Izzati Mohamad Abdul Wahab
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Izzati Mohamad Abdul Wahab has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Mariam Firdhaus Mad Nordin
Department of Chemical and Environmental Engineering, Malaysia-Japan International Institute of Technology, Universiti Teknologi Malaysia, Jalan Sultan Yahya Petra, 54100 Kuala Lumpur, Malaysia
2 shared publications - Ka-Liong Tan
Faculty of Medicine & Health Sciences, Universiti Sains Islam Malaysia (USIM), Persiaran Ilmu, Putra Nilai, 71800, Nilai, Negeri Sembilan, Malaysia.
1 shared publication - Kamyar Shameli
School of Medicine, Institute of Virology, Technical University of Munich, Munich, Germany
1 shared publication - Mardawani Mohamad
Universiti Malaysia Kelantan, Jeli Campus
1 shared publication Mariani Abdul Hamid
Fakulti Kejuruteraan Kimia & Kejuruteraan Sumber Asli, Universiti Teknologi Malaysia, 81310, UTM Johor Bahru, Johor, Malaysia
1 shared publicationMuhamad Ali Muhammad Yuzir
Department of Chemical and Environmental Engineering, Malaysia-Japan International Institute of Technology, Universiti Teknologi Malaysia, Jalan Sultan Yahya Petra, 54100 Kuala Lumpur, Malaysia
1 shared publication
Latest Publications
- Open Access
- 28 March 2025
- Published by Penerbit Universiti Sains Malaysia in Tropical Life Sciences Research
- Vol. 36 (1) , 163-186
Antibacterial Potential and Phytochemical Composition in Subcritical Water Extraction of Lempoyang (Zingiber zerumbet)
Lempoyang, scientifically known as Zingiber zerumbet, is a plant rich in potential medicinal properties due to its numerous active ingredients. The aim of this study was to investigate the phytochemical composition and antibacterial potential of crude extracts of lempoyang obtained by subcritical water extraction (SWE). Fresh rhizomes of lempoyang were extracted using the one-factor-at-a-time (OFAT) approach with different extraction times (5 min, 10 min, 15 min, 20 min and 25 min), while other extraction parameters were kept constant. The resulting crude extracts, characterised by gas chromatography mass spectrometry (GCMS), contained 13 different constituents. Among these, 2,6,10-cycloundecatrien-1-one,2,6,9,9-tetramethyl-,(E,E,E)- or zerumbone consistently had the highest percentage area under the peak across all extraction times, ranging from 17.15% to 28.72% at retention times of 19.215 min to 19.270 min. Qualitative screening of these crude extracts revealed the presence of phenolics, alkaloids, flavonoids, terpenoids, saponins and tannins, indicating the rich phytochemical diversity of lempoyang. However, steroids and anthocyanins have not been detected. In terms of antibacterial activity, disc diffusion using the Kirby-Bauer method showed positive results for the 25-minute crude extract against Escherichia coli, yielding a zone of inhibition of 8.63 ± 0.36 mm at a concentration of 100 mg/mL/disc. None of the extracts were found to have detectable antibacterial activity against Bacillus subtilis, Staphylococcus aureus, Pseudomonas aeruginosa, Salmonella choleraesuis and Serratia marcescens. These results emphasise the potential of SWE for extracting valuable compounds from fresh lempoyang rhizomes. At the same time, they highlight that different extraction times influence the phytochemical profile and antibacterial activity of the crude extracts at higher extract concentrations.
- 28 March 2025
- Published by Penerbit Universiti Sains Malaysia in Tropical Life Sciences Research
- Vol. 36 (1) , 163-186
Open AccessAntibacterial Potential and Phytochemical Composition in Subcritical Water Extraction of Lempoyang (Zingiber zerumbet)
Lempoyang, scientifically known as Zingiber zerumbet, is a plant rich in potential medicinal properties due to its numerous active ingredients. The aim of this study was to investigate the phytochemical composition and antibacterial potential of crude extracts of lempoyang obtained by subcritical water extraction (SWE). Fresh rhizomes of lempoyang were extracted using the one-factor-at-a-time (OFAT) approach with different extraction times (5 min, 10 min, 15 min, 20 min and 25 min), while other extraction parameters were kept constant. The resulting crude extracts, characterised by gas chromatography mass spectrometry (GCMS), contained 13 different constituents. Among these, 2,6,10-cycloundecatrien-1-one,2,6,9,9-tetramethyl-,(E,E,E)- or zerumbone consistently had the highest percentage area under the peak across all extraction times, ranging from 17.15% to 28.72% at retention times of 19.215 min to 19.270 min. Qualitative screening of these crude extracts revealed the presence of phenolics, alkaloids, flavonoids, terpenoids, saponins and tannins, indicating the rich phytochemical diversity of lempoyang. However, steroids and anthocyanins have not been detected. In terms of antibacterial activity, disc diffusion using the Kirby-Bauer method showed positive results for the 25-minute crude extract against Escherichia coli, yielding a zone of inhibition of 8.63 ± 0.36 mm at a concentration of 100 mg/mL/disc. None of the extracts were found to have detectable antibacterial activity against Bacillus subtilis, Staphylococcus aureus, Pseudomonas aeruginosa, Salmonella choleraesuis and Serratia marcescens. These results emphasise the potential of SWE for extracting valuable compounds from fresh lempoyang rhizomes. At the same time, they highlight that different extraction times influence the phytochemical profile and antibacterial activity of the crude extracts at higher extract concentrations.
