GVGuilherme Fernandes Vasquez

Guilherme Fernandes Vasquez

*This is an algorithmically generated author record based on publicly available information.

Guilherme Fernandes Vasquez has a total of 87 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Laboratory Measurements and Estimates of the Biot Coefficient of a Pre-Salt Oil Field, Santos Basin

    by Marcio Jose Morschbacher, Guilherme Fernandes Vasquez, Julio Cesar Ramos Justen, Marcos Pozzato Figueiredo, Flavia de Oliveira Lima Falcão, Ana Lucia Matias Maria

    The Biot’s coefficient is an important parameter in geomechanical models of hydrocarbon reservoirs, with direct influence over the stress distribution in space and time along the production history. We conducted stress-strain experiments (quasi-static measurements) to measure the Biot coefficient of rock samples from an oil field in the Santos Basin. We found strong correlations between these quasi-static measurements and the estimates from dry rock ultrasonic elastic velocities (dynamic measurements). Additionally, we observed good correlations between the Biot’s coefficients and the effective porosity of the rocks, as well as with the acoustic impedances. These findings suggest that it is possible to derive poroelastic parameter logs of Biot’s coefficient in well locations, which can be used as input for geostatistical interpolation between wells. This would help in constructing more accurate reservoir geomechanical models and may even enable the generation of a three-dimensional distribution of the coefficient based on acoustic inversion of seismic data.

  • Petroacoustics and composition of presalt rocks from Santos Basin

    by Guilherme Fernandes Vasquez, Marcio José Morschbacher, Camila Wense Dias dos Anjos, Yaro Moisés Parisek Silva, Vanessa Madrucci, Julio Cesar Ramos Justen

    The deposition of the presalt section from Santos Basin began when Gondwana started to break up and South America and Africa were separating. Initial synrift carbonate deposits affected by relatively severe tectonic activity evolved to a lacustrine carbonate environment during the later stages of basin formation. Although the reservoirs are composed of carbonate rocks, the occurrence of faults and the intense colocation of igneous rocks served as a source of chemical elements uncommon in typical carbonate environments. Consequently, beyond the presence of different facies with complex textures and pore geometries, the presalt reservoir rocks present marked compositional and microstructural variability. Therefore, rock-physics modeling is used to understand and interpret the extensive laboratory measurements of P-wave velocities, S-wave velocities, and density that we have undertaken on the presalt carbonate cores from Santos Basin. We show that quartz and exotic clay minerals (such as stevensite and other magnesium-rich clay minerals), which have different values of elastic moduli and Poisson's ratio as compared to calcite and dolomite, may introduce noticeable “Poisson's reflectivity anomalies” on prestack seismic data. Moreover, although the authors concentrate their attention on composition, it will become clear that pore-space geometry also may influence seismic rock properties of presalt carbonate reservoirs.


  • Experimental efforts to access 4D feasibility and interpretation issues of Brazilian presalt carbonate reservoirs

    by Guilherme Fernandes Vasquez, Marcio Jose Morschbacher, Julio Cesar Ramos Justen

    Brazilian presalt reservoirs comprise carbonate rocks saturated with light oil with different amounts of CO2 and excellent productivity. The occurrence of giant-size accumulations with such productivity generates the interest in production monitoring tools, such as time-lapse seismic. However, time-lapse seismic may present several challenges, such as imaging difficulties, repeatability, and detectability of small variations of reservoir properties. In addition, when assessing time-lapse seismic feasibility, the validity of Gassmann’s modeling for complex, heterogeneous carbonate rocks is arguable. Other questions include the pressure variation effects on the seismic properties of competent rocks. The effective stress is a linear combination of confining stress and pore pressure that governs the behavior of physical properties of rocks. Many applications assume that the effective stress for elastic-wave velocity is given by the difference between confining stress and pore pressure, whereas another common approach uses the Biot-Willis coefficient as a weight applied to the pore pressure to estimate the effective stress. Through a series of experiments involving ultrasonic pulse transmission on saturated core plugs in the laboratory, we verified the applicability of Gassmann’s fluid substitution and estimated the empirical effective stress coefficients related to the P- and S-wave velocities for rock samples from two offshore carbonate reservoirs from the presalt section, Santos Basin. We observed that Gassmann’s equation predicts quite well the effects of fluid replacement, and we found that the effective stress coefficient is less than one and not equal to the Biot-Willis coefficient. Moreover, there is a good agreement between the static and dynamic Biot-Willis coefficient, which is a suggestion that the presalt rocks behave as a poroelastic media. These observations suggest that more accurate time-lapse studies require the estimation of the effective stress coefficient for the particular reservoir of interest.


