Masahiro Teshima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Masahiro Teshima has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- A. Dettlaff
Max Planck Institute for Physics (Werner-Heisenberg-Institut) Boltzmannstr. 8 85748 Garching Germany
2 shared publications - Alexander Hahn
Max-Planck-Institut für Physik
2 shared publications - D. Fink
Max Planck Institute for Physics (Werner-Heisenberg-Institut) Boltzmannstr. 8 85748 Garching Germany
2 shared publications - Daisuke Nakajima
Institute for Cosmic Ray Research The University of Tokyo 5-1-5 277-8582 Kashiwanoha Chiba Kashiwa-city Japan
2 shared publications - Daniel Mazin
Japanese MAGIC Group: Institute for Cosmic Ray Research (ICRR), The University of Tokyo, Kashiwa, 277-8582 Chiba, Japan
2 shared publications - Daniela Hadasch
Japanese MAGIC Group: Institute for Cosmic Ray Research (ICRR), The University of Tokyo, Kashiwa, 277-8582 Chiba, Japan
2 shared publications
Latest Publications
- Open Access
Direct Comparison of SiPM and PMT Sensor Performances in a large-size imaging air Cherenkov telescope
The peak photon detection efficiency (PDE) of silicon photomultipliers (SiPMs) can be as good or better than the PDE of photomultiplier tubes (PMTs). There are experiments where the signal is measured in the presence of a strong, steady background light emission. In these, one needs to accurately evaluate the signal-to-noise ratio. Imaging Atmospheric Cherenkov Telescopes (IACTs) observe in the presence of strong noise induced by the light of the night sky. It is certainly interesting to investigate the SiPM performance under operational conditions of IACTs and to compare it with that of the PMTs. For that purpose, we built a SiPM-based detector module, which was installed in one of the imaging cameras of the two Major Atmospheric Gamma-ray Imaging Cherenkov (MAGIC) telescopes in 2015. The experience gained from that module was used to design the second generation of modules of improved performance. Two such modules were installed in 2017. MAGIC is a system of two IACTs located on the Canary Island of La Palma. The mechanical structure of the MAGIC imaging cameras offers the possibility to install up to 6 additional detector modules of 7 pixels each into the open vertices of the hexagonal-shaped camera. This allows us to directly, without making any assumption, compare the performance of the PMT-based modules with that of the SiPM-based prototype modules, where SiPMs from three different manufacturers are used.
Open AccessDirect Comparison of SiPM and PMT Sensor Performances in a large-size imaging air Cherenkov telescope
The peak photon detection efficiency (PDE) of silicon photomultipliers (SiPMs) can be as good or better than the PDE of photomultiplier tubes (PMTs). There are experiments where the signal is measured in the presence of a strong, steady background light emission. In these, one needs to accurately evaluate the signal-to-noise ratio. Imaging Atmospheric Cherenkov Telescopes (IACTs) observe in the presence of strong noise induced by the light of the night sky. It is certainly interesting to investigate the SiPM performance under operational conditions of IACTs and to compare it with that of the PMTs. For that purpose, we built a SiPM-based detector module, which was installed in one of the imaging cameras of the two Major Atmospheric Gamma-ray Imaging Cherenkov (MAGIC) telescopes in 2015. The experience gained from that module was used to design the second generation of modules of improved performance. Two such modules were installed in 2017. MAGIC is a system of two IACTs located on the Canary Island of La Palma. The mechanical structure of the MAGIC imaging cameras offers the possibility to install up to 6 additional detector modules of 7 pixels each into the open vertices of the hexagonal-shaped camera. This allows us to directly, without making any assumption, compare the performance of the PMT-based modules with that of the SiPM-based prototype modules, where SiPMs from three different manufacturers are used.
