Göran B. Scharmer

Context . Fabry-Pérot interferometer (FPI) observations are commonly used in solar physics to infer physical parameters in the photosphere and chromosphere using observational modeling. Such techniques require detailed knowledge of the spectral instrumental profile to produce accurate results. Aims . We present a method to characterize the spatial variation of the parameters of dual-etalon FPI instruments mounted in a telecentric configuration: spatially resolved cavity separation, the reflectivities of both etalons, and the prefilter variation across the field of view. We aim to characterize the field-of-view dependence of the parameters of the new CRISP2 FPI. Methods . We implemented a forward model of the FPI instrumental degradation combined with a template average quiet-Sun spectrum at disk center to model two sets of observational data. Our method does not require any changes to the optical setup or the use of external illumination sources. We assessed the validity of several functional forms to calculate the FPI transmission profiles. Results . Our results show that, in general, including the secondary transmission peaks at ±1 times the free spectral range (FSR) and a detailed estimate of the prefilter curve are necessary to obtain accurate values of both etalon reflectivities. For very narrow prefilters relative to the FSR, the former requirement can be relaxed. Our results show that the CRISP2 cavity separation is very flat, with an RMS variation below 2 nm over the entire field of view for both etalons. Reflectivity RMS variations are 0.4 and 0.3% for the primary and secondary etalons at 617.3 nm. Conclusions . We assessed the data and modeling requirements needed to derive accurate dual-etalon telecentric FPI parameters and minimize errors in determining etalon reflectivities. The methods described in this paper are relevant for the characterization of present and future FPI instruments, and we have made them publicly available to the solar community.

We discuss the requirements, concepts, simulations, implementation, and calibration of two dual Fabry-Perot (FPI)-based imaging spectropolarimeters, CRISP and CHROMIS, at the Swedish 1-m Solar Telescope, and CRISP2, which is under construction. These instruments are optimised for a large field of view and high cadence at the expense of a moderate spectral resolution, and use a combination of a high-resolution and a low-resolution etalon together with an order-sorting prefilter to define the bandpass. The overall design is made robust and stable by tailoring the low-resolution etalon reflectivity to accommodate expected cavity errors from both etalons, by using a compact optical design that eliminates the need for folding mirrors, and enclosing the entire system within a single container sealed by lenses. By using a telecentric design based on lenses rather than mirrors, image degradation by the FPI system is negligible, as shown in a previous publication, and the throughput of the system is maximised. The initial alignment, and maintaining that alignment over time, is greatly simplified. Moreover, the telecentric design allows the full calibration and/or modelling of essential system parameters to be carried out without interfering with the optical set-up or the cameras. We also discuss briefly the polarimeters developed for CRISP and CHROMIS. The high performance of CRISP and CHROMIS has been demonstrated in an earlier publication through measurements of the granulation contrast and comparisons with similar measurements simultaneously made through broadband continuum filters. Here, we focus on the aspects of the design that are central to enabling high performance and robustness, but also discuss the calibration and processing of the data, and use a few examples of processed data to demonstrate the achievable image and data quality. We put forward a proposal for a similar conceptual design for the European Solar Telescope and conclude by discussing potential problems of the proposed approach to designs of this type. Some aspects of these FPI systems may also be of interest outside the solar community.

Context. Flux emergence in the solar atmosphere is a complex process that causes a release of magnetic energy as heat and acceleration of solar plasma on a variety of spatial scales. Aims. We aim to investigate temperatures and velocities in small-scale reconnection episodes during flux emergence. Methods. We analyzed imaging spectropolarimetric data taken in the He I 1083 nm line with a spatial resolution of 0.26″, a time cadence of 2.8 s, and a spectral range corresponding to ±220 km s⁻¹ around the line. This line is sensitive to temperatures higher than 15 kK, unlike diagnostics such as Mg II h&k, Ca II H&K, and Hα, which lose sensitivity already at 15 kK. The He I data is complemented by imaging spectropolarimetry in the Fe I 617.3 nm and Ca II 854.2 nm lines and imaging spectroscopy in Ca II K and Hα at a cadence between 12 s and 36 s. We employed inversions to determine the magnetic field and vertical velocity in the solar atmosphere. We computed He I 1083 nm profiles from a radiation-magneto-hydrodynamics simulation of the solar atmosphere to help in the interpretation of the observations. Results. We find fast-evolving blob-like emission features in the He I 1083 nm triplet at locations where the magnetic field is rapidly changing direction, and these are likely sites of magnetic reconnection. We fit the line with a model consisting of an emitting layer located below a cold layer representing the fibril canopy. The modeling provides evidence that this model, while simple, catches the essential characteristics of the line formation. The morphology of the emission in the He I 1083 nm is localized and blob-like, unlike the emission in the Ca II K line, which is more filamentary. Conclusions. The modeling shows that the He I 1083 nm emission features and their Doppler shifts can be caused by opposite-polarity reconnection and/or horizontal current sheets below the canopy layer in the chromosphere. Based on the high observed Doppler width and the blob-like appearance of the emission features, we conjecture that at least a fraction of them are produced by plasmoids. We conclude that transition-region-like temperatures in the deeper layers of the active region chromosphere are more common than previously thought.

