Raghavan Dhanasekaran
Raghavan Dhanasekaran has a total of 80 co-authors. Here are the top co-authors by number of shared publications:
M. Periyasamy
6 shared publicationsS. Muthulakshmi
5 shared publicationsB. Sargunam
Avinashilingam University for Women
4 shared publications- Muneeswaran Dhamodaran
Mount Zion College of Engineering and Technology, India
4 shared publications - Velusamy Bhanumathi
Anna University Regional Campus
4 shared publications D. Selvaraj
Sathyabama University
3 shared publications
Latest Publications
- RetractionOpen Access
- 20 May 2023
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 82 (19) , 30271
Retraction Note: Early diagnosis of Glaucoma in retinal images using multi structure descriptor and hybrid neural network classifiers
- 20 May 2023
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 82 (19) , 30271
RetractionOpen AccessRetraction Note: Early diagnosis of Glaucoma in retinal images using multi structure descriptor and hybrid neural network classifiers
- 20 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (1) , 55-63
Optimum Band ε Shaped Miniature Implantable Antennas for Telemetry Applications
An Implantable antenna appropriate for Wireless Medical Telemetry Services Band (1.39 GHz – 1.42 GHz) and ISM Band (2.4 GHz – 2.48 GHz) bio-telemetry application is presented in this paper. Meandered structure of varying width ended with spiral is employed for miniaturization. Antenna size is further reduced by a shorting pin with an overall dimension of 11mm*11mm*1.28mm and coaxial fed. The proposed antenna is designed, simulated and optimized with a layer of skin phantom model. The measured -10 dB bandwidth range from 1.395 GHz to 1.44 GHz at WMTS band and 2.3905 GHz to 2.4512GHz at ISM band. The proposed antenna shows a S11 of -25.78dB and -39.95dB at WMTS and ISM band respectively. The antenna has been simulated and found to radiate at ISM and WMTS band in free space scenario too. The proposed work is implemented using Rogers 3010 substrate and the reflection coefficient of those modules were then measured using network analyzer.
- 20 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (1) , 55-63
Optimum Band ε Shaped Miniature Implantable Antennas for Telemetry Applications
An Implantable antenna appropriate for Wireless Medical Telemetry Services Band (1.39 GHz – 1.42 GHz) and ISM Band (2.4 GHz – 2.48 GHz) bio-telemetry application is presented in this paper. Meandered structure of varying width ended with spiral is employed for miniaturization. Antenna size is further reduced by a shorting pin with an overall dimension of 11mm*11mm*1.28mm and coaxial fed. The proposed antenna is designed, simulated and optimized with a layer of skin phantom model. The measured -10 dB bandwidth range from 1.395 GHz to 1.44 GHz at WMTS band and 2.3905 GHz to 2.4512GHz at ISM band. The proposed antenna shows a S11 of -25.78dB and -39.95dB at WMTS and ISM band respectively. The antenna has been simulated and found to radiate at ISM and WMTS band in free space scenario too. The proposed work is implemented using Rogers 3010 substrate and the reflection coefficient of those modules were then measured using network analyzer.
- Open Access
- 31 January 2020
- Published by Springer Nature in Journal of Ambient Intelligence and Humanized Computing
- Vol. 11 (3) , 1045
Special issue on “Brain computing for healthcare and wellness applications”
- 31 January 2020
- Published by Springer Nature in Journal of Ambient Intelligence and Humanized Computing
- Vol. 11 (3) , 1045
Open AccessSpecial issue on “Brain computing for healthcare and wellness applications”
- 1 December 2019
- Published by Elsevier in Cognitive Systems Research
- Vol. 58, 143-155
SEAT-DSR: Spatial and energy aware trusted dynamic distance source routing algorithm for secure data communications in wireless sensor networks
- 1 December 2019
- Published by Elsevier in Cognitive Systems Research
- Vol. 58, 143-155
SEAT-DSR: Spatial and energy aware trusted dynamic distance source routing algorithm for secure data communications in wireless sensor networks
- Retracted
- 12 March 2019
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 79 (23-24) , 16915-16925
RETRACTED ARTICLE: Early diagnosis of Glaucoma in retinal images using multi structure descriptor and hybrid neural network classifiers
- 12 March 2019
- Published by Springer Nature in Multimedia Tools and Applications
- Vol. 79 (23-24) , 16915-16925
RetractedRETRACTED ARTICLE: Early diagnosis of Glaucoma in retinal images using multi structure descriptor and hybrid neural network classifiers
- Open Access
- 1 May 2017
- Published by University of Slavonski Brod in Tehnicki vjesnik - Technical Gazette
- Vol. 24 (Supplement) , 163-168
Maximization of length and lifetime of clustered industrial automation network
- 1 May 2017
- Published by University of Slavonski Brod in Tehnicki vjesnik - Technical Gazette
- Vol. 24 (Supplement) , 163-168
Open AccessMaximization of length and lifetime of clustered industrial automation network
- Open Access
- 1 September 2016
- Published by Elsevier in Journal of Advanced Research
- Vol. 7 (5) , 727-738
Effects of electromagnetic interference on the functional usage of medical equipment by 2G/3G/4G cellular phones: A review
- 1 September 2016
- Published by Elsevier in Journal of Advanced Research
- Vol. 7 (5) , 727-738
Open AccessEffects of electromagnetic interference on the functional usage of medical equipment by 2G/3G/4G cellular phones: A review
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 380-384
Improvement of speed control performance in BLDC motor using fuzzy PID controller
Brushless DC motor (BLDC) are widely used for many industrial applications because of their high efficiency, high torque and low volume. This paper focuses on speed control of BLDC motor using soft computing technique. The problems related to control systems are undesirable overshoot, longer settling times and vibrations while going from one state to another. To overcome the maximum overshoot and longer settling times, PID and self-tuning Fuzzy PID control techniques were used in the closed loop controller architecture. The speed control of BLDC motor was simulated using MATLAB/SIMULINK and the results are obtained. The simulation results revealed that the proposed self-tuning fuzzy PID controller provides better performance than conventional controller. The prototype model of BLDC motor is presented and the speed response of BLDC motor is observed by LCD display.
