AHAlireza Homayouni

Alireza Homayouni

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alireza Homayouni has a total of 29 co-authors. Here are the top co-authors by number of shared publications:

  • Ali Nokhodchi

    School of Life Sciences, University of Sussex, Brighton BN1 9QG, UK

    6 shared publications
  • Fatemeh Sadeghi

    Targeted Drug Delivery Research Center, Pharmaceutical Technology Institute, Mashhad University of Medical Sciences, Mashhad, Iran

    6 shared publications
  • Hadi Afrasiabi Garekani

    Department of Pharmaceutics, School of Pharmacy, Mashhad University of Medical Sciences, Mashhad, Iran

    6 shared publications
  • Jaleh Varshosaz

    Department of Pharmaceutics, Faculty of Pharmacy and Novel Drug Delivery System Research Center, Isfahan University of Medical Sciences, Isfahan, Iran

    4 shared publications
  • Azade Taheri

    Department of Pharmaceutics, Faculty of Pharmacy and Novel Drug Delivery Systems Research Center, Isfahan University of Medical Sciences, Postal Code 81746-73461, Iran

    1 shared publication
  • Azade Taheri

    Novel Drug Delivery Systems Research Center, Department of Pharmaceutics, Faculty of Pharmacy, Isfahan University of Medical sciences, Isfahan, Iran

    1 shared publication

Latest Publications

  • Open Access

    Preparation and evaluation of valsartan orodispersible tablets using PVP-K30 and HPMC E3 solid dispersions by the solvent evaporation method

    by Mahsa Zaghian, Alireza Homayouni, Zahra Keshavarz, Ladan Dayani, Zeinab Fakhari, Fatemeh Sadat Osooli

    Background and purpose: Valsartan (Val), administered for hypertension, exhibits poor water solubility, resulting in low oral bioavailability. This study aimed to enhance the dissolution of Val by preparing orodispersible tablets (ODT) using solid dispersion (SD) technology with PVP and HPMC as hydrophilic carriers. Experimental approach: After preparation of the SDs and physical mixtures of Val: PVP and Val: HPMC at various ratios, the physicochemical characteristics of these mixtures were analyzed. Then, the ODTs were prepared using the best SD sample and evaluated through USP tests. Findings/Results: The saturation solubility of Val: PVP 1:1 and 1:2 at pH 6.8 was notably higher than that of pure Val. The SDs exhibited a superior dissolution rate compared to pure Val and its physical mixtures. Increasing the drug/carrier ratio resulted in a decrease in the percentage of drug in SD, with Val: PVP 1:1 SD showing significantly higher drug loading percentage compared to other formulations. All formulations exhibited entrapment efficiencies above 80%. Also, the flow of the SDs was good based on the Hausner ratio. Conclusion and implications: The SDs exhibited more favorable attributes compared to pure Val and its physical mixtures. The research suggests that PVP and HPMC are effective carriers for improving the solubility and dissolution rate of Val. Additionally, mannitol was identified as a beneficial excipient for achieving the desired properties of ODTs. The findings can be applied to other drugs with similar solubility issues, paving the way to improve therapeutic outcomes for patients.

  • Open Access

    The Effects of Berberis integerrima Fruit Extract on Glycemic Control Parameters in Patients with Type 2 Diabetes Mellitus: A Randomized Controlled Clinical Trial

    by Rasool Soltani, Syed Mustafa Ghanadian, Bijan Iraj, Alireza Homayouni, Tanin Shahmiveh Esfahani, Mojtaba Akbari