We discuss the chosen concepts, detailed design, implementation and calibration of the 85-electrode adaptive optics (AO) system of the Swedish 1-meter Solar Telescope (SST), which was installed in 2013. The AO system is unusual in that it uses a combination of a monomorph mirror with a Shack-Hartmann (SH) wavefront sensor (WFS) and a second high-resolution SH microlens array to aid the characterization, calibration, and modal control of the deformable mirror. An Intel PC workstation performs the heavy image processing associated with cross-correlations and real-time control at a 2 kHz update rate with very low latency. The computer and software continue the successful implementation since 1995 of earlier generations of correlation tracker and AO systems at SST and its predecessor, the 50-cm Swedish Vacuum Solar Telescope, by relying entirely on work-station technology and an extremely efficient algorithm for implementing cross-correlations with the large field of view of the WFS. We describe critical aspects of the design, calibrations, software, and functioning of the AO system. The exceptionally high performance is testified through the highest Strehl ratio (inferred from the measured granulation contrast) of existing meter-class solar telescopes, as demonstrated here at wavelengths shorter than 400 nm and discussed in more detail in a previous separate publication We expect that some aspects of this AO system may also be of interest outside the solar community.

Context. Data from ground-based, high-resolution solar telescopes can only be used for science with calibrations and processing, which requires detailed knowledge about the instrumentation. Space-based solar telescopes provide science-ready data, which are easier to work with for researchers whose expertise is in the interpretation of data. Recently, data-processing pipelines for ground-based instruments have been constructed. Aims. We aim to provide observers with a user-friendly data pipeline for data from the Swedish 1-meter Solar Telescope (SST) that delivers science-ready data together with the metadata needed for proper interpretation and archiving. Methods. We briefly describe the CHROMospheric Imaging Spectrometer (CHROMIS) instrument, including its (pre)filters, as well as recent upgrades to the CRisp Imaging SpectroPolarimeter (CRISP) prefilters and polarization optics. We summarize the processing steps from raw data to science-ready data cubes in FITS files. We report calibrations and compensations for data imperfections in detail. Misalignment of Ca II data due to wavelength-dependent dispersion is identified, characterized, and compensated for. We describe intensity calibrations that remove or reduce the effects of filter transmission profiles as well as solar elevation changes. We present REDUX, a new version of the MOMFBD image restoration code, with multiple enhancements and new features. It uses projective transforms for the registration of multiple detectors. We describe how image restoration is used with CRISP and CHROMIS data. The science-ready output is delivered in FITS files, with metadata compliant with the SOLARNET recommendations. Data cube coordinates are specified within the World Coordinate System (WCS). Cavity errors are specified as distortions of the WCS wavelength coordinate with an extension of existing WCS notation. We establish notation for specifying the reference system for Stokes vectors with reference to WCS coordinate directions. The CRIsp SPectral EXplorer (CRISPEX) data-cube browser has been extended to accept SSTRED output and to take advantage of the SOLARNET metadata. Results. SSTRED is a mature data-processing pipeline for imaging instruments, developed and used for the SST/CHROMIS imaging spectrometer and the SST/CRISP spectropolarimeter. SSTRED delivers well-characterized, science-ready, archival-quality FITS files with well-defined metadata. The SSTRED code, as well as REDUX and CRISPEX, is freely available through git repositories.

