JNJacopo Nava

Jacopo Nava

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jacopo Nava has a total of 47 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Seismic Versus Sub‐Seismic Experimental Mirror‐Like Fault Surfaces in Bituminous Dolostones

    by M. Chinello, S. Aretusini, E. Spagnuolo, J. Nava, T. Tesei, M. Fondriest, G. Di Toro

    Mirror‐like Surfaces (MSs) are ultra‐polished surfaces frequently found in exhumed seismogenic fault zones in carbonates. They form over a wide range of pressure‐temperature conditions and slip rates, from seismic (≈1 m/s) to sub‐seismic (≈0.1–100 μm/s), reflecting distinct phases of the seismic cycle. Motivated by the abundance of MSs in bituminous dolostones from the Central Apennines (Italy), we performed rotary‐shear experiments at seismic and sub‐seismic slip rates on incohesive samples under water‐dampened and room‐humidity conditions, to determine the conditions favoring MSs formation. MSs developed under all tested conditions, regardless of water content. Mechanical data indicate that, compared to pure dolomite, the presence of bitumen lowers the friction coefficient and promotes slip‐neutral behavior at seismic slip rate. FEG‐FIB‐SEM microstructural investigations revealed that all experimental MSs consist of a 10s‐nm‐thick film of rounded nanoparticles ≈5–15 nm in diameter. Subtle microstructural differences emerged in the “room‐humidity” MSs. The “sub‐seismic” MSs display nanoparticles arranged in sub‐spherical aggregates measuring a few 10s nm. Differently, “seismic” MS is cut by micro‐cracks due to thermal contraction or desiccation, and nanoparticles are arranged in flat, sub‐rounded aggregates measuring 5–150 nm. Changes in porosity, grain size and foliation are observed in the firsts μm of the slip zone under all the “seismic” MSs. These results suggest that MSs represent a morphological convergence of physical and chemical processes acting across a broad range of deformation conditions. However, micro‐ to nano‐scale structural features, if preserved in natural faults, may help distinguish between “seismic” and “sub‐seismic” MSs, with implications for seismic hazard assessment.

  • Open Access

    Discovery of a Roman Quarry for Pozzolanic aggregates in the Euganean Hills Magmatic District, Northeast Italy: A stepwise archaeometric approach

    by Simone Dilaria, Luigi Germinario, Claudio Mazzoli, Caterina Previato, Milo K. Pilgrim, Josiah Olah, Jacopo Nava, Jacopo Bonetto, Michele Secco

    This study investigates the provenance of volcanic aggregates used in Roman lime-based mortars from the theatre–bath complex at Via Scavi in Montegrotto Terme (ancient Fons Aponi , northeastern Italy), dated to the Early Imperial period. An integrated stepwise archaeometric approach combining petrographic observations via Transmitted Polarized Light-Optical Microscopy (TPL-OM), mineralogical analyses via Quantitative Phase Analysis-X-Ray Powder Diffraction (QPA-XRPD), bulk geochemical data via X-Ray Fluorescence (XRF), microchemical analyses via Scanning Electron Microscopy coupled with Energy-Dispersive Spectroscopy (SEM-EDS), and µ-Raman Spectroscopy were applied to characterize the volcanic components of the mortars and assess their hydraulic behaviour. The results show that the mortars incorporate angular trachytic to trachyandesitic volcanic breccias displaying well-developed reaction rims and extensive pozzolanic reactivity, leading to the formation of calcium–aluminosilicate hydrate phases typical of pozzolanic lime mortars. Comparison with a comprehensive reference database of volcanic rocks from the Euganean Hills Magmatic District (Veneto, Italy) indicates that these aggregates are consistent with explosive diatreme breccias exposed in the eastern sector of the district, most likely corresponding to quarry sites near Villa Draghi (Montegrotto Terme). The identification of these volcanic materials in mortars from Aquileia (northeastern Italy, approximately 150 km north-east of the Euganean Hills) further suggests that such “Euganean pozzolans” were not used exclusively at a local scale but were traded over longer distances. These findings provide new archaeometric evidence for the exploitation of non-Vitruvian volcanic pozzolans in Roman construction and illustrate the potential of integrated petrographic and geochemical approaches for provenance studies of these mortar aggregates.


  • Open Access

    Inulin's paradoxical effect on Ca( ii )-alginate encapsulation of phenolic extracts

    by Peyman Ebrahimi, Alberto De Iseppi, Zeynep Gülbeş, Elisa Canazza, Jacopo Nava, Barbara Simonato, Corrado Rizzi, Dasha Mihaylova, Anna Lante

    Encapsulating polyphenols in Ca(II)-alginate beads requires suitable co-carriers, such as inulin, to reduce bead porosity and enhance protective efficiency. However, the real impact of inulin remains unknown, with some studies showing improved encapsulation efficiency (EE) and others indicating a decline. This study investigated the actual effect of inulin on the EE, physical properties, and release behaviour of Ca(II)-alginate beads loaded with spent sour cherry pomace extracts. EE based on total phenolic content (TPC) determined from bead dissolution in sodium citrate increased significantly with inulin addition, exceeding 90%. In contrast, TPC-based EE calculated from unloaded compounds in the residual calcium chloride solution decreased with inulin, dropping below 40%. This inconsistency was attributed to interference from inulin in the Folin–Ciocalteu assay, as its incorporation into the bead matrix may lead to overestimated TPC values. Supporting this, pure inulin exhibited a measurable TPC of 74.79 ± 2.28 µg GAE per g and notable reducing activity in the ferric-reducing antioxidant assay. Moreover, beads containing inulin exhibited reduced hardness, due to increased viscosity of the feed solution, which likely hindered alginate-calcium cross-linking. However, inulin significantly enhanced anthocyanin-based EE from 47.18 ± 2.54% to 53.26 ± 0.91% (p ≤ 0.05). It also increased the beads' diameter, filling the pores within the Ca(II)-alginate matrix, as confirmed by SEM imaging. Release kinetics of TPC and anthocyanins followed the Korsmeyer–Peppas model (R2 > 0.9), with n values indicating Fickian diffusion. Although inulin reduced apparent TPC-based EE and bead rigidity, its functional advantages warrant further optimization of formulation parameters.