  • New Experimental Results on Dynamic Biot Coefficient on Brazilian Reservoir Rocks

    by Guilherme F. Vasquez, Márcio J. Morschbaher, Julio C. R. Justen, Ana Júlia P. P. M. Silveira

    Predicting or estimating pore pressure from seismic data is a common goal on exploration and reservoir geophysics. In exploration there is the important issue of abnormal pore pressure prediction in order to assist on a better well drilling program, avoiding unnecessary costs and also dangerous hazards associated to unexpected high pore pressure zones. During the production phase, time lapse seismic interpretation may help to improve and update the reservoir model if one can estimate both pore pressures and saturation changes from 4D data. The use of seismic data or acoustic well logs to estimate pore pressure relies essentially on the fact that the seismic-wave velocities are sensitive to the effective stress. Generally the effective stress is assumed to be the difference between overburden stresses and pore pressure, as a first approximation. This is a good approximation for loose sands and other unconsolidated reservoirs, but may fail even in weakly cemented rocks. A more refined approach is to use the Biot coefficient, or an effective stress coefficient, as a weighting parameter multiplying the pore pressure, so that the effective stress is the overburden stress minus this coefficient times the pore pressure. In this paper we present new results on the measurement of the dynamic Biot coefficient of Brazilian rocks based on the method introduced by Todd and Simmons (1972). We interpret and discuss the results in terms of rock texture and compare it to some previous results obtained on the past.

  • IMPLICAÇÕES DA INTERAÇÃO ROCHA-FLUIDO NA GEOFÍSICA DE RESERVATÓRIOS CARBONÁTICOS

    by Márcio J. Morschbacher, Guilherme F. Vasquez, Júlio C. R. Justen, Ana Júlia P. P. M. Silveira

    This paper is in Portuguese. Due to their nature, carbonate rocks are extremely sensitive to chemical reactions with fluids. Water injection in carbonate rocks for reservoir pressure maintenance may start geochemical reactions that may change the composition of the fluids and the petrophysical properties of the rock, especially when there is CO2 involved in the process. This paper presents a study addressing the impact of geochemical interactions between fluid and rock on the elastic properties of limestone reservoir rocks, resulting from CO2 and water injection. Initial modeling indicate that the geochemical effects can generate a differentiated time-lapse (4D) seismic response, going in the opposite direction when compared to conventional response due to the reservoir production only, where the oil is generally replaced by water.