We present the design and performance of a polychromatic polarization modulator for the CRisp Imaging SpectroPolarimeter (CRISP) Fabry–Perot tunable narrow-band imaging spectropolarimer at the Swedish 1 m Solar Telescope (SST). We discuss the design process in depth, compare two possible modulator designs through a tolerance analysis, and investigate thermal sensitivity of the selected design. The trade-offs and procedures described in this paper are generally applicable in the development of broadband polarization modulators. The modulator was built and has been operational since 2015. Its measured performance is close to optimal between 500 and 900 nm, and differences between the design and as-built modulator are largely understood. We show some example data, and briefly review scientific work that used data from SST/CRISP and this modulator.

NASA’s Interface Region Imaging Spectrograph (IRIS) provides high-resolution observations of the solar atmosphere through ultraviolet spectroscopy and imaging. Since the launch of IRIS in June 2013, we have conducted systematic observation campaigns in coordination with the Swedish 1 m Solar Telescope (SST) on La Palma. The SST provides complementary high-resolution observations of the photosphere and chromosphere. The SST observations include spectropolarimetric imaging in photospheric Fe I lines and spectrally resolved imaging in the chromospheric Ca II 8542 Å, Hα, and Ca II K lines. We present a database of co-aligned IRIS and SST datasets that is open for analysis to the scientific community. The database covers a variety of targets including active regions, sunspots, plages, the quiet Sun, and coronal holes.

We study the polarization signals and physical parameters of penumbral microjets (PMJs) by using high spatial resolution data taken in the Fe i 630 nm pair, Ca ii 854.2 nm, and Ca ii K lines with the CRISP and CHROMIS instruments at the Swedish 1 m Solar Telescope. We infer their physical parameters, such as physical observables in the photosphere and chromospheric velocity diagnostics, by different methods, including inversions of the observed Stokes profiles with the STiC code. PMJs harbor overall brighter Ca ii K line profiles and conspicuous polarization signals in Ca ii 854.2 nm, specifically in circular polarization that often shows multiple lobes mainly due to the shape of Stokes I. They usually overlap photospheric regions with a sheared magnetic field configuration, suggesting that magnetic reconnections could play an important role in the origin of PMJs. The discrepancy between their low LOS velocities and the high apparent speeds reported on earlier, as well as the existence of different vertical velocity gradients in the chromosphere, indicate that PMJs might not be entirely related to mass motions. Instead, PMJs could be due to perturbation fronts induced by magnetic reconnections occurring in the deep photosphere that propagate through the chromosphere. This reconnection may be associated with current heating that produces temperature enhancements from the temperature minimum region. Furthermore, enhanced collisions with electrons could also increase the coupling to the local conditions at higher layers during the PMJ phase, giving a possible explanation for the enhanced emission in the overall Ca ii K profiles emerging from these transients.

Magnetic reconnection is thought to drive a wide variety of dynamic phenomena in the solar atmosphere. Yet, the detailed physical mechanisms driving reconnection are difficult to discern in the remote sensing observations that are used to study the solar atmosphere. In this Letter, we exploit the high-resolution instruments Interface Region Imaging Spectrograph and the new CHROMIS Fabry–Pérot instrument at the Swedish 1-m Solar Telescope (SST) to identify the intermittency of magnetic reconnection and its association with the formation of plasmoids in so-called UV bursts in the low solar atmosphere. The Si iv 1403 Å UV burst spectra from the transition region show evidence of highly broadened line profiles with often non-Gaussian and triangular shapes, in addition to signatures of bidirectional flows. Such profiles had previously been linked, in idealized numerical simulations, to magnetic reconnection driven by the plasmoid instability. Simultaneous CHROMIS images in the chromospheric Ca ii K 3934 Å line now provide compelling evidence for the presence of plasmoids by revealing highly dynamic and rapidly moving brightenings that are smaller than 0.″2 and that evolve on timescales of the order of seconds. Our interpretation of the observations is supported by detailed comparisons with synthetic observables from advanced numerical simulations of magnetic reconnection and associated plasmoids in the chromosphere. Our results highlight how subarcsecond imaging spectroscopy sensitive to a wide range of temperatures combined with advanced numerical simulations that are realistic enough to compare with observations can directly reveal the small-scale physical processes that drive the wide range of phenomena in the solar atmosphere.

Astronomy & Astrophysics (A&A) is an international journal which publishes papers on all aspects of astronomy and astrophysics