Weimin Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Weimin Li has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Chan Zeng
Dept. Navigation Chip, Beijing Microelectronics Technology Institute, Beijing, China
1 shared publication- Guoqing Xu
Department of Mechanical and Automation Engineering, The Chinese University of Hong Kong, Shatin, Hong Kong
1 shared publication - Hao Zhang
Department of Mechanical Engineering, Carnegie Mellon University, Pittsburgh, PA 15213, USA
1 shared publication - Jianping Guo
School of Electronics and Information Technology, Sun Yat-sen University, Guangzhou, China
1 shared publication - Meilan Zhou
School of Electrical and Electronic Engineering, Harbin University of Science and Technology, Harbin 150080, China
1 shared publication - Qi Cheng
Department of Electrical and Computer Engineering, The University of Texas at Dallas, Richardson, TX, USA
1 shared publication
Latest Publications
- Open Access
- 23 May 2019
- Published by MDPI AG in Electronics
- Vol. 8 (5) , 572
Design and Analysis of Three-Stage Amplifier for Driving pF-to-nF Capacitive Load Based on Local Q-Factor Control and Cascode Miller Compensation Techniques
This paper presents a new frequency compensation approach for three-stage amplifiers driving a pF-to-nF capacitive load. Thanks to the cascode Miller compensation, the non-dominant complex pole frequency is extended effectively, and the physical size of the compensation capacitors is also reduced. A local Q-factor control (LQC) loop is introduced to alter the Q-factor adaptively when loading capacitance CL varies significantly. This LQC loop decides how much damping current should be injected into the corresponding parasitic node to control the Q-factor of the complex-pole pair, which affects the frequency peak at the gain plot and the settling time of the proposed amplifier in the closed-loop step response. Additionally, a left-half-plane (LHP) zero is created to increase the phase margin and a feed-forward transconductance stage is paralleled to improve the slew rate (SR). Simulated in 0.13-µm CMOS technology, the amplifier is verified to handle a 4-pF-to-1.5-nF (375× drivability) capacitive load with at least 0.88-MHz gain-bandwidth (GBW) product and 42.3° phase margin (PM), while consuming 24.0-µW quiescent power at 1.0-V nominal supply voltage.
- 23 May 2019
- Published by MDPI AG in Electronics
- Vol. 8 (5) , 572
Open AccessDesign and Analysis of Three-Stage Amplifier for Driving pF-to-nF Capacitive Load Based on Local Q-Factor Control and Cascode Miller Compensation Techniques
This paper presents a new frequency compensation approach for three-stage amplifiers driving a pF-to-nF capacitive load. Thanks to the cascode Miller compensation, the non-dominant complex pole frequency is extended effectively, and the physical size of the compensation capacitors is also reduced. A local Q-factor control (LQC) loop is introduced to alter the Q-factor adaptively when loading capacitance CL varies significantly. This LQC loop decides how much damping current should be injected into the corresponding parasitic node to control the Q-factor of the complex-pole pair, which affects the frequency peak at the gain plot and the settling time of the proposed amplifier in the closed-loop step response. Additionally, a left-half-plane (LHP) zero is created to increase the phase margin and a feed-forward transconductance stage is paralleled to improve the slew rate (SR). Simulated in 0.13-µm CMOS technology, the amplifier is verified to handle a 4-pF-to-1.5-nF (375× drivability) capacitive load with at least 0.88-MHz gain-bandwidth (GBW) product and 42.3° phase margin (PM), while consuming 24.0-µW quiescent power at 1.0-V nominal supply voltage.
- 1 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 503-507
Application of Extended Kalman Filter for tracking high dynamic GPS signal
This paper introduces the Extended Kalman Filter (EKF) to realize high dynamic tracking of GPS signal. It's compared with the traditional tracking loop with a third-order phase-locked loop (PLL), which is assisted by a second-order frequency-locked loop (FLL) and a second-order delay-locked loop (DLL). It can estimate carrier phase, Doppler shift, rate of change of Doppler shift and code phase in real-time for higher dynamics. The results of simulation show that the new tracking method can not only improve the dynamic acceleration as high as 100g, also improve the tracking accuracy.
- 1 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 503-507
Application of Extended Kalman Filter for tracking high dynamic GPS signal
This paper introduces the Extended Kalman Filter (EKF) to realize high dynamic tracking of GPS signal. It's compared with the traditional tracking loop with a third-order phase-locked loop (PLL), which is assisted by a second-order frequency-locked loop (FLL) and a second-order delay-locked loop (DLL). It can estimate carrier phase, Doppler shift, rate of change of Doppler shift and code phase in real-time for higher dynamics. The results of simulation show that the new tracking method can not only improve the dynamic acceleration as high as 100g, also improve the tracking accuracy.
- 1 June 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 588-591
Fuzzy logic control in regenerative braking system for electric vehicle
In this paper a regenerative braking energy recovery control strategy for electric vehicle (EV) based on fuzzy logic control is proposed. By analyzing the characteristic and the influence factors of the regenerative braking, the sugeno fuzzy logic controller (FLC) is established. Under assurance of braking safety and stability, the strategy distributes regenerative braking force and frictional braking force reasonably during braking, to make use of regenerative braking characteristic of motor as much as possible, so that much more kinetic energy can be converted into electric energy and stored in the battery. Model based on fuzzy logic control was established under the Matlab/Simulink environment and embedded into simulation software ADVISOR. Simulation experiments with different driving cycles were carried out, and the feasibility and effectiveness of fuzzy logic control strategy is tested with the state of charge (SOC) and braking energy recovery.
- 1 June 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 588-591
Fuzzy logic control in regenerative braking system for electric vehicle
In this paper a regenerative braking energy recovery control strategy for electric vehicle (EV) based on fuzzy logic control is proposed. By analyzing the characteristic and the influence factors of the regenerative braking, the sugeno fuzzy logic controller (FLC) is established. Under assurance of braking safety and stability, the strategy distributes regenerative braking force and frictional braking force reasonably during braking, to make use of regenerative braking characteristic of motor as much as possible, so that much more kinetic energy can be converted into electric energy and stored in the battery. Model based on fuzzy logic control was established under the Matlab/Simulink environment and embedded into simulation software ADVISOR. Simulation experiments with different driving cycles were carried out, and the feasibility and effectiveness of fuzzy logic control strategy is tested with the state of charge (SOC) and braking energy recovery.