Marcin Majer

This article addresses the challenge of searching for the optimal location for a newly designed pollutant emitter (new factory or other facility) in relation to the requirements imposed by environmental protection regulations on the concentrations of selected pollutants in a given area, taking into account the currently existing levels of analysed substances. The paper presents the key issues of the dispersion of pollutants in atmospheric air and pollutant dispersion models. The Gaussian model of a plume, based on the Pasquill diffusion equation, is chosen to simulate the dispersion of pollutants in atmospheric air. The key issue within the paper constitutes the research section responsible for using the Monte Carlo global optimisation method in order to find the optimal location. The proposed algorithm is intended to offer measurable and subjective arguments and options to preliminary discussions on choosing a location for new factories, while such discussions choices should be fact-based and ecologically acceptable instead of fulfilling only political or economical goals. The paper is intended to present the need for easily interpretable arguments for discussions and responsible decisions on choosing the lowest-impact location of pollutant emitters to the scientific community.

The differential pressure of gas measurement is very often used in industrial measurements. During the gas flow, liquid condensation often occurs. The result is that when measuring a gas flow, the gas-liquid mixture is essentially measured. Errors in the indications of measuring instruments are starting to appear due to a change in the properties of the continuous phase, which is gas. In addition, the appearance of liquid droplets leads to flow disturbances and pressure pulsations. Therefore, new methods and tools for measuring the flow of gas-liquid mixture are being sought. The work involves the use of slotted orifices for measuring gas-liquid mixtures. An analysis of the influence of the slotted orifice geometry on the measurement of the biphasic mixture stream was carried out. Standard orifice and three slotted orifices of various designs. The experiment included measuring the air flow with a small amount of water dispersed in the form of drops.