Yuliang Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yuliang Zhang has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Xinbo Zou
ShanghaiTech University
3 shared publications Min Zhu
2 shared publications- Bin Li
School of Mathematical Sciences, Shanxi University, Taiyuan, China
1 shared publication - Chak Wah Tang
Department of Electronic and Computer Engineering, The Hong Kong University of Science and Technology, Hong Kong
1 shared publication Chao Liu
1 shared publicationJiaxiang Chen
SIST, Shanghaitech University, Shanghai 201210, China, also with the Shanghai Institute of Microsystem and Information Technology, Chinese Academy of Sciences, Shanghai 200050, China, and also with the University of Chinese Academy of Sciences, Beijing 100049, China
1 shared publication
Latest Publications
- 1 July 2021
- Published by Elsevier in Information Sciences
- Vol. 564, 343-367
Negative influence blocking maximization with uncertain sources under the independent cascade model
- 1 July 2021
- Published by Elsevier in Information Sciences
- Vol. 564, 343-367
Negative influence blocking maximization with uncertain sources under the independent cascade model
- 1 July 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 869
A review on GaN-based two-terminal devices grown on Si substrates
- 1 July 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 869
A review on GaN-based two-terminal devices grown on Si substrates
- 11 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (10) , 3992-3998
Forward Conduction Instability of Quasi-Vertical GaN p-i-n Diodes on Si Substrates
This article reports trap-related forward conduction instability of GaN quasi-vertical p-i-n diodes grown on a Si substrate. Three hole traps with activation energies of 0.38, 0.60, and 0.70 eV together with one electron trap with an energy level of 0.26 eV under the conduction band were revealed by deep-level transient spectroscopy (DLTS). Pulsed I-V measurements were performed on a device whose traps were prefilled. The rest time durations and off-state bias levels and periods were varied to investigate the forward I-V recovery phenomenon, which was highly correlated with the carrier detrapping process inside the device. The detrapping process could be greatly accelerated by a reverse bias or a lifted temperature. An ``on-the-fly'' resistance characterization was carried out to study the time-dependent carrier release process using short positive voltage pulses. The device was further submitted to switch-on transient assessment to investigate the time-resolved dynamic Ron evolution. The initial dynamic Ron ratio was proportional to the reverse bias level and duration and was gradually decreased after continuous carrier injection until the trapping effects were overwhelmed. With a forward voltage slightly higher than the threshold voltage, it took dozens of milliseconds for the dynamic Ron to be equal to its static counterpart. It was found that at 350 K, the on-resistance ratio could reach unit more rapidly than the room temperature case, indicating mitigation of current collapse of p-i-n diodes and their great potential for high-temperature switching applications.
- 11 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (10) , 3992-3998
Forward Conduction Instability of Quasi-Vertical GaN p-i-n Diodes on Si Substrates
This article reports trap-related forward conduction instability of GaN quasi-vertical p-i-n diodes grown on a Si substrate. Three hole traps with activation energies of 0.38, 0.60, and 0.70 eV together with one electron trap with an energy level of 0.26 eV under the conduction band were revealed by deep-level transient spectroscopy (DLTS). Pulsed I-V measurements were performed on a device whose traps were prefilled. The rest time durations and off-state bias levels and periods were varied to investigate the forward I-V recovery phenomenon, which was highly correlated with the carrier detrapping process inside the device. The detrapping process could be greatly accelerated by a reverse bias or a lifted temperature. An ``on-the-fly'' resistance characterization was carried out to study the time-dependent carrier release process using short positive voltage pulses. The device was further submitted to switch-on transient assessment to investigate the time-resolved dynamic Ron evolution. The initial dynamic Ron ratio was proportional to the reverse bias level and duration and was gradually decreased after continuous carrier injection until the trapping effects were overwhelmed. With a forward voltage slightly higher than the threshold voltage, it took dozens of milliseconds for the dynamic Ron to be equal to its static counterpart. It was found that at 350 K, the on-resistance ratio could reach unit more rapidly than the room temperature case, indicating mitigation of current collapse of p-i-n diodes and their great potential for high-temperature switching applications.
- Open Access
- 16 December 2019
- Published by MDPI AG in Electronics
- Vol. 8 (12) , 1550
Device Design Assessment of GaN Merged P-i-N Schottky Diodes
Device characteristics of GaN merged P-i-N Schottky (MPS) diodes were evaluated and studied via two-dimensional technology computer-aided design (TCAD) after calibrating model parameters and critical electrical fields with experimental proven results. The device’s physical dimensions and drift layer concentration were varied to study their influence on the device’s performance. Extending the inter-p-GaN region distance or the Schottky contact portion could enhance the forward conduction capability; however, this leads to compromised electrical field screening effects from neighboring PN junctions, as well as reduced breakdown voltage. By reducing the drift layer background concentration, a higher breakdown voltage was expected for MPSs, as a larger portion of the drift layer itself could be depleted for sustaining vertical reverse voltage. However, lowering the drift layer concentration would also result in a reduction in forward conduction capability. The method and results of this study provide a guideline for designing MPS diodes with target blocking voltage and forward conduction at a low bias.
- 16 December 2019
- Published by MDPI AG in Electronics
- Vol. 8 (12) , 1550
Open AccessDevice Design Assessment of GaN Merged P-i-N Schottky Diodes
Device characteristics of GaN merged P-i-N Schottky (MPS) diodes were evaluated and studied via two-dimensional technology computer-aided design (TCAD) after calibrating model parameters and critical electrical fields with experimental proven results. The device’s physical dimensions and drift layer concentration were varied to study their influence on the device’s performance. Extending the inter-p-GaN region distance or the Schottky contact portion could enhance the forward conduction capability; however, this leads to compromised electrical field screening effects from neighboring PN junctions, as well as reduced breakdown voltage. By reducing the drift layer background concentration, a higher breakdown voltage was expected for MPSs, as a larger portion of the drift layer itself could be depleted for sustaining vertical reverse voltage. However, lowering the drift layer concentration would also result in a reduction in forward conduction capability. The method and results of this study provide a guideline for designing MPS diodes with target blocking voltage and forward conduction at a low bias.