Robert Thresher
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Robert Thresher has a total of 96 co-authors. Here are the top co-authors by number of shared publications:
- Michael Lawson
National Laboratory of the Rockies, 15013 Denver West Parkway, Golden, CO 80401, USA
4 shared publications A. D. Wright
Solar Energy Research Institute, Wind Energy Research Center, Golden, CO 80401-3393
3 shared publicationsGolden National Renewable Energy Laboratory (Nrel)
3 shared publicationsPaul Veers
Wind Energy Technology Department Sandia National Laboratories Albuquerque, NM 87185
3 shared publications- Ye Li
Southern University of Science and Technology
3 shared publications Ann Dallman
2 shared publications
Latest Publications
- Open Access
- 23 June 2025
- Published by MDPI AG in Clean Technologies
- Vol. 7 (3) , 52
Hybrid Energy-Powered Electrochemical Direct Ocean Capture Model
Offshore synthetic fuel production and marine carbon dioxide removal can be enabled by direct ocean capture, which extracts carbon dioxide from the ocean that then can be used as a feedstock for fuel production or sequestered underground. To maximize carbon capture, plants require a variety of low-carbon energy sources to operate, such as variable renewable energy. However, the impacts of variable power on direct ocean capture have not yet been thoroughly investigated. To facilitate future deployments, a generalizable model for electrodialysis-based direct ocean capture plants is created to evaluate plant performance and electricity costs under intermittent power availability. This open-source Python-based model captures key aspects of the electrochemistry, ocean chemistry, post-processing, and operation scenarios under various conditions. To incorporate realistic energy supply dynamics and cost estimates, the model is coupled with the National Renewable Energy Laboratory’s H2Integrate tool, which simulates hybrid energy system performance profiles and costs. This integrated framework is designed to provide system-level insights while maintaining computational efficiency and flexibility for scenario exploration. Initial evaluations show similar results to those predicted by the industry, and demonstrate how a given plant could function with variable power in different deployment locations, such as with wind energy off the coast of Texas and with wind and wave energy off the coast of Oregon. The results suggest that electrochemical systems with greater tolerances for power variability and low minimum power requirements may offer operational advantages in variable-energy contexts. However, further research is needed to quantify these benefits and evaluate their implications across different deployment scenarios.
- 23 June 2025
- Published by MDPI AG in Clean Technologies
- Vol. 7 (3) , 52
Open AccessHybrid Energy-Powered Electrochemical Direct Ocean Capture Model
Offshore synthetic fuel production and marine carbon dioxide removal can be enabled by direct ocean capture, which extracts carbon dioxide from the ocean that then can be used as a feedstock for fuel production or sequestered underground. To maximize carbon capture, plants require a variety of low-carbon energy sources to operate, such as variable renewable energy. However, the impacts of variable power on direct ocean capture have not yet been thoroughly investigated. To facilitate future deployments, a generalizable model for electrodialysis-based direct ocean capture plants is created to evaluate plant performance and electricity costs under intermittent power availability. This open-source Python-based model captures key aspects of the electrochemistry, ocean chemistry, post-processing, and operation scenarios under various conditions. To incorporate realistic energy supply dynamics and cost estimates, the model is coupled with the National Renewable Energy Laboratory’s H2Integrate tool, which simulates hybrid energy system performance profiles and costs. This integrated framework is designed to provide system-level insights while maintaining computational efficiency and flexibility for scenario exploration. Initial evaluations show similar results to those predicted by the industry, and demonstrate how a given plant could function with variable power in different deployment locations, such as with wind energy off the coast of Texas and with wind and wave energy off the coast of Oregon. The results suggest that electrochemical systems with greater tolerances for power variability and low minimum power requirements may offer operational advantages in variable-energy contexts. However, further research is needed to quantify these benefits and evaluate their implications across different deployment scenarios.
- Open Access
- 28 September 2023
- Published by Office of Scientific and Technical Information (OSTI)
Mission Analysis for Marine Renewable Energy to Provide Power for Marine Carbon Dioxide Removal
The mission of this project was to provide a preliminary feasibility assessment of powering different marine carbon dioxide removal (mCDR), marine carbon capture, and marine carbon sequestration strategies with marine energy. In this report, carbon capture refers to methods that can separate or capture carbon dioxide (CO2) from the air or ocean; carbon sequestration refers to methods that store CO2 obtained by capture methods out of the atmosphere for long periods of time; and carbon dioxide removal (CDR) refers to methods that do both. The project found that mCDR powered by marine energy and offshore wind energy available in the United States could meet global CDR scales needed by 2040 and 2050 to limit warming to 1.5 degrees C by 2100. Note that this preliminary estimate assumes that it is possible to harvest all the marine and offshore wind resources available in the United States with existing technology options, and it does not account for the power needed for monitoring these methods, as these power needs are not yet well defined and require further research. Additionally, these CDR scales will still require emissions reductions.
