Katarzyna Bielak
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Katarzyna Bielak has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Beata Sciana
Faculty of Microsystem Electronics and Photonics, Wrocław University of Science and Technology, Janiszewskiego 11/17, 50-372 Wrocław, Poland
15 shared publications - Wojciech Dawidowski
Faculty of Electronics, Photonics and Microsystems Wrocław University of Science and Technology Wrocław Poland
13 shared publications - Mikołaj Badura
Faculty of Microsystem Electronics and Photonics, Wrocław University of Technology, Janiszewskiego 11/17, 50-372 Wrocław, Poland
10 shared publications - Jaroslav Kováč
Institute of Electronics and Photonics, Slovak University of Technology, SK-812 19 Bratislava, Slovakia
7 shared publications Damian Pucicki
Faculty of Microsystem Electronics and Photonics, Wrocław University of Technology, Z. Janiszewskiego 11/17, 50-372, Wrocław, Poland
6 shared publicationsMarek Tłaczała
Wroclaw Univ Sci & Technol, Fac Microsyst Elect & Photon, Janiszewskiego 11-17, PL-50372 Wroclaw, Poland
5 shared publications
Latest Publications
- Open Access
Analysis of Current Transport Mechanism in AP-MOVPE Grown GaAsN p-i-n Solar Cell
Basic knowledge about the factors and mechanisms affecting the performance of solar cells and their identification is essential when thinking of future improvements to the device. Within this paper, we investigated the current transport mechanism in GaAsN p-i-n solar cells grown with atmospheric pressure metal organic vapour phase epitaxy (AP-MOVPE). We examined the electro-optical and structural properties of a GaAsN solar cell epitaxial structure and correlated the results with temperature-dependent current-voltage measurements and deep level transient spectroscopy findings. The analysis of J-V-T measurements carried out in a wide temperature range allows for the determination of the dominant current transport mechanism in a GaAsN-based solar cell device and assign it a nitrogen interstitial defect, the presence of which was confirmed by DLTFS investigation.
Open AccessAnalysis of Current Transport Mechanism in AP-MOVPE Grown GaAsN p-i-n Solar Cell
Basic knowledge about the factors and mechanisms affecting the performance of solar cells and their identification is essential when thinking of future improvements to the device. Within this paper, we investigated the current transport mechanism in GaAsN p-i-n solar cells grown with atmospheric pressure metal organic vapour phase epitaxy (AP-MOVPE). We examined the electro-optical and structural properties of a GaAsN solar cell epitaxial structure and correlated the results with temperature-dependent current-voltage measurements and deep level transient spectroscopy findings. The analysis of J-V-T measurements carried out in a wide temperature range allows for the determination of the dominant current transport mechanism in a GaAsN-based solar cell device and assign it a nitrogen interstitial defect, the presence of which was confirmed by DLTFS investigation.
- 1 January 2020
- Published by Politechnika Wroclawska Oficyna Wydawnicza in Optica Applicata
- Vol. 50 (2) , 289-299
Photoluminescence and Raman spectroscopies as an optical approach of stress determining in MOVPE grown quantum cascade laser structures
In the presented work, an optical approach of stress determining in metalorganic vapor phase epitaxy (MOVPE) grown quantum cascade laser (QCL) structures was reported. In the case of such sophisticated structures containing hundreds of thin layers, it is important to minimize the stress generated in the QCL core. Techniques enabling determination of stress in such thin layers as those described in the article are photoluminescence and Raman spectroscopies. Based on Raman shift or changes in photoluminescence signal, it is possible to analyze stress occurring in the structure.
- 1 January 2020
- Published by Politechnika Wroclawska Oficyna Wydawnicza in Optica Applicata
- Vol. 50 (2) , 289-299
Photoluminescence and Raman spectroscopies as an optical approach of stress determining in MOVPE grown quantum cascade laser structures
In the presented work, an optical approach of stress determining in metalorganic vapor phase epitaxy (MOVPE) grown quantum cascade laser (QCL) structures was reported. In the case of such sophisticated structures containing hundreds of thin layers, it is important to minimize the stress generated in the QCL core. Techniques enabling determination of stress in such thin layers as those described in the article are photoluminescence and Raman spectroscopies. Based on Raman shift or changes in photoluminescence signal, it is possible to analyze stress occurring in the structure.
