Tommy Yiu Lo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tommy Yiu Lo has a total of 77 co-authors. Here are the top co-authors by number of shared publications:
- Shazim Ali Memon
Department of Civil and Environmental Engineering, School of Engineering and Digital Sciences, Nazarbayev University, Astana 010000, Republic of Kazakhstan
22 shared publications H.Z. Cui
11 shared publications- Waiching Tang
School of Architecture and Built Environment, The University of Newcastle, University Drive, Callaghan, NSW 2308, Australia
8 shared publications Hongzhi Cui
Shenzhen Univ, Coll Civil Engn, Guangdong Prov Key Lab Durabil Marine Civil Engn, Shenzhen 518060, Peoples R China
7 shared publications- Abid Nadeem
Nazarbayev University
6 shared publications Weiting Xu
Shenzhen Univ, Guangdong Prov Key Lab Durabil Marine Civil Engn, Coll Civil Engn, Shenzhen, Peoples R China
6 shared publications
Latest Publications
- 1 October 2020
- Published by Elsevier in Construction and Building Materials
- Vol. 257
Study of optimizing graphene oxide dispersion and properties of the resulting cement mortars
- 1 October 2020
- Published by Elsevier in Construction and Building Materials
- Vol. 257
Study of optimizing graphene oxide dispersion and properties of the resulting cement mortars
- Open Access
Thermal and Mechanical Properties of Expanded Graphite/Paraffin Gypsum-Based Composite Material Reinforced by Carbon Fiber
Phase change material (PCM) is a kind of thermal energy storage material. Solid-liquid PCM composite materials must overcome the issues of material leakage and low thermal conductivity before they are suitable for widespread use in the fields of building and industry. In this study, porous expanded graphite (EG) is used as a carrier, which absorbs the PCM to fabricate EG/paraffin composites (EG/P) containing 90.6% paraffin, and a latent heat of up to 105.3 J/g was measured. Because gypsum board is widely used in buildings, therefore, EG/P composites are suitable to be integrated into gypsum to develop expanded graphite/paraffin gypsum-based composite material (EGPG) for thermal energy storage. In order to optimize the performance of EGPG, carbon fiber (CF) is used to reinforce their thermal and mechanical properties. The test results show that when 1 wt % CF is incorporated into the EGPG, the thermal conductivity increased 36.0%, and thus EGPG shows superior thermal control through the significantly increased efficiency of heat transfer. After 1 wt % CF was added, the flexural and compressive strength of EGPG were increased by 65.6% and 6.4%, respectively. The improved thermal and mechanical performance of EGPG modified by CF demonstrates that it is a structural-functional integrated building material suitable for building envelope system.
Open AccessThermal and Mechanical Properties of Expanded Graphite/Paraffin Gypsum-Based Composite Material Reinforced by Carbon Fiber
Phase change material (PCM) is a kind of thermal energy storage material. Solid-liquid PCM composite materials must overcome the issues of material leakage and low thermal conductivity before they are suitable for widespread use in the fields of building and industry. In this study, porous expanded graphite (EG) is used as a carrier, which absorbs the PCM to fabricate EG/paraffin composites (EG/P) containing 90.6% paraffin, and a latent heat of up to 105.3 J/g was measured. Because gypsum board is widely used in buildings, therefore, EG/P composites are suitable to be integrated into gypsum to develop expanded graphite/paraffin gypsum-based composite material (EGPG) for thermal energy storage. In order to optimize the performance of EGPG, carbon fiber (CF) is used to reinforce their thermal and mechanical properties. The test results show that when 1 wt % CF is incorporated into the EGPG, the thermal conductivity increased 36.0%, and thus EGPG shows superior thermal control through the significantly increased efficiency of heat transfer. After 1 wt % CF was added, the flexural and compressive strength of EGPG were increased by 65.6% and 6.4%, respectively. The improved thermal and mechanical performance of EGPG modified by CF demonstrates that it is a structural-functional integrated building material suitable for building envelope system.
