MHMieczysław Hajnos

Mieczysław Hajnos

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Mieczysław Hajnos has a total of 113 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Behavior of new hydroxyapatite/glucan composite in human serum

    by Leszek Borkowski, Tomasz Lübek, Mariusz Jojczuk, Adam Nogalski, Anna Belcarz, Krzysztof Palka, Mieczysław Hajnos, Grazyna Ginalska

    Biomaterials for bone tissue regeneration, including polymer‐based composites, are typically evaluated in vitro prior to the clinical trials. However, such composites tested in vivo may behave different due to the specific body conditions. For example, some composites implanted into the tissue acidified due to transient postoperative inflammation may unexpectedly swell which delays the wound healing. Such massive swelling in acidic medium was previously observed for new elastic hydroxyapatite (HAp)/β‐glucan biomaterial. However, in further clinical cases concerning the composite implantation in patients without significant inflammation indicators, no side effects were observed. Therefore, it was reasonable to test the effect of human serum of neutral pH (typical for noninflamed tissues) on the composite parameters, in particular volume changes. Thus, this article shows the characterization of physicochemical parameters of the composite after incubation (5 days) in human serum of neutral pH by means of weight and volume measurement, scanning electron microscopy, X‐ray diffraction, Fourier‐transform infrared spectroscopy, microcomputed tomography, mercury intrusion, and biochemical techniques. Results showed that human serum collected from healthy people caused no uncontrolled changes in weight and volume, porosity and mechanical properties of the composite. Therefore, this suggests the lack of volume change‐related side effects of HAp/glucan composite in bone defects treatment if postoperative inflammation is prevented. © 2018 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 106B: 2653–2664, 2018.


  • Pore size distribution and stability of ortstein and overlying horizons in podzolic soils under forest

    by Jerzy Lipiec, Ryszard Świeboda, Jacek Chodorowski, Marcin Turski, Mieczysław Hajnos


  • Influence of physico-chemical modification of waxy corn starch on changes in its structure

    by Marzena Włodarczyk-Stasiak, Artur Mazurek, Jerzy Jamroz, Mieczysław Hajnos, Zofia Sokołowska


  • Open Access

    Effect of long-term fertilizer application in maize crop growing on chemical element leaching in Fluvisol

    by Tsetska Simeonova, Dimitranka Stoicheva, Venelina Koleva, Zofia Sokołowska, Mieczysław Hajnos

    The study characterized the regime of nutrient leaching under different nitrogen and phosphorus supply of irrigated maize grown as monoculture on Fluvisol for the period 1999-2008 and additionally studied in the years 2009, 2010, and 2011. The aim of the study was to estimate the effect of longterm fertilizer application on the leaching of nutrients from the soil under maize grown as monoculture. The experiment design included four nitrogen fertilizer rates (B1-control, B5, B4, B3, B2) calculated to compensate 50, 75, 100, and 125% from the plant N uptake, respectively. The field plots were equipped with lysimeters (at 50 and 100 cm depth) for studying the relationship between the applied fertilizer rates and the nutrient concentrations in the lysimetric water. The greatest nitrogen concentration in lysimetric water was observed under variant (B3-N200 P150) throughout the study period and the highest N losses were registered (36 kg ha-1) in 2010 under the same treatment (B3). A very good correlation was found between the N rates, calcium, and magnesium losses. Lysimetric water component compensation shows that agricultural activities have only influenced the speed of weathering and had no significant effect on the rates.


  • Open Access

    Physical parameters of Fluvisols on flooded and non-flooded terraces

    by Milena Kercheva, Zofia Sokołowska, Mieczysław Hajnos, Kamil Skic, Toma Shishkov

    The heterogeneity of soil physical properties of Fluvisols, lack of large pristine areas, and different moisture regimes on non-flooded and flooded terraces impede the possibility to find a soil profile which can serve as a baseline for estimating the impact of natural or anthropogenic factors on soil evolution. The aim of this study is to compare the pore size distribution of pristine Fluvisols on flooded and non-flooded terraces using the method of the soil water retention curve, mercury intrusion porosimetry, nitrogen adsorption isotherms, and water vapour sorption. The pore size distribution of humic horizons of pristine Fluvisols on the non-flooded terrace differs from pore size distribution of Fluvisols on the flooded terrace. The peaks of textural and structural pores are higher in the humic horizons under more humid conditions. The structural characteristics of subsoil horizons depend on soil texture and evolution stage. The peaks of textural pores at about 1 mm diminish with lowering of the soil organic content. Structureless horizons are characterized by uni-modal pore size distribution. Although the content of structural pores of the subsoil horizons of Fluvisols on the non-flooded terrace is low, these pores are represented by biopores, as the coefficient of filtration is moderately high. The difference between non-flooded and flooded profiles is well expressed by the available water storage, volume and mean radius of pores, obtained by mercury intrusion porosimetry and water desorption, which are higher in the surface horizons of frequently flooded Fluvisols.


