BBBraham Barkat

Braham Barkat

*This is an algorithmically generated author record based on publicly available information.

Braham Barkat has a total of 62 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Analysis of partial discharge in air using emitted electromagnetic waves and the HFCT method

    by F. A. Nugraha, N. Harid, B. Barkat, N. Al Sayari, S. Jayaram, H. Griffiths

    Recently, non-contact radio-frequency (RF) methods have shown promising potential to be used as a complement to the IEC 60270 standard method for the detection and localization of partial discharge (PD) in high voltage insulation. This paper reports the results of an experimental investigation on the characteristic of partial discharge in an air gap using the (RF) method combined with the high-frequency current transformer (HFCT) method. The experiments were carried out under DC and AC high voltages and the effect of voltage polarity, voltage magnitude, and locations of the RF sensor relative to the PD source were examined. Analysis of the measured signals was carried out to classify both the frequency content of the discharge and its duration. The results show that the emitted electromagnetic signals from the AC discharge typically has its energy focused within two dominant frequency bands, while those of the DC discharge showed one dominant frequency band. The results indicate that the location of the RF sensor relative to the PD source had significant influence on the magnitude of measured PD signals.


  • Investigation of DC corona discharge properties using UHF method

    by F. A. Nugraha, N. Harid, N. Al Sayari, B. Barkat, S. Ohtsuka, K. Harada, Y. Okura, T Sonoda

    Partial Discharge (PD) measurement is well known as powerful method to identify the condition of high-voltage insulation. This paper investigates the properties of the ultra-high frequency (UHF) electromagnetic (EM) wave emanating from the air discharge (corona) under high voltage DC source. By applying both positive and negative high voltage DC ranging up to 135 kV, a rod antenna and a horn antenna were used as UHF sensors to detect any EM wave emission from PD activity and breakdown in air insulation. The experiment results show that typical PD emission signals under positive DC have higher voltage amplitude and wider burst width pulses than the typical PD emission signals under negative DC. Moreover, it is found that the first-peak of EM wave emission under positive DC has negative polarity while under negative DC has positive polarity. In addition, FFT analysis shows that this typical air discharge has dominant amplitude in frequency bands below 250MHz. Another significant result of this experiment is the inability of the horn antenna to detect the EM emission from air discharge.


  • A low-frequency passive seismic array experiment over an onshore oil field in Abu Dhabi, United Arab Emirates

    by Mohammed Y. Ali, Braham Barkat, Karl A. Berteussen, James Small

    A low-frequency passive seismic experiment using an array of 49 3C broadband seismometers was conducted over an onshore oil field in the emirate of Abu Dhabi in the United Arab Emirates. The aim of the experiment was to understand the characteristics and origins of the microseism (0.15–0.4 Hz) and microtremor (about 1–6 Hz) signals recorded, the latter having been reported as being a hydrocarbon indicator above several reservoirs in the region. The recorded array data were analyzed for their polarization, apparent velocities, and wavefront azimuths using various techniques, including spectral and time-frequency analyses, particle motion, H/V spectral ratios, and high-resolution frequency-wavenumber (f-k) analyses. In the frequency range of 0.15–0.4 Hz, the dominant feature observed consisted of double-frequency microseisms peaks generated by the nonlinear interactions of ocean waves with the shoreline along the coasts of the Arabian Sea and the Arabian Gulf. The f-k analyses confirmed that microtremor events in the frequency range of 2–3 Hz have an azimuth pointing toward a major oil pipeline and oil plant facilities to the west–southwest of the study area, as well as a motorway to the southeast. This would indicate that the microtremor events are probably caused by local sources, including the continuous movement of oil through the pipeline, the noise from oil plant facilities, as well as nearby traffic noise. This interpretation was confirmed by the polarization analysis performed on the data. The data also indicated that no clear correlation exists between the microtremor signal and local meteorological conditions. Although some body waves with an infinite apparent velocity generated by earthquakes were recorded, no other body waves that could have possibly been generated by hydrocarbon reservoirs were observed using the analyses techniques used in this study. Therefore, our results indicated that for the site under investigation, the microseism and the microtremor signals detected could not be related to the presence of hydrocarbon accumulations in the subsurface, but instead they may be attributed to local anthropogenic sources.


  • Smart electrical protection method for industries operations

    by Abdul Hasib Siddique, Braham Barkat, Majid Poshtan

    This paper describes an alternate method for performing current measurement for protection of generators and motors, particularly in the oil and gas industry. This technique involves the use of Hall Effect sensors instead of the current transformer (CT) to measure and detect fault current and different wireless communication methods to send and receive the fault signal. The paper first analyzes and asses the risks associated with the use of a conventional CT and come up with test models to further support the use of Hall Effect sensors instead. Three case studies are presented describing the use of Hall Effect sensors as tools for diagnosing the problems with each potential wireless technology. The methods of wireless communication used are analog transmission and digital transmission. For analog transmission, the modulation techniques Amplitude Modulation (AM) and Frequency Modulation (FM) are tested. Comparative studies of cost related to existing and the proposed system have also been done.


  • Statistical evaluation of a new technique for Sweep Frequency Response Analysis

    by Esam Al Murawwi, Braham Barkat, Redy Mardiana

    This paper presents a statistical evaluation of a new technique for Sweep Frequency Response Analysis (SFRA). The new technique is based on the time-frequency distribution (TFD). Unlike the Fourier transform based (SFRA) which is a 1-dimensional representation, a TFD is a 2-dimensional representation where both time and frequency are present in one plot. Moreover, a 2-dimensional cross-correlation coefficient (CRC) was used for the proposed technique instead of 1-dimentional CRC which is used for the existing SFRA method. To assess the strength of the proposed technique, Monte-Carlo simulations are used and the average 1-dimentional and 2-dimentional cross correlation coefficients are measured for both SFRA and TFD, respectively.


  • Mitigating the effect of optical back-scatter in multispectral underwater imaging

    by Halleh Mortazavi, John P. Oakley, Braham Barkat

    Spectral information of an underwater scene, which can be found from a set of underwater multispectral images, is a very useful technique for extracting information from underwater world. But, underwater imaging is problematic even in multispectral image format. The main problem is the effect of optical back-scatter, which changes the scene reflectance value in each spectral band and this causes inaccuracy in the spectral information. In this work, a filter is used to detect the level of optical back-scatter in each spectral band from a set of multispectral images. Extraction of an underwater object spectra can be done by subtracting the estimated level of optical back-scatter and scaling the remainder in each spectral band from the captured image in the corresponding band. An experiment is designed to show the performance of the proposed filter for correcting the set of multispectral underwater images and recovering the pixel spectra. The multispectral images are captured in 33 bands in clear and different levels of turbid water. The results of processing experimental images in turbid water show that the effect of optical back-scatter can be mitigated in the image of each spectral band and as a result the spectra of the object can be recovered. However, for very high level of turbid water the recovery is limited because of the effect of extinction.