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 380-384
Improvement of speed control performance in BLDC motor using fuzzy PID controller
Brushless DC motor (BLDC) are widely used for many industrial applications because of their high efficiency, high torque and low volume. This paper focuses on speed control of BLDC motor using soft computing technique. The problems related to control systems are undesirable overshoot, longer settling times and vibrations while going from one state to another. To overcome the maximum overshoot and longer settling times, PID and self-tuning Fuzzy PID control techniques were used in the closed loop controller architecture. The speed control of BLDC motor was simulated using MATLAB/SIMULINK and the results are obtained. The simulation results revealed that the proposed self-tuning fuzzy PID controller provides better performance than conventional controller. The prototype model of BLDC motor is presented and the speed response of BLDC motor is observed by LCD display.
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 207-211
A review on design considerations of implantable antennas
Biotelemetry is the transmission of any physiological data from the Implantable Medical Devices (IMDs), implanted inside the human body to a remote place. These IMDs are widely used for both diagnostic and therapeutic applications. The important component used in IMDs is the miniaturized antenna that plays a crucial role in the design and development of IMDs. Numerous works have been proposed on the design of implantable antennas and the challenges related with biocompatibility, miniaturization, patient safety etc. This paper gives a review on related works carried out by various authors regarding the design of miniaturized antennas, testing and its performance evaluation in the field of biomedical telemetry.
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 207-211
A review on design considerations of implantable antennas
Biotelemetry is the transmission of any physiological data from the Implantable Medical Devices (IMDs), implanted inside the human body to a remote place. These IMDs are widely used for both diagnostic and therapeutic applications. The important component used in IMDs is the miniaturized antenna that plays a crucial role in the design and development of IMDs. Numerous works have been proposed on the design of implantable antennas and the challenges related with biocompatibility, miniaturization, patient safety etc. This paper gives a review on related works carried out by various authors regarding the design of miniaturized antennas, testing and its performance evaluation in the field of biomedical telemetry.
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 827-831
Generating capability of modified switched reluctance machine for wind energy applications
The reduced weight due to the active parts makes reluctance machines a viable candidate for electro-mechanical applications. The critical choice in wind applications are on the capability of motoring and generative characteristics. Switched reluctance machines are viable candidate as with its extended constant power range operation replacing the conventional multi-gear transmission. Recently introduced dual magnetic circuit reluctance machine configuration makes it advantageous through the magnetic flux flow control. In this paper the dual magnetic circuit reluctance machines through double rotor is presented and compared with conventional machine for its power density. Further to evaluate the dynamic performance the proposed machine is compared with that of the conventional machine of same volume. The power density is increased by 68% at any operating speed and the motor constant square density is increased by 65% The average torque in case of the proposed machine is increased by 36% compared to that of the conventional machine.
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 827-831
Generating capability of modified switched reluctance machine for wind energy applications
The reduced weight due to the active parts makes reluctance machines a viable candidate for electro-mechanical applications. The critical choice in wind applications are on the capability of motoring and generative characteristics. Switched reluctance machines are viable candidate as with its extended constant power range operation replacing the conventional multi-gear transmission. Recently introduced dual magnetic circuit reluctance machine configuration makes it advantageous through the magnetic flux flow control. In this paper the dual magnetic circuit reluctance machines through double rotor is presented and compared with conventional machine for its power density. Further to evaluate the dynamic performance the proposed machine is compared with that of the conventional machine of same volume. The power density is increased by 68% at any operating speed and the motor constant square density is increased by 65% The average torque in case of the proposed machine is increased by 36% compared to that of the conventional machine.