ZZZhihao Zhao

Zhihao Zhao

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Zhihao Zhao has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Modified Carrier-Based PWM Strategy for Common Mode Voltage Elimination and Neutral Point Voltage Balance in a Unidirectional Three-Level Converter for AC Motor Drives

    by Hong Cheng, Wei Yuan, Cong Wang, Zhihao Zhao, Junhao Hao

    High-frequency and high-magnitude common mode voltage (CMV) generated by the operation of transformerless multilevel converters is one of the main causes for decreasing the lifespan of ac motors. In this article, the principle of CMV generated by rectifier and inverter stages of a recently proposed transformerless unidirectional three-level converter for ac motor drives is studied, a modified carrier-based pulsewidth modulation strategy for both CMV elimination and neutral point (NP) voltage balance is proposed. The strategy can effectively eliminate the CMV of the system by modifying the pulse voltage generation and replacing the phase of the carrier signal of the two active switches in the three-level power circuit according to the polarity of each phase current. Moreover, by superposing the NP voltage balance control signal onto the reference voltage of those selected active switches (whose switching action has no impact on the CMV) in the rectifier stage, the NP voltage balance control is integrated into the CMV elimination. The merit of this method is that it does not require the complex calculation of phase shift position and has little impact on the multilevel voltages of the rectifier and inverter stages. The experiments verified the effectiveness of the method.


  • Open Access

    SEPIC-Boost-Based Unidirectional PFC Rectifier with Wide Output Voltage Range

    by Hong Cheng, Xin Li, Cong Wang, Zhihao Zhao, Yucheng Shen, Wei Yuan

    A novel unidirectional hybrid PFC rectifier topology based on SEPIC and boost converters is proposed, which is applicable to various industrial applications such as electric vehicle charging stations, variable speed AC drives, and energy storage systems. Compared to other rectifiers, the proposed SEPIC-boost-based rectifier exhibits continuous current on the AC side, lower voltage stress on the active switches, a wider range of DC output voltage, no auxiliary DC-DC converters, and a high step-up static voltage gain operating with low input voltage and a low step-up static gain for the high-input-voltage operation. These traits allow the SEPIC-boost-based rectifier to utilize smaller input-side harmonic filtering inductors and adopt active switches with lower voltage ratings, resulting in reduced conduction losses. Additionally, the proposed rectifier features power factor correction and high boost/buck voltage-gain capabilities, simplifying control for electric vehicle charging and expanding its range of applications. In this paper, the operating principle of the novel topology is presented first, and then the mathematical model of the proposed rectifier is built. Based on this, the comparison between the proposed topology and conventional boost and SEPIC converters is given. Furthermore, the control strategy, including the high-power-factor control and the balancing control to the DC capacitor voltages, is discussed. Finally, to validate the accuracy of the proposed rectifier’s theoretical research, a 500-W SEPIC-boost rectifier system has been constructed in the laboratory, generating a 200/120 Vdc output voltage from a 155 Vpk/50 Hz power source.


  • A Novel DC-Link Capacitor Voltage Balance Control Based on Coordination of Rectifier–Inverter Stage in a Modified Unidirectional Five-Level Converter for AC Motor Drives

    by Hong Cheng, Zhihao Zhao, Cong Wang, Wei Yuan, Junhao Hao

    Aiming at the difficulty of voltage balancing control of four dc-link split capacitors in a recently proposed transformerless unidirectional five-level (5-L) converter for ac motor drives, a novel dc-link capacitor voltage control based on coordination of rectifier-inverter stage is proposed. To facilitate the independent voltage control of four dc-link split capacitors, in the rectifier stage, two additional diodes are added to each single-phase rectifier. Compared with those similar control for the same purpose such as those requiring adding additional bulky storge components, or those by utilizing non-nearest vectors and virtual medium-vectors to achieve PWM control which will cause higher harmonics in the output and larger switching loss, this proposed coordinated control can achieve the dc-link capacitor voltage balancing control under full operating range with simple implementation, reduced calculation and better performance due to the coordination. In this paper, the basic operating principle of the modified 5-L rectifier is comprehensively analyzed, the voltage imbalance mechanism of four dc-link split capacitors and the balancing principle of the proposed coordinated control are discussed in detail. Simulations and a downscaled (2.2kW) prototype experimental results are provided which validate the feasibility and advancement of the proposed topology and the corresponding coordinated control strategy.


  • A Novel Unidirectional Three-Phase Multilevel Rectifier Composed of Star-Connected Three Single-Phase Topology Based on Five-Level Flying Capacitor DC–DC Converter

    by Hong Cheng, Zhihao Zhao, Cong Wang

    A novel unidirectional three-phase multilevel rectifier composed of star-connected three single-phase topology based on five-level flying capacitor dc–dc converter is proposed, which can be widely applied to many industrial applications, especially for the front-end of multilevel converters for ac adjustable motor drives with open-end winding connection. In addition to not requiring transformers (either line frequency or high frequency), compared to other high-voltage rectifiers, this proposed topology features fewer active switches with lower voltage stress, a high-voltage common dc bus, high input power factor, and low input current harmonics. In this article, a comprehensive analysis to the basic operating principles including the topology configuration, the steady-state modeling, and phase-shifted SPWM modulation is presented. A hybrid control strategy is studied, including the input power factor control, the dc-link voltage balancing control, and the flying capacitor voltage balancing control with balanced and unbalanced loads. Finally, the experimental results are presented to validate the feasibility and correctness of the proposed solution.


