James T. Jenkins
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
James T. Jenkins has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Michele Larcher
Faculty of Agricultural, Environmental and Food Science, Free University of Bozen-Bolzano, Bolzano, Italy
11 shared publications - Diego Berzi
Department of Civil and Environmental Engineering, Politecnico di Milano, 20133 Milano, Italy
10 shared publications - Luigi La Ragione
Politecnico di Bari
10 shared publications - Sovan Lal Das
Physical and Chemical Biology Laboratory and Department of Mechanical Engineering, Indian Institute of Technology, Palakkad, India
4 shared publications Alexandre Valance
Institut de Physique de Rennes, Univ Rennes, CNRS, UMR 6251 , 35 042 Rennes Cedex, France
2 shared publications- Alexandre Valance
Institut de Physique de Rennes Université de Rennes 1 Rennes France
2 shared publications
Latest Publications
- 9 October 2026
- Published by Springer Nature in Granular Matter
- Vol. 28 (4) , 121
The influence of wall roughness on moderately dense, gas-particle flows in a vertical pipe
- 9 October 2026
- Published by Springer Nature in Granular Matter
- Vol. 28 (4) , 121
The influence of wall roughness on moderately dense, gas-particle flows in a vertical pipe
- 15 September 2026
- Published by Cassyni
The influence of wall roughness on moderately dense, gas-particle flow in a vertical pipe.
We show that the nature of the boundaries has a strong influence on the particle and gas profiles in a steady, fully developed flow of spherical particles and a turbulent gas through a vertical, circular pipe. The boundaries considered are featureless-frictional and bumpy-frictionless. Bumpy-frictionless boundaries increase the particle velocity fluctuations and the particle pressure over those of featureless walls and are likely to stabilize the flow against the development of clusters.
- 15 September 2026
- Published by Cassyni
The influence of wall roughness on moderately dense, gas-particle flow in a vertical pipe.
We show that the nature of the boundaries has a strong influence on the particle and gas profiles in a steady, fully developed flow of spherical particles and a turbulent gas through a vertical, circular pipe. The boundaries considered are featureless-frictional and bumpy-frictionless. Bumpy-frictionless boundaries increase the particle velocity fluctuations and the particle pressure over those of featureless walls and are likely to stabilize the flow against the development of clusters.
- Open Access
- 24 August 2026
- Published by Springer Nature in Granular Matter
- Vol. 28 (4) , 96
Unphysical coefficients of sliding friction in numerical simulations of granular materials
- 24 August 2026
- Published by Springer Nature in Granular Matter
- Vol. 28 (4) , 96
Open AccessUnphysical coefficients of sliding friction in numerical simulations of granular materials
- 11 May 2026
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 11 (5)
Internal streamlines in oscillatory heap formation on a submerged particle bed
- 11 May 2026
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 11 (5)
Internal streamlines in oscillatory heap formation on a submerged particle bed
- Open Access
- 1 December 2025
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 340, 03010
Dilute gas-particle flow through a vertical axisymmetric pipe
We investigate the flow of a dilute gas-particle flow through a vertical axisymmetric pipe under the influence of gravity. A simplified gas turbulence model is considered for the flow of relatively heavy particles within the turbulent gas, whereas the particle phase is described using constitutive relations from kinetic theory. Featureless frictional and bumpy frictionless boundary conditions are applied to analyze any resulting changes in flow behaviour. We present and compare the radial profiles of mean particle and gas velocity, particle and gas velocity fluctuations, and particle concentration for the two diferent wall boundary conditions.
- 1 December 2025
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 340, 03010
Open AccessDilute gas-particle flow through a vertical axisymmetric pipe
We investigate the flow of a dilute gas-particle flow through a vertical axisymmetric pipe under the influence of gravity. A simplified gas turbulence model is considered for the flow of relatively heavy particles within the turbulent gas, whereas the particle phase is described using constitutive relations from kinetic theory. Featureless frictional and bumpy frictionless boundary conditions are applied to analyze any resulting changes in flow behaviour. We present and compare the radial profiles of mean particle and gas velocity, particle and gas velocity fluctuations, and particle concentration for the two diferent wall boundary conditions.
