Edan Bainglass
Edan Bainglass has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Muhammad N. Huda
Department of Physics, University of Texas at Arlington
2 shared publications - Oliviero Andreussi
Boise State University
2 shared publications Alexander Carl
Department of Chemistry and Biochemistry, Worcester Polytechnic Institute, Worcester, USA
1 shared publicationBenjamin Kunz
Materials for Energy Conversion, Empa, Überlandstr. 129, 8600 Dübendorf, Switzerland
1 shared publication- Binod Giri
Department of Mechanical Engineering
1 shared publication - Cedric L. Mayfield
Department of Physics, University of Texas Arlington, Arlington, TX 76019, USA
1 shared publication
Latest Publications
- 22 October 2025
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 163 (16)
Coupling all-electron full-potential density functional theory with grid-based continuum embeddings
Recent advances in continuum embedding models have enabled the incorporation of solvent and electrolyte effects into density functional theory (DFT) simulations of material surfaces, significantly benefiting electrochemistry, catalysis, and other applications. To extend the simulation of diverse systems and properties, the implementation of continuum embedding models into the Environ library adopts a modular programming paradigm, offering a flexible interface for communication with various DFT programs. The speed and scalability of the current implementation rely on a smooth definition of the key physical properties of the atomistic system, in particular, of its electronic density. This has hindered the coupling of Environ with all-electron simulation packages, as the sharp electron density peaks near atomic nuclei are difficult to represent on regular grids. In this work, we introduce a novel smoothing scheme that transforms atom-centered electron densities into a regular grid representation while preserving the accuracy of electrostatic calculations. This approach enables a minimal and generic interface, facilitating seamless interoperability between Environ and all-electron DFT programs. We demonstrate this development through the coupling of Environ with the FHI-aims package and present benchmark simulations that validate the proposed method.
- 22 October 2025
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 163 (16)
Coupling all-electron full-potential density functional theory with grid-based continuum embeddings
Recent advances in continuum embedding models have enabled the incorporation of solvent and electrolyte effects into density functional theory (DFT) simulations of material surfaces, significantly benefiting electrochemistry, catalysis, and other applications. To extend the simulation of diverse systems and properties, the implementation of continuum embedding models into the Environ library adopts a modular programming paradigm, offering a flexible interface for communication with various DFT programs. The speed and scalability of the current implementation rely on a smooth definition of the key physical properties of the atomistic system, in particular, of its electronic density. This has hindered the coupling of Environ with all-electron simulation packages, as the sharp electron density peaks near atomic nuclei are difficult to represent on regular grids. In this work, we introduce a novel smoothing scheme that transforms atom-centered electron densities into a regular grid representation while preserving the accuracy of electrostatic calculations. This approach enables a minimal and generic interface, facilitating seamless interoperability between Environ and all-electron DFT programs. We demonstrate this development through the coupling of Environ with the FHI-aims package and present benchmark simulations that validate the proposed method.
- Open Access
- 3 April 2024
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 12 (18) , 10773-10783
A bridge between trust and control: computational workflows meet automated battery cycling
We demonstrate a link between workflow management and instrument automation tools, effectively bridging “trust” from tracking data provenance with automated “control” of experiments. We illustrate our approach using a battery cycling case study.
- 3 April 2024
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 12 (18) , 10773-10783
Open AccessA bridge between trust and control: computational workflows meet automated battery cycling
We demonstrate a link between workflow management and instrument automation tools, effectively bridging “trust” from tracking data provenance with automated “control” of experiments. We illustrate our approach using a battery cycling case study.