    Background. Berberis integerrima Bunge fruits have been utilized in traditional medicine to control diabetes mellitus (DM). However, no clinical survey has been done in this regard. This study was conducted to clinically evaluate the effects of fruit extract of this plant in improving glycemic control indices in patients with type 2 DM (T2DM). Methods. In a randomized controlled clinical trial, patients with T2DM who met the inclusion criteria were randomly divided into two groups of drug (Berberis) and control to receive the extract solution 5 ml twice daily (equivalent to 1000 mg of dry extract) with standard treatment (metformin) or only standard treatment, respectively, for 8 weeks. Before and after the intervention, fasting blood sugar (FBS), serum glycosylated hemoglobin (HbA1c), serum insulin, the homeostasis assessment model for insulin resistance (HOMA-IR), body mass index (BMI), and systolic and diastolic blood pressure were determined and compared between the two groups. Results. During the study, 30 and 35 patients in the drug and control groups, respectively, completed the study. Although no significant changes occurred in any parameter within each group, postintervention FBS (117.5 [107–128.8] versus 134 [120–142], ) and HbA1c (7 [6.4–7.7] versus 7.5 [6.8–7.9], ) were significantly lower in the drug group than in the control one. In terms of other parameters, there were no significant differences between the groups. Conclusion. Consumption of B. integerrima Bunge fruit extract at a dosage of 1000 mg daily decreases FBS and HbA1c but does not affect HOMA-IR in patients with type 2 diabetes mellitus.


  • Design, Optimization and Evaluation of Orally Disintegrating Tablet of Meloxicam Using Its Menthol Based Solid Dispersions

    by Hossein Dehghani, Azade Taheri, Alireza Homayouni

    Background: Meloxicam (MLX) is classified as NSAID that is used for the treatment of rheumatoid arthritis and osteoarthritis. Poor water solubility of MLX leads to its slow oral absorption and slow onset. Preparation of solid dispersion (SD) could improve the water solubility of poorly water soluble drugs. It has been demonstrated that orally disintegrating tablets (ODTs) show faster onset of action and could be more appropriate for the treatment of acute pain. Method: The purpose of this study is to improve the solubility of MLX through the preparation of its SD and then decrease the onset of action by preparation of ODTs from prepared SD. MLX SDs were prepared by solvent evaporation method. MLX, polyvinylpyrrolidone k30 (PVP k30), crospovidone and sodium lauryl sulfate (SLS) with different ratios were dispersed in molten menthol as solvent. Menthol was separated by freeze drying. Differential scanning calorimetry (DSC) and X-ray diffraction (XRD) analysis approved amorphous form of MLX in SDs. Result: The optimum SD with highest saturation solubility in water (12.60±1.2 microgram/ml) which consists of MLX, PVP, crospovidone and SLS in a ratio of 1:1:1:0.03 was used for the preparation of MLX ODTs. ODTs were prepared by direct compression method and optimized by 23 factorial design. The effect of the superdisintegrant concentration, mannitol/avicel ratio and the level of compression force was evaluated on the disintegration time, hardness and percent of dissolved MLX after 30 min of prepared MLX ODTs. The optimized ODT formulation contained 10% superdisintegrant, mannitol and avicel a ratio of 2:1 compressed using a high level of compression force. Conclusion: Optimized ODT showed hardness (48±4.3 N) and friability (0.81±0.07%). This formulation provided rapid disintegration in 19±2 seconds of which 77.8±5.1% of drug was released within 30 minutes. The present study demonstrated an effective method for the preparation of suitable dosage form of MLX with improved solubility and onset of action.


  • Antisolvent precipitation technique: A very promising approach to crystallize curcumin in presence of polyvinyl pyrrolidon for solubility and dissolution enhancement

    by Fatemeh Sadeghi, Mohammad Ashofteh, Alireza Homayouni, Mohammadreza Abbaspour, Ali Nokhodchi, Hadi Afrasiabi Garekani


    • 1 December 2015
      • Vol. 14  (1) , 35-50
    Open Access

    Preparation and Characterization of Celecoxib Dispersions in Soluplus®: Comparison of Spray Drying and Conventional Methods

    by Alireza Homayouni, Fatemeh Sadeghi, Ali Nokhodchi, Jaleh Varshosaz, Hadi Afrasiabi Garekani

