Jarosław Zalewski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Jarosław Zalewski has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Jerzy Kisilowski
Kazimierz Pulaski University of Technology and Humanities, Faculty of Transport and Electrical Engineering, Radom, Poland
6 shared publications- Jerzy Kisilowski
Kazimierz Pulaski University of Technology and Humanities in Radom
4 shared publications - Iwo Aleksandrowicz
Almot Ekspert, Tech Dept, Janusza Kusocinskiego 20, PL-86032 Niemcz, Poland
2 shared publications - Piotr Aleksandrowicz
Faculty of Mechanical Engineering, University of Science and Technology in Bydgoszcz, Al. prof. S. Kaliskiego 7, Poland
2 shared publications - Iwo Aleksandrowicz1 shared publication
Piotr Aleksandrowicz
Bydgoszcz Univ Sci & Technol, Fac Mech Engn, Al Prof S Kaliskiego 7, PL-85796 Bydgoszcz, Poland
1 shared publication
Latest Publications
- Open Access
- 1 July 2026
- Published by WNGB Scientific Publishing House Sp. z o.o. in Advances in Science and Technology Research Journal
- Vol. 20 (8) , 201-212
A theoretical model of a collision between a car and a car-trailer set
In this paper a theoretical model of a collision between a car and a car with a trailer was considered. To properly model the phenomena occurring in this case the principles of mechanics of bodies with variable mass have been used, specifically in case of trailer unhooking and disconnecting from...
- 1 July 2026
- Published by WNGB Scientific Publishing House Sp. z o.o. in Advances in Science and Technology Research Journal
- Vol. 20 (8) , 201-212
Open AccessA theoretical model of a collision between a car and a car-trailer set
In this paper a theoretical model of a collision between a car and a car with a trailer was considered. To properly model the phenomena occurring in this case the principles of mechanics of bodies with variable mass have been used, specifically in case of trailer unhooking and disconnecting from...
- 30 March 2026
- Published by Index Copernicus in Journal of Konbin
- Vol. 56 (1) , 65-80
Simulation of a motor vehicle braking from 120 km/h – Part 2
The paper presents a second part of analysis based on a simulation of a vehicle braking from an initial speed of 120 km/h with 50% of the applied braking force. The aim of this paper was to compare the results obtained here, where it was assumed that the vehicle was uncontrolled during the maneuver, with the analysis in part 1 in which the straightforward motion was adopted.The problem was undertaken to examine how the given vehicle would behave in various road conditions. Analysis of the exemplary literature has been prepared to address the presented problem. Then the results obtained were discussed and related to part 1.This analysis has been prepared with the use of Adams/Car software and is the second part of broader research.
- 30 March 2026
- Published by Index Copernicus in Journal of Konbin
- Vol. 56 (1) , 65-80
Simulation of a motor vehicle braking from 120 km/h – Part 2
The paper presents a second part of analysis based on a simulation of a vehicle braking from an initial speed of 120 km/h with 50% of the applied braking force. The aim of this paper was to compare the results obtained here, where it was assumed that the vehicle was uncontrolled during the maneuver, with the analysis in part 1 in which the straightforward motion was adopted.The problem was undertaken to examine how the given vehicle would behave in various road conditions. Analysis of the exemplary literature has been prepared to address the presented problem. Then the results obtained were discussed and related to part 1.This analysis has been prepared with the use of Adams/Car software and is the second part of broader research.
- 28 March 2025
- Published by Index Copernicus in Journal of Konbin
- Vol. 55 (1) , 169-185
Simulation of a motor vehicle braking from 120 km/h – Part 1
This paper presents an analysis based on a simulation of a vehicle braking from an initial speed of 120 km/h with 50% of the maximum braking force applied. The aim of this paper was to examine the vehicle’s selected properties while braking on various road conditions, including dry and icy surface and some other selected factors making the maneuver more demanding. Moreover, a straightforward motion during the braking was imposed on the vehicle’s model which could reflect that the vehicle was controlled by a driver in order to maintain the adopted direction of motion. Analysis of the exemplary literature has been prepared in order to specify the discussed problem. Then the model of the vehicle with the necessary assumptions was presented. Finally the obtained results was discussed. This analysis has been prepared with the use of the Adams/Car software and is only the first part because of the adopted straightforward motion of the vehicle.
