TMThomas M. Miller

Thomas M. Miller

*This is an algorithmically generated author record based on publicly available information.

Thomas M. Miller has a total of 39 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • The associative ionization of N(2P) + O(3P) revisited

    by Nicholas S. Shuman, Thomas M. Miller, Tucker W. R. Lewis, Albert A. Viggiano, Shaun G. Ard, Michael C. Heaven

    The room temperature rate constant for the reaction of N(2P) + O(3P) has been measured using a flow tube apparatus by monitoring the concentrations of both reactants via absorption spectroscopy and simultaneously monitoring the associative ionization product, NO+, using time-of-flight mass spectrometry. A value of 2.5 ± 1.3 × 10−11 cm3 s−1 is reported along with a lower limit on the product branching fraction for associative ionization (as opposed to quenching) of 0.5 and likely much larger, >0.9.

  • Open Access

    Electron attachment, thermal detachment, and the electron affinity of the SF6 substitute C4F7N (heptafluoroisobutyronitrile) and related compounds

    by Thomas M. Miller, Tucker W. R. Lewis, Albert A. Viggiano, Shaun G. Ard, Nicholas S. Shuman

    Gas phase experiments in a flowing afterglow under thermal conditions were carried out on a common substitute for SF6 in electrical devices, heptafluoroisobutyronitrile (i-C4F7N), yielding the electron attachment efficiency, electron affinity (EA), and providing information on thermal limitations to its usage. Analogous information was obtained for the chain isomer, heptafluorobutyronitrile (n-C4F7N), and the shorter pentafluoropropionitrile (C3F5N), which scavenge electrons poorly. Experiments were carried out between 295 and 1000 K. The measured electron affinities are 1.12 ± 0.06 eV for i-C4F7N and 0.56 ± 0.03 eV for the chain isomer. Calculated EAs are varied: DLPNO-CCSD(T) yields 0.98 eV (i-C4F7N), 0.29 eV (n-C4F7N), and 0.17 eV (C3F5N); G4 1.29, 0.63, and 0.48 eV, respectively. The attachment rate constant to i-C4F7N varies minimally between 295 K (1.55 ± 0.30 × 10−7 cm3 s−1) and 700 K (1.7 ± 0.4 × 10−7 cm3 s−1). At room temperature, the i-C4F7N attachment rate constant is in agreement with previously reported cross sections; however, as temperature increases, the present measurements deviate indicating internal energy of the neutral enhances attachment. At 295 K and between 1 and 2 Torr, attachment is purely associative forming the parent anion. Above 500 K, attachment becomes increasingly dissociative, producing C4F6N− and at higher temperatures CN−, F−, and C3F4N−. At room temperature, the other measured attachment rate constants are 8.5 ± 1.6 × 10−9 cm3 s−1 (n-C4F7N) and <1.6 × 10−10 cm3 s−1 (C3F5N). The experiments are supported by statistical modeling of the attachment process and by quantum chemical calculations. The thermal electron attachment of i-C4F7N is found to be remarkably similar to that of SF6. The predominant factor in the efficient electron attachment for both species is identified as the EAs of ∼1 eV, while compounds with both smaller and larger EAs are expected to show a decrease in attachment efficiency.

  • Dissociative electron attachment and Ar+ reaction with chromium hexacarbonyl, 296–400 K

    by Thomas M. Miller, Virginia G. Rodriguez, Shaun G. Ard, Albert A. Viggiano, Nicholas S. Shuman

    Dissociative electron attachment rate constants have been measured for Cr(CO)6 under thermal conditions, 296–400 K, yielding Cr(CO)5− product. At 296 K, 2.92 ± 0.70 cm3 s−1 was measured and a small decrease with temperature was observed (2.72 ± 0.70 cm3 s−1 at 400 K). We additionally determined the cation products of Ar+ reacting with Cr(CO)6.