    The present study deals with characterization of dispersions of a poorly water-soluble drug, celecoxib (CLX) in polyvinyl caprolactame-polyvinyl acetate-polyethylene glycol graft copolymer (Soluplus (R) (SOL)) prepared by different techniques. Dispersions of CLX in SOL at different ratios (2: 1, 1: 1, 1: 2, 1: 4 and 1: 6) were prepared by spray drying, conventional solvent evaporation and melting methods. The solid states of samples were characterized using particle size measurements, optical and scanning electron microscopy, XRPD, DSC and FT-IR. The Gordon-Taylor equation was used to predict the T-g of samples and the possibility of interaction between CLX and SOL. The solubility and dissolution rate of all samples were determined. Stability of samples was studied at ambient conditions for a period of 12 months. DSC and XRPD analyses confirmed amorphous state of drug in samples. Surprisingly dispersions of CLX: SOL with the ratio of 2: 1 and 1: 1 showed slower dissolution rate than CLX while other samples showed higher dissolution rate. At 1: 2 ratio the spray dried samples exhibited higher dissolution rate than corresponding samples prepared by other methods. However at higher SOL content (1: 4 and 1: 6), samples prepared by different methods showed similar dissolution profiles. The stability studies showed that there were no remarkable changes in the dissolution profiles and solid state of the drug after 12 months storage at ambient conditions. It was concluded that SOL was a proper carrier to enhance the dissolution rate of CLX. At high SOL ratios the method of preparation of dispersed samples had no effect on dissolution rate, whilst at low SOL content spray drying was more efficient method.


  • Open Access

    Crystal engineering of ibuprofen using starch derivatives in crystallization medium to produce promising ibuprofen with improved pharmaceutical performance

    by Ali Nokhodchi, Alireza Homayouni, Ruta Araya, Waseem Kaialy, Wasfy Obeidat, Kofi Asare-Addo

    Ibuprofen exhibits poor flow, poor compaction and dissolution behaviour, and it is prone to capping after ejection from the die, therefore it needs particle modification.


  • Comparing various techniques to produce micro/nanoparticles for enhancing the dissolution of celecoxib containing PVP

    by Alireza Homayouni, Fatemeh Sadeghi, Jaleh Varshosaz, Hadi Afrasiabi Garekani, Ali Nokhodchi


    • 1 May 2014
      • Vol. 17  (5) , 322-31
    Open Access

    Preparation and characterization of celecoxib solid dispersions; comparison of poloxamer-188 and PVP-K30 as carriers.

    by Alireza Homayouni, Fatemeh Sadeghi, Ali Nokhodchi, Jaleh Varshosaz, Hadi Afrasiabi Garekani

    Solid dispersion formulation is the most promising strategy to improve oral bioavailability of poorly water soluble drugs. The aim of this study was to compare the effect of polyvinylpyrrolidone K30 (PVP) and poloxamer-188 (PLX) as carrier in solid dispersion formulations of celecoxib (CLX). Solid dispersions of CLX:PVP or CLX:PLX were prepared at different ratios (2:1, 1:1, 1:2, 1:4, 1:6) by solvent evaporation and melting methods, respectively. The characterization of samples was performed using differential scanning calorimetery (DSC), X-Ray powder diffraction (XRPD) and Fourier transform infrared spectroscopy (FT-IR). The Gordon-Taylor equation was used to estimate the Tg of solid dispersion systems and the possibility of the interaction between CLX and PVP. Also, the dissolution rate of all samples was determined. DSC and XRPD analyses confirmed the presence of amorphous state of drug in solid dispersion systems. FT-IR studies showed CLX could participate in hydrogen bonding with PVP whilst no specific interaction between CLX and PLX was observed. Both PVP and PLX enhanced the dissolution rate of drug in solid dispersion samples. The dissolution rate was dependent on the ratio of drug: carrier. Interestingly, the solid dispersion samples of PLX at 2:1 and 1:1 drug: carrier showed slower dissolution rate than pure CLX, whilst these results were not observed for PVP. The effect of PVP on dissolution rate enhancement was more pronounced compared to the other carrier. Having a higher Tg and more effect on dissolution rate, PVP could be considered as a more suitable carrier compared to PLX in solid dispersion formulation of CLX.