David Furniss
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
David Furniss has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
- Angela Beth Seddon
Mid-Infrared Photonics Group, George Green Institute for Electromagnetics’ Research, Faculty of Engineering, University of Nottingham, Nottingham NG7 2RD, UK
4 shared publications - Trevor. M. Benson
George Green Institute for Electromagnetics Research, University of Nottingham, Nottingham, U.K.
3 shared publications A. Engelbrecht
Stellenbosch University
1 shared publicationA. Loni
Nottingham Univ., UK
1 shared publication- Ana Vukovic
University of Nottingham
1 shared publication - Andrew Julian Phillips
University of Nottingham
1 shared publication
Latest Publications
- Open Access
- 8 August 2023
- Published by Academy of Science of South Africa in South African Journal of Science
- Vol. 119 (7/8)
Land cover change in marginalised landscapes of South Africa (1984–2014): Insights into the influence of socio-economic and political factors
Rural landscapes in South Africa experience high conversion rates due to intense land use; however, the changes are site specific and depend on the socio-economic and political history of the area. Land cover change (LCC) was assessed in response to socio-economic and political factors in uThukela Municipal District, KwaZulu-Natal, using Landsat imagery from 1984 to 2014, while making comparisons to other studies in South Africa. Socio-economic/political data were used to gain insights into the observed LCC patterns. Land cover was classified using a random forest classifier, and accuracies ranging from 87% to 92% were achieved. Systematic and intensity analysis methods were used to describe patterns, rates, and transitions of LCC in Imbabazane (ILM) and Okhahlamba (OLM) local municipalities. The results showed a reduced rate of change intensity from 3.4% to 0.9% in ILM and from 3.1% to 1.1% in OLM between 1984 and 2014. Grassland was persistent, covering over 70% in both local municipalities between 1984 and 2014. Although persistent, grassland experienced respective losses of 3.7% and 14.3% in both observation periods in ILM and of 10.2% and 13.3% in OLM. During the analysis period, settlements and cropland gained actively in both local municipalities. The changes represent a degree of population, local authority, and people’s perception as influencers of land use and LCC. It is therefore argued that socio-economic and political changes can potentially influence land use and LCC; however, natural ecosystems can persist under those conditions, and this requires more research efforts. Significance: This study contributes towards a growing knowledge and understanding of land cover change studies in marginalised landscapes in South Africa. The findings enforce the notion that natural vegetation systems can be altered by human-induced land use such as expansion of settlement and commercial agricultural. We show that in recent times there has been a decline in the overall rate of land cover conversion, and a high persistence of grassland amid global change, although the quality of the vegetation needs further research. We argue that the changes observed in marginalised landscapes are potentially driven by socio-economic and political dynamics.
- 8 August 2023
- Published by Academy of Science of South Africa in South African Journal of Science
- Vol. 119 (7/8)
Open AccessLand cover change in marginalised landscapes of South Africa (1984–2014): Insights into the influence of socio-economic and political factors
Rural landscapes in South Africa experience high conversion rates due to intense land use; however, the changes are site specific and depend on the socio-economic and political history of the area. Land cover change (LCC) was assessed in response to socio-economic and political factors in uThukela Municipal District, KwaZulu-Natal, using Landsat imagery from 1984 to 2014, while making comparisons to other studies in South Africa. Socio-economic/political data were used to gain insights into the observed LCC patterns. Land cover was classified using a random forest classifier, and accuracies ranging from 87% to 92% were achieved. Systematic and intensity analysis methods were used to describe patterns, rates, and transitions of LCC in Imbabazane (ILM) and Okhahlamba (OLM) local municipalities. The results showed a reduced rate of change intensity from 3.4% to 0.9% in ILM and from 3.1% to 1.1% in OLM between 1984 and 2014. Grassland was persistent, covering over 70% in both local municipalities between 1984 and 2014. Although persistent, grassland experienced respective losses of 3.7% and 14.3% in both observation periods in ILM and of 10.2% and 13.3% in OLM. During the analysis period, settlements and cropland gained actively in both local municipalities. The changes represent a degree of population, local authority, and people’s perception as influencers of land use and LCC. It is therefore argued that socio-economic and political changes can potentially influence land use and LCC; however, natural ecosystems can persist under those conditions, and this requires more research efforts. Significance: This study contributes towards a growing knowledge and understanding of land cover change studies in marginalised landscapes in South Africa. The findings enforce the notion that natural vegetation systems can be altered by human-induced land use such as expansion of settlement and commercial agricultural. We show that in recent times there has been a decline in the overall rate of land cover conversion, and a high persistence of grassland amid global change, although the quality of the vegetation needs further research. We argue that the changes observed in marginalised landscapes are potentially driven by socio-economic and political dynamics.
