Isabel Antunes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Isabel Antunes has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
- Duncan Paul Fagg
TEMA – Centre for Mechanical Technology and Automation, Department of Mechanical Engineering, University of Aveiro, 3810-193 Aveiro, Portugal
14 shared publications - Jorge Ribeiro Frade
Department of Materials and Ceramic Engineering, CICECO—Aveiro Institute of Materials, University of Aveiro, 3810-193 Aveiro, Portugal
11 shared publications - Glenn Christopher Mather
Instituto de Cerámica y Vidrio (CSIC) C/Kelsen 5 Campus De Cantoblanco Madrid Spain
6 shared publications - D. Pukazhselvan
Deenbandhu Chhotu Ram University of Science and Technology
3 shared publications - J. A. Pérez
University of Aveiro
3 shared publications - Narendar Nasani
Nanotechnology Research Division
3 shared publications
Latest Publications
- Open Access
Thermodynamic Guidelines for the Mechanosynthesis or Solid-State Synthesis of MnFe2O4 at Relatively Low Temperatures
Herein, thermodynamic assessment is proposed to screen suitable precursors for the solid-state synthesis of manganese ferrite, by mechanosynthesis at room temperature or by subsequent calcination at relatively low temperatures, and the main findings are validated by experimental results for the representative precursor mixtures MnO + FeO3, MnO2 + Fe2O3, and MnO2 +2FeCO3. Thermodynamic guidelines are provided for the synthesis of manganese ferrite from (i) oxide and/or metallic precursors; (ii) carbonate + carbonate or carbonate + oxide powder mixtures; (iii) other precursors. It is also shown that synthesis from metallic precursors (Mn + 2Fe) requires a controlled oxygen supply in limited redox conditions, which is hardly achieved by reducing gases H2/H2O or CO/CO2. Oxide mixtures with an overall oxygen balance, such as MnO + Fe2O3, act as self-redox buffers and offer prospects for mechanosynthesis for a sufficient time (>9 h) at room temperature. On the contrary, the fully oxidised oxide mixture MnO2 + Fe2O3 requires partial reduction, which prevents synthesis at room temperature and requires subsequent calcination at temperatures above 1100 °C in air or in nominally inert atmospheres above 750 °C. Oxide + carbonate mixtures, such as MnO2 +2FeCO3, also yield suitable oxygen balance by the decomposition of the carbonate precursor and offer prospects for mechanosynthesis at room temperature, and residual fractions of reactants could be converted by firing at relatively low temperatures (≥650 °C).
Open AccessThermodynamic Guidelines for the Mechanosynthesis or Solid-State Synthesis of MnFe2O4 at Relatively Low Temperatures
Herein, thermodynamic assessment is proposed to screen suitable precursors for the solid-state synthesis of manganese ferrite, by mechanosynthesis at room temperature or by subsequent calcination at relatively low temperatures, and the main findings are validated by experimental results for the representative precursor mixtures MnO + FeO3, MnO2 + Fe2O3, and MnO2 +2FeCO3. Thermodynamic guidelines are provided for the synthesis of manganese ferrite from (i) oxide and/or metallic precursors; (ii) carbonate + carbonate or carbonate + oxide powder mixtures; (iii) other precursors. It is also shown that synthesis from metallic precursors (Mn + 2Fe) requires a controlled oxygen supply in limited redox conditions, which is hardly achieved by reducing gases H2/H2O or CO/CO2. Oxide mixtures with an overall oxygen balance, such as MnO + Fe2O3, act as self-redox buffers and offer prospects for mechanosynthesis for a sufficient time (>9 h) at room temperature. On the contrary, the fully oxidised oxide mixture MnO2 + Fe2O3 requires partial reduction, which prevents synthesis at room temperature and requires subsequent calcination at temperatures above 1100 °C in air or in nominally inert atmospheres above 750 °C. Oxide + carbonate mixtures, such as MnO2 +2FeCO3, also yield suitable oxygen balance by the decomposition of the carbonate precursor and offer prospects for mechanosynthesis at room temperature, and residual fractions of reactants could be converted by firing at relatively low temperatures (≥650 °C).
