Yisheng Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yisheng Hu has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Ali Akbari
School of Chemical Engineering, Payame Noor University of Tehran, Tehran 14500, Iran
1 shared publicationChao Min
State Key Laboratory of Oil & Gas Reservoir Geology & Exploitation, Southwest Petroleum University, Chengdu, China; School of Science, Southwest Petroleum University, Chengdu, China
1 shared publication- Fanhua Zeng
Faculty of Engineering and Applied Science, University of Regina, Regina, SK S4S 0A2, Canada
1 shared publication Fengtan Lin
State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Chengdu, 610500, PR China
1 shared publicationHuang Liu
State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Chengdu 610500, Sichuan, China
1 shared publication- Huang Liu
State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Chengdu 610500, China
1 shared publication
Latest Publications
- 8 October 2019
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 34 (1) , 1033-1040
Investigation of Biomass Gasification Potential in Syngas Production: Characteristics of Dried Biomass Gasification Using Steam as the Gasification Agent
- 8 October 2019
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 34 (1) , 1033-1040
Investigation of Biomass Gasification Potential in Syngas Production: Characteristics of Dried Biomass Gasification Using Steam as the Gasification Agent
- 4 April 2019
- Published by Wiley in Journal of Energy Resources Technology
- Vol. 141 (9) , 1-12
Experimental Investigation of the Damage Mechanisms of Drilling Mud in Fractured Tight gas Reservoir
Mud pollution seriously restricts the development of tight gas reservoirs. For the Dabei tight gas field in Tarim Basin, lots of wells show a higher skin factor on the pressure buildup test curves after drilling. Little researches on mud damage have been conducted for the fracture gas reservoir. Based on the previous researches, a dynamic filtration experimental method utilizing full diameter cores is established for fracture-porous cores under reservoir temperature. Twelve sets of dynamic filtration tests with full diameter cores (D = 10 cm) on the established device and some cuttings microscopic analysis on environmental-scanning-electron microscope/energy dispersive X-ray detector (ESEM/EDX) have been conducted. The effects of core type, fracture width, pressure difference, and mud type on mud damage are all investigated. The results show that the fractured cores suffer a more serious damage degree and exhibit lower return permeability ratio, compared with the porous cores. And the damage degree of fractured cores is proportional to the fracture width and pressure difference. The solids invasion is the key factor damaging the fractured cores, while the porous is mainly impaired by the filtrate invasion. This paper provides a scientific, in-depth understanding of the behaviors, laws, and characteristics of mud damage in fractured and porous cores.
- 4 April 2019
- Published by Wiley in Journal of Energy Resources Technology
- Vol. 141 (9) , 1-12
Experimental Investigation of the Damage Mechanisms of Drilling Mud in Fractured Tight gas Reservoir
Mud pollution seriously restricts the development of tight gas reservoirs. For the Dabei tight gas field in Tarim Basin, lots of wells show a higher skin factor on the pressure buildup test curves after drilling. Little researches on mud damage have been conducted for the fracture gas reservoir. Based on the previous researches, a dynamic filtration experimental method utilizing full diameter cores is established for fracture-porous cores under reservoir temperature. Twelve sets of dynamic filtration tests with full diameter cores (D = 10 cm) on the established device and some cuttings microscopic analysis on environmental-scanning-electron microscope/energy dispersive X-ray detector (ESEM/EDX) have been conducted. The effects of core type, fracture width, pressure difference, and mud type on mud damage are all investigated. The results show that the fractured cores suffer a more serious damage degree and exhibit lower return permeability ratio, compared with the porous cores. And the damage degree of fractured cores is proportional to the fracture width and pressure difference. The solids invasion is the key factor damaging the fractured cores, while the porous is mainly impaired by the filtrate invasion. This paper provides a scientific, in-depth understanding of the behaviors, laws, and characteristics of mud damage in fractured and porous cores.
