PDPartha Das

Partha Das

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Partha Das has a total of 62 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Performance Assessment of Spacer Engineered InGaAs NSFETs: APhysical Insight

    by Divya Singh, Akhilesh Jain, Jyoti Prakash Purohit, Shobhit Srivastava, Shashidhara M., Partha Das, Kirti Inamdar, Abhishek Acharya

    A comprehensive electrical and analog performance is carried out to study the outcome of spacer engineering of the InGaAs channel Nanosheet FETs (NSFETs). The use of high-𝜅 spacers significantly suppresses the leakage current by approximately 70% and enhances the switching ratio (𝐼on∕𝐼off) by approximately ≈ 3 × for high-𝜅 to low-𝜅 of the proposed device. This improvement is primarily credited to the spacer-induced fringing electric field across the source/channel and channel/drain interface region, thereby major improvements in electrostatic control are found. The device parameters for analog performance, including transconductance (𝑔m), output resistance (𝑟o), transconductance generation factor (TGF), and intrinsic gain (𝐴v), show significant improvements for both 10 nm and 5 nm of the proposed device, when the spacer material changes from low-𝜅 to high-𝜅. Whereas the unity-gain bandwidth is found to improve for low-𝜅 spacer material and large spacer length due tothe reduced fringing-field capacitance. From a thermal perspective, the Si3N4 spacer provides a lower peak lattice temperature of 392K under the self-heating effect (SHE), indicating improved thermal stability. These results confirm that spacer layer optimization plays an important role in analog, electrical and thermal performance for low voltage analog applications.

  • Accurate band alignment of sputtered Sc2O3 on GaN for high electron mobility transistor applications

    by Partha Das, Harry Finch, Holly J Edwards, Saeed Almalki, Vinod R Dhanak, Rajat Mahapatra, Ivona Z Mitrovic

    Sc2O3 is a promising gate dielectric for surface passivation in GaN-based devices. However, the interface quality and band alignment of sputtered Sc2O3 on GaN has not been fully explored. In this work, x-ray photoelectron spectroscopy (XPS) and variable angle spectroscopic ellipsometry were performed to extract the discontinuities in the valence and conduction bands of the Sc2O3/GaN system. Sc2O3 films were deposited on GaN using radio frequency sputtering. The valence band offset of Sc2O3/GaN was determined to be 0.76 ± 0.1 eV using Kraut’s method. The Sc2O3 band gap of 6.03 ± 0.25 eV was measured using O 1s energy loss spectroscopy. The electron affinity measurements of GaN and Sc2O3 using XPS secondary electron cut-off spectra provided an additional degree of accuracy to the derived band line-up for the Sc2O3/GaN interface. The band alignment results were compared with literature values of band offsets determined experimentally and theoretically for differently grown Sc2O3 films on GaN.

  • Impact of AlOy Interfacial Layer on Resistive Switching Performance of Flexible HfOₓ/AlOy ReRAMs

    by S. Biswas, A. D. Paul, P. Das, P. Tiwary, H. J. Edwards, V. R. Dhanak, I. Z. Mitrovic, R. Mahapatra

    The Al/HfO x /AlO y /indium tin oxide (ITO)/polyethylene terephthalate (PET) flexible resistive random access memory (ReRAM) device was fabricated at room temperature to study the effect of AlO y interfacial layer on resistive switching (RS). Incorporating the interfacial layer AlO y improves the cycle-to-cycle, cell-to-cell uniformity and switching resistance ratio (>10 3 ). It introduces the oxygen vacancies in HfO x which controls the formation and rupture of filament and plays an important role in improving RS characteristics. The device also maintains the stable switching operation under the flexible condition and at elevated temperature up to 100 °C. The device area and temperature-dependent switching characteristics confirm the Ohmic (hopping) conduction in low-resistance state (LRS) and the space charge-limited conduction (SCLC) in high-resistance state (HRS).


  • Effect of Aluminum Doping on Performance of HfOₓ-Based Flexible Resistive Memory Devices

    by A. D. Paul, S. Biswas, P. Das, H. J. Edwards, V. R. Dhanak, R. Mahapatra

    The Al-doped HfOₓ-based resistive memory devices have been fabricated on indium tin oxide (ITO)-coated polyethylene terephthalate (PET) flexible substrate at room temperature. X-ray photoelectron spectroscopy is used to extract the different doping percentage of Al which allows optimizing the switching performance. It improves the cycle-to-cycle and cell-to-cell uniformity of switching parameters by tuning the oxygen vacancies in HfOₓ layers. The 7.5% Al-doped HfOₓ-based flexible resistive memory device shows excellent switching characteristics such as resistance ratio (>10³) and retention (~10⁴ s). There is no degradation of memory window under the mechanical strain with bending radius ranging from 25 to 5 mm. The temperature-dependent resistive switching characteristics have also been studied. There is sufficient memory window (>10²) till ~10⁴ s at elevated temperature. The I-V curve fitting shows the ohmic (hopping) conduction in low resistance state (LRS) and the trap-controlled space charge limited conduction (SCLC) in high resistance state (HRS), supported by Arrhenius plot.