- 28 March 2025
- Published by Index Copernicus in Journal of Konbin
- Vol. 55 (1) , 169-185
Simulation of a motor vehicle braking from 120 km/h – Part 1
This paper presents an analysis based on a simulation of a vehicle braking from an initial speed of 120 km/h with 50% of the maximum braking force applied. The aim of this paper was to examine the vehicle’s selected properties while braking on various road conditions, including dry and icy surface and some other selected factors making the maneuver more demanding. Moreover, a straightforward motion during the braking was imposed on the vehicle’s model which could reflect that the vehicle was controlled by a driver in order to maintain the adopted direction of motion. Analysis of the exemplary literature has been prepared in order to specify the discussed problem. Then the model of the vehicle with the necessary assumptions was presented. Finally the obtained results was discussed. This analysis has been prepared with the use of the Adams/Car software and is only the first part because of the adopted straightforward motion of the vehicle.
- Open Access
- 1 March 2025
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Advances in Science and Technology Research Journal
- Vol. 19 (3) , 63-73
On a possibility of complicating the mathematical model of a collision between two motor vehicles
In this paper a survey on some selected problems of motor vehicle collisions modeling has been undertaken. The aim of this paper was to replace the classic approach basing on a planar motion with a more complex resultant motion to examine the potential additional factors affecting the process of...
- 1 March 2025
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Advances in Science and Technology Research Journal
- Vol. 19 (3) , 63-73
Open AccessOn a possibility of complicating the mathematical model of a collision between two motor vehicles
In this paper a survey on some selected problems of motor vehicle collisions modeling has been undertaken. The aim of this paper was to replace the classic approach basing on a planar motion with a more complex resultant motion to examine the potential additional factors affecting the process of...
- Open Access
- 11 July 2024
- Published by University of Zilina in Communications - Scientific letters of the University of Zilina
- Vol. 26 (3) , B175-B186
Exemplary Determination of the Adhesion Ellipses Based on Simulation of an Accelerating Motor Vehicle
In the paper, some selected results concerning the ellipses of adhesion for various conditions of motion of a vehicle model, have been presented. The analysis, regarding the phenomena between the road and the wheels of the given motor vehicle'...
- 11 July 2024
- Published by University of Zilina in Communications - Scientific letters of the University of Zilina
- Vol. 26 (3) , B175-B186
Open AccessExemplary Determination of the Adhesion Ellipses Based on Simulation of an Accelerating Motor Vehicle
In the paper, some selected results concerning the ellipses of adhesion for various conditions of motion of a vehicle model, have been presented. The analysis, regarding the phenomena between the road and the wheels of the given motor vehicle'...
- 30 March 2024
- Published by Silesian University of Technology in Transport Problems
- Vol. 19 (1) , 199-208
SELECTED PROBLEMS IN A VEHICLE-TO-TRUCK COLLISION MODELING
- 30 March 2024
- Published by Silesian University of Technology in Transport Problems
- Vol. 19 (1) , 199-208
SELECTED PROBLEMS IN A VEHICLE-TO-TRUCK COLLISION MODELING
- 28 December 2023
- Published by Index Copernicus in Journal of Konbin
- Vol. 53 (4) , 211-222
Simulation of a motor vehicle braking with the unlocked steering wheel
- 28 December 2023
- Published by Index Copernicus in Journal of Konbin
- Vol. 53 (4) , 211-222
Simulation of a motor vehicle braking with the unlocked steering wheel
- Open Access
- 5 June 2023
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Advances in Science and Technology Research Journal
- Vol. 17 (3) , 257-268
On a Possibility of a Side Impact Collision Analysis
In this paper a potential use of the tangential coefficient of restitution has been analyzed on the basis of a computer simulation of a side oblique collision between two motor vehicles. The simulation was carried out in PC-Crash 8.0. The results obtained for a side impact collision have been...