- 1 August 2018
- Published by Elsevier in Construction and Building Materials
- Vol. 181, 713-720
Effect of carbon fibers grafted with carbon nanotubes on mechanical properties of cement-based composites
- 1 August 2018
- Published by Elsevier in Construction and Building Materials
- Vol. 181, 713-720
Effect of carbon fibers grafted with carbon nanotubes on mechanical properties of cement-based composites
- 1 September 2016
- Published by Elsevier in Construction and Building Materials
- Vol. 120, 1-9
Carbonation of concrete made with dredged marine sand and its effect on chloride binding
- 1 September 2016
- Published by Elsevier in Construction and Building Materials
- Vol. 120, 1-9
Carbonation of concrete made with dredged marine sand and its effect on chloride binding
- 1 August 2016
- Published by Elsevier in Applied Energy
- Vol. 175, 324-336
Energy and economic analysis of building integrated with PCM in different cities of China
- 1 August 2016
- Published by Elsevier in Applied Energy
- Vol. 175, 324-336
Energy and economic analysis of building integrated with PCM in different cities of China
- 12 April 2016
- Published by SPIE-Intl Soc Optical Eng
- p. 980415-980415-6
Preparation and characterization of phase change material for thermal energy storage in buildings
- 12 April 2016
- Published by SPIE-Intl Soc Optical Eng
- p. 980415-980415-6
Preparation and characterization of phase change material for thermal energy storage in buildings
- Open Access
Pozzolanic Reactivity of Silica Fume and Ground Rice Husk Ash as Reactive Silica in a Cementitious System: A Comparative Study
This study comparably assessed the pozzolanic effect of silica fume (SF) and ground rice husk ash (RHA) as supplementary cementing materials on the properties of blended cement pastes and concretes. A commonly commercial silica fume (SF) and locally-produced rice husk ash (RHA) samples with two finenesses (one with larger size than cement and the other with smaller size than cement) were used in this study. Material properties of SF and RHA were experimentally characterized. Hydration and mechanical properties of cement pastes incorporating SF and RHA were determined by thermogravimetric analysis (TGA) and compressive strength tests, respectively. Properties of concretes regarding workability, mechanical property, durability, and microstructure were evaluated. Results showed that, although the finely ground RHA used in this study possessed lower SiO2 content and higher particle size compared to SF, it exhibited comparable pozzolanic reactivity with SF due to the nano-scale pores on its each single particle, leading to a higher specific surface area. The optimal replacement levels of SF and RHA were 10% by weight of cement in pastes and concretes. Although addition of SF and RHA led to a significant reduction in slump for the fresh mixtures, inclusion of up to 30% of SF or 15% of ground RHA did not adversely affect the strength of concretes. At the same mix, incorporation of finely-ground RHA in cement composites provided comparable mechanical properties, hydration degree, and durability with SF blended cement composites, owing to the porous structure and high specific surface area of RHA particles. Microstructure morphology analysis of concretes explored by scanning electron microscopy (SEM) further validated the strength and the durability test results.
Open AccessPozzolanic Reactivity of Silica Fume and Ground Rice Husk Ash as Reactive Silica in a Cementitious System: A Comparative Study
This study comparably assessed the pozzolanic effect of silica fume (SF) and ground rice husk ash (RHA) as supplementary cementing materials on the properties of blended cement pastes and concretes. A commonly commercial silica fume (SF) and locally-produced rice husk ash (RHA) samples with two finenesses (one with larger size than cement and the other with smaller size than cement) were used in this study. Material properties of SF and RHA were experimentally characterized. Hydration and mechanical properties of cement pastes incorporating SF and RHA were determined by thermogravimetric analysis (TGA) and compressive strength tests, respectively. Properties of concretes regarding workability, mechanical property, durability, and microstructure were evaluated. Results showed that, although the finely ground RHA used in this study possessed lower SiO2 content and higher particle size compared to SF, it exhibited comparable pozzolanic reactivity with SF due to the nano-scale pores on its each single particle, leading to a higher specific surface area. The optimal replacement levels of SF and RHA were 10% by weight of cement in pastes and concretes. Although addition of SF and RHA led to a significant reduction in slump for the fresh mixtures, inclusion of up to 30% of SF or 15% of ground RHA did not adversely affect the strength of concretes. At the same mix, incorporation of finely-ground RHA in cement composites provided comparable mechanical properties, hydration degree, and durability with SF blended cement composites, owing to the porous structure and high specific surface area of RHA particles. Microstructure morphology analysis of concretes explored by scanning electron microscopy (SEM) further validated the strength and the durability test results.
- 1 March 2016
- Published by Elsevier in Construction and Building Materials
- Vol. 107, 299-306
Evaluation of carbonation resistance of paint coated concrete for buildings
- 1 March 2016
- Published by Elsevier in Construction and Building Materials
- Vol. 107, 299-306
Evaluation of carbonation resistance of paint coated concrete for buildings
- Open Access
- 1 January 2016
- Published by Elsevier in Journal of Cleaner Production
- Vol. 112, 753-762
Manufacturing of sintered lightweight aggregate using high-carbon fly ash and its effect on the mechanical properties and microstructure of concrete
- 1 January 2016
- Published by Elsevier in Journal of Cleaner Production
- Vol. 112, 753-762
Open AccessManufacturing of sintered lightweight aggregate using high-carbon fly ash and its effect on the mechanical properties and microstructure of concrete
- 1 October 2015
- Published by Elsevier in Energy and Buildings
- Vol. 105, 273-284
Study on functional and mechanical properties of cement mortar with graphite-modified microencapsulated phase-change materials
- 1 October 2015
- Published by Elsevier in Energy and Buildings
- Vol. 105, 273-284
Study on functional and mechanical properties of cement mortar with graphite-modified microencapsulated phase-change materials