  • The associative ionization of N(2P) + O(3P)

    by Nicholas S. Shuman, Thomas M. Miller, Shaun G. Ard, Albert A. Viggiano

    The rate constant of the associative ionization reaction N(2P) + O(3P) → NO+ + e− was measured using a flow tube apparatus. A flowing afterglow source was used to produce an ion/electron plasma containing a mixture of ions, including N2+, N3+, and N4+. Dissociative recombination of these species produced a population of nitrogen atoms, including N(2P). Charged species were rejected from the flow tube using an electrostatic grid, subsequent to which oxygen atoms were introduced, produced either using a discharge of helium and oxygen or via the titration of nitrogen atoms with NO. Only the title reaction can produce the NO+ observed after the introduction of O atoms. The resulting rate constant (8 ± 5 ×10−11 cm3 s−1) is larger than previously reported N(2P) + O disappearance rate constants (∼2 × 10−11 cm3 s−1). The possible errors in this or previous experiments are discussed. It is concluded that the N(2P) + O(3P) reaction proceeds almost entirely by associative ionization, with quenching to the 2D or 4S states as only minor processes.


  • Open Access

    Electron and Ar+ interaction with Mo(CO)6 at thermal energies; energetic limit on removal of 5 ligands from Mo(CO)6+

    by Thomas M. Miller, Tucker W. R. Lewis, Shaun G. Ard, Albert A. Viggiano, Nicholas S. Shuman

    The rate constant for electron attachment to Mo(CO)6 was determined to be ka = 2.4 ± 0.6 × 10−7 cm3 s−1 at 297 K in a flowing-afterglow Langmuir-probe experiment. The sole anion product is Mo(CO)5−. A small decline in ka was observed up to 450 K, and decomposition was apparent at higher temperatures. The charge transfer reaction of Ar+ with Mo(CO)6 is exothermic by 7.59 ± 0.03 eV, which appears to be sufficient to remove the first 5 ligands from Mo(CO)6+.


  • Elementary Reactions Leading to Perfluoroalkyl Substance Degradation in an Ar+/e– Plasma

    by Justin P. Wiens, Thomas M. Miller, Shaun G. Ard, Albert A. Viggiano, Nicholas S. Shuman

    The reactivities of three perfluoroalkyl carboxylic acids (PFCAs) (perfluoropropanoic acid (C2F5COOH, PFPA), perfluorobutanoic acid (C3F7COOH, PFBA), and perfluorooctanoic acid (C7F15COOH, PFOA)) in a thermal, weakly ionized, argon/electron plasma were investigated from 300 to 600 K using a Langmuir probe-flowing afterglow apparatus. The results are supported by density functional theory calculations of the energetics of PFCA, CnF2n+1COOH, from n = 1 to 7. PFPA and PFBA attach electrons at a substantial fraction of the calculated capture rate; PFOA likely attaches electrons with similarly high efficiency, but the low vapor pressure of PFOA resulted in only qualitative results. All three compounds attach electrons dissociatively via HF elimination. The "acidity channel" (i.e., formation of H + CnF2n+1COO-), calculated to be slightly endothermic, is never observed even at higher temperatures where this channel would be energetically allowed. Attachment to perfluorooctanesulfonic acid (n-C8F17SO3H) is rapid, yielding the conjugate base n-C8F17SO3- as proton transfer to the electron is exothermic. At temperatures near 450 K (PFOA), 550 K (PFBA), or 600 K (PFPA), the parent neutrals thermally decompose as evidenced by abrupt changes in rate constants and branching ratios. PFPA and PFBA react with Ar+ close to the calculated capture rate, and PFOA likely does as well. The reaction mechanism starts via charge transfer, which can then lead to a range of product ions. Reactions with Ar+ yield fluorocarbon radicals, clarifying and supporting a previously proposed mechanism of PFCA degradation in an argon plasma.