- 25 August 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 993, A16
Particle motion in a bed under a rigid plate, submerged and oscillated over its surface, and bed morphologies induced by flexible plates
We study the behaviour of a particle bed immersed in water when a flow generated by an oscillating plate is induced above it. We first consider a rigid plate submerged and oscillated over a particle bed. During upward motion of the plate, a portion of the bed fails, allowing particle displacement, and the bed surface to deform into a heap. We have already determined the flow of the fluid above and within the bed. This work describes the particle motion within the failed region of the bed: when the particles are mobile, they follow the fluid. We depth average the balance of mass and obtain an evolution equation for the displacement of the bed surface. We solve this equation and compare the predictions with the measurements of surface displacement in earlier experiments on rigid square plates. We carry out new experiments to measure the surface displacements under elongated plates. Elongated rigid plates behave similarly to the rigid square ones. Flexible plates produce multiple heaps. We determine that the peaks of these heaps are correlated with the flexural modes of the plates and occur at points along the bed at which the fluid pressure has its extreme values. Different plate flexural modes, resulting in different numbers of heaps, are produced by driving the plate at different frequencies. The particle motion within the bed and heap evolution under a flexible plate can be roughly described by regarding it as two or more rigid plates. We test the predictions of the theory against experiments.
- 25 August 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 993, A16
Particle motion in a bed under a rigid plate, submerged and oscillated over its surface, and bed morphologies induced by flexible plates
We study the behaviour of a particle bed immersed in water when a flow generated by an oscillating plate is induced above it. We first consider a rigid plate submerged and oscillated over a particle bed. During upward motion of the plate, a portion of the bed fails, allowing particle displacement, and the bed surface to deform into a heap. We have already determined the flow of the fluid above and within the bed. This work describes the particle motion within the failed region of the bed: when the particles are mobile, they follow the fluid. We depth average the balance of mass and obtain an evolution equation for the displacement of the bed surface. We solve this equation and compare the predictions with the measurements of surface displacement in earlier experiments on rigid square plates. We carry out new experiments to measure the surface displacements under elongated plates. Elongated rigid plates behave similarly to the rigid square ones. Flexible plates produce multiple heaps. We determine that the peaks of these heaps are correlated with the flexural modes of the plates and occur at points along the bed at which the fluid pressure has its extreme values. Different plate flexural modes, resulting in different numbers of heaps, are produced by driving the plate at different frequencies. The particle motion within the bed and heap evolution under a flexible plate can be roughly described by regarding it as two or more rigid plates. We test the predictions of the theory against experiments.
- 25 July 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 991, A15
Collisionless kinetic theory for saltation over a rigid, bumpy bed
We employ the methods of statistical mechanics to obtain closures for the balance equations of momentum and fluctuation kinetic energy that govern the ballistic motion of grains rebounding at a rigid, bumpy bed that are driven by turbulent or non-turbulent shearing fluids, in the absence of mid-trajectory collisions and fluid velocity fluctuations. We obtain semi-analytical solutions for steady and fully developed saltation over horizontal beds for the vertical profiles of particle concentration and stresses and fluid and particle velocities. These compare favourably with measurements in discrete-element numerical simulations in the wide range of conditions of Earth and other planetary environments. The predictions of the particle horizontal mass flux and its scaling with the amount of particles in the system, the properties of the carrier fluid and the intensity of the shearing also agree with numerical simulations and wind-tunnel experiments.
- 25 July 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 991, A15
Collisionless kinetic theory for saltation over a rigid, bumpy bed
We employ the methods of statistical mechanics to obtain closures for the balance equations of momentum and fluctuation kinetic energy that govern the ballistic motion of grains rebounding at a rigid, bumpy bed that are driven by turbulent or non-turbulent shearing fluids, in the absence of mid-trajectory collisions and fluid velocity fluctuations. We obtain semi-analytical solutions for steady and fully developed saltation over horizontal beds for the vertical profiles of particle concentration and stresses and fluid and particle velocities. These compare favourably with measurements in discrete-element numerical simulations in the wide range of conditions of Earth and other planetary environments. The predictions of the particle horizontal mass flux and its scaling with the amount of particles in the system, the properties of the carrier fluid and the intensity of the shearing also agree with numerical simulations and wind-tunnel experiments.
- 1 February 2024
- Published by Oxford University Press (OUP) in Quarterly Journal of Mechanics and Applied Mathematics
- Vol. 77 (1-2)
Periodic Rolling and Bumping
We consider a sphere that rolls down an inclined corrugation of identical, frictional circular cylinders in contact. We assume that the motion is a periodic succession of rolling and bumping that results in a velocity that is, on average, steady. We use balances of force and moment and impulse and momentum change to calculate the instantaneous and average velocities, the tangential and normal contact forces, and their ratio in rolling regimes that involve no sliding, some sliding and a transition between these at contact. We compare the predictions for the steady average velocity versus the inclination for different sphere to cylinders radii ratio and the predictions for the angle of inclination versus the radii ratio for stopping, initiation of sliding and loss of contact with the results of numerical simulations.