- 28 September 2023
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessMission Analysis for Marine Renewable Energy to Provide Power for Marine Carbon Dioxide Removal
The mission of this project was to provide a preliminary feasibility assessment of powering different marine carbon dioxide removal (mCDR), marine carbon capture, and marine carbon sequestration strategies with marine energy. In this report, carbon capture refers to methods that can separate or capture carbon dioxide (CO2) from the air or ocean; carbon sequestration refers to methods that store CO2 obtained by capture methods out of the atmosphere for long periods of time; and carbon dioxide removal (CDR) refers to methods that do both. The project found that mCDR powered by marine energy and offshore wind energy available in the United States could meet global CDR scales needed by 2040 and 2050 to limit warming to 1.5 degrees C by 2100. Note that this preliminary estimate assumes that it is possible to harvest all the marine and offshore wind resources available in the United States with existing technology options, and it does not account for the power needed for monitoring these methods, as these power needs are not yet well defined and require further research. Additionally, these CDR scales will still require emissions reductions.
- Open Access
- 31 December 2020
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 15 (12) , e0242485
An investigation into the potential for wind turbines to cause barotrauma in bats
The high rates of bat mortality caused by operating wind turbines is a concern for wind energy and wildlife stakeholders. One theory that explains the mortality is that bats are not only killed by impact trauma, but also by barotrauma that results from exposure to the pressure variations caused by rotating turbine blades. To date, no published research has calculated the pressure changes that bats may be exposed to when flying near wind turbines and then used these data to estimate the likelihood that turbines cause barotrauma in bats. To address this shortcoming, we performed computational fluid dynamics simulations of a wind turbine and analytical calculations of blade-tip vortices to estimate the characteristics of the sudden pressure changes bats may experience when flying near a utility-scale wind turbine. Because there are no data available that characterize the pressure changes that cause barotrauma in bats, we compared our results to changes in pressure levels that cause barotrauma and mortality in other mammals of similar size. This comparison shows that the magnitude of the low-pressures bats experience when flying near wind turbines is approximately 8 times smaller than the pressure that causes mortality in rats, the smallest mammal for which data are available. The magnitude of the high-pressures that bats may experience are approximately 80 times smaller than the exposure level that causes 50% mortality in mice, which have a body mass similar to several bat species that are killed by wind turbines. Further, our results show that for a bat to experience the largest possible magnitude of low- and high-pressures, they must take very specific and improbable flight paths that skim the surface of the blades. Even a small change in the flight path results in the bat being hit by the blade or experiencing a much smaller pressure change. Accordingly, if bats have a physiological response to rapid low- and high-pressure exposure that is similar to other mammals, we conclude that it is unlikely that barotrauma is responsible for a significant number of turbine-related bat fatalities, and that impact trauma is the likely cause of the majority of wind-turbine-related bat fatalities.
- 31 December 2020
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 15 (12) , e0242485
Open AccessAn investigation into the potential for wind turbines to cause barotrauma in bats
The high rates of bat mortality caused by operating wind turbines is a concern for wind energy and wildlife stakeholders. One theory that explains the mortality is that bats are not only killed by impact trauma, but also by barotrauma that results from exposure to the pressure variations caused by rotating turbine blades. To date, no published research has calculated the pressure changes that bats may be exposed to when flying near wind turbines and then used these data to estimate the likelihood that turbines cause barotrauma in bats. To address this shortcoming, we performed computational fluid dynamics simulations of a wind turbine and analytical calculations of blade-tip vortices to estimate the characteristics of the sudden pressure changes bats may experience when flying near a utility-scale wind turbine. Because there are no data available that characterize the pressure changes that cause barotrauma in bats, we compared our results to changes in pressure levels that cause barotrauma and mortality in other mammals of similar size. This comparison shows that the magnitude of the low-pressures bats experience when flying near wind turbines is approximately 8 times smaller than the pressure that causes mortality in rats, the smallest mammal for which data are available. The magnitude of the high-pressures that bats may experience are approximately 80 times smaller than the exposure level that causes 50% mortality in mice, which have a body mass similar to several bat species that are killed by wind turbines. Further, our results show that for a bat to experience the largest possible magnitude of low- and high-pressures, they must take very specific and improbable flight paths that skim the surface of the blades. Even a small change in the flight path results in the bat being hit by the blade or experiencing a much smaller pressure change. Accordingly, if bats have a physiological response to rapid low- and high-pressure exposure that is similar to other mammals, we conclude that it is unlikely that barotrauma is responsible for a significant number of turbine-related bat fatalities, and that impact trauma is the likely cause of the majority of wind-turbine-related bat fatalities.