- 22 February 2021
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 83 (2) , 143-150
EVALUATION OF PARAMETERS FOR SUBCRITICAL WATER EXTRACTION OF ZINGIBER ZERUMBET USING FRACTIONAL FACTORIAL DESIGN
Zingiber zerumbet (Z. zerumbet) is recognized for decades for its usability as spice and condiment in food flavoring as well as having high medicinal properties. Up to date, there are limited literature on evaluation of the effects of multiple variables in details especially in pilot-scale subcritical water extraction (SWE) of Z. zerumbet. The aim for this study is to implement the fractional factorial design with five variables which are temperature (100-170°C), time (10-40 minutes), pressure (10-20 bar), particle size (0.89-3.56 mm) and solvent to solid ratio (20-40 ml/g) in SWE of Z. zerumbet. Analysis of variance for all responses stated that temperature, time, particle size and solvent to solid ratio are significant variables. Temperature is the most significant factor for zerumbone concentration and antioxidant activity with a p-value of <0.0001 and 0.0002, respectively. The solvent to solid ratio was the most significant factor for the yield of extraction with a p-value of 0.0002. Time and particle size were significant towards all responses, however pressure was not significant on zerumbone concentration and yield. Thus, the fractional factorial design could give a broad overview in selecting the significant variables for further optimization in SWE from the findings.
- 22 February 2021
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 83 (2) , 143-150
EVALUATION OF PARAMETERS FOR SUBCRITICAL WATER EXTRACTION OF ZINGIBER ZERUMBET USING FRACTIONAL FACTORIAL DESIGN
Zingiber zerumbet (Z. zerumbet) is recognized for decades for its usability as spice and condiment in food flavoring as well as having high medicinal properties. Up to date, there are limited literature on evaluation of the effects of multiple variables in details especially in pilot-scale subcritical water extraction (SWE) of Z. zerumbet. The aim for this study is to implement the fractional factorial design with five variables which are temperature (100-170°C), time (10-40 minutes), pressure (10-20 bar), particle size (0.89-3.56 mm) and solvent to solid ratio (20-40 ml/g) in SWE of Z. zerumbet. Analysis of variance for all responses stated that temperature, time, particle size and solvent to solid ratio are significant variables. Temperature is the most significant factor for zerumbone concentration and antioxidant activity with a p-value of <0.0001 and 0.0002, respectively. The solvent to solid ratio was the most significant factor for the yield of extraction with a p-value of 0.0002. Time and particle size were significant towards all responses, however pressure was not significant on zerumbone concentration and yield. Thus, the fractional factorial design could give a broad overview in selecting the significant variables for further optimization in SWE from the findings.
- 12 September 2014
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 625, 911-915
Effect of Ultrasonic Pre-Treatment Durations on the Formation of Zeolite-T
In the present work, the lengthy synthesis duration of zeolite-T was successfully reduced by inducing the ultrasonic pre-treatment method prior to hydrothermal growth. The effect of ultrasonic pre-treatment durations on the formation of zeolite-T was investigated. The structure and morphology of the resultant samples were characterized by FTIR, XRD and FESEM. As verified by FTIR, samples produced using synthesis durations of 5, 4, 3 and 2 days with ultrasonic pre-treatment durations of 60 min and 90 min, respectively, demonstrated zeolite-T structure. One day synthesis duration was not sufficient for the formation of zeolite-T. From the results obtained by XRD and FESEM, it was found that samples underwent 60 min ultrasonic pre-treatment produced zeolite-T with higher crystallinity, while no significant changes on the morphology of the resultant zeolite-T synthesized using ultrasonic pre-treatment durations of 60 min and 90 min.
- 12 September 2014
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 625, 911-915
Effect of Ultrasonic Pre-Treatment Durations on the Formation of Zeolite-T
In the present work, the lengthy synthesis duration of zeolite-T was successfully reduced by inducing the ultrasonic pre-treatment method prior to hydrothermal growth. The effect of ultrasonic pre-treatment durations on the formation of zeolite-T was investigated. The structure and morphology of the resultant samples were characterized by FTIR, XRD and FESEM. As verified by FTIR, samples produced using synthesis durations of 5, 4, 3 and 2 days with ultrasonic pre-treatment durations of 60 min and 90 min, respectively, demonstrated zeolite-T structure. One day synthesis duration was not sufficient for the formation of zeolite-T. From the results obtained by XRD and FESEM, it was found that samples underwent 60 min ultrasonic pre-treatment produced zeolite-T with higher crystallinity, while no significant changes on the morphology of the resultant zeolite-T synthesized using ultrasonic pre-treatment durations of 60 min and 90 min.