  • Open Access

    Determination of local geometrical distortions in an ordered omphacite under high pressure

    by Lisa Baratelli, Marco Merlini, Fabrizio Nestola, Jacopo Nava, Boby Joseph, Mauro Prencipe, Fernando Cámara

    Single-crystal synchrotron X-ray diffraction data were collected up to 10 GPa at room temperature on a natural omphacite with composition close to Jd 43 Di 57 , at the Xpress beamline at Elettra Synchrotron, using a diamond anvil cell. A second-order Birch-Murnaghan equation of state (EoS) fit to the unit-cell volumes determined at 20 pressure points yielded V 0 = 422.85(15) Å 3 , and K 0 = 121.3(1.2) GPa. These elastic parameters are consistent with the general trend of the diopside–jadeite join. The structural evolution with pressure was determined from both ab initio simulations and structure refinements to the X-ray intensity data. The consistency between experimental findings and local geometrical distortions identified through ab initio calculations is discussed. A distortion variation at the M 1 polyhedron occurs at ∼3 GPa, which correlates with the TILT angle of the T 2 tetrahedron which stabilises at a similar pressure, coinciding with a decrease in the rate of M 1 deformation under pressure. These results revealing the structural evolution with pressure correlate with changes observed previously in some Raman shifts in the same pressure range in the same material.

  • Open Access

    Nano-scale impact shock features of diamond and graphite in ureilites

    by Anna Barbaro, Fabrizio Nestola, Sheryl A. Singerling, Jacopo Nava, Frank E. Brenker


  • Open Access

    Analytical data on three Martian simulants

    by Nicole Costa, Alessandro Bonetto, Patrizia Ferretti, Bruno Casarotto, Matteo Massironi, Francesca Altieri, Jacopo Nava, Marco Favero


  • Open Access

    Deterioration Effects on Bricks Masonry in the Venice Lagoon Cultural Heritage: Study of the Main Façade of the Santa Maria dei Servi Church (14th Century)

    by Chiara Coletti, Ludovica Pia Cesareo, Jacopo Nava, Luigi Germinario, Lara Maritan, Matteo Massironi, Claudio Mazzoli

    Tidal exchange, capillary rise, water condensation-evaporation cycles, and crystallization of salts are the main causes of damage in historic brick buildings in Venice. The present study addressed these issues by proposing a study of twenty-three brick samples collected on the main façade of the Santa Maria dei Servi Church (14th century). The color, mineralogical composition, and texture of these samples were studied using standard methods such as spectrophotometry, X-ray powder diffraction (XRPD), optical microscopy (OM), and field emission scanning electron microscopy (FESEM). The presence of carbonates (calcite and dolomite) and newly formed silicate phases, such as gehlenite and diopside, provided indications of the temperatures reached during firing and suggested the absence of a good standardization in the production process. Meanwhile, XRPD and hyperspectral analysis (HA) detected sulfates (e.g., gypsum and mirabilite) as the main weathering products due to the salt decay process that affects monuments in the Venice lagoon environment. Moreover, secondary phases, such as Mg- and Ca-zeolites, occurred in bricks where the groundmass observed by OM was more vitrificated, and the XRPD patterns displayed the highest amorphous content. On-site mapping of sulfates and chlorophyll by HA was also performed on the main façade of the Church, highlighting the large presence of salts and biodeterioration.


  • Hydrothermal activity on the CV parent body: New perspectives from the giant Transantarctic Mountains minimeteorite TAM5.29

    by J. Nava, M. D. Suttle, R. Spiess, L. Folco, J. Najorka, C. Carli, M. Massironi

    TAM5.29 is an extraterrestrial dust grain, collected on the Transantarctic Mountains (TAM). Its mineralogy is dominated by an Fe‐rich matrix composed of platy fayalitic olivines and clasts of andradite surrounded by diopside‐jarosite mantles; chondrules are absent. TAM5.29 records a complex geological history with evidence of extensive thermal metamorphism in the presence of fluids at T < 300 °C. Alteration was terminated by an impact, resulting in shock melt veins and compaction‐orientated foliation of olivine. A second episode of alteration at lower temperatures (ox group with a mineralogical assemblage in between the Allende‐like and Bali‐like subgroups (CVoxA and TAM5.29 are rich in andradite, magnetite, and FeNiS, but CVoxA lacks hydrated minerals, common in TAM5.29; conversely, CVoxB are rich in hydrated phyllosilicates but contain almost pure fayalite, not found in TAM5.29). In addition, TAM5.29 has a slightly different metasomatic history, in between the oxidized and reduced CV metamorphic grades while also recording higher oxidizing conditions as compared to the known CV chondrites. This study represents the third CV‐like cosmic dust particle, containing a unique composition, mineralogy, and fabric, demonstrating variation in the thermal metamorphic history of the CV parent body(‐ies).