- 5 June 2023
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Advances in Science and Technology Research Journal
- Vol. 17 (3) , 257-268
Open AccessOn a Possibility of a Side Impact Collision Analysis
In this paper a potential use of the tangential coefficient of restitution has been analyzed on the basis of a computer simulation of a side oblique collision between two motor vehicles. The simulation was carried out in PC-Crash 8.0. The results obtained for a side impact collision have been...
- 31 March 2023
- Published by Index Copernicus in Journal of Konbin
- Vol. 53 (1) , 137-146
Analysis of an accelerating model of motor vehicle with the uncontrolled steering wheel
In this paper a continuation of the previous research has been presented. A simulation of a vehicles acceleration in various road conditions but without a drivers control has been taken into account. The main aim of this paper was to answer the question whether the random road conditions could affect the vehicle while accelerating while a driver cannot control the direction of its motion. The three various maximum amplitudes of the irregularities for both the dry and the icy road surface were used. Almost different road profiles were also adopted for the analyzed maneuver, which defines a specific coefficient. Apart from no control of the vehicle the initial speed was set to 5 km/h and after 1 s the vehicle started to accelerate. The time of reaching the full throttle (100%) was only 0.25 s which provided a rapid acceleration. The simulation time was 10 s.
- 31 March 2023
- Published by Index Copernicus in Journal of Konbin
- Vol. 53 (1) , 137-146
Analysis of an accelerating model of motor vehicle with the uncontrolled steering wheel
In this paper a continuation of the previous research has been presented. A simulation of a vehicles acceleration in various road conditions but without a drivers control has been taken into account. The main aim of this paper was to answer the question whether the random road conditions could affect the vehicle while accelerating while a driver cannot control the direction of its motion. The three various maximum amplitudes of the irregularities for both the dry and the icy road surface were used. Almost different road profiles were also adopted for the analyzed maneuver, which defines a specific coefficient. Apart from no control of the vehicle the initial speed was set to 5 km/h and after 1 s the vehicle started to accelerate. The time of reaching the full throttle (100%) was only 0.25 s which provided a rapid acceleration. The simulation time was 10 s.
- Open Access
- 2 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (19) , 9921
Selected Problems in a Two-Vehicle Impact Collision Modeling
In this paper, a potential use of the basic parameters of a road collision in a forensic activity was analyzed. A selected case of a frontal, eccentric, and oblique collision between two motor vehicles was analyzed from the point of view of both a computer simulation and a model. The case has been presented as an attempt to identify the collision parameters necessary to conduct the analytical calculations useful in analyzing specific road accidents. The simulation results were obtained in V-SIM software, which is widely used in collision reconstructions by forensic experts and appraisers. It was further analyzed from the point of view of a mathematical model, with the use of the force–impulse method and avoiding the use of the coefficients of restitution in the normal and tangential directions versus the adopted coordinate frame. In the analytical calculations, apart from the masses and the velocities of vehicles, the collision angles and the vicarial coefficient of adhesion between the colliding vehicles (µ) are also important. The approach presented in the article enables an expert to verify the obtained results of a computer program simulation.
- 2 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (19) , 9921
Open AccessSelected Problems in a Two-Vehicle Impact Collision Modeling
In this paper, a potential use of the basic parameters of a road collision in a forensic activity was analyzed. A selected case of a frontal, eccentric, and oblique collision between two motor vehicles was analyzed from the point of view of both a computer simulation and a model. The case has been presented as an attempt to identify the collision parameters necessary to conduct the analytical calculations useful in analyzing specific road accidents. The simulation results were obtained in V-SIM software, which is widely used in collision reconstructions by forensic experts and appraisers. It was further analyzed from the point of view of a mathematical model, with the use of the force–impulse method and avoiding the use of the coefficients of restitution in the normal and tangential directions versus the adopted coordinate frame. In the analytical calculations, apart from the masses and the velocities of vehicles, the collision angles and the vicarial coefficient of adhesion between the colliding vehicles (µ) are also important. The approach presented in the article enables an expert to verify the obtained results of a computer program simulation.