  • Open Access

    Open-Circuit Fault-Tolerant Design of the Cascaded H-Bridge Rectifier Incorporating Reactive Power Compensation

    by Ting Chen, Hong Cheng, Cong Wang, Wenbo Chen, Zhihao Zhao

    This paper proposes an open-circuit fault-tolerant design for the cascaded H-Bridge rectifier incorporating reactive power compensation. If one or two switching devices of the H-bridge modules are fault, the drive signals of the faulty H-bridge modules will be artificially redistributed into the bridgeless mode (including the boost bridgeless mode, the symmetric boost bridgeless mode, the totem-pole bridgeless mode and the symmetry totem-pole bridgeless mode) and cooperate with the normally operated H-bridge modules. In this case, the faulty cascaded H-bridge rectifier is not only able to achieve active power transmission, but also can still provide part of reactive power compensation when injecting reactive power from the power grid. Nonetheless, the reactive power that it can supply will be limited, due to the unidirectional characteristics of the bridgeless mode for the faulty modules. Therefore, a method for calculating its adjustable power factor angle range is also presented, which provides the basis for the faulty modules switching to the bridgeless mode. Then, a control strategy of the cascaded H-bridge rectifier incorporating reactive power compensation under the faulty condition and normal operation is presented. Finally, an experimental platform with a single-phase cascaded H-bridge rectifier containing three cells is given to verify the proposed theories.


  • Open Access

    Voltage Balancing Control of Cascaded Single-Phase VIENNA Converter Based on One Cycle Control With Unbalanced Loads

    by Cong Wang, Haoyu Hu, Hong Cheng, Zhihao Zhao, Jinqi Liu

    A research study on a type of cascaded single-phase VIENNA converter (CSVC) is presented in this paper. And a type of DC voltage balancing control strategy for each cascaded module of the CSVC based on improved one-cycle control (I-OCC) is proposed, in which voltage balancing signals are added to the conventional OCC (C-OCC) control loop to cause a difference in the modulation signals of each of the cascaded modules, so that the DC voltages of all modules can be quickly balanced under unbalanced loads. At the same time, the average modulation wave maintains a constant value so that the CSVC achieves a unity power factor operation. The operating principle of the I-OCC strategy is discussed in detail, and the corresponding mathematical relationships are derived. In the proposed strategy, the ability to adjust the DC voltages is also analyzed. Finally, the simulation and experiment results are provided to verify the validity and feasibility of this I-OCC-based voltage balancing control strategy. The control strategy proposed by this paper is also applicable to all other cascaded unidirectional rectifiers.


  • Open Access

    Single-Phase Bridgeless Rectifier Based System With Enhanced Capability of Reactive Power Compensation

    by Hong Cheng, Ting Chen, Cong Wang, Zhihao Zhao, Zhi Li, Yuying Guan

    Aiming at enhancing reactive power compensation (RPC) capability of the traditional single-phase bridgeless rectifier, a 2.5kVA circuit topology composed of a single-phase bridgeless rectifier and a third-order tuned LC series branch in parallel connection is proposed. The corresponding control strategy using the third harmonic injection pulse width modulation (THIPWM) technique is also presented, which enables the proposed single-phase bridgeless rectifier to operate under varied power factor with the near-sinusoidal current at the point of common coupling (PCC). The principle of the proposed topology is discussed in detail and reactive power compensation capability of the proposed single-phase bridgeless rectifier under a certain amount of active power to be transmitted to the load is studied. Simulation and experiment results are given to validate the feasibility of the proposed circuit topology and the correctness of the theoretical analysis.


  • Open Access

    A Modified One-Cycle Control for Vienna Rectifiers with Functionality of Input Power Factor Regulation and Input Current Distortion Mitigation

    by Cong Wang, Jinqi Liu, Hong Cheng, Yuan Zhuang, Zhihao Zhao

    In this paper, aiming at incorporating reactive power compensation functionality into the Vienna rectifiers, a modified one-cycle-control (MOCC) strategy is proposed by which the three-phase Vienna rectifier can be regulated in leading, lagging or unity power factors with near-sinusoidal input current waveform. First, a brief review of the working principle of the conventional OCC (COCC) strategy is conducted. Then, the MOCC strategy with the functionality of input current phase-shift control is discussed in detail. To mitigate input current distortion caused by the current phase-shift, a method whereby the signal of one phase current which is flowing in an uncontrollable region is injected into the other two phases’ current command signals is further presented. The constraints to the implementation of the MOCC scheme and the reactive power compensation capacity of the rectifier under MOCC control are analyzed as well. The proposed MOCC strategy is as easy to implement as the COCC strategy. Moreover, the MOCC strategy also preserves all other advantages of the COCC strategy, such as no phase-locked loop, no frame transformation and constant switching frequency. Finally, the theoretical analysis of the proposed MOCC strategy is fully verified by simulation and experimental results from a 1 kV·A three-phase Vienna rectifier prototype.