  • Open Access

    A STUDY OF THE ELASTIC BEHAVIOUR PRESENTED BY DIFFERENT TYPES OF SEDIMENTARY ROCKS

    by Ana Paula O. Castro, Eliane Da Costa Alves, Guilherme F. Vasquez

    The purpose of this paper is to study the elastic behavior of the different kinds of sedimentary rocks from outcrops of the Middle-West region of the United States of America, among those, Berea sandstone from Bedford formation (Ohio), Indiana limestone from Salem formation (Indiana) and Silurian dolomite from Thornton formation (Illinois). To do so, it has been made in the Laboratório de Física de Rochas from Cenpes (Centro de Pesquisas e Desenvolvimento da Petrobras ), measurements of porosity, density and elastic wave propagation velocity presented by each type of studied rock. The wave propagation velocities were estimated by measuring the transit time ultrasonic pulses transmitted through the samples. From the results obtained, it was possible to compare the measured velocities with predictions from theoretical models, as well as to observe correlations between the petrophysical properties of rocks and its seismic behavior. Understanding these correlations helps to improve the interpretation of geophysical measurements and to improve the seismic method, which in turn has a direct impact on exploration and development activities reservoirs. Keywords: seismic velocities, elastic properties, sedimentary rocks. RESUMO. O objetivo deste trabalho é estudar o comportamento elástico de diferentes tipos de rochas sedimentares provenientes de afloramentos da região Centro-Oeste dos Estados Unidos da América, entres estas, o arenito Berea da formação Bedford (Ohio), o calcário Indiana da formação Salem (Indiana) e o dolomito Silurian da formação Thornton (Illinois). Para tanto, foram realizadas, no Laboratório de Física de Rochas do Cenpes (Centro de Pesquisas e Desenvolvimento da Petrobras), medidas de porosidade, densidade e de velocidades de propagação das ondas elásticas apresentadas por tipo de rocha estudada. As velocidades de propagação das ondas foram determinadas medindo-se o tempo de trânsito de um pulso ultrassônico de alta frequência transmitido através das amostras. A partir dos resultados obtidos, foi possível comparar as velocidades medidas com as previsões feitas a partir de modelos teóricos, assim como foi possível observar correlações existentes entre as propriedades petrofísicas das rochas e o seu comportamento sísmico. O entendimento dessas correlações contribui para a melhoria da interpretação de medidas geofísicas e para o aprimoramento do método sísmico, que por sua vez, tem impacto direto nas atividades de exploração e desenvolvimento de reservatórios. Palavras-chave: velocidades sísmicas, propriedades elásticas, rochas sedimentares.

  • Elastic wave velocity and porosity evolution under anisotropic stress conditions

    by Guilherme Vasquez, Marcio Morschbacher, Marcos Leão, Vinicius Machado

    The study of rock properties evolution with stress changes is extremely important for petroleum exploration and reservoir development. Unfortunately, even the behavior of elementary rock attributes, such as porosity, permeability and seismic velocities are not completely understood, at least for some boundary conditions. For instance, there are disagreements regarding the seismic velocity behavior under anisotropic stress conditions. Furthermore, in daily works laboratory testing for porosity, permeability and velocity usually involves only hydrostatic compression of the samples trying to reconstruct the original effective stress. Actually, even the fundamental concept of effective stress is sometimes a matter of discussion. In this paper, we present and discuss experimental results on the evolution of porosity and seismic velocities under several different stress paths. Our goal is to test some plausible boundary conditions and their influences on velocity and porosity, aiming to get an insight of the possible errors involved in adopting usual approximations and simplifications. It was observed that the velocity and porosity evolution depends on rock type (composition, texture, cementation) as well as on horizontal to vertical stress ratio.

  • Petroelasticity: Assessing Rock Properties under Stress through (Often) Non-Destructive Tests

    by Guilherme Vasquez, Marcio Morschbacher, Julio Justen, Douglas Lacerda

    The record of the transition of rock properties with stress changes is extremely important for petroleum exploration and reservoir development. Unfortunately, even the behavior of elementary rock attributes, such as porosity and seismic velocities are not completely understood, at least for some boundary conditions. For instance, there are disagreements regarding the seismic velocity behavior under anisotropic stress conditions. Some authors claim that the average effective stress is the governing parameter, while others suggest that the average method is more complex than the simple arithmetic mean. Actually, the fundamental concept of effective stress is sometimes a matter of discussion. In this paper, we present and discuss experimental results on the evolution of porosity and seismic velocities under several different stress paths. Our goal is to test some plausible boundary conditions and their influences on velocity and porosity, aiming to get an insight of the possible errors involved in adopting usual approximations and simplifications.

  • Reservoir Characterization: Which Rock Physics Input Should You Put?

    by Guilherme Vasquez

    Seismic rock physics is a powerful tool for reservoir characterization. Seismic data has a moderate resolution, but a terrific lateral and volumetric continuity, and may be the main driver for reservoir properties estimation. Reservoir seismic properties, e.g. impedances, velocities and even density, can be extracted from seismic volumes and these properties very often contains a lot of petrophysical and litological information. Nowadays there are some efforts trying to extract the petrophysical information directly from the seismic data volumes, without the intermediate step of seismic property estimation. Nevertheless, these data must be calibrated and validated with similar data obtained from more direct measurements, like sonic logs and laboratory experiments, in order to achieve a good quantitative match, no matter what inversion scheme is used. Some strength, as well as some caveats, of rock physics data will be discussed on this paper. The aim of it is not to suggest any ground truth or rule of thumb, but ratter to provoke the discussion of this interesting subject.