- Open Access
- 1 August 2023
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 159 (5)
Uncoupling system and environment simulation cells for fast-scaling modeling of complex continuum embeddings
Continuum solvation models are becoming increasingly relevant in condensed matter simulations, allowing to characterize materials interfaces in the presence of wet electrified environments at a reduced computational cost with respect to all atomistic simulations. However, some challenges with the implementation of these models in plane-wave simulation packages still persists, especially when the goal is to simulate complex and heterogeneous environments. Among these challenges is the computational cost associated with large heterogeneous environments, which in plane-wave simulations has a direct effect on the basis-set size and, as a result, on the cost of the electronic structure calculation. Moreover, the use of periodic simulation cells is not well-suited for modeling systems embedded in semi-infinite media, which is often the case in continuum solvation models. To address these challenges, we present the implementation of a double-cell formalism, in which the simulation cell used for the continuum environment is uncoupled from the one used for the electronic-structure simulation of the quantum-mechanical system. This allows for a larger simulation cell to be used for the environment, without significantly increasing computational time. In this work, we show how the double-cell formalism can be used as an effective periodic boundary conditions correction scheme for nonperiodic and partially periodic systems. The accuracy of the double-cell formalism is tested using representative examples with different dimensionalities, both in vacuum and in a homogeneous continuum dielectric environment. Fast convergence and good speedups are observed for all the simulation setups, provided the quantum-mechanical simulation cell is chosen to completely fit the electronic density of the system.
- 1 August 2023
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 159 (5)
Open AccessUncoupling system and environment simulation cells for fast-scaling modeling of complex continuum embeddings
Continuum solvation models are becoming increasingly relevant in condensed matter simulations, allowing to characterize materials interfaces in the presence of wet electrified environments at a reduced computational cost with respect to all atomistic simulations. However, some challenges with the implementation of these models in plane-wave simulation packages still persists, especially when the goal is to simulate complex and heterogeneous environments. Among these challenges is the computational cost associated with large heterogeneous environments, which in plane-wave simulations has a direct effect on the basis-set size and, as a result, on the cost of the electronic structure calculation. Moreover, the use of periodic simulation cells is not well-suited for modeling systems embedded in semi-infinite media, which is often the case in continuum solvation models. To address these challenges, we present the implementation of a double-cell formalism, in which the simulation cell used for the continuum environment is uncoupled from the one used for the electronic-structure simulation of the quantum-mechanical system. This allows for a larger simulation cell to be used for the environment, without significantly increasing computational time. In this work, we show how the double-cell formalism can be used as an effective periodic boundary conditions correction scheme for nonperiodic and partially periodic systems. The accuracy of the double-cell formalism is tested using representative examples with different dimensionalities, both in vacuum and in a homogeneous continuum dielectric environment. Fast convergence and good speedups are observed for all the simulation setups, provided the quantum-mechanical simulation cell is chosen to completely fit the electronic density of the system.
- 1 March 2021
- Published by Elsevier in Surface Science
- Vol. 705
Low-Index Stoichiometric Surfaces of CuBiW2O8
- 1 March 2021
- Published by Elsevier in Surface Science
- Vol. 705
Low-Index Stoichiometric Surfaces of CuBiW2O8
- 14 December 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 9 (3) , 1643-1654
Synthesis and optoelectronic properties of a promising quaternary metal oxide light absorber CuBiW2O8
First synthesis of CuBiW2O8 with direct bandgap of 1.9−2.0 eV and characterization of photoexcited charge dynamics from picoseconds to nanoseconds.
- 14 December 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 9 (3) , 1643-1654
Synthesis and optoelectronic properties of a promising quaternary metal oxide light absorber CuBiW2O8
First synthesis of CuBiW2O8 with direct bandgap of 1.9−2.0 eV and characterization of photoexcited charge dynamics from picoseconds to nanoseconds.
- 1 September 2017
- Published by Elsevier in Chemical Physics Letters
- Vol. 684, 60-66
Weakening of Si Si bonding in exohydrogenated Si60 nanoclusters
- 1 September 2017
- Published by Elsevier in Chemical Physics Letters
- Vol. 684, 60-66
Weakening of Si Si bonding in exohydrogenated Si60 nanoclusters