Guozhi Zhang

Addressing the insufficient sensitivity of typical Archimedean spiral antennas for detecting partial discharge (PD) in electrical equipment, this paper proposes a high-sensitivity regulation technique for PD Archimedean antennas based on rotating unit-cell reflective metasurfaces. First, a finite element model of the ultra-high-frequency Archimedean antenna was constructed. Then, employing metasurface electromagnetic wave reflection technology and phase compensation principles, a rotating-unit reflective metasurface was designed to optimize its full-bandwidth gain. A multi-parameter joint optimization method was used to obtain the optimal data for the antenna and metasurface parameters. Finally, simulations and experimental analyses of the super-surface-controlled Archimedean antenna revealed the following: The gain of the Archimedean antenna controlled by the rotating-unit super-surface increases by up to 15.61 dB in the 0.3–1.5 GHz band, with an average full-band gain enhancement of 3.42 dB. During electrostatic discharge (ESD), the amplitude of UHF signals detected by the Archimedean antenna increases by approximately 88.9%, and the amplitude detection of UHF signals during GIS discharges increases by approximately 138.6–150%. These results demonstrate that the metasurface significantly enhances the antenna’s gain performance, providing a reference for highly sensitive control technologies in detecting discharges in electrical equipment.

To meet the high-sensitivity requirement of ultra-high-frequency (UHF) sensors for electromagnetic waves radiated by partial discharge (PD) in power equipment of substations, this paper proposes a Koch complementary fractal UHF antenna based on the artificial magnetic conductor (AMC) metasurface. First, based on the Iterated Function System (IFS), a finite element model of the UHF Koch fractal antenna is constructed via affine transformation. Then, leveraging the in-phase reflection characteristic of the metasurface, an AMC metasurface for gain enhancement of the Koch fractal antenna is designed, and a multi-dimensional parameter joint optimization method is adopted to obtain the optimal structural parameter set of the Koch fractal antenna loaded with the AMC metasurface. Finally, experimental tests and analyses are carried out on the Koch complementary fractal UHF antenna. The results show that the antenna loaded with the AMC metasurface achieves a better voltage standing wave ratio (VSWR) and improved gain in both low and high frequency bands: the average gain increases by 35.19% in the frequency range of 0.3 GHz to 1.5 GHz, and the peak gain reaches approximately 11.5 dB with an enhancement of 120%.

Addressing the pressing need to extend the communication range of RF RFID tag antennas, this paper introduces a novel UHF RFID tag antenna technology based on resonant superstrate regulation using a Split-Ring Resonator (SRR). First, a finite element model of the UHF RFID folded dipole antenna was constructed based on the tag chip’s port impedance. Subsequently, a Two-element SRR resonant superstrate was employed to enhance the dipole antenna’s gain through “resonance and near-field coupling” technology. A folded dipole antenna gain-enhancing SRR resonant superstrate unit was designed, and a multi-parameter joint optimization method was adopted to obtain the optimal SRR resonant superstrate configuration for regulating the dipole antenna. Near-field coupling technology was used to design SRR resonant superstrate elements that enhance the folded dipole antenna’s gain. A multi-parameter joint optimization method was employed to obtain the optimal structural parameter set for the SRR resonant superstrate-controlled dipole antenna. Finally, simulations and experimental measurements of the RFID antenna performance revealed that: within the 920–925 MHz band, the maximum measured forward reading distance enhancement reached 62.1%. The research findings significantly enhance the practical performance of UHF RFID tags in complex environments, enabling more stable and efficient long-range identification in applications such as logistics tracking, asset management, and smart warehousing.

