Katarína Zmorayová
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Katarína Zmorayová has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Pavel Diko
Slovak Academy of Sciences
5 shared publications - Liudmila Vojtkova
Institute of Experimental Physics, Slovak Academy of Sciences, Kosice Slovakia 04001
2 shared publications Michal Rajnak
Slovak Academy of Sciences - Institute of Experimental Physics, Watsonova 47, 04001 Kosice, SLOVAKIA
2 shared publications- Daniela Volochová
Institute of Experimental Physics SAS, Watsonova 47, 040 01 Kosice, Slovak Republic
1 shared publication Difan Zhou
1 shared publication- Felip Sandiumenge
Institute of cost and management accountants of bangladesh
1 shared publication
Latest Publications
- 25 September 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (23) , 39280-39288
Microstructure of DyBCO bulk superconductors prepared using single-direction melt-growth (SDMG) method
- 25 September 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (23) , 39280-39288
Microstructure of DyBCO bulk superconductors prepared using single-direction melt-growth (SDMG) method
- 8 April 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (13) , 22177-22186
Complex microstructural analysis of YBCO single-grain bulks with artificial holes: Effect on superconducting properties
- 8 April 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (13) , 22177-22186
Complex microstructural analysis of YBCO single-grain bulks with artificial holes: Effect on superconducting properties
- 22 April 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (15) , 22196-22205
An in situ self-assembly strategy for exact-(110)-plane-controlled crystallization of high-performance YBa2Cu3O7−δ single grains
- 22 April 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (15) , 22196-22205
An in situ self-assembly strategy for exact-(110)-plane-controlled crystallization of high-performance YBa2Cu3O7−δ single grains
- 17 February 2020
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 33 (4) , 044004
Relationship between local microstructure and superconducting properties of commercial YBa 2 Cu 3 O 7− δ bulk
The relationship between local microstructure and superconducting properties of commercially prepared YBa 2 Cu 3 O 7− δ single-grain bulk superconductor was investigated. The small samples for magnetization measurements were taken from the beginning and end of the a -growth sector and the c -growth sector as well as from the beginning and end of a / a -growth sector boundary. The field dependence of the magnetic moment was measured at temperatures starting from liquid helium (4.2 K) to liquid nitrogen (77 K) using the commercial Magnetic Property Measurement System with a magnetic field of up to 7 and 18 T. The microstructure was analysed using polarised light optical microscopy and scanning electron microscopy. The quantitative microstructural data were determined using an image processing software package. Microstructure analysis was focused on the size and volume fraction of Y 2 BaCuO 5 particles as well as on the characterisation of subgrain structure. These measurements showed that not only inhomogeneous distribution of Y 2 BaCuO 5 particles had influence on the critical current density but it can also be significantly affected by the subgrain structure within the bulk or by local contamination of YBa 2 Cu 3 O 7− δ from the seed during fabrication process. It was observed that the critical current density along the a / a -growth sector boundary could be substantially higher in comparison to the other parts of the bulk and this behaviour can be related to the subgrain structure in the sample.
- 17 February 2020
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 33 (4) , 044004
Relationship between local microstructure and superconducting properties of commercial YBa 2 Cu 3 O 7− δ bulk
The relationship between local microstructure and superconducting properties of commercially prepared YBa 2 Cu 3 O 7− δ single-grain bulk superconductor was investigated. The small samples for magnetization measurements were taken from the beginning and end of the a -growth sector and the c -growth sector as well as from the beginning and end of a / a -growth sector boundary. The field dependence of the magnetic moment was measured at temperatures starting from liquid helium (4.2 K) to liquid nitrogen (77 K) using the commercial Magnetic Property Measurement System with a magnetic field of up to 7 and 18 T. The microstructure was analysed using polarised light optical microscopy and scanning electron microscopy. The quantitative microstructural data were determined using an image processing software package. Microstructure analysis was focused on the size and volume fraction of Y 2 BaCuO 5 particles as well as on the characterisation of subgrain structure. These measurements showed that not only inhomogeneous distribution of Y 2 BaCuO 5 particles had influence on the critical current density but it can also be significantly affected by the subgrain structure within the bulk or by local contamination of YBa 2 Cu 3 O 7− δ from the seed during fabrication process. It was observed that the critical current density along the a / a -growth sector boundary could be substantially higher in comparison to the other parts of the bulk and this behaviour can be related to the subgrain structure in the sample.