- Open Access
Ca2Fe2O5-Based WGS Catalysts to Enhance the H2 Yield of Producer Gases
Ca2Fe2O5-based catalysts were synthesized from siderite and calcite precursors, which were processed in the form of pelletized samples and tested as water gas shift catalysts. Catalytic tests were performed in a tubular reactor, at temperatures in the range 400–500 °C and with different H2O:CO ratios, diluted with N2; this demonstrates the positive impact of Ca2Fe2O5 on conversion of CO and H2 yield, relative to corresponding tests without catalyst. The catalytic performance was also remarkably boosted in a microwave-heated reactor, relative to conventional electric heating. Post-mortem analysis of spent catalysts showed significant XRD reflections of spinel phases (Fe3O4 and CaFe2O4), and SiO2 from the siderite precursor. Traces of calcium carbonate were also identified, and FTIR analysis revealed relevant bands ascribed to calcium carbonate and adsorbed CO2. Thermodynamic modelling was performed to assess the redox tolerance of Ca2Fe2O5-based catalysts in conditions expected for gasification of biomass and thermochemical conditions at somewhat lower temperatures (≤500 °C), as a guideline for suitable conditions for water gas shift. This modelling, combined with the results of catalytic tests and post-mortem analysis of spent catalysts, indicated that the O2 and CO2 storage ability of Ca2Fe2O5 contributes to its catalytic activity, suggesting prospects to enhance the H2 content of producer gases by water gas shift.
Open AccessCa2Fe2O5-Based WGS Catalysts to Enhance the H2 Yield of Producer Gases
Ca2Fe2O5-based catalysts were synthesized from siderite and calcite precursors, which were processed in the form of pelletized samples and tested as water gas shift catalysts. Catalytic tests were performed in a tubular reactor, at temperatures in the range 400–500 °C and with different H2O:CO ratios, diluted with N2; this demonstrates the positive impact of Ca2Fe2O5 on conversion of CO and H2 yield, relative to corresponding tests without catalyst. The catalytic performance was also remarkably boosted in a microwave-heated reactor, relative to conventional electric heating. Post-mortem analysis of spent catalysts showed significant XRD reflections of spinel phases (Fe3O4 and CaFe2O4), and SiO2 from the siderite precursor. Traces of calcium carbonate were also identified, and FTIR analysis revealed relevant bands ascribed to calcium carbonate and adsorbed CO2. Thermodynamic modelling was performed to assess the redox tolerance of Ca2Fe2O5-based catalysts in conditions expected for gasification of biomass and thermochemical conditions at somewhat lower temperatures (≤500 °C), as a guideline for suitable conditions for water gas shift. This modelling, combined with the results of catalytic tests and post-mortem analysis of spent catalysts, indicated that the O2 and CO2 storage ability of Ca2Fe2O5 contributes to its catalytic activity, suggesting prospects to enhance the H2 content of producer gases by water gas shift.