- 26 September 2013
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 46 (4) , 593-602
Numerical investigation of mid-infrared emission from Pr $^{3+}$ 3 + doped GeAsGaSe fibre- 26 September 2013
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 46 (4) , 593-602
Numerical investigation of mid-infrared emission from Pr $^{3+}$ 3 + doped GeAsGaSe fibre- 5 June 2013
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 45 (9) , 961-967
Large core, multimode, chalcogenide glass fibre coupler by side-polishing
- 5 June 2013
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 45 (9) , 961-967
Large core, multimode, chalcogenide glass fibre coupler by side-polishing
- 19 November 2012
- Published by Springer Nature in Hydrobiologia
- Vol. 702 (1) , 1-4
The propagation and dispersal of misinformation in ecology: Is there a relationship between citation accuracy and journal impact factor?
- 19 November 2012
- Published by Springer Nature in Hydrobiologia
- Vol. 702 (1) , 1-4
The propagation and dispersal of misinformation in ecology: Is there a relationship between citation accuracy and journal impact factor?
- 1 January 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, III-1067-III-1070
Deriving indices of landscape function from spectral reflectance of grassland and savanna on gold mines in South Africa
The aim of this study is to develop hyperspectral (HS) models using partial least squares regression (PLSR) for predicting indices of grassland and savanna ecological condition on deep-level gold mines in a semi-arid region. Landscape Function Analysis (LFA) indices (surface stability, infiltration and nutrient cycling) were derived from four, increasingly complex, vegetation types on each end of a disturbance continuum in the dry season (winter) and wet season (summer). PLSR models for one of the most structurally simple vegetation types (non-rocky grassland on the lowest rainfall mine in summer) produced the strongest validation CoD for indices predicting stability and nutrient cycling (R2 = 0.70, P < 0.0001 and R2 = 0.71, P < 0.0001 respectively), whereas the infiltration index had the strongest CoD for validation with HS data from non-rocky grassland on the highest rainfall mine in summer (R2 = 0.63, P < 0.0001). Increasingly complex vegetation structure (rocky grassland and dolomite sinkhole woodland) had weaker validation CoDs for LFA indices. Combining all vegetation categories or mining regions in a model also weakened CoD.
- 1 January 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, III-1067-III-1070
Deriving indices of landscape function from spectral reflectance of grassland and savanna on gold mines in South Africa
The aim of this study is to develop hyperspectral (HS) models using partial least squares regression (PLSR) for predicting indices of grassland and savanna ecological condition on deep-level gold mines in a semi-arid region. Landscape Function Analysis (LFA) indices (surface stability, infiltration and nutrient cycling) were derived from four, increasingly complex, vegetation types on each end of a disturbance continuum in the dry season (winter) and wet season (summer). PLSR models for one of the most structurally simple vegetation types (non-rocky grassland on the lowest rainfall mine in summer) produced the strongest validation CoD for indices predicting stability and nutrient cycling (R2 = 0.70, P < 0.0001 and R2 = 0.71, P < 0.0001 respectively), whereas the infiltration index had the strongest CoD for validation with HS data from non-rocky grassland on the highest rainfall mine in summer (R2 = 0.63, P < 0.0001). Increasingly complex vegetation structure (rocky grassland and dolomite sinkhole woodland) had weaker validation CoDs for LFA indices. Combining all vegetation categories or mining regions in a model also weakened CoD.