- 20 January 2020
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 33 (3) , 034005
Influence of CeO 2 on microstructure, cracking and trapped field of TSIG YBCO single-grain superconductors
YBCO bulk single-grain samples with and without cerium oxide addition, were prepared by the two-step top seeded infiltration growth. The microstructure observations showed that cerium oxide addition led to formation of small Y 2 BaCuO 5 (Y211) particles in the YBa 2 Cu 3 O 7 single-grain matix. On the other hand, the sample without cerium oxide addition exhibited clusters of large Y211 particles. Observed difference in Y211 paricles led to significantly different size of a/c-oxygenation cracks. While the mean length of a/c-cracks in the sample with cerium oxide addition was several hundred micrometers, it was smaller than 50 μ m in the sample without cerium oxide addition. It was shown that the clusters of large Y211 particles can effectively prevent extension of oxygenation a/c-cracks. The trapped magnetic field measured at 77 K is shown.
- 20 January 2020
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 33 (3) , 034005
Influence of CeO 2 on microstructure, cracking and trapped field of TSIG YBCO single-grain superconductors
YBCO bulk single-grain samples with and without cerium oxide addition, were prepared by the two-step top seeded infiltration growth. The microstructure observations showed that cerium oxide addition led to formation of small Y 2 BaCuO 5 (Y211) particles in the YBa 2 Cu 3 O 7 single-grain matix. On the other hand, the sample without cerium oxide addition exhibited clusters of large Y211 particles. Observed difference in Y211 paricles led to significantly different size of a/c-oxygenation cracks. While the mean length of a/c-cracks in the sample with cerium oxide addition was several hundred micrometers, it was smaller than 50 μ m in the sample without cerium oxide addition. It was shown that the clusters of large Y211 particles can effectively prevent extension of oxygenation a/c-cracks. The trapped magnetic field measured at 77 K is shown.
- 20 January 2020
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 33 (3) , 034003
Inhomogeneity of SmBCO bulk superconductors grown in air
The local superconducting properties and microstructure of SmBCO bulk single-grain superconductors with the addition of different quantities of BaO 2 were studied. The single-grain bulk SmBCO superconductors were fabricated via the top-seeded melt growth process in air. Increasing transition temperature, critical current density and the narrowing superconducting transition width were observed with BaO 2 addition. It was shown that the transition temperature and critical current density depend on the distance from the seed. Microstructural analysis showed that the reaction of Ba with the supporting ZrO 2 bars is responsible for the gradient of Ba concentration in the peritectic melt, and consequent changes in Sm/Ba substitution in the Sm123 crystal lattice lead to the inhomogeneity of local superconducting properties.
- 20 January 2020
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 33 (3) , 034003
Inhomogeneity of SmBCO bulk superconductors grown in air
The local superconducting properties and microstructure of SmBCO bulk single-grain superconductors with the addition of different quantities of BaO 2 were studied. The single-grain bulk SmBCO superconductors were fabricated via the top-seeded melt growth process in air. Increasing transition temperature, critical current density and the narrowing superconducting transition width were observed with BaO 2 addition. It was shown that the transition temperature and critical current density depend on the distance from the seed. Microstructural analysis showed that the reaction of Ba with the supporting ZrO 2 bars is responsible for the gradient of Ba concentration in the peritectic melt, and consequent changes in Sm/Ba substitution in the Sm123 crystal lattice lead to the inhomogeneity of local superconducting properties.
- 1 October 2004
- Published by Elsevier in Journal of Crystal Growth
- Vol. 270 (3-4) , 685-690
Oscillation of Y2BaCuO5 particle concentration in the melt-grown YBaCuO bulk superconductors
- 1 October 2004
- Published by Elsevier in Journal of Crystal Growth
- Vol. 270 (3-4) , 685-690
Oscillation of Y2BaCuO5 particle concentration in the melt-grown YBaCuO bulk superconductors