  • (Invited) Band Line-up of High-k Oxides on GaN

    by Ivona Z. Mitrovic, Partha Das, Leanne Jones, James Gibbon, Vinod R. Dhanak, Rajat Mahapatra, Teresa Partida Manzanera, Joseph W. Roberts, Richard J Potter, Paul R. Chalker, et al.

    We present comprehensive experimental work on TixAl1-xOy (with x = 9%, 16%, 25%, 36%, 100%) and GaxAl1-xOy (x = 5%, 20%, 80% and 95%) fabricated using atomic layer deposition with the aim of achieving favorable band alignment with GaN for device applications. The permittivity, k, has been found to be enhanced from ~10 for 9% Ti to 76 for TiO2, but brings unfavorable band line-up and a small conduction band offset (< 0.1 eV) with GaN for all Ti% studied. On the other hand, GaxAl1-xOy (x = 5%, 20%) films show substantial increase of the band gap from 4.5 eV for Ga2O3 to 5.5 eV for x = 5% Ga and 6.0 eV for x = 20% Ga in mixed oxides and a strong suppression of leakage current in associated metal insulator semiconductor (MIS) capacitors.


  • Band Line-up Investigation of Atomic Layer Deposited TiAlO and GaAlO on GaN

    by Partha Das, Leanne A. H. Jones, James T. Gibbon, Vinod R. Dhanak, Teresa Partida-Manzanera, Joseph W. Roberts, Richard Potter, Paul R. Chalker, Sung-Jin Cho, Iain G. Thayne, et al.

    A comprehensive study of the band alignments of Ti x Al 1−x O y (with x = 9%, 16%, 25%, 36%, 100%) and Ga x Al 1−x O y (x = 5%, 20%, 80% and 95%) fabricated using atomic layer deposition on GaN has been presented using X-ray photoelectron spectroscopy and variable angle spectroscopic ellipsometry. The permittivity, k, has been found to be enhanced from ∼10 for 9% Ti in Ti x Al 1−x O y to 76 for TiO 2 , however TiO 2 brings an unfavorable band alignment and a small conduction band offset (x Al 1−x O y films deposited on GaN. On the other hand, Ga x Al 1−x O y films show a substantial increase of the band gap from 4.5 eV for Ga 2 O 3 to 5.5 eV for x = 20% Ga and 6.0 eV for x = 5% Ga. A strong suppression of leakage current in associated Ga x Al 1−x O y -based metal insulator semiconductor capacitors has also been observed, showing promise for device applications.


  • Band alignments of sputtered dielectrics on GaN

    by S N Supardan, P Das, J D Major, A Hannah, Z H Zaidi, R Mahapatra, K B Lee, R Valizadeh, P A Houston, S Hall, et al.

    The band alignments of sputtered ZrO 2 , Al 2 O 3 and MgO on GaN have been measured experimentally using x-ray photoelectron spectroscopy (XPS). The valence band offsets (±0.2 eV) for ZrO 2 , Al 2 O 3 and MgO on GaN using Kraut’s method and charge-corrected XPS core levels were found to be 0.4 eV, 1.1 eV and 1.2 eV with corresponding conduction band offsets (±0.2 eV) of 1.3 eV, 2.0 eV and 2.8 eV, respectively. The electrical characterization of metal insulator semiconductor (MIS)-capacitors with different gate dielectrics (ZrO 2 , Al 2 O 3 and MgO) has been performed as well. The current density of the MIS-capacitors with gate dielectrics MgO and Al 2 O 3 at a positive bias of 1 V show lower leakage currents of 3.2 × 10 −6 A cm −2 and 5.3 × 10 −6 A cm −2 respectively, whereas, the MIS-capacitors with ZrO 2 gate dielectric have the highest leakage current of 6.2 × 10 −4 A cm −2 at 1 V.


  • Set compliance current induced resistive memory characteristics of W/Hf/HfOx/TiN devices

    by S. Maji, S. Samanta, P. Das, S. Maikap, V. R. Dhanak, I. Z. Mitrovic, R. Mahapatra

    In this paper, the authors have investigated the effect of current compliance during the set process on the resistive memory characteristics and switching mechanism of W/Hf/HfOx/TiN devices. The presence of an Hf thin cap layer enables the stable and uniform bipolar resistive switching behavior. Compliance current can modify the barrier height at the oxide-electrode interface by increasing or reducing the oxygen vacancies and induce different switching mechanisms. Low compliance current (50 μA) based switching confirms the Schottky conduction mechanism due to the interfacial effects, while high compliance current (500 μA) involves the ohmic conduction mechanism, signifying the formation of a conductive filament. No significant dispersion of reset current and reset voltage has been found for each set compliance current varying from 50 to 500 μA, indicating uniform performance of the devices. The devices also exhibited a read endurance up to 2000 cycles.


  • Experimental band alignment of Ta2O5/GaN for MIS-HEMT applications

    by K. Sawangsri, P. Das, S.N. Supardan, I.Z. Mitrovic, S. Hall, R. Mahapatra, A.K. Chakraborty, R. Treharne, J. Gibbon, V.R. Dhanak, et al.