA as a dimensionality reduction approach with respect to two performance metrics: the classification rate (CR) and the system’s response time. This advantage was confirmed via numerical tests using three different classifiers: K-nearest neighbor (KNN), probabilistic neural network (PNN), and learning vector quantization (LVQ), with and without PCA. The obtained classification rates highlighted the success of the proposed method since a clear improvement in the classification rates was achieved.
- 4 March 2022
- Published by MDPI AG in Engineering Proceedings
- Vol. 14 (1) , 23
Open AccessEvaluation of Dimensionality Reduction Using PCA on EMG-Based Signal Pattern Classification
In this paper, we present a new low-cost system for surface electromyogram (sEMG) acquisition. developed and designed for rehabilitation application purposes. The noninvasive device delivers four-channel EMG bio-signals describing the electrical activity for the right upper limb muscles. The recorded EMG signals obtained from several healthy subjects were exploited to build a database for movement detection and to evaluate the mechanical properties of the upper limb muscles. The proposed study focuses mainly on the influence of the use of the principal component analysis (PCA) method on the movement classification performance based on the sEMG extracted signals. Several tests were conducted, and the simulation results clearly showed the positive impact of PCA as a dimensionality reduction approach with respect to two performance metrics: the classification rate (CR) and the system’s response time. This advantage was confirmed via numerical tests using three different classifiers: K-nearest neighbor (KNN), probabilistic neural network (PNN), and learning vector quantization (LVQ), with and without PCA. The obtained classification rates highlighted the success of the proposed method since a clear improvement in the classification rates was achieved.
- Open Access
- 30 November 2021
- Published by Springer Nature in Research Square
Enhanced Local Patterns Using Deep Learning Techniques for ECG Based Identity Recognition System
Electrocardiogram (ECG) signals have distinct features of the electrical activity of the heart which are unique among individuals and have recently emerged as a potential biometric tool for human identification. The paper attempts to address the problem of ECG identification based on non-fiducial approach using unsupervised classifier and a Deep Learning approaches. This work investigates the ability of local binary pattern to extract the significant pattern/feature that describes the heartbeat activity for each person’s ECG and the use of staked autoencoders and deep belief network to further enhance the extracted features and classify them based on their heartbeat activity. The proposed approach is validated using experimental datasets from two publicly available databases MIT-BIH Normal Sinus Rhythm and ECG-ID and the results demonstrate the effectiveness of this approach for ECG-based human authentication.
- 30 November 2021
- Published by Springer Nature in Research Square
Open AccessEnhanced Local Patterns Using Deep Learning Techniques for ECG Based Identity Recognition System
Electrocardiogram (ECG) signals have distinct features of the electrical activity of the heart which are unique among individuals and have recently emerged as a potential biometric tool for human identification. The paper attempts to address the problem of ECG identification based on non-fiducial approach using unsupervised classifier and a Deep Learning approaches. This work investigates the ability of local binary pattern to extract the significant pattern/feature that describes the heartbeat activity for each person’s ECG and the use of staked autoencoders and deep belief network to further enhance the extracted features and classify them based on their heartbeat activity. The proposed approach is validated using experimental datasets from two publicly available databases MIT-BIH Normal Sinus Rhythm and ECG-ID and the results demonstrate the effectiveness of this approach for ECG-based human authentication.
- 1 January 2021
- Published by Wydawnictwo SIGMA-NOT, sp. z.o.o. in PRZEGLĄD ELEKTROTECHNICZNY
- Vol. 97 (11) , 97-101
Electric vehicle yaw moment control based on the body sideslip estimation
The direct yaw moment control (DYC) presents an operative solution to improve the stability and road holding of vehicles, in particular electric vehicles equipped with independent motors. The torque control applied to each wheel can improve the handling performance of a vehicle making it safer and faster and in critical driving situations. In this article, a new method proposed for the control of the direct yaw moment based on the sliding mode control. This method uses a new design of switching function to simultaneously track the desired yaw rate and the side slip of the vehicle. The lateral sideslip angle of the vehicle is estimated by using a Kalman filter. The results of the comparative simulations show the effectiveness of the proposed method with the other conventional methods in terms of following the reference yaw rate, the vehicle trajectory and the vehicle skidding in various difficult driving scenarios
- 1 January 2021
- Published by Wydawnictwo SIGMA-NOT, sp. z.o.o. in PRZEGLĄD ELEKTROTECHNICZNY
- Vol. 97 (11) , 97-101
Electric vehicle yaw moment control based on the body sideslip estimation
The direct yaw moment control (DYC) presents an operative solution to improve the stability and road holding of vehicles, in particular electric vehicles equipped with independent motors. The torque control applied to each wheel can improve the handling performance of a vehicle making it safer and faster and in critical driving situations. In this article, a new method proposed for the control of the direct yaw moment based on the sliding mode control. This method uses a new design of switching function to simultaneously track the desired yaw rate and the side slip of the vehicle. The lateral sideslip angle of the vehicle is estimated by using a Kalman filter. The results of the comparative simulations show the effectiveness of the proposed method with the other conventional methods in terms of following the reference yaw rate, the vehicle trajectory and the vehicle skidding in various difficult driving scenarios
- 1 January 2008
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 41 (2) , 1772-1777
Friction Compensation in Servo Systems Using a Local Control Design Approach
- 1 January 2008
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 41 (2) , 1772-1777
Friction Compensation in Servo Systems Using a Local Control Design Approach