Bohan Yang
Bohan Yang has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Xingzhong Weng
Professor, Department of Airfield and Building Engineering, Air Force Engineering University, Xi'an, Shaanxi, P. R. China
4 shared publicationsJunzhong Liu
Lecturer, Department of Airfield and Building Engineering, Air Force Engineering University, Xi'an, Shaanxi, P. R. China
3 shared publications- Jun Zhang
Aviation Engineering School, Air Force Engineering University, Xi’an 710038, China
2 shared publications Le Jiang
Engineer, PLA Unit 93055, Shenyang, Liaoning, P. R. China
2 shared publicationsBo Qu
PhD candidate, Department of Airfield and Building Engineering, Air Force Engineering University, Xi'an, Shaanxi, P. R. China
1 shared publication- Giancarlo Luis Gomez Gonzáles
Department of Mechanical and Mining Engineering, University of Jaén, 23071 Jaén, Spain
1 shared publication
Latest Publications
- 1 May 2019
- Published by Emerald Publishing in Advances in Cement Research
- Vol. 31 (5) , 214-224
Durability of airport concrete pavement improved by four novel coatings
In order to repair surface damage to airport pavements quickly and efficiently, surface-strengthening materials are applied to the surface of the concrete to improve its durability. In the current study, several materials, namely concrete protectant, polyurea, epoxy resin and silane, were applied to concrete samples in various amounts. One-sided freeze–thaw cycle experiments, wear tests and flame ablation tests, along with scanning electron microscopy to observe morphologies, were carried out on these four coatings and the uncoated samples to determine the best material for strengthening runway concrete. Results showed that polyurea had excellent wear resistance and poor flame ablation resistance. The epoxy resin had good resistance to freeze–thaw cycles and flame ablation, but had poor wear resistance. The protective layer of silane reduced the loss by freeze–thaw by 66% compared with non-coated samples, the relative dynamic elastic modulus increased by 64·8% and the unit area wear quality decreased by 41%, and there was no obvious damage to the samples after flame ablation. Silane is the most suitable material for surface improvement of the airport concrete pavement, with an optimum dosage of 4 m2/kg.
- 1 May 2019
- Published by Emerald Publishing in Advances in Cement Research
- Vol. 31 (5) , 214-224
Durability of airport concrete pavement improved by four novel coatings
In order to repair surface damage to airport pavements quickly and efficiently, surface-strengthening materials are applied to the surface of the concrete to improve its durability. In the current study, several materials, namely concrete protectant, polyurea, epoxy resin and silane, were applied to concrete samples in various amounts. One-sided freeze–thaw cycle experiments, wear tests and flame ablation tests, along with scanning electron microscopy to observe morphologies, were carried out on these four coatings and the uncoated samples to determine the best material for strengthening runway concrete. Results showed that polyurea had excellent wear resistance and poor flame ablation resistance. The epoxy resin had good resistance to freeze–thaw cycles and flame ablation, but had poor wear resistance. The protective layer of silane reduced the loss by freeze–thaw by 66% compared with non-coated samples, the relative dynamic elastic modulus increased by 64·8% and the unit area wear quality decreased by 41%, and there was no obvious damage to the samples after flame ablation. Silane is the most suitable material for surface improvement of the airport concrete pavement, with an optimum dosage of 4 m2/kg.
- 1 August 2018
- Published by Wiley in Structural Concrete
- Vol. 19 (6) , 2029-2039
Bending mechanical properties research on prestressed airport concrete pavements
To prevent airport pavements from suffering fatigue failure before the end of designed life and to construct high‐grade airport concrete pavements quickly, this study has developed a method which applies the prestressed concrete to airport pavements. A three‐point bending loading scheme has been designed to conduct the bending, flexural strength, and fatigue tests on 96 concrete beams. The results showed that, compared with ordinary concrete beams, the resistance of prestressed concrete beam to bending deformation was greatly enhanced. For the beams subjected to the vertical load with increasing prestressing force, however, the deflection of the beams was decreased by a minor degree while both of their tensile stress and tensile stress area showed a sharp decrease. Moreover, the flexural strength of the concrete showed an evident increased with verified degrees while both the numbers and the width of cracks generated at the bottom of specimens decreased significantly. The average fatigue life of the prestressed concrete beams was extended 3 to 6 times longer than that of the ordinary concrete beams depending on the increasing levels of prestressing force. In general, the bending fatigue life of the prestressed concrete beams follows the two‐parameter Weibull distribution with a correlation coefficient greater than 0.96. Based on this Weibull distribution, a double‐logarithmic fatigue equation among three parameters, that is, the survival rate P, the stress level S, and the fatigue life N has been developed.
- 1 August 2018
- Published by Wiley in Structural Concrete
- Vol. 19 (6) , 2029-2039
Bending mechanical properties research on prestressed airport concrete pavements
To prevent airport pavements from suffering fatigue failure before the end of designed life and to construct high‐grade airport concrete pavements quickly, this study has developed a method which applies the prestressed concrete to airport pavements. A three‐point bending loading scheme has been designed to conduct the bending, flexural strength, and fatigue tests on 96 concrete beams. The results showed that, compared with ordinary concrete beams, the resistance of prestressed concrete beam to bending deformation was greatly enhanced. For the beams subjected to the vertical load with increasing prestressing force, however, the deflection of the beams was decreased by a minor degree while both of their tensile stress and tensile stress area showed a sharp decrease. Moreover, the flexural strength of the concrete showed an evident increased with verified degrees while both the numbers and the width of cracks generated at the bottom of specimens decreased significantly. The average fatigue life of the prestressed concrete beams was extended 3 to 6 times longer than that of the ordinary concrete beams depending on the increasing levels of prestressing force. In general, the bending fatigue life of the prestressed concrete beams follows the two‐parameter Weibull distribution with a correlation coefficient greater than 0.96. Based on this Weibull distribution, a double‐logarithmic fatigue equation among three parameters, that is, the survival rate P, the stress level S, and the fatigue life N has been developed.
- 1 August 2017
- Published by Elsevier in Construction and Building Materials
- Vol. 145, 528-537
Bonding characteristics of grouting layer in Prefabricated Cement Concrete Pavement
- 1 August 2017
- Published by Elsevier in Construction and Building Materials
- Vol. 145, 528-537
Bonding characteristics of grouting layer in Prefabricated Cement Concrete Pavement
- 1 July 2016
- Published by Elsevier in Construction and Building Materials
- Vol. 115, 214-220
Influence of low temperature on dynamic behavior of concrete
- 1 July 2016
- Published by Elsevier in Construction and Building Materials
- Vol. 115, 214-220
Influence of low temperature on dynamic behavior of concrete
- Open Access
- 28 February 2016
- Published by David Publishing Company in Journal of Mechanics Engineering and Automation
- Vol. 6 (2)
Determination of a U-Notch Stress Concentration Factor Using Thermoelasticity
- 28 February 2016
- Published by David Publishing Company in Journal of Mechanics Engineering and Automation
- Vol. 6 (2)
Open AccessDetermination of a U-Notch Stress Concentration Factor Using Thermoelasticity
- 1 November 2015
- Published by Elsevier in Construction and Building Materials
- Vol. 98, 171-175
The influence on the durability of semi-flexible airport pavement materials to cyclic wheel load test
- 1 November 2015
- Published by Elsevier in Construction and Building Materials
- Vol. 98, 171-175
The influence on the durability of semi-flexible airport pavement materials to cyclic wheel load test