- 1 January 2020
- Published by Politechnika Wroclawska Oficyna Wydawnicza in Optica Applicata
- Vol. 50 (2) , 251-256
The influence of quantum well and barrier thicknesses on photoluminescence spectra of InGaAs/AlInAs superlattices grown by LP-MOVPE
In the presented work, the influence of the quantum well and barrier thicknesses on optical characteristics of InGaAs/AlInAs superlattices was reported. Six different structures of In0.53Ga0.47As/Al-0.48In0.52As superlattices lattice-matched to InP were grown by low pressure metal organic vapour phase epitaxy (LP-MOVPE). Optical properties of the obtained structures were examined by means of photoluminescence spectroscopy. This technique allows quick, simple and non-destructive measurements of radiative optical transitions in different semiconductor hetero structures. The analysis of recorded photoluminescence spectra revealed the influence of the quantum well and barrier thicknesses on the emission line energy.
- 1 January 2020
- Published by Politechnika Wroclawska Oficyna Wydawnicza in Optica Applicata
- Vol. 50 (2) , 251-256
The influence of quantum well and barrier thicknesses on photoluminescence spectra of InGaAs/AlInAs superlattices grown by LP-MOVPE
In the presented work, the influence of the quantum well and barrier thicknesses on optical characteristics of InGaAs/AlInAs superlattices was reported. Six different structures of In0.53Ga0.47As/Al-0.48In0.52As superlattices lattice-matched to InP were grown by low pressure metal organic vapour phase epitaxy (LP-MOVPE). Optical properties of the obtained structures were examined by means of photoluminescence spectroscopy. This technique allows quick, simple and non-destructive measurements of radiative optical transitions in different semiconductor hetero structures. The analysis of recorded photoluminescence spectra revealed the influence of the quantum well and barrier thicknesses on the emission line energy.
- Open Access
- 10 August 2019
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 30 (17) , 16216-16225
Impact of gallium concentration in the gas phase on composition of InGaAsN alloys grown by AP-MOVPE correlated with their structural and optical properties
- 10 August 2019
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 30 (17) , 16216-16225
Open AccessImpact of gallium concentration in the gas phase on composition of InGaAsN alloys grown by AP-MOVPE correlated with their structural and optical properties
- Open Access
- 1 September 2018
- Published by VSB Technical University of Ostrava, Faculty of Electrical Engineering and Computer Sciences in Advances in Electrical and Electronic Engineering
- Vol. 16 (3) , 374-379
GAINNAS/GAAS QW BASED STRUCTURES TO COMPENSATE PARASITIC EFFECT OF QUANTUM-CONFINED STARK EFFECT IN PHOTODETECTOR APPLICATIONS
The inhomogeneities of multicomponent semiconductor alloys, as well as phase segregation, can be utilized for enhancement of photodetector absorption properties and thus its efficiency. In this paper, the influence of external electric field on the probability of light absorption in the GaInNAs quantum well is discussed. Both phenomenon: indium and nitrogen composition gradient as well as step-like quantum well are applied to design the QW with compensation of the Quantum-Confined Stark Effect (QCSE) Parasitic effect of QCSE results from decrease of the wave functions overlapping in the QWs placed in reverse biased junction, which finally decrease the efficiency of the photodetector.
- 1 September 2018
- Published by VSB Technical University of Ostrava, Faculty of Electrical Engineering and Computer Sciences in Advances in Electrical and Electronic Engineering
- Vol. 16 (3) , 374-379
Open AccessGAINNAS/GAAS QW BASED STRUCTURES TO COMPENSATE PARASITIC EFFECT OF QUANTUM-CONFINED STARK EFFECT IN PHOTODETECTOR APPLICATIONS
The inhomogeneities of multicomponent semiconductor alloys, as well as phase segregation, can be utilized for enhancement of photodetector absorption properties and thus its efficiency. In this paper, the influence of external electric field on the probability of light absorption in the GaInNAs quantum well is discussed. Both phenomenon: indium and nitrogen composition gradient as well as step-like quantum well are applied to design the QW with compensation of the Quantum-Confined Stark Effect (QCSE) Parasitic effect of QCSE results from decrease of the wave functions overlapping in the QWs placed in reverse biased junction, which finally decrease the efficiency of the photodetector.
