Zhifa Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zhifa Liu has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Thomas Kirchartz
IMD-3 Photovoltaics, Forschungszentrum Jülich GmbH, Jülich, Germany
7 shared publications - Uwe Rau
IMD3‐Photovoltaics Forschungszentrum Jülich GmbH Jülich North Rhine‐Westphalia Germany
6 shared publications - Li-Chung Kin
Institut für Energie- und Klimaforschung (IEK-9), Forschungszentrum Jülich GmbH, 52428 Jülich, Germany
3 shared publications - Oleksandr Astakhov
Forschungszentrum Jülich GmbH, IMD-3 Photovoltaik, Jülich, Germany
3 shared publications - Tsvetelina Merdzhanova
Forschungszentrum Jülich GmbH, IMD-3 Photovoltaik, Jülich, Germany
3 shared publications Bart E. Pieters
IEK5-Photovoltaics, Forschungszentrum Jülich, 52425 Jülich, Germany
1 shared publication
Latest Publications
- Open Access
- 2 August 2023
- Published by American Physical Society (APS) in PRX Energy
- Vol. 2 (3) , 033006
How Charge Carrier Exchange between Absorber and Contact Influences Time Constants in the Frequency Domain Response of Perovskite Solar Cells
A model is derived for the frequency and time domain optoelectronic response of perovskite solar cells (PSCs) that emphasizes the role of charge carrier exchange, i.e., extraction and injection, from (to) the perovskite through the transport layer to (from) the collecting electrode. This process is described by a charge carrier exchange velocity that depends on the mobility and electric field inside the transport layer. The losses implied by this process are modeled in an equivalent circuit model in the form of a voltage-dependent transport layer resistance. The analysis of the model predicts that the voltage dependence of the measured time constants allows discriminating situations where the transport layer properties dominate the experimental response. Application of this method to experimental impedance spectroscopy data identifies charge extraction velocities between 1 and 100 cm/s under 1-sun open-circuit conditions for p-i-n PSCs with poly(triaryl amine) as the hole transport layer; this corresponds to transport layer mobilities between and 3 × s. The model paves the way for an accurate estimation of the photocurrent and fill factor losses in PSCs caused by low mobilities in the transport layers, using small-perturbation measurements in the time and frequency domain.- 2 August 2023
- Published by American Physical Society (APS) in PRX Energy
- Vol. 2 (3) , 033006
Open AccessHow Charge Carrier Exchange between Absorber and Contact Influences Time Constants in the Frequency Domain Response of Perovskite Solar Cells
A model is derived for the frequency and time domain optoelectronic response of perovskite solar cells (PSCs) that emphasizes the role of charge carrier exchange, i.e., extraction and injection, from (to) the perovskite through the transport layer to (from) the collecting electrode. This process is described by a charge carrier exchange velocity that depends on the mobility and electric field inside the transport layer. The losses implied by this process are modeled in an equivalent circuit model in the form of a voltage-dependent transport layer resistance. The analysis of the model predicts that the voltage dependence of the measured time constants allows discriminating situations where the transport layer properties dominate the experimental response. Application of this method to experimental impedance spectroscopy data identifies charge extraction velocities between 1 and 100 cm/s under 1-sun open-circuit conditions for p-i-n PSCs with poly(triaryl amine) as the hole transport layer; this corresponds to transport layer mobilities between and 3 × s. The model paves the way for an accurate estimation of the photocurrent and fill factor losses in PSCs caused by low mobilities in the transport layers, using small-perturbation measurements in the time and frequency domain. - 18 July 2023
- Published by Fundacio Scito
Efficient indoor light harvesting with CH3NH3PB(I,BR)3 Perovskite Solar Cells
- 18 July 2023
- Published by Fundacio Scito
Efficient indoor light harvesting with CH3NH3PB(I,BR)3 Perovskite Solar Cells
- Open Access
- 26 July 2022
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (31) , 27532-27541
Toward the Integration of a Silicon/Graphite Anode-Based Lithium-Ion Battery in Photovoltaic Charging Battery Systems
Solar photovoltaic (PV) energy generation is highly dependent on weather conditions and only applicable when the sun is shining during the daytime, leading to a mismatch between demand and supply. Merging PVs with battery storage is the straightforward route to counteract the intermittent nature of solar generation. Capacity (or energy density), overall efficiency, and stability at elevated temperatures are among key battery performance metrics for an integrated PV-battery system. The performance of high-capacity silicon (Si)/graphite (Gr) anode and LiNi0.6Mn0.2Co0.2O2 (NMC622) cathode cells at room temperature, 45, and 60 °C working temperatures for PV modules are explored. The electrochemical performance of both half and full cells are tested using a specially formulated electrolyte, 1 M LiPF6 in ethylene carbonate: diethyl carbonate, with 5 wt % fluoroethylene carbonate, 2 wt % vinylene carbonate, and 1 wt % (2-cyanoethyl)triethoxysilane. To demonstrate solar charging, perovskite solar cells (PSCs) are coupled to the developed batteries, following the evaluation of each device. An overall efficiency of 8.74% under standard PV test conditions is obtained for the PSC charged lithium-ion battery via the direct-current-direct-current converter, showing the promising applicability of silicon/graphite-based anodes in the PV-battery integrated system.
