A. Yu. Smolin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
A. Yu. Smolin has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- S. B. Kravets
Scientific and Engineering Centre for Nuclear and Radiation Safety (SEC NRS)
2 shared publications - A. E. Dembitsky
Volgodonsk Engineering Technical Institute the branch of National Research Nuclear University «MEPhI
1 shared publication - A. S. Grachev
Volgodonsk Engineering Technical Institute, National Research Nuclear University MEPhI, Volgodonsk, Rostov oblast, Russia
1 shared publication - A.M. Besedin
Volgodonsk Engineering Technical Institute the branch of National Research Nuclear University “MEPhI”, Lenin St., 73/94, Volgodonsk, Rostov region, Russia 347360
1 shared publication - A.S. Mirzaliev
Volgodonsk Engineering Technical Institute the branch of National Research Nuclear University “MEPhI”, Lenin St., 73/94, Volgodonsk, Rostov region, Russia 347360
1 shared publication - A.S. Shamarokov
Russian Research and Development Institute for Nuclear Power Production Sector Engineering, Kosmonavta Volkova St.. 6A, Moscow, Russia 125171
1 shared publication
Latest Publications
- 11 February 2026
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- No. 1,p. 67-73
ELEMENTS FOR SOLAR BATTERIES ON THE GAINAS NANOSTRUCTURE BASIS OBTAINED BY ION-BEAM DEPOSITION METHOD
The study experimentally showed the possibility of quantum dots formation based on three-component InGaAs solid solutions of various compositions on the surface of GaAs by the method of ion-beam deposition of quantum dots. The features of the technology of ion – beam deposition are considered. The optimal ratios of the of the GaInAs solid solution components are determined at which the quantum dots are characterized by the smallest dimensions, and the technological conditions are established where their density increases. The results of the study of the photoluminescence spectra and the surface morphology of the obtained nanostructures are presented. The results obtained may be of practical interest as materials for the formation of highly efficient solar cell panels on their basis, which are widely used as alternative environmentally friendly energy sources in the energy sector at present .
- 11 February 2026
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- No. 1,p. 67-73
ELEMENTS FOR SOLAR BATTERIES ON THE GAINAS NANOSTRUCTURE BASIS OBTAINED BY ION-BEAM DEPOSITION METHOD
The study experimentally showed the possibility of quantum dots formation based on three-component InGaAs solid solutions of various compositions on the surface of GaAs by the method of ion-beam deposition of quantum dots. The features of the technology of ion – beam deposition are considered. The optimal ratios of the of the GaInAs solid solution components are determined at which the quantum dots are characterized by the smallest dimensions, and the technological conditions are established where their density increases. The results of the study of the photoluminescence spectra and the surface morphology of the obtained nanostructures are presented. The results obtained may be of practical interest as materials for the formation of highly efficient solar cell panels on their basis, which are widely used as alternative environmentally friendly energy sources in the energy sector at present .
- Open Access
- 27 March 2024
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- No. 1,p. 52-57
Modern approaches to determining the standardised parameters of vibration state of NPP steam pipelines
During the operation of NPP steam pipelines the main damaging factors are not only corrosion and erosion leading to thinning of the pipe wall but also fatigue damage resulting not only from temperature self-compensation efforts, but also high vibration load. As practice shows, the most promising direction of ensuring the vibration resistance of steam pipelines at present is the computational and experimental study of the stress-strain state of pipelines under vibration loading. This work shows that the strength of the most commonly used standard sizes of steel pipelines under the influence of vibration loads is determined in accordance with Russian State Standard R 59115.9-2021. Taking into account the stress concentration, the amplitudes of the conditional elastic reduced stresses were determined for the 4 variants of the calculation schemes accepted for consideration. The permissible amplitude of stresses from an operating condition of 60 years is determined. It is shown that the permissible voltage amplitude for the design temperature t = 350°C will be no more than 46.4 Mpa for a pipe made of 12X18H10T. As for NPP pipelines, the normalized vibration parameters in the regulatory documentation were not established until 2022, when the following vibration velocity limits were adopted for pipelines of nuclear power plants in Russian State Standard R 59115.11-2021, vibration resistance testing is not required: nmax up to 15 mm/s, nmsv up to 7 mm/s. Thus, currently in the Russian regulatory documentation there are no normalized values of vibration parameters (as a rule, vibration velocity) for pipelines selected depending on the frequency of vibration exposure. It is proposed to develop and introduce into the regulatory documentation frequency-dependent criteria for limiting vibration parameters of NPP pipelines, specified in accordance with the actual operating conditions of these pipelines.