- 1 February 2024
- Published by Oxford University Press (OUP) in Quarterly Journal of Mechanics and Applied Mathematics
- Vol. 77 (1-2)
Periodic Rolling and Bumping
We consider a sphere that rolls down an inclined corrugation of identical, frictional circular cylinders in contact. We assume that the motion is a periodic succession of rolling and bumping that results in a velocity that is, on average, steady. We use balances of force and moment and impulse and momentum change to calculate the instantaneous and average velocities, the tangential and normal contact forces, and their ratio in rolling regimes that involve no sliding, some sliding and a transition between these at contact. We compare the predictions for the steady average velocity versus the inclination for different sphere to cylinders radii ratio and the predictions for the angle of inclination versus the radii ratio for stopping, initiation of sliding and loss of contact with the results of numerical simulations.
- Open Access
Granular Segregation in Gravity-Driven, Dense, Steady, Fluid–Particle Flows over Erodible Beds and Rigid, Bumpy Bases
Kinetic theory is used to propose and solve boundary value problems for fully developed, steady, dense gravity-driven flows of mixtures composed of identical inelastic spheres and water over both inclined erodible beds and rigid, bumpy bases confined by vertical sidewalls. We solve the boundary value problems assuming values of the mass density and of the size of the spheres typical of natural materials and show the numerical solutions for the profiles of the mean velocities of the particles and fluid, the intensity of the particle velocity fluctuations, and the granular concentration. In addition, we indicate how the features of the grain velocity fluctuations profile would influence segregation in three situations when the particle phase consists of two sizes of spheres: (1) the spheres are of the same material, and only gradients of temperature influence their segregation; (2) the mass densities of the material of the spheres are such that only gravity influences segregation; and (3) the mass densities are such that the coefficients of the temperature gradients and gravity segregation mechanisms are equal. For spheres of the same material, over a rigid bumpy base, the concentration of larger spheres increases from zero at the bed to the maximum value at the top of the flow; while over an erodible bed, this concentration has its maximum value at both the bed and the top of the flow.
Open AccessGranular Segregation in Gravity-Driven, Dense, Steady, Fluid–Particle Flows over Erodible Beds and Rigid, Bumpy Bases
Kinetic theory is used to propose and solve boundary value problems for fully developed, steady, dense gravity-driven flows of mixtures composed of identical inelastic spheres and water over both inclined erodible beds and rigid, bumpy bases confined by vertical sidewalls. We solve the boundary value problems assuming values of the mass density and of the size of the spheres typical of natural materials and show the numerical solutions for the profiles of the mean velocities of the particles and fluid, the intensity of the particle velocity fluctuations, and the granular concentration. In addition, we indicate how the features of the grain velocity fluctuations profile would influence segregation in three situations when the particle phase consists of two sizes of spheres: (1) the spheres are of the same material, and only gradients of temperature influence their segregation; (2) the mass densities of the material of the spheres are such that only gravity influences segregation; and (3) the mass densities are such that the coefficients of the temperature gradients and gravity segregation mechanisms are equal. For spheres of the same material, over a rigid bumpy base, the concentration of larger spheres increases from zero at the bed to the maximum value at the top of the flow; while over an erodible bed, this concentration has its maximum value at both the bed and the top of the flow.
- 5 July 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (7) , L072301
Granular flow through a vertical axisymmetric pipe
We study steady, fully developed, axisymmetric flows of soft, inelastic grains within a vertical circular pipe under the influence of gravity. We use extended kinetic theory to describe the collisional flow and include a region above the critical solid volume fraction near the center line that is the analog of an erodible bed. We calculate the profiles of velocity, shear stress, granular temperature, and particle concentration across the pipe for a variety of volume flow rates and pipe radii. We compare these with those measured in discrete element simulations by Barker et al. [ J. Fluid Mech. 930, A21 (2022)] and see good agreement.
- 5 July 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (7) , L072301
Granular flow through a vertical axisymmetric pipe
We study steady, fully developed, axisymmetric flows of soft, inelastic grains within a vertical circular pipe under the influence of gravity. We use extended kinetic theory to describe the collisional flow and include a region above the critical solid volume fraction near the center line that is the analog of an erodible bed. We calculate the profiles of velocity, shear stress, granular temperature, and particle concentration across the pipe for a variety of volume flow rates and pipe radii. We compare these with those measured in discrete element simulations by Barker et al. [ J. Fluid Mech. 930, A21 (2022)] and see good agreement.