- 1 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 149-152
DLTFS study of InGaAs/AlInAs heterostructures grown on n-InP:S substrates
In this paper authors are presenting the first results of electrically active defect investigations in the three 5×UD-In 0.53 Ga 0.47 As/Al 0.42 In 0.58 As MQW structures grown on n-InP:S substrates by low pressure metal organic vapour phase epitaxy at same growth conditions but at different growth rates. The defect distribution is different for each sample. As thinner are the quantum well layers as more significant minority carrier responses are measured. Parameters of nine deep energy levels were identified by Deep Level Transient Fourier Spectroscopy method. The three of them T3 (~0.38 eV), T5 (~0.17 eV) and T7 (~0.32 eV) were identified in all investigated structures. We assume that level T1 (~0.19 eV) and T5 (0.17 eV) are with high probability the result of carrier emissions from QWs.
- 1 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 149-152
DLTFS study of InGaAs/AlInAs heterostructures grown on n-InP:S substrates
In this paper authors are presenting the first results of electrically active defect investigations in the three 5×UD-In 0.53 Ga 0.47 As/Al 0.42 In 0.58 As MQW structures grown on n-InP:S substrates by low pressure metal organic vapour phase epitaxy at same growth conditions but at different growth rates. The defect distribution is different for each sample. As thinner are the quantum well layers as more significant minority carrier responses are measured. Parameters of nine deep energy levels were identified by Deep Level Transient Fourier Spectroscopy method. The three of them T3 (~0.38 eV), T5 (~0.17 eV) and T7 (~0.32 eV) were identified in all investigated structures. We assume that level T1 (~0.19 eV) and T5 (0.17 eV) are with high probability the result of carrier emissions from QWs.
- 1 August 2016
- Published by Elsevier in Microelectronic Engineering
- Vol. 161, 13-17
Influence of GaInNAs/GaAs QWs composition profile on the transitions selection rules
- 1 August 2016
- Published by Elsevier in Microelectronic Engineering
- Vol. 161, 13-17
Influence of GaInNAs/GaAs QWs composition profile on the transitions selection rules
- 1 June 2016
- Published by Elsevier in Solid-State Electronics
- Vol. 120, 13-18
The influence of top electrode of InGaAsN/GaAs solar cell on their electrical parameters extracted from illuminated I–V characteristics
- 1 June 2016
- Published by Elsevier in Solid-State Electronics
- Vol. 120, 13-18
The influence of top electrode of InGaAsN/GaAs solar cell on their electrical parameters extracted from illuminated I–V characteristics
- 1 January 2016
- Published by Polish Academy of Sciences Chancellery in Opto-Electronics Review
- Vol. 24 (2)
LP-MOVPE growth and properties of high Si-doped InGaAs contact layer for quantum cascade laser applications
The work presents doping characteristics and properties of high Si−doped InGaAs epilayers lattice−matched to InP grown by low pressure metal−organic vapour phase epitaxy. Silane and disilane were used as dopant sources. The main task of investigations was to obtain heavily doped InGaAs epilayers suitable for usage as plasmon−confinement layers in the construction of mid−infrared InAlAs/InGaAs/InP quantum−cascade lasers (QCLs). It requires the doping concentration of 1×10
- 1 January 2016
- Published by Polish Academy of Sciences Chancellery in Opto-Electronics Review
- Vol. 24 (2)
LP-MOVPE growth and properties of high Si-doped InGaAs contact layer for quantum cascade laser applications
The work presents doping characteristics and properties of high Si−doped InGaAs epilayers lattice−matched to InP grown by low pressure metal−organic vapour phase epitaxy. Silane and disilane were used as dopant sources. The main task of investigations was to obtain heavily doped InGaAs epilayers suitable for usage as plasmon−confinement layers in the construction of mid−infrared InAlAs/InGaAs/InP quantum−cascade lasers (QCLs). It requires the doping concentration of 1×10