Nicolas Goubard-Bretesché
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Nicolas Goubard-Bretesché has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Frédéric Favier
ICGM Univ. Montpellier CNRS ENSCM Montpellier France
4 shared publications - Olivier Crosnier
Nantes Université, CNRS, Institut des Matériaux de Nantes Jean Rouxel
4 shared publications - Thierry Brousse
Université de Nantes, CNRS, Institut des Matériaux Jean Rouxel, IMN, F-44000 Nantes, France
3 shared publications - Gaëtan Buvat
Institut National de la RechercheScientifique - Centre EMT
2 shared publications - Nicola Pinna
Department of Chemistry and The Center for the Science of Materials Berlin, Humboldt-Universität zu Berlin, Berlin, Germany
2 shared publications Camille Douard
1 shared publication
Latest Publications
- 21 August 2019
- Published by Royal Society of Chemistry (RSC) in Materials Chemistry Frontiers
- Vol. 3 (10) , 2164-2174
A general low-temperature synthesis route to polyanionic vanadium phosphate fluoride cathode materials: AVPO4F (A = Li, Na, K) and Na3V2(PO4)2F3
A versatile wet chemistry route is reported for the synthesis of highly pure (Li, Na, K)VPO4F and Na3V2(PO4)2F3 cathode materials.
- 21 August 2019
- Published by Royal Society of Chemistry (RSC) in Materials Chemistry Frontiers
- Vol. 3 (10) , 2164-2174
A general low-temperature synthesis route to polyanionic vanadium phosphate fluoride cathode materials: AVPO4F (A = Li, Na, K) and Na3V2(PO4)2F3
A versatile wet chemistry route is reported for the synthesis of highly pure (Li, Na, K)VPO4F and Na3V2(PO4)2F3 cathode materials.
- 19 February 2019
- Published by Wiley in Chemistry – A European Journal
- Vol. 25 (24) , 6189-6195
Fluorolytic Sol–Gel Route and Electrochemical Properties of Polyanionic Transition‐Metal Phosphate Fluorides
Fluorine‐containing polyanionic compounds have attracted much attention in the last few years as potential positive electrode materials for rechargeable batteries. With their formula AaMbXcO4Yd (A=Li, Na…; M=Ti, V, Mn, Fe, Co, Ni…; X=P or S, and Y=F, OH, O), they offer a very rich chemistry and their electrochemical properties can be tuned by carefully choosing the different constituting elements. However, synthesis approaches that allow these materials to be obtained at low temperature are almost nonexistent. In this paper, the use of a nonaqueous fluorolytic sol–gel approach is reported to synthesize a tavorite‐type LiFePO4F material and its electrochemical characterization was performed. The obtained material displays an electrochemical performance that positively compares with the literature with an excellent cycling stability (115 mA h−1 g−1 after 100 cycles at C/2 rate). A slight change in the synthesis parameters allowed Li2CoPO4F to be successfully obtained, demonstrating the versatility of the reported route, which can be adapted to synthesize other fluorine‐containing polyanionic compounds, which are of great interest for energy storage applications.
- 19 February 2019
- Published by Wiley in Chemistry – A European Journal
- Vol. 25 (24) , 6189-6195
Fluorolytic Sol–Gel Route and Electrochemical Properties of Polyanionic Transition‐Metal Phosphate Fluorides
Fluorine‐containing polyanionic compounds have attracted much attention in the last few years as potential positive electrode materials for rechargeable batteries. With their formula AaMbXcO4Yd (A=Li, Na…; M=Ti, V, Mn, Fe, Co, Ni…; X=P or S, and Y=F, OH, O), they offer a very rich chemistry and their electrochemical properties can be tuned by carefully choosing the different constituting elements. However, synthesis approaches that allow these materials to be obtained at low temperature are almost nonexistent. In this paper, the use of a nonaqueous fluorolytic sol–gel approach is reported to synthesize a tavorite‐type LiFePO4F material and its electrochemical characterization was performed. The obtained material displays an electrochemical performance that positively compares with the literature with an excellent cycling stability (115 mA h−1 g−1 after 100 cycles at C/2 rate). A slight change in the synthesis parameters allowed Li2CoPO4F to be successfully obtained, demonstrating the versatility of the reported route, which can be adapted to synthesize other fluorine‐containing polyanionic compounds, which are of great interest for energy storage applications.
- 30 January 2019
- Published by Wiley in Chemistry – A European Journal
- Vol. 25 (18) , 4757-4766
Highly Dispersible Hexagonal Carbon–MoS2–Carbon Nanoplates with Hollow Sandwich Structures for Supercapacitors
MoS2, a typical layered transition‐metal dichalcogenide, is promising as an electrode material in supercapacitors. However, its low electrical conductivity could lead to limited capacitance if applied in electrochemical devices. Herein, a new nanostructure composed of hollow carbon–MoS2–carbon was successfully synthesized through an l‐cysteine‐assisted hydrothermal method by using gibbsite as a template and polydopamine as a carbon precursor. After calcination and etching of the gibbsite template, uniform hollow platelets, which were made of a sandwich‐like assembly of partial graphitic carbon and two‐dimensional layered MoS2 flakes, were obtained. The platelets showed excellent dispersibility and stability in water, and good electrical conductivity due to carbon provided by the calcination of polydopamine coatings. The hollow nanoplate morphology of the material provided a high specific surface area of 543 m2 g−1, a total pore volume of 0.677 cm3 g−1, and fairly small mesopores (≈5.3 nm). The material was applied in a symmetric supercapacitor and exhibited a specific capacitance of 248 F g−1 (0.12 F cm−2) at a constant current density of 0.1 A g−1; thus suggesting that hollow carbon–MoS2–carbon nanoplates are promising candidate materials for supercapacitors.
- 30 January 2019
- Published by Wiley in Chemistry – A European Journal
- Vol. 25 (18) , 4757-4766
Highly Dispersible Hexagonal Carbon–MoS2–Carbon Nanoplates with Hollow Sandwich Structures for Supercapacitors
MoS2, a typical layered transition‐metal dichalcogenide, is promising as an electrode material in supercapacitors. However, its low electrical conductivity could lead to limited capacitance if applied in electrochemical devices. Herein, a new nanostructure composed of hollow carbon–MoS2–carbon was successfully synthesized through an l‐cysteine‐assisted hydrothermal method by using gibbsite as a template and polydopamine as a carbon precursