Teresa Lorente
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Teresa Lorente has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Carmen Lorente
Department of Human Anatomy and Histology, University of Zaragoza, Zaragoza, Spain
7 shared publications - Pedro Lorente
Lorente Orthodontic Clinic, Zaragoza, Spain
7 shared publications - Maria Perez-Vela
Lorente Orthodontic Clinic, Zaragoza, Spain
6 shared publications - Cristina Esquinas
Department of Public Health Nursing, Mental Health and Maternal and Child Health, Faculty of Nursing, University of Barcelona, 08036 Barcelona, Spain
2 shared publications Cristina Esquinas
1 shared publicationCristina Esquinas
Valle de Hebrón Hospital Research Institute, Barcelona, Spain
1 shared publication
Latest Publications
- Open Access
- 10 October 2022
- Published by Springer Nature in Progress in Orthodontics
- Vol. 23 (1) , 1-11
Treatment of impacted or retained second molars with the miniscrew-supported pole technique: a prospective follow-up study
Background: Eruption disturbances of permanent molars are uncommon; however, it is important to treat them as soon as they are diagnosed. The main objective was to analyze the effectiveness of the “miniscrew-supported pole technique,” a surgically assisted orthodontic procedure to force the eruption of impacted/retained second molars (M2s) when there are indicators of complex molar inclusion. An observational prospective study was carried out during a 2-year period. Sociodemographic, clinical and low-dose scanner variables were taken at baseline (T0). Follow-up variables (T1) were the time between surgery and tooth eruption, radiographic measurements, debonding of buttons, failure rate of miniscrews and success rate of eruption. Results: A total of 21 patients (mean age of 13.9 years) with 24 retained/impacted M2s were recruited; 13 molars were maxillary (54.2%) and 11 (45.8%) were mandibular. Six (25%) were impacted molars and 18 (75%) primarily retained. At T0, molar angulation was mesial in six molars (25%), distal in five molars (20.8%) and 13 molars were vertically positioned (54.2%). Infraocclusion degree was moderate in four (16.7%) molars and severe in 20 (83.3%). Only three (12.5%) third molars were removed due to lack of space. All M2s managed to erupt, achieving a success rate of 100%; however, two molars of the same patient did not achieve occlusion. The period of eruption after surgery was 126.8 (117.3) days. Anatomical radicular alteration was the only variable independently related to a longer time of treatment (p = 0.027). Conclusions: The pole technique, using one mesial miniscrew and simple orthodontic mechanics, applies forces that succeed in erupting complicated retained/impacted M2s in a short period of time and with a low failure rate.
- 10 October 2022
- Published by Springer Nature in Progress in Orthodontics
- Vol. 23 (1) , 1-11
Open AccessTreatment of impacted or retained second molars with the miniscrew-supported pole technique: a prospective follow-up study
Background: Eruption disturbances of permanent molars are uncommon; however, it is important to treat them as soon as they are diagnosed. The main objective was to analyze the effectiveness of the “miniscrew-supported pole technique,” a surgically assisted orthodontic procedure to force the eruption of impacted/retained second molars (M2s) when there are indicators of complex molar inclusion. An observational prospective study was carried out during a 2-year period. Sociodemographic, clinical and low-dose scanner variables were taken at baseline (T0). Follow-up variables (T1) were the time between surgery and tooth eruption, radiographic measurements, debonding of buttons, failure rate of miniscrews and success rate of eruption. Results: A total of 21 patients (mean age of 13.9 years) with 24 retained/impacted M2s were recruited; 13 molars were maxillary (54.2%) and 11 (45.8%) were mandibular. Six (25%) were impacted molars and 18 (75%) primarily retained. At T0, molar angulation was mesial in six molars (25%), distal in five molars (20.8%) and 13 molars were vertically positioned (54.2%). Infraocclusion degree was moderate in four (16.7%) molars and severe in 20 (83.3%). Only three (12.5%) third molars were removed due to lack of space. All M2s managed to erupt, achieving a success rate of 100%; however, two molars of the same patient did not achieve occlusion. The period of eruption after surgery was 126.8 (117.3) days. Anatomical radicular alteration was the only variable independently related to a longer time of treatment (p = 0.027). Conclusions: The pole technique, using one mesial miniscrew and simple orthodontic mechanics, applies forces that succeed in erupting complicated retained/impacted M2s in a short period of time and with a low failure rate.
- 1 March 2021
- Published by Elsevier in International Orthodontics
- Vol. 19 (1) , 147-158
Miniscrew-supported pole technique: Surgical-orthodontic approach for impacted or retained second molars in adolescents
- 1 March 2021
- Published by Elsevier in International Orthodontics
- Vol. 19 (1) , 147-158
Miniscrew-supported pole technique: Surgical-orthodontic approach for impacted or retained second molars in adolescents
- 1 May 2020
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 90 (3) , 457-466
Orthodontic management of a complete and an incomplete maxillary canine-first premolar transposition
Maxillary canine and first premolar transposition is a complicated dental anomaly to treat, especially if the clinician's goal is to orthodontically move the canine into its normal position. Early diagnosis with cone-beam computed tomography simplifies the treatment of this pathology. This case report describes a patient with bilateral transposition, one complete and the other incomplete, involving the maxillary canine and the first premolar (Mx.C.1P). The orthodontic treatment involved the correction of both transpositions. In the complete transposition, the traction was mesial and upward to move the canine into a more apical position with a wider dentoalveolar process for easier crown interchange.
- 1 May 2020
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 90 (3) , 457-466
Orthodontic management of a complete and an incomplete maxillary canine-first premolar transposition
Maxillary canine and first premolar transposition is a complicated dental anomaly to treat, especially if the clinician's goal is to orthodontically move the canine into its normal position. Early diagnosis with cone-beam computed tomography simplifies the treatment of this pathology. This case report describes a patient with bilateral transposition, one complete and the other incomplete, involving the maxillary canine and the first premolar (Mx.C.1P). The orthodontic treatment involved the correction of both transpositions. In the complete transposition, the traction was mesial and upward to move the canine into a more apical position with a wider dentoalveolar process for easier crown interchange.
- 31 January 2020
- Published by Springer Nature in Journal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie
- Vol. 81 (2) , 142-149
Quad-helix compression to decompensate molar inclination prior to skeletal expansion
To demonstrate that patients without posterior crossbite (PCB) but with maxillary transverse deficiency, not previously observed due to an increased curve of Wilson, can benefit from the same palatal expansion as patients with PCB, after correction of the buccal inclination.
- 31 January 2020
- Published by Springer Nature in Journal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie
- Vol. 81 (2) , 142-149
Quad-helix compression to decompensate molar inclination prior to skeletal expansion
To demonstrate that patients without posterior crossbite (PCB) but with maxillary transverse deficiency, not previously observed due to an increased curve of Wilson, can benefit from the same palatal expansion as patients with PCB, after correction of the buccal inclination.
- Open Access
- 26 August 2019
- Published by Springer Nature in Progress in Orthodontics
- Vol. 20 (1) , 1-9
Surgical-orthodontic approach for facial rejuvenation based on a reverse facelift
Orthodontic treatment combined with a maxillomandibular advancement (MMA) can be an effective option for patients who need not only corrected occlusion but also facial rejuvenation. In this case series, two patients underwent orthodontic treatment and bimaxillary orthognathic surgery involving MMA, one of them with a counterclockwise rotation of the occlusal plane (OP). In both cases, the face was rejuvenated, a functional occlusion was established, and the posterior airway space (PAS) was widened. The facial mask ages three dimensionally. MMA should be offered to patients who have insufficient skeletal projection and are considering improving their facial appearance beyond just correcting a malocclusion problem. The reverse facelift provides more soft-tissue support, resulting in mid- and lower-face rejuvenation.
- 26 August 2019
- Published by Springer Nature in Progress in Orthodontics
- Vol. 20 (1) , 1-9
Open AccessSurgical-orthodontic approach for facial rejuvenation based on a reverse facelift
Orthodontic treatment combined with a maxillomandibular advancement (MMA) can be an effective option for patients who need not only corrected occlusion but also facial rejuvenation. In this case series, two patients underwent orthodontic treatment and bimaxillary orthognathic surgery involving MMA, one of them with a counterclockwise rotation of the occlusal plane (OP). In both cases, the face was rejuvenated, a functional occlusion was established, and the posterior airway space (PAS) was widened. The facial mask ages three dimensionally. MMA should be offered to patients who have insufficient skeletal projection and are considering improving their facial appearance beyond just correcting a malocclusion problem. The reverse facelift provides more soft-tissue support, resulting in mid- and lower-face rejuvenation.
- 1 November 2018
- Vol. 52 (11) , 589-97
Management of Deeply Impacted Molars with the Miniscrew-Supported Pole Technique.
Impacted molars occur more often in the mandibular arch than in the maxillary arch, with an overall prevalence of .01-1.8%.(1-4) The most common type of impaction, a mesially inclined molar, is also the most successfully treated.(5) Even a horizontally impacted lower second molar can be uprighted. If a molar is diagnosed in a vertical position, however, its prognosis is more compromised and ankylosis should be suspected.(5,6).
- 1 November 2018
- Vol. 52 (11) , 589-97
Management of Deeply Impacted Molars with the Miniscrew-Supported Pole Technique.
Impacted molars occur more often in the mandibular arch than in the maxillary arch, with an overall prevalence of .01-1.8%.(1-4) The most common type of impaction, a mesially inclined molar, is also the most successfully treated.(5) Even a horizontally impacted lower second molar can be uprighted. If a molar is diagnosed in a vertical position, however, its prognosis is more compromised and ankylosis should be suspected.(5,6).
- 1 November 2016
- Published by Elsevier in American Journal of Orthodontics and Dentofacial Orthopedics
- Vol. 150 (5) , 876-885
Surgical and orthodontic management of maxillary canine-lateral incisor transpositions
- 1 November 2016
- Published by Elsevier in American Journal of Orthodontics and Dentofacial Orthopedics
- Vol. 150 (5) , 876-885
Surgical and orthodontic management of maxillary canine-lateral incisor transpositions