- 12 September 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1 (21627339) , 296-299
Novel glass compositions and fabrication technologies for photonic integrated circuits
Heavy metal fluoride, chalcogenide, and fluoro-tellurite glasses proffer photonic integrated circuit functionality over a wide wavelength range, and combine high optical non-linearity with the ability to incorporate active dopants. The ability to access a range of glass compositions offers great flexibility in both design and processing. In this paper, we present fabrication methodologies for producing such novel glass-based waveguide components.
- 12 September 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1 (21627339) , 296-299
Novel glass compositions and fabrication technologies for photonic integrated circuits
Heavy metal fluoride, chalcogenide, and fluoro-tellurite glasses proffer photonic integrated circuit functionality over a wide wavelength range, and combine high optical non-linearity with the ability to incorporate active dopants. The ability to access a range of glass compositions offers great flexibility in both design and processing. In this paper, we present fabrication methodologies for producing such novel glass-based waveguide components.
- 10 June 2004
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5273, 430-439
Chalcogenide glass films for the bonding of GaAs optical parametric oscillator elements
There are many applications driving the need for frequency agile solid state laser systems for use in the mid-infrared. Most of these are centred on the development of optical parametric oscillators (OPOs), which exploit the non-linear optical characteristics of non-centrosymmetric materials. In a new approach highlighted in a companion paper, OPO elements are formed by bonding gallium arsenide wafers precoated with RF sputtered films of a quaternary chalcogenide glass. The conditions used for sputtering the glass films are critical in ensuring the realisation of reliable bonds, where the glass is required to be index matched to the GaAs within very close tolerances. Issues such as glass composition, purity, porosity, devitrification and optical absorption are all key factors in determining the success of the approach. This paper describes a summary of some of the results achieved, emphasising the degree of control necessary for both the sputtering process and the preparation of the sputtering targets. Composition changes on sputtering can influence the refractive index of the glass and can easily introduce levels of insertion loss that are unacceptable by the time that stacks containing 50 or more individual phase-matched GaAs elements have been produced. Oxygen-related impurities are also easily introduced from a variety of sources and can degrade performance levels further. Such difficulties have been overcome and a reproducible technique for fabricating glass-bonded GaAs crystals has been developed. Optimised conditions for thermal bonding pairs of glass coated GaAs wafers are also reported.
- 10 June 2004
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5273, 430-439
Chalcogenide glass films for the bonding of GaAs optical parametric oscillator elements
There are many applications driving the need for frequency agile solid state laser systems for use in the mid-infrared. Most of these are centred on the development of optical parametric oscillators (OPOs), which exploit the non-linear optical characteristics of non-centrosymmetric materials. In a new approach highlighted in a companion paper, OPO elements are formed by bonding gallium arsenide wafers precoated with RF sputtered films of a quaternary chalcogenide glass. The conditions used for sputtering the glass films are critical in ensuring the realisation of reliable bonds, where the glass is required to be index matched to the GaAs within very close tolerances. Issues such as glass composition, purity, porosity, devitrification and optical absorption are all key factors in determining the success of the approach. This paper describes a summary of some of the results achieved, emphasising the degree of control necessary for both the sputtering process and the preparation of the sputtering targets. Composition changes on sputtering can influence the refractive index of the glass and can easily introduce levels of insertion loss that are unacceptable by the time that stacks containing 50 or more individual phase-matched GaAs elements have been produced. Oxygen-related impurities are also easily introduced from a variety of sources and can degrade performance levels further. Such difficulties have been overcome and a reproducible technique for fabricating glass-bonded GaAs crystals has been developed. Optimised conditions for thermal bonding pairs of glass coated GaAs wafers are also reported.