  • Thermal Electron Attachment to Pyruvic Acid, Thermal Detachment from the Parent Anion, and the Electron Affinity of Pyruvic Acid

    by Thomas M. Miller, Justin P. Wiens, Albert A. Viggiano, Shaun G. Ard, Nicholas S. Shuman

    The kinetics of electron attachment to pyruvic acid (CH3COCOOH) and thermal detachment from the resulting parent anion were measured from 300-515 K using a flowing afterglow─Langmuir probe apparatus. An adiabatic electron affinity (EA) for pyruvic acid was derived, 0.84 ± 0.02 eV. Electron attachment rate constants to pyruvic acid of 2.1 × 10-8 and 1.2 × 10-8 were measured at 300 and 400 K, respectively. Rate constants at higher temperatures are less well-defined due to possible contributions from attachment to zymonic open ketone, an endemic impurity in pyruvic acid. Similarly, unimolecular detachment rates are complicated by secondary proton transfer reaction of the pyruvic acid anion with pyruvic acid to yield an 87 Da anion. The possible contributions from these chemistries are considered, and in all cases the equilibrium constant between attachment and detachment remains well-defined, allowing for determination of the EA.


  • Thermal rate constants for electron attachment to N2O: An example of endothermic attachment

    by Jordan C. Sawyer, Thomas M. Miller, Shaun G. Ard, Brendan C. Sweeny, Albert A. Viggiano, Nicholas S. Shuman

    Rate constants for dissociative electron attachment to N2O yielding O− have been measured as a function of temperature from 400 K to 1000 K. Detailed modeling of kinetics was needed to derive the rate constants at temperatures of 700 K and higher. In the 400 K–600 K range, upper limits are given. The data from 700 K to 1000 K follow the Arrhenius equation behavior described by 2.4 × 10−8 e−0.288 eV/kT cm3 s−1. The activation energy derived from the Arrhenius plot is equal to the endothermicity of the reaction. However, calculations at the CCSD(T)/complete basis set level suggest that the lowest energy crossing between the neutral and anion surfaces lies 0.6 eV above the N2O equilibrium geometry and 0.3 eV above the endothermicity of the dissociative attachment. Kinetic modeling under this assumption is in modest agreement with the experimental data. The data are best explained by attachment occurring below the lowest energy crossing of the neutral and valence anion surfaces via vibrational Feshbach resonances.


  • Open Access

    Toward a quantitative analysis of the temperature dependence of electron attachment to SF6

    by John C. Poutsma, Nicholas S. Shuman, Thomas M. Miller, Jürgen Troe, Albert A. Viggiano

    New flowing afterglow/Langmuir probe investigations of electronic attachment to SF6 are described. Thermal attachment rate constants are found to increase from 1.5 × 10−7 cm3 s−1 at 200 K to 2.3 × 10−7 cm3 s−1 at 300 K. Attachment rate constants over the range of 200–700 K (from the present work and the literature), together with earlier measurements of attachment cross sections, are analyzed with respect to electronic and nuclear contributions. The latter suggest that only a small nuclear barrier (of the order of 20 meV) on the way from SF6 to SF6− has to be overcome. The analysis shows that not only s-waves but also higher partial waves have to be taken into account. Likewise, finite-size effects of the neutral target contribute in a non-negligible manner.


  • Reactions of C+ + Cl−, Br−, and I−—A comparison of theory and experiment

    by Jordan C. Sawyer, Patrik Hedvall, Thomas M. Miller, Kenneth W. Engeling, Åsa Larson, Ann E. Orel, Albert A. Viggiano, Nicholas S. Shuman

    Rate constants for the reactions of C+ + Cl−, Br−, and I− were measured at 300 K using the variable electron and neutral density electron attachment mass spectrometry technique in a flowing afterglow Langmuir probe apparatus. Upper bounds of −8 cm3 s−1 were found for the reaction of C+ with Br− and I−, and a rate constant of 4.2 ± 1.1 × 10−9 cm3 s−1 was measured for the reaction with Cl−. The C+ + Cl− mutual neutralization reaction was studied theoretically from first principles, and a rate constant of 3.9 × 10−10 cm3 s−1, an order of magnitude smaller than experiment, was obtained with spin-orbit interactions included using a semiempirical model. The discrepancy between the measured and calculated rate constants could be explained by the fact that in the experiment, the total loss of C+ ions was measured, while the theoretical treatment did not include the associative ionization channel. The charge transfer was found to take place at small internuclear distances, and the spin-orbit interaction was found to have a minor effect on the rate constant.