- 26 February 2019
- Published by Elsevier in Ceramics International
- Vol. 45 (8) , 10976-10981
Three-dimensional carbon nanotube-scaffolded Li4Ti5O12@C microsphere with enhanced rate property for electrochemical energy storage
- 26 February 2019
- Published by Elsevier in Ceramics International
- Vol. 45 (8) , 10976-10981
Three-dimensional carbon nanotube-scaffolded Li4Ti5O12@C microsphere with enhanced rate property for electrochemical energy storage
- 2 October 2018
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 36 (19) , 1568-1572
Modeling crude oil gasification
The characteristics of CO2-gasification of crude oil under steady-state condition were studied using a simulator. The model was developed using the minimization Gibbs free energy minimization. The effects of reactor temperature and CO2/crude oil ratio on gas composition and lower heating value (LHV) of the produced syngas were investigated. As a result, the maximum LHV was obtained at a CO2/crude oil ratio of 0.1 and gasification temperature of 800 °C.
- 2 October 2018
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 36 (19) , 1568-1572
Modeling crude oil gasification
The characteristics of CO2-gasification of crude oil under steady-state condition were studied using a simulator. The model was developed using the minimization Gibbs free energy minimization. The effects of reactor temperature and CO2/crude oil ratio on gas composition and lower heating value (LHV) of the produced syngas were investigated. As a result, the maximum LHV was obtained at a CO2/crude oil ratio of 0.1 and gasification temperature of 800 °C.
- 16 September 2016
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 34 (17-18) , 1595-1601
Identification and modeling of geochemical reactions occurring within the sandstone reservoir flooded by seawater
Field X has one of the harshest oilfield scaling regimes in the North Sea and frequent squeeze treatments were implemented, so it will be beneficial to study and identify reservoir interactions among formation water, injected seawater, and reservoir rock, and even predict or evaluate scale problems in the field. For this field, produced water is sampled repeatedly during production and observation and analyses of variations in produced water chemical composition could reveal the extent of brine mixing in the field and enables an in-depth understanding of the fluid-fluid/fluid-rock interactions occurring in the reservoir during water injection. Produced water chemical compositional data from one well have been presented to provide a basic understanding of what geochemical reactions were possibly occurring in the reservoir, which could be then verified through developing a one-dimensional reactive transport model. Any possible occurring reactions among minerals, mixture of formation water and seawater, and CO2 gas phase would be included in this model to study their effects on variation in produced water chemical composition. A fairly good match between modelled and observed produced water chemical composition has been achieved through varying solubility products and the initial amount of some minerals, ion exchange capacity, and CO2 partial pressure, which indicates that the final achieved model, could, to some extent, reveal the physical, chemical, and thermodynamic responses of this reservoir system to injected seawater.
- 16 September 2016
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 34 (17-18) , 1595-1601
Identification and modeling of geochemical reactions occurring within the sandstone reservoir flooded by seawater
Field X has one of the harshest oilfield scaling regimes in the North Sea and frequent squeeze treatments were implemented, so it will be beneficial to study and identify reservoir interactions among formation water, injected seawater, and reservoir rock, and even predict or evaluate scale problems in the field. For this field, produced water is sampled repeatedly during production and observation and analyses of variations in produced water chemical composition could reveal the extent of brine mixing in the field and enables an in-depth understanding of the fluid-fluid/fluid-rock interactions occurring in the reservoir during water injection. Produced water chemical compositional data from one well have been presented to provide a basic understanding of what geochemical reactions were possibly occurring in the reservoir, which could be then verified through developing a one-dimensional reactive transport model. Any possible occurring reactions among minerals, mixture of formation water and seawater, and CO2 gas phase would be included in this model to study their effects on variation in produced water chemical composition. A fairly good match between modelled and observed produced water chemical composition has been achieved through varying solubility products and the initial amount of some minerals, ion exchange capacity, and CO2 partial pressure, which indicates that the final achieved model, could, to some extent, reveal the physical, chemical, and thermodynamic responses of this reservoir system to injected seawater.