  • Open Access

    Modification of Lightweight Aggregates’ Microstructure by Used Motor Oil Addition

    by Małgorzata Franus, Grzegorz Jozefaciuk, Lidia Bandura, Krzysztof Lamorski, Mieczysław Hajnos, Wojciech Franus

    An admixture of lightweight aggregate substrates (beidellitic clay containing 10 wt % of natural clinoptilolite or Na-P1 zeolite) with used motor oil (1 wt %–8 wt %) caused marked changes in the aggregates’ microstructure, measured by a combination of mercury porosimetry (MIP), microtomography (MT), and scanning electron microscopy. Maximum porosity was produced at low (1%–2%) oil concentrations and it dropped at higher concentrations, opposite to the aggregates’ bulk density. Average pore radii, measured by MIP, decreased with an increasing oil concentration, whereas larger (MT) pore sizes tended to increase. Fractal dimension, derived from MIP data, changed similarly to the MIP pore radius, while that derived from MT remained unaltered. Solid phase density, measured by helium pycnometry, initially dropped slightly and then increased with the amount of oil added, which was most probably connected to changes in the formation of extremely small closed pores that were not available for He atoms.


  • Unexpected reaction of new HAp/glucan composite to environmental acidification: Defect or advantage?

    by Leszek Borkowski, Małgorzata Kiernicka, Anna Belcarz, Krzysztof Pałka, Mieczysław Hajnos, Grażyna Ginalska

    Natural polymer-based composites become very popular in design of biomaterials for bone tissue regeneration. Their rheological and mechanical properties are typically evaluated in vitro according to standard methods. However, in vivo such composites may behave completely different due to specific body conditions (e.g., inflammation-assisted acidification of tissue liquids). Such surprising phenomenon was observed for hydroxyapatite/β−1, 3-glucan composite during alveolus extraction socket augmentation in people. Implanted composite showed unexpected massive swelling, caused stitches loosening and wound reopening 5 days after implantation. Acidic pH was selected as a potential factor affecting this phenomenon, as all implantations are accompanied by transient local inflammation and acidification. Composite parameters were therefore studied after 5 days of soaking in acidic medium by weight and volume measurement, SEM, XRD, FTIR, microCT, and mercury intrusion techniques. Results showed significant volume increase, pore size remodelling and ceramic phase rearrangement in the composite, accompanied by change of mechanical properties. Simple quantitative correction of amount of implanted composite was sufficient to control in vivo appearance of side effects, confirming that pH-related volume increase of HAp/glucan composite is not a disqualifying factor. This strongly suggests the necessity of very detailed and individually designed tests concerning all new polymer-based composite biomaterials before clinical trials. © 2016 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 105B: 1178–1190, 2017.


  • Effect of humic acids, sesquioxides and silica on the pore system of silt aggregates measured by water vapour desorption, mercury intrusion and microtomography

    by G. Jozefaciuk, H. Czachor, K. Lamorski, M. Hajnos, R. Swieboda, W. Franus

    Summary: Most of the information on soil aggregation and porosity comes from studies of natural soil in which the effects of the different constituents that form the structure overlap. The aim of this research was to study the effects of these constituents separately on well‐characterized artificial aggregates in order to understand them better. To do this, the pore system of model silt aggregates, amended with different amounts of humic acids, iron and aluminium hydroxides or colloidal silica, was investigated at three levels of magnification with water vapour desorption (nanometre sizes), mercury intrusion (micrometre sizes) and microtomography (tens of micrometres). Humic acid and aluminium hydroxide increased aggregate porosities measured by all methods. An increase in porosity with increasing additions of each constituent was indicated only by water desorption. We did not observe any well‐defined trends in the dynamics of average pore radii. The pore surface fractal dimension determined by mercury intrusion was negatively correlated with that measured by water desorption. The pore system in granular media comprises larger voids joined by narrower necks; therefore, we attempted to relate their sizes with a novel approach that combined microtomography with mercury intrusion and extrusion data. We observed a decrease in the size of pore necks that give access to voids of the same sizes with increasing additions of all constituents. With additions of humic acid this effect was the smallest. The mercury intrusion data showed the formation of separate concretions of iron hydroxides and silica in silt aggregates.