Hong Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Hong Zhang has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Bo Cheng
School of Microelectronics, Xian Jiaotong University, Xian, China
1 shared publication - Feng Li
Nanjing University of Posts and Telecommunications
1 shared publication Hongrui Luo
School of Microelectronics, Xi'an Jiaotong University, Xi'an, Shaanxi, CHINA
1 shared publicationHuanhuan Qi
School of Microelectronics, Xian Jiaotong University, Xian, China
1 shared publicationHui Cao
School of Microelectronics, Xian Jiaotong University, Xian, China
1 shared publicationJia Shen
School of Microelectronics, Xian Jiaotong University, Xian, China
1 shared publication
Latest Publications
- 16 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 35 (12) , 2029-2032
A 2–2.65-GHz Dual-Core VCO With High- Linearity Varactor Array and High- Q Switched Capacitor Bank Achieving −128 dBc/Hz Phase Noise at 1 MHz Offset
A dual-core LC voltage-controlled oscillator (VCO) implemented in a 28-nm CMOS process, targeting low phase noise and wide tuning range with improved linearity. To enhance phase noise performance while minimizing area overhead, a direct-coupled dual-core architecture is adopted, effectively halving the inductance while preserving high-Q characteristics. A dual-gain segmented varactor array is introduced, with a 1:9 sizing ratio to reduce tuning gain and improve linearity. In addition, a low-leakage, high-Q switched-capacitor array is proposed to effectively suppress off-state parasitic capacitance. Owing to its ultralow leakage current, the array enables wider tuning range without degrading the quality factor. The proposed VCO achieves a measured tuning range from 2.0 to 2.65 GHz across 16 bands with more than 65% overlap. The tuning sensitivity is 95 MHz/V with high-linear response from 0.2 to 1.0 V. The phase noise is −128 dBc/Hz at 1 MHz offset. The proposed VCO is suitable for high-performance, low-noise RF applications.
- 16 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 35 (12) , 2029-2032
A 2–2.65-GHz Dual-Core VCO With High- Linearity Varactor Array and High- Q Switched Capacitor Bank Achieving −128 dBc/Hz Phase Noise at 1 MHz Offset
A dual-core LC voltage-controlled oscillator (VCO) implemented in a 28-nm CMOS process, targeting low phase noise and wide tuning range with improved linearity. To enhance phase noise performance while minimizing area overhead, a direct-coupled dual-core architecture is adopted, effectively halving the inductance while preserving high-Q characteristics. A dual-gain segmented varactor array is introduced, with a 1:9 sizing ratio to reduce tuning gain and improve linearity. In addition, a low-leakage, high-Q switched-capacitor array is proposed to effectively suppress off-state parasitic capacitance. Owing to its ultralow leakage current, the array enables wider tuning range without degrading the quality factor. The proposed VCO achieves a measured tuning range from 2.0 to 2.65 GHz across 16 bands with more than 65% overlap. The tuning sensitivity is 95 MHz/V with high-linear response from 0.2 to 1.0 V. The phase noise is −128 dBc/Hz at 1 MHz offset. The proposed VCO is suitable for high-performance, low-noise RF applications.
- 22 June 2022
- Published by Elsevier in Applied Surface Science
- Vol. 599, 154059
Electrochemical oxidation pre-treatment for wet texturing of monocrystalline silicon solar cells
- 22 June 2022
- Published by Elsevier in Applied Surface Science
- Vol. 599, 154059
Electrochemical oxidation pre-treatment for wet texturing of monocrystalline silicon solar cells
- 13 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 15 (4) , 802-819
A Closed-Loop Neuromodulation Chipset With 2-Level Classification Achieving 1.5-Vpp CM Interference Tolerance, 35-dB Stimulation Artifact Rejection in 0.5ms and 97.8%-Sensitivity Seizure Detection
This work presents an 8-channel closed-loop neuromodulation chipset with 2-level seizure classification. The power-consuming fine classifier is only enabled when the coarse classifier in the frontend chip judges the patient's status as “suspected seizure”. This scheme can reduce the overall power consumption extensively since seizure usually occurs with very low possibility. In the capacitive-coupled instrument amplifier (CCIA) of the front-end IC, a feedback based common-mode (CM) cancellation circuit is proposed to suppress large-scale CM interferences and the stimulation artifacts are suppressed by a mixed-signal loop with fast response. An auto-zero based pre- charge path is adopted to boost the input impedance, while the electrode DC offset is canceled by a DC servo loop with very-large and accurate time constant. The 2.32-mm 2 front-end chip and 3.51-mm 2 DSP chip implemented in 0.18 μm CMOS are applied in a deep-brain stimulation (DBS) neuromodulator. Measurement results show that the CCIA can suppress 1.5-Vpp CM interference, and achieve an accurate high-pass corner frequency as low as 0.1 Hz and an input impedance greater than 2.2 GΩ. The overall classifier achieves 97.8% sensitivity and consumes only 1.16-μW average power for the CHB-MIT database test. The chipset has been verified by in vivo measurement, showing that the stimulation artifact can be suppressed by 35 dB within 0.5 ms.