The use of flexible, built-in, ultra-high-frequency (UHF) antenna sensors is an effective method to solve the weak high-frequency electromagnetic wave signal sensing of partial discharge (PD) inside gas-insulated switchgears (GISs), and the compatibility of flexible UHF antenna sensor substrate materials and SF6/N2 mixtures is the key to the realization of a flexible UHF antenna sensor inside a GIS. Based on this, this paper builds an experimental platform for the compatibility of a 30% SF6/70% N2 gas mixture and a PD flexible UHF antenna sensor substrate and conducts compatibility experiments between the 30% SF6/70% N2 gas mixture and PD flexible UHF antenna sensor substrate under different temperatures in combination with the actual operating temperature range of the GIS. In this article, a Fourier transform infrared spectrometer, scanning electron microscope and X-ray photoelectron spectrometer were used to test and analyze the gas composition, the surface morphology and the elemental change in the PD flexible UHF antenna sensor substrate, respectively. PET material will be slightly oxidized under the environment of a 30% SF6/70% N2 gas mixture at 110 °C, PI material will generate metal fluoride under the environment of a 30% SF6/70% N2 gas mixture and only PDMS material will remain stable under the environment of a 30% SF6/70% N2 gas mixture; therefore, it is appropriate to use PDMS substrate in the development of flexible UHF antenna sensors.

Spiral antenna sensors are commonly used in partial discharge (PD) ultra-high frequency (UHF) detection in gas-insulated switchgears (GISs). However, most of the existing UHF spiral antenna sensors are based on a rigid base and balun, such as FR-4. The safe built-in installation of antenna sensors requires the complex structural transformation of GISs. To solve this problem, a low-profile spiral antenna sensor is designed based on a polyimide (PI) flexible base, and its performance is optimized by improving the clearance ratio. The simulation and measurement results show that the profile height and diameter of the designed antenna sensor is 0.3 mm and 137 mm, which is 99.7% and 25.4% smaller than the traditional spiral antenna. Under a different bending radius, the antenna sensor can maintain VSWR ≤ 5 in 650 MHz~3 GHz, and its maximum g_re is up to 6.1 dB. Finally, the PD detection performance of the antenna sensor is carried out on a real 220 kV GIS. The results show that, after being built in, the PD with a weak discharge magnitude of 4.5 pC can be effectively detected by the antenna sensor, and the antenna sensor has the ability to quantify the severity of PD. In addition, through the simulation, the antenna sensor has potential for the detection of micro water in GISs.

Mo₂C is a two-dimensional material with high electrical conductivity, low power consumption, and catalytic effect, which has promising applications in the field of microfluidic gas detection. First principles were used to study the adsorption characteristics of Mo₂C monolayer on four typical decomposition gases of SF₆ (H₂S, SO₂, SOF₂, and SO₂F₂), and to explore the feasibility of its application in the detection of SF₆ decomposition components. The results showed that Mo₂C chemisorbed all four gases, and the adsorption capacity was H₂S < SO₂ < SOF₂ < SO₂F₂. The adsorption mechanism of Mo₂C as a microfluidic sensor was analyzed in combination with its charge-density difference and density of states. On the other hand, the different work-function change trends after adsorbing gases provide the possibility for Mo₂C to selectively detect gases as a low-power field-effect transistor sensor. All content can be used as theoretical guidance in the realization of Mo₂C as a gas-sensitive material for the detection of SF₆ decomposition components.

To address the problem of low space utilization of existing rigid Ultra-High Frequency (UHF) sensors for partial discharge (PD) in Gas-Insulated Switchgears (GIS) and the problem of disrupting the electric field distribution inside the GIS. This paper draws on the idea of flexible wearable antennas and introduces planar monopole antennas commonly used in the communication field as GIS PD detection sensors and carried out research on flexible planar monopole sensing technology built into GIS PD. The VSWR of monopole antenna in the UHF low band is optimized by the meandering technique. The size of the designed flexible antenna is 142 mm × 195 mm × 0.28 mm. The simulation and physical test results show that the improved monopole antenna with meandering technology has a VSWR of ≤2 in the frequency bands 570 MHz–830 MHz, 1.38 GHz–1.8 GHz, and 2.2 GHz–2.76 GHz when the bending radius is 0 mm, 200 mm, and 400 mm, respectively. The VSWR in the frequency band 450 MHz–3 GHz is ≤5. A 220 kV GIS PD detection platform was built to test the performance of the designed antenna, and the results showed that the antenna could detect the PD signal after bending deformation with a high Signal Noise Ratio (SNR).