- 11 March 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (11) , 19495-19504
MnFe2O4-based spinels by mechanochemical and thermochemical reaction of siderite and MnO2 powder mixtures
- 11 March 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (11) , 19495-19504
MnFe2O4-based spinels by mechanochemical and thermochemical reaction of siderite and MnO2 powder mixtures
- 1 July 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (52) , 26466-26477
Effect of the addition mechanism of ZnO sintering aid on densification, microstructure and electrical properties of Ba(Zr,Y)O3-δ proton-conducting perovskite
- 1 July 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (52) , 26466-26477
Effect of the addition mechanism of ZnO sintering aid on densification, microstructure and electrical properties of Ba(Zr,Y)O3-δ proton-conducting perovskite
- 25 July 2017
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 56 (15) , 9120-9131
Structure and Electrical-Transport Relations in Ba(Zr,Pr)O3−δ Perovskites
- 25 July 2017
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 56 (15) , 9120-9131
Structure and Electrical-Transport Relations in Ba(Zr,Pr)O3−δ Perovskites
- 10 August 2016
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 55 (17) , 8552-8563
Site Redistribution, Partial Frozen-in Defect Chemistry, and Electrical Properties of Ba1–x(Zr,Pr)O3−δ
Changes in nominal composition of the perovskite (ABO3) solid solution Ba1–x(Zr,Pr)O3−δ and adjusted firing conditions at very high temperatures were used to induce structural changes involving site redistribution and frozen-in point defects, as revealed by Raman and photoluminescence spectroscopies. Complementary magnetic measurements allowed quantification of the reduced content of Pr. Weak dependence of oxygen stoichiometry with temperature was obtained by coulometric titration at temperatures below 1000 °C, consistent with a somewhat complex partial frozen-in defect chemistry. Electrical conductivity measurements combined with transport number and Seebeck coefficient measurements showed prevailing electronic transport and also indicated trends expected for partial frozen-in conditions. Nominal Ba deficiency and controlled firing at very high temperatures allows adjustment of structure and partial frozen-in defect chemistry, opening the way to engineer relevant properties for high-temperature electrochemical applications.
- 10 August 2016
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 55 (17) , 8552-8563
Site Redistribution, Partial Frozen-in Defect Chemistry, and Electrical Properties of Ba1–x(Zr,Pr)O3−δ
Changes in nominal composition of the perovskite (ABO3) solid solution Ba1–x(Zr,Pr)O3−δ and adjusted firing conditions at very high temperatures were used to induce structural changes involving site redistribution and frozen-in point defects, as revealed by Raman and photoluminescence spectroscopies. Complementary magnetic measurements allowed quantification of the reduced content of Pr. Weak dependence of oxygen stoichiometry with temperature was obtained by coulometric titration at temperatures below 1000 °C, consistent with a somewhat complex partial frozen-in defect chemistry. Electrical conductivity measurements combined with transport number and Seebeck coefficient measurements showed prevailing electronic transport and also indicated trends expected for partial frozen-in conditions. Nominal Ba deficiency and controlled firing at very high temperatures allows adjustment of structure and partial frozen-in defect chemistry, opening the way to engineer relevant properties for high-temperature electrochemical applications.
- 1 July 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (27) , 11510-11519
A detailed study of hydrostatic press, sintering aids and temperature on the densification behavior of Ba(Zr,Y)O3−d electrolyte
- 1 July 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (27) , 11510-11519
A detailed study of hydrostatic press, sintering aids and temperature on the densification behavior of Ba(Zr,Y)O3−d electrolyte
- 1 January 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (4) , 2677-2688
Formation of Mg–Nb–O rock salt structures in a series of mechanochemically activated MgH2 + nNb2O5 (n = 0.083–1.50) mixtures
- 1 January 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (4) , 2677-2688
Formation of Mg–Nb–O rock salt structures in a series of mechanochemically activated MgH2 + nNb2O5 (n = 0.083–1.50) mixtures
- 1 May 2015
- Published by Elsevier in Electrochimica Acta
- Vol. 165, 443-449
Modeling of electrical conductivity in the proton conductor Ba0.85K0.15ZrO3−δ
- 1 May 2015
- Published by Elsevier in Electrochimica Acta
- Vol. 165, 443-449
Modeling of electrical conductivity in the proton conductor Ba0.85K0.15ZrO3−δ
- 1 February 2015
- Published by Elsevier in Electrochimica Acta
- Vol. 154, 387-396
Electrochemical behaviour of Ni-BZO and Ni-BZY cermet anodes for Protonic Ceramic Fuel Cells (PCFCs) – A comparative study
- 1 February 2015
- Published by Elsevier in Electrochimica Acta
- Vol. 154, 387-396
Electrochemical behaviour of Ni-BZO and Ni-BZY cermet anodes for Protonic Ceramic Fuel Cells (PCFCs) – A comparative study