- Open Access
- 15 December 2019
- Published by Japan Radioisotope Association in RADIOISOTOPES
- Vol. 68 (12) , 857-864
Cherenkov Telescope Array and High-Energy Gamma Ray Astronomy
CTA(Cherenkov Telescope Array)大口径望遠鏡4基をスペイン,ラパルマに現在建設中である。CTA大口径望遠鏡は23 mの口径を持ち,これら4基のアレイは従来の装置と比較して20 GeV–1 TeVのエネルギー領域で一桁高い感度を持つ。これら,CTA国際宇宙ガンマ線天文台,CTA大口径望遠鏡建設の現状と,またCTAがこれから開こうとしているサイエンスについて述べる。
- 15 December 2019
- Published by Japan Radioisotope Association in RADIOISOTOPES
- Vol. 68 (12) , 857-864
Open AccessCherenkov Telescope Array and High-Energy Gamma Ray Astronomy
CTA(Cherenkov Telescope Array)大口径望遠鏡4基をスペイン,ラパルマに現在建設中である。CTA大口径望遠鏡は23 mの口径を持ち,これら4基のアレイは従来の装置と比較して20 GeV–1 TeVのエネルギー領域で一桁高い感度を持つ。これら,CTA国際宇宙ガンマ線天文台,CTA大口径望遠鏡建設の現状と,またCTAがこれから開こうとしているサイエンスについて述べる。
- 2 December 2018
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 912, 259-263
Development of three silicon photomultiplier detector modules for the MAGIC telescopes for a performance comparison to PMTs
- 2 December 2018
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 912, 259-263
Development of three silicon photomultiplier detector modules for the MAGIC telescopes for a performance comparison to PMTs
- Open Access
- 18 August 2016
- Published by Sissa Medialab Srl
- Vol. 236, 1024
Development of Slow Control Boards for the Large Size Telescopes of the Cherenkov Telescope Array
The camera of the Large Size Telescopes (LSTs) of the Cherenkov Telescope Array (CTA) consists of 265 photosensor modules, each of them containing 7 photomultiplier tubes (PMTs), a slow control board (SCB), a readout board, and a trigger logic. We have developed the SCB, which is installed between the 7 PMTs and the readout board. The main task for SCBs is the controlling of the high voltages for the PMTs and the monitoring of their anode currents. In addition, the SCB provides the functionality to create test pulses that can be injected at the input of the PMT preamplifier in order to emulate a PMT signal without the need of setting a high voltage, or even without the PMT itself. The test pulses have a very similar width as the PMT pulses (less than 3 ns FWHM) and their amplitude can be adjusted in a wide dynamic range. These features allow us not only to test the functionality of the camera modules but also to fully characterize these. We report on the design and the functions of the SCB together with the results of test measurements.
- 18 August 2016
- Published by Sissa Medialab Srl
- Vol. 236, 1024
Open AccessDevelopment of Slow Control Boards for the Large Size Telescopes of the Cherenkov Telescope Array
The camera of the Large Size Telescopes (LSTs) of the Cherenkov Telescope Array (CTA) consists of 265 photosensor modules, each of them containing 7 photomultiplier tubes (PMTs), a slow control board (SCB), a readout board, and a trigger logic. We have developed the SCB, which is installed between the 7 PMTs and the readout board. The main task for SCBs is the controlling of the high voltages for the PMTs and the monitoring of their anode currents. In addition, the SCB provides the functionality to create test pulses that can be injected at the input of the PMT preamplifier in order to emulate a PMT signal without the need of setting a high voltage, or even without the PMT itself. The test pulses have a very similar width as the PMT pulses (less than 3 ns FWHM) and their amplitude can be adjusted in a wide dynamic range. These features allow us not only to test the functionality of the camera modules but also to fully characterize these. We report on the design and the functions of the SCB together with the results of test measurements.
- Open Access
Development of Slow Control Boards for the Large Size Telescopes of the Cherenkov Telescope Array
The camera of the Large Size Telescopes (LSTs) of the Cherenkov Telescope Array (CTA) consists of 265 photosensor modules, each of them containing 7 photomultiplier tubes (PMTs), a slow control board (SCB), a readout board, and a trigger logic. We have developed the SCB, which is installed between the 7 PMTs and the readout board. The main task for SCBs is the controlling of the high voltages for the PMTs and the monitoring of their anode currents. In addition, the SCB provides the functionality to create test pulses that can be injected at the input of the PMT preamplifier in order to emulate a PMT signal without the need of setting a high voltage, or even without the PMT itself. The test pulses have a very similar width as the PMT pulses (less than 3 ns FWHM) and their amplitude can be adjusted in a wide dynamic range. These features allow us not only to test the functionality of the camera modules but also to fully characterize these. We report on the design and the functions of the SCB together with the results of test measurements.
Open AccessDevelopment of Slow Control Boards for the Large Size Telescopes of the Cherenkov Telescope Array
The camera of the Large Size Telescopes (LSTs) of the Cherenkov Telescope Array (CTA) consists of 265 photosensor modules, each of them containing 7 photomultiplier tubes (PMTs), a slow control board (SCB), a readout board, and a trigger logic. We have developed the SCB, which is installed between the 7 PMTs and the readout board. The main task for SCBs is the controlling of the high voltages for the PMTs and the monitoring of their anode currents. In addition, the SCB provides the functionality to create test pulses that can be injected at the input of the PMT preamplifier in order to emulate a PMT signal without the need of setting a high voltage, or even without the PMT itself. The test pulses have a very similar width as the PMT pulses (less than 3 ns FWHM) and their amplitude can be adjusted in a wide dynamic range. These features allow us not only to test the functionality of the camera modules but also to fully characterize these. We report on the design and the functions of the SCB together with the results of test measurements.