- 26 July 2022
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (31) , 27532-27541
Open AccessToward the Integration of a Silicon/Graphite Anode-Based Lithium-Ion Battery in Photovoltaic Charging Battery Systems
Solar photovoltaic (PV) energy generation is highly dependent on weather conditions and only applicable when the sun is shining during the daytime, leading to a mismatch between demand and supply. Merging PVs with battery storage is the straightforward route to counteract the intermittent nature of solar generation. Capacity (or energy density), overall efficiency, and stability at elevated temperatures are among key battery performance metrics for an integrated PV-battery system. The performance of high-capacity silicon (Si)/graphite (Gr) anode and LiNi0.6Mn0.2Co0.2O2 (NMC622) cathode cells at room temperature, 45, and 60 °C working temperatures for PV modules are explored. The electrochemical performance of both half and full cells are tested using a specially formulated electrolyte, 1 M LiPF6 in ethylene carbonate: diethyl carbonate, with 5 wt % fluoroethylene carbonate, 2 wt % vinylene carbonate, and 1 wt % (2-cyanoethyl)triethoxysilane. To demonstrate solar charging, perovskite solar cells (PSCs) are coupled to the developed batteries, following the evaluation of each device. An overall efficiency of 8.74% under standard PV test conditions is obtained for the PSC charged lithium-ion battery via the direct-current-direct-current converter, showing the promising applicability of silicon/graphite-based anodes in the PV-battery integrated system.
- Open Access
Fill Factor Losses and Deviations from the Superposition Principle in Lead-Halide Perovskite Solar Cells
The enhancement of the fill factor in the current generation of perovskite solar cells is the key for further efficiency improvement. Thus, methods to quantify the fill factor losses are urgently needed. A classical method to quantify Ohmic and non-Ohmic resistive losses in solar cells is based on the comparison between the voltage in the dark and under illumination analysed at equal recombination current density. Applied to perovskite solar cells, we observe a combination of an Ohmic series resistance with a voltage-dependent resistance that is most prominent at short circuit and low forward bias. The latter is most likely caused by the poor transport properties of the electron and/or hole transport layers. By measuring the photoluminescence of perovskite solar cells as a function of applied voltage, we provide direct evidence for a high quasi-Fermi level splitting at low and moderate forward bias that substantially exceeds the externally applied voltage. This quasi-Fermi level splitting causes recombination losses and, thus, reduces both the short-circuit current and the fill factor of the solar cell.
Open AccessFill Factor Losses and Deviations from the Superposition Principle in Lead-Halide Perovskite Solar Cells
The enhancement of the fill factor in the current generation of perovskite solar cells is the key for further efficiency improvement. Thus, methods to quantify the fill factor losses are urgently needed. A classical method to quantify Ohmic and non-Ohmic resistive losses in solar cells is based on the comparison between the voltage in the dark and under illumination analysed at equal recombination current density. Applied to perovskite solar cells, we observe a combination of an Ohmic series resistance with a voltage-dependent resistance that is most prominent at short circuit and low forward bias. The latter is most likely caused by the poor transport properties of the electron and/or hole transport layers. By measuring the photoluminescence of perovskite solar cells as a function of applied voltage, we provide direct evidence for a high quasi-Fermi level splitting at low and moderate forward bias that substantially exceeds the externally applied voltage. This quasi-Fermi level splitting causes recombination losses and, thus, reduces both the short-circuit current and the fill factor of the solar cell.
- 27 November 2019
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 3 (1) , 431-439
Efficient Area Matched Converter Aided Solar Charging of Lithium Ion Batteries Using High Voltage Perovskite Solar Cells
- 27 November 2019
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 3 (1) , 431-439
Efficient Area Matched Converter Aided Solar Charging of Lithium Ion Batteries Using High Voltage Perovskite Solar Cells
- 6 December 2018
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 4 (1) , 110-117
Open-Circuit Voltages Exceeding 1.26 V in Planar Methylammonium Lead Iodide Perovskite Solar Cells
- 6 December 2018
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 4 (1) , 110-117
Open-Circuit Voltages Exceeding 1.26 V in Planar Methylammonium Lead Iodide Perovskite Solar Cells
- 9 November 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (48) , 27263-27272
How Contact Layers Control Shunting Losses from Pinholes in Thin-Film Solar Cells
- 9 November 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (48) , 27263-27272
How Contact Layers Control Shunting Losses from Pinholes in Thin-Film Solar Cells
- 3 October 2017
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 5 (44) , 11515-11521
Benzene-like N6rings in a Be2N6monolayer: a stable 2D semiconductor with high carrier mobility
Abundant delocalized six-centre–two-electron (6c–2e) π-bonds are responsible for the planar configuration and high structural stability of a Be2N6monolayer, which satisfies the Hückel rule [4n+ 2] (n= 2).
- 3 October 2017
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 5 (44) , 11515-11521
Benzene-like N6rings in a Be2N6monolayer: a stable 2D semiconductor with high carrier mobility
Abundant delocalized six-centre–two-electron (6c–2e) π-bonds are responsible for the planar configuration and high structural stability of a Be2N6monolayer, which satisfies the Hückel rule [4n+ 2] (n= 2).