- 13 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 15 (4) , 802-819
A Closed-Loop Neuromodulation Chipset With 2-Level Classification Achieving 1.5-Vpp CM Interference Tolerance, 35-dB Stimulation Artifact Rejection in 0.5ms and 97.8%-Sensitivity Seizure Detection
This work presents an 8-channel closed-loop neuromodulation chipset with 2-level seizure classification. The power-consuming fine classifier is only enabled when the coarse classifier in the frontend chip judges the patient's status as “suspected seizure”. This scheme can reduce the overall power consumption extensively since seizure usually occurs with very low possibility. In the capacitive-coupled instrument amplifier (CCIA) of the front-end IC, a feedback based common-mode (CM) cancellation circuit is proposed to suppress large-scale CM interferences and the stimulation artifacts are suppressed by a mixed-signal loop with fast response. An auto-zero based pre- charge path is adopted to boost the input impedance, while the electrode DC offset is canceled by a DC servo loop with very-large and accurate time constant. The 2.32-mm 2 front-end chip and 3.51-mm 2 DSP chip implemented in 0.18 μm CMOS are applied in a deep-brain stimulation (DBS) neuromodulator. Measurement results show that the CCIA can suppress 1.5-Vpp CM interference, and achieve an accurate high-pass corner frequency as low as 0.1 Hz and an input impedance greater than 2.2 GΩ. The overall classifier achieves 97.8% sensitivity and consumes only 1.16-μW average power for the CHB-MIT database test. The chipset has been verified by in vivo measurement, showing that the stimulation artifact can be suppressed by 35 dB within 0.5 ms.
- Open Access
- 5 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 175443-175453
A Pseudo-Constant Frequency Constant On-Time Buck Converter With Internal Current Ripple Injection and Output DC Offset Cancellation
- 5 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 175443-175453
Open AccessA Pseudo-Constant Frequency Constant On-Time Buck Converter With Internal Current Ripple Injection and Output DC Offset Cancellation
- 31 May 2014
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 80 (2) , 243-253
A voltage mode buck DC–DC converter with automatic PWM/PSM mode switching by detecting the transient inductor current
- 31 May 2014
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 80 (2) , 243-253
A voltage mode buck DC–DC converter with automatic PWM/PSM mode switching by detecting the transient inductor current
- 26 March 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 56 (2) , 756-765
Iterative Decision-Aided Clipping Compensation and Its Application to Scalable Video Transmission With Multiband OFDM
Deliberate digital clipping is a simple and efficient way of controlling the peak-to-average power ratio of orthogonal frequency division multiplexing (OFDM) systems. However, a clipping is a nonlinear process that may lead to significant distortion and performance loss. An iterative time-domain decision-aided clipping compensation framework is proposed to mitigate the distortion caused by the intentional clipping with the additional constraint of out-of-band noise filtering, and it is compared with the existing frequency-domain scheme. It incorporates the simple additive distortion model and the minimum mean-square distortion (MMSD) model, with the options of hard and soft symbol estimation. Extensive simulation results are provided for the performance comparison among different schemes. The MMSD-distortion-model-based frequency-domain clipping compensation gives the best performance and is applied to scalable video transmission with a multiband OFDM. Simulations demonstrate an effective mitigation of the performance loss by the applied compensation algorithm
- 26 March 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 56 (2) , 756-765
Iterative Decision-Aided Clipping Compensation and Its Application to Scalable Video Transmission With Multiband OFDM
Deliberate digital clipping is a simple and efficient way of controlling the peak-to-average power ratio of orthogonal frequency division multiplexing (OFDM) systems. However, a clipping is a nonlinear process that may lead to significant distortion and performance loss. An iterative time-domain decision-aided clipping compensation framework is proposed to mitigate the distortion caused by the intentional clipping with the additional constraint of out-of-band noise filtering, and it is compared with the existing frequency-domain scheme. It incorporates the simple additive distortion model and the minimum mean-square distortion (MMSD) model, with the options of hard and soft symbol estimation. Extensive simulation results are provided for the performance comparison among different schemes. The MMSD-distortion-model-based frequency-domain clipping compensation gives the best performance and is applied to scalable video transmission with a multiband OFDM. Simulations demonstrate an effective mitigation of the performance loss by the applied compensation algorithm