- 1 December 2018
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 98, 79-91
Evaluation of performance metrics for the Wave Energy Prize converters tested at 1/20th scale
- 1 December 2018
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 98, 79-91
Evaluation of performance metrics for the Wave Energy Prize converters tested at 1/20th scale
- 1 October 2018
- Published by Elsevier in Renewable Energy
- Vol. 126, 987-1002
Added-mass effects on a horizontal-axis tidal turbine using FAST v8
- 1 October 2018
- Published by Elsevier in Renewable Energy
- Vol. 126, 987-1002
Added-mass effects on a horizontal-axis tidal turbine using FAST v8
- 14 May 2018
- Published by Springer Nature in Nature Energy
- Vol. 3 (6) , 453-454
Taking advantage of modern turbines
- 14 May 2018
- Published by Springer Nature in Nature Energy
- Vol. 3 (6) , 453-454
Taking advantage of modern turbines
- 8 March 2018
- Published by Office of Scientific and Technical Information (OSTI)
Methodology to Calculate the ACE and HPQ Metrics Used in the Wave Energy Prize
The U.S. Department of Energy's Wave Energy Prize Competition encouraged the development of innovative deep-water wave energy conversion technologies that at least doubled device performance above the 2014 state of the art. Because levelized cost of energy (LCOE) metrics are challenging to apply equitably to new technologies where significant uncertainty exists in design and operation, the prize technical team developed a reduced metric as proxy for LCOE, which provides an equitable comparison of low technology readiness level wave energy converter (WEC) concepts. The metric is called 'ACE' which is short for the ratio of the average climate capture width to the characteristic capital expenditure. The methodology and application of the ACE metric used to evaluate the performance of the technologies that competed in the Wave Energy Prize are explained in this report.
- 8 March 2018
- Published by Office of Scientific and Technical Information (OSTI)
Methodology to Calculate the ACE and HPQ Metrics Used in the Wave Energy Prize
The U.S. Department of Energy's Wave Energy Prize Competition encouraged the development of innovative deep-water wave energy conversion technologies that at least doubled device performance above the 2014 state of the art. Because levelized cost of energy (LCOE) metrics are challenging to apply equitably to new technologies where significant uncertainty exists in design and operation, the prize technical team developed a reduced metric as proxy for LCOE, which provides an equitable comparison of low technology readiness level wave energy converter (WEC) concepts. The metric is called 'ACE' which is short for the ratio of the average climate capture width to the characteristic capital expenditure. The methodology and application of the ACE metric used to evaluate the performance of the technologies that competed in the Wave Energy Prize are explained in this report.
- 1 October 2016
- Published by Office of Scientific and Technical Information (OSTI)
Marine Hydrokinetic Energy Site Identification and Ranking Methodology Part II: Tidal Energy
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 October 2016
- Published by Office of Scientific and Technical Information (OSTI)
Marine Hydrokinetic Energy Site Identification and Ranking Methodology Part II: Tidal Energy
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 October 2016
- Published by Office of Scientific and Technical Information (OSTI)
Marine Hydrokinetic Energy Site Identification and Ranking Methodology Part I: Wave Energy
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 October 2016
- Published by Office of Scientific and Technical Information (OSTI)
Marine Hydrokinetic Energy Site Identification and Ranking Methodology Part I: Wave Energy
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 January 2015
- Published by Office of Scientific and Technical Information (OSTI)
Reference Model 5 (RM5): Oscillating Surge Wave Energy Converter
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 January 2015
- Published by Office of Scientific and Technical Information (OSTI)
Reference Model 5 (RM5): Oscillating Surge Wave Energy Converter
The U.S. Department of Energy's Office of Scientific and Technical Information