Daniel W. Beh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Daniel W. Beh has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Benjamin Sidney Gelfand
Department of Chemistry, University of Calgary, 2500 University Drive NW, Calgary, Alberta T2N 1N4, Canada
3 shared publications - Warren E. Piers
University of Calgary
3 shared publications Jian-Bin Li
Department of Chemistry, University of Calgary, 2500 University Drive NW, Calgary, Alberta T2N 1N4, Canada
2 shared publicationsJian-Bin Lin
Department of Chemistry, University of Calgary, 2500 University Drive NW, Calgary, Canada
2 shared publicationsLaurent Maron
2 shared publications- Alejandro J. Cuellar De Lucio
Department of Chemistry University of Calgary Calgary Alberta Canada
1 shared publication
Latest Publications
- 1 March 2023
- Published by American Chemical Society (ACS) in Organometallics
- Vol. 42 (11) , 1149-1157
Organotitanium Complexes Supported by a Dianionic Pentadentate Ligand
- 1 March 2023
- Published by American Chemical Society (ACS) in Organometallics
- Vol. 42 (11) , 1149-1157
Organotitanium Complexes Supported by a Dianionic Pentadentate Ligand
- Open Access
- 1 March 2020
- Published by Elsevier in Polyhedron
- Vol. 179
Hydrolysis of scandium alkyl derivatives supported by a pentadentate diborate ligand: Interconversion of hydroxo and oxo complexes
- 1 March 2020
- Published by Elsevier in Polyhedron
- Vol. 179
Open AccessHydrolysis of scandium alkyl derivatives supported by a pentadentate diborate ligand: Interconversion of hydroxo and oxo complexes
- 22 November 2019
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 49 (1) , 95-101
Tandem deoxygenative hydrosilation of carbon dioxide with a cationic scandium hydridoborate and B(C6F5)3
A scandium hydridoborate complex supported by the dianionic pentadentate ligand B2Pz4Py is prepared via hydride abstraction from the previously reported scandium hydride complex with tris-pentafluorophenyl borane.
- 22 November 2019
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 49 (1) , 95-101
Tandem deoxygenative hydrosilation of carbon dioxide with a cationic scandium hydridoborate and B(C6F5)3
A scandium hydridoborate complex supported by the dianionic pentadentate ligand B2Pz4Py is prepared via hydride abstraction from the previously reported scandium hydride complex with tris-pentafluorophenyl borane.
- Open Access
- 10 September 2018
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 47 (38) , 13680-13688
Scandium alkyl and hydride complexes supported by a pentadentate diborate ligand: reactions with CO 2 and N 2 O
Alkyl and hydrido scandium complexes of the dianionic pentadentate ligand B2Pz4Py are reported. The key starting material (B2Pz4Py)ScCl is readily prepared and alkylated with organolithium reagents RLi (R = CH3, CH2SiMe3, CH2SiMe2Ph, CH2CH2CH3 and CH2CHMe2) to form alkyl derivatives in 61–93% yields. These compounds are very thermally stable and do not undergo sigma bond metathesis reactions with dihydrogen. The hydrido complex was prepared from (B2Pz4Py)ScCl and NaHBEt3 in 80% yield and was found to be more stable by 28 kcal mol−1 as a dimer, rather than a monomeric hydrido complex. However, the monomer is accessible through dissociation of the dimer at 80 °C. All of the compounds (B2Pz4Py)ScR react with water to form the bridging oxo dimer (B2Pz4Py)ScOSc(B2Pz4Py). The reactivity of the hydrido and methyl complexes towards carbon dioxide was explored; heating to 80 °C results in the formation of κ2 formato and acetate complexes, respectively. The mechanisms were studied via density functional theory and distinct transition states for insertion of CO2 into the Sc–R (R = H, CH3) were found, with the insertion into Sc–CH3 being more enthalpically difficult (by 18 kcal mol−1) than insertion into Sc–H. The slow rate of reaction between [(B2Pz4Py)ScH]2 and CO2 is attributed to the barrier associated with dimer dissociation. In both insertion reactions, the kinetic products are κ1 formato or acetate complexes that are only slightly less stable than the observed κ2 derivatives. The κ1 compounds can therefore be trapped by treating the κ2 isomers with tris-pentafluorophenyl borane.
- 10 September 2018
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 47 (38) , 13680-13688
Open AccessScandium alkyl and hydride complexes supported by a pentadentate diborate ligand: reactions with CO 2 and N 2 O
Alkyl and hydrido scandium complexes of the dianionic pentadentate ligand B2Pz4Py are reported. The key starting material (B2Pz4Py)ScCl is readily prepared and alkylated with organolithium reagents RLi (R = CH3, CH2SiMe3, CH2SiMe2Ph, CH2CH2CH3 and CH2CHMe2) to form alkyl derivatives in 61–93% yields. These compounds are very thermally stable and do not undergo sigma bond metathesis reactions with dihydrogen. The hydrido complex was prepared from (B2Pz4Py)ScCl and NaHBEt3 in 80% yield and was found to be more stable by 28 kcal mol−1 as a dimer, rather than a monomeric hydrido complex. However, the monomer is accessible through dissociation of the dimer at 80 °C. All of the compounds (B2Pz4Py)ScR react with water to form the bridging oxo dimer (B2Pz4Py)ScOSc(B2Pz4Py). The reactivity of the hydrido and methyl complexes towards carbon dioxide was explored; heating to 80 °C results in the formation of κ2 formato and acetate complexes, respectively. The mechanisms were studied via density functional theory and distinct transition states for insertion of CO2 into the Sc–R (R = H, CH3) were found, with the insertion into Sc–CH3 being more enthalpically difficult (by 18 kcal mol−1) than insertion into Sc–H. The slow rate of reaction between [(B2Pz4Py)ScH]2 and CO2 is attributed to the barrier associated with dimer dissociation. In both insertion reactions, the kinetic products are κ1 formato or acetate complexes that are only slightly less stable than the observed κ2 derivatives. The κ1 compounds can therefore be trapped by treating the κ2 isomers with tris-pentafluorophenyl borane.
- Open Access
- 6 March 2015
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 44 (27) , 12326-12337
Comparing a series of 8-quinolinolato complexes of aluminium, titanium and zinc as initiators for the ring-opening polymerization of rac-lactide
The preparation and characterization of a series of 8-hydroxyquinoline ligands and their complexes with Ti(IV), Al(III) and Zn(II) centres is presented. The complexes are characterized using NMR spectroscopy, elemental analysis and, in some cases, by single crystal X-ray diffraction experiments. The complexes are compared as initiators for the ring-opening polymerization of racemic-lactide; all the complexes show moderate/good rates and high levels of polymerization control. In the case of the titanium or aluminium complexes, moderate iso-selectivity is observed (Pi = 0.75), whereas in the case of the zinc complexes, moderate hetero-selectivity is observed (Ps = 0.70).
- 6 March 2015
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 44 (27) , 12326-12337
Open AccessComparing a series of 8-quinolinolato complexes of aluminium, titanium and zinc as initiators for the ring-opening polymerization of rac-lactide
The preparation and characterization of a series of 8-hydroxyquinoline ligands and their complexes with Ti(IV), Al(III) and Zn(II) centres is presented. The complexes are characterized using NMR spectroscopy, elemental analysis and, in some cases, by single crystal X-ray diffraction experiments. The complexes are compared as initiators for the ring-opening polymerization of racemic-lactide; all the complexes show moderate/good rates and high levels of polymerization control. In the case of the titanium or aluminium complexes, moderate iso-selectivity is observed (Pi = 0.75), whereas in the case of the zinc complexes, moderate hetero-selectivity is observed (Ps = 0.70).
- 28 August 2014
- Published by Wiley in Chemistry – A European Journal
- Vol. 20 (41) , 13345-13355
3‐Rhoda‐1,2‐diazacyclopentanes: A Series of Novel Metallacycle Complexes Derived From C-N Functionalization of Ethylene
Rh‐containing metallacycles, [(TPA)RhIII(κ2‐(C,N)‐CH2CH2(NR)2‐]Cl; TPA=N,N,N,N‐tris(2‐pyridylmethyl)amine have been accessed through treatment of the RhI ethylene complex, [(TPA)Rh(η2‐CH2CH2)]Cl ([1]Cl) with substituted diazenes. We show this methodology to be tolerant of electron‐deficient azo compounds including azo diesters (RCO2NNCO2R; R=Et [3]Cl, R=iPr [4]Cl, R=tBu [5]Cl, and R=Bn [6]Cl) and a cyclic azo diamide: 4‐phenyl‐1,2,4‐triazole‐3,5‐dione (PTAD), [7]Cl. The latter complex features two ortho‐fused ring systems and constitutes the first 3‐rhoda‐1,2‐diazabicyclo[3.3.0]octane. Preliminary evidence suggests that these complexes result from N–N coordination followed by insertion of ethylene into a [Rh]N bond. In terms of reactivity, [3]Cl and [4]Cl successfully undergo ring‐opening using p‐toluenesulfonic acid, affording the Rh chlorides, [(TPA)RhIII(Cl)(κ1‐(C)‐CH2CH2(NCO2R)(NHCO2R)]OTs; [13]OTs and [14]OTs. Deprotection of [5]Cl using trifluoroacetic acid was also found to give an ethyl substituted, end‐on coordinated diazene [(TPA)RhIII(κ2‐(C,N)‐CH2CH2(NH)2‐]+ [16]Cl, a hitherto unreported motif. Treatment of [16]Cl with acetyl chloride resulted in the bisacetylated adduct [(TPA)RhIII(κ2‐(C,N)‐CH2CH2(NAc)2‐]+, [17]Cl. Treatment of [1]Cl with AcNNAc did not give the RhN insertion product, but instead the N,O‐chelated complex [(TPA)RhI(κ2‐(O,N)‐CH3(CO)(NH)(NC(CH3)(OCHCH2))]Cl [23]Cl, presumably through insertion of ethylene into a [Rh]O bond.
- 28 August 2014
- Published by Wiley in Chemistry – A European Journal
- Vol. 20 (41) , 13345-13355
3‐Rhoda‐1,2‐diazacyclopentanes: A Series of Novel Metallacycle Complexes Derived From C-N Functionalization of Ethylene
Rh‐containing metallacycles, [(TPA)RhIII(κ2‐(C,N)‐CH2CH2(NR)2‐]Cl; TPA=N,N,N,N‐tris(2‐pyridylmethyl)amine have been accessed through treatment of the RhI ethylene complex, [(TPA)Rh(η2‐CH2CH2)]Cl ([1]Cl) with substituted diazenes. We show this methodology to be tolerant of electron‐deficient azo compounds including azo diesters (RCO2NNCO2R; R=Et [3]Cl, R=iPr [4]Cl, R=tBu [5]Cl, and R=Bn [6]Cl) and a cyclic azo diamide: 4‐phenyl‐1,2,4‐triazole‐3,5‐dione (PTAD), [7]Cl. The latter complex features two ortho‐fused ring systems and constitutes the first 3‐rhoda‐1,2‐diazabicyclo[3.3.0]octane. Preliminary evidence suggests that these complexes result from N–N coordination followed by insertion of ethylene into a [Rh]N bond. In terms of reactivity, [3]Cl and [4]Cl successfully undergo ring‐opening using p‐toluenesulfonic acid, affording the Rh chlorides, [(TPA)RhIII(Cl)(κ1‐(C)‐CH2CH2(NCO2R)(NHCO2R)]OTs; [13]OTs and [14]OTs. Deprotection of [5]Cl using trifluoroacetic acid was also found to give an ethyl substituted, end‐on coordinated diazene [(TPA)RhIII(κ2‐(C,N)‐CH2CH2(NH)2‐]+ [16]Cl, a hitherto unreported motif. Treatment of [16]Cl with acetyl chloride resulted in the bisacetylated adduct [(TPA)RhIII(κ2‐(C,N)‐CH2CH2(NAc)2‐]+, [17]Cl. Treatment of [1]Cl with AcNNAc did not give the RhN insertion product, but instead the N,O‐chelated complex [(TPA)RhI(κ2‐(O,N)‐CH3(CO)(NH)(NC(CH3)(OCHCH2))]Cl [23]Cl, presumably through insertion of ethylene into a [Rh]O bond.