- 27 March 2024
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- No. 1,p. 52-57
Open AccessModern approaches to determining the standardised parameters of vibration state of NPP steam pipelines
During the operation of NPP steam pipelines the main damaging factors are not only corrosion and erosion leading to thinning of the pipe wall but also fatigue damage resulting not only from temperature self-compensation efforts, but also high vibration load. As practice shows, the most promising direction of ensuring the vibration resistance of steam pipelines at present is the computational and experimental study of the stress-strain state of pipelines under vibration loading. This work shows that the strength of the most commonly used standard sizes of steel pipelines under the influence of vibration loads is determined in accordance with Russian State Standard R 59115.9-2021. Taking into account the stress concentration, the amplitudes of the conditional elastic reduced stresses were determined for the 4 variants of the calculation schemes accepted for consideration. The permissible amplitude of stresses from an operating condition of 60 years is determined. It is shown that the permissible voltage amplitude for the design temperature t = 350°C will be no more than 46.4 Mpa for a pipe made of 12X18H10T. As for NPP pipelines, the normalized vibration parameters in the regulatory documentation were not established until 2022, when the following vibration velocity limits were adopted for pipelines of nuclear power plants in Russian State Standard R 59115.11-2021, vibration resistance testing is not required: nmax up to 15 mm/s, nmsv up to 7 mm/s. Thus, currently in the Russian regulatory documentation there are no normalized values of vibration parameters (as a rule, vibration velocity) for pipelines selected depending on the frequency of vibration exposure. It is proposed to develop and introduce into the regulatory documentation frequency-dependent criteria for limiting vibration parameters of NPP pipelines, specified in accordance with the actual operating conditions of these pipelines.
- Open Access
- 21 June 2023
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- No. 2,p. 66-78
Potential and possibility of extending the campaign to increase VVER-1000 power units on sliding distribution of the secondary circuit
The paper considers the efficiency and possibility of implementing into the operational practice of VVER-1000 power units the campaign extension mode at the sliding pressure of the second circuit. The history of research of Russian nuclear scientists in terms of extending the campaign of VVER reactors is considered. It is shown that reducing the pressure of fresh steam within the permissible limits will release additional reactivity due to the release of the temperature effect and generate additional energy during the operation of the unit on the power effect. A mathematical model of changes in the main parameters of the reactor plant has been compiled, including the reactivity balance equations, the Stodola-Flugel equation for the turbine, the equations of thermal balance and heat transfer in the steam generator. The calculation of the expected increase in electricity generation for modern fuel loads of VVER-1000 reactors has been performed. The degree of compliance of the proposed regime with the current technological limitations of the VVER-1000 «large series» power unit is analyzed. The results of the analysis were confirmed by numerical experiment on a multifunctional mode analyzer of the VVER-1000 reactor unit developed by the MEPhI Research Institute, built on the basis of the ENIKAD medium and the certified diffusion neutron-physical code PROSTOR. Conclusions are drawn about the possibility of introducing the proposed regime into the operational practice of modern VVER-1000 power units.
- 21 June 2023
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- No. 2,p. 66-78
Open AccessPotential and possibility of extending the campaign to increase VVER-1000 power units on sliding distribution of the secondary circuit
The paper considers the efficiency and possibility of implementing into the operational practice of VVER-1000 power units the campaign extension mode at the sliding pressure of the second circuit. The history of research of Russian nuclear scientists in terms of extending the campaign of VVER reactors is considered. It is shown that reducing the pressure of fresh steam within the permissible limits will release additional reactivity due to the release of the temperature effect and generate additional energy during the operation of the unit on the power effect. A mathematical model of changes in the main parameters of the reactor plant has been compiled, including the reactivity balance equations, the Stodola-Flugel equation for the turbine, the equations of thermal balance and heat transfer in the steam generator. The calculation of the expected increase in electricity generation for modern fuel loads of VVER-1000 reactors has been performed. The degree of compliance of the proposed regime with the current technological limitations of the VVER-1000 «large series» power unit is analyzed. The results of the analysis were confirmed by numerical experiment on a multifunctional mode analyzer of the VVER-1000 reactor unit developed by the MEPhI Research Institute, built on the basis of the ENIKAD medium and the certified diffusion neutron-physical code PROSTOR. Conclusions are drawn about the possibility of introducing the proposed regime into the operational practice of modern VVER-1000 power units.
- 1 March 2017
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- Vol. 13 (1) , 68-77
Operating Condition Research of Air Heat Exchanger of Emergency Cooling
- 1 March 2017
- Published by National Research Nuclear University MEPhI (Moscow Engineering Physics Institute) in Global Nuclear Safety
- Vol. 13 (1) , 68-77
Operating Condition Research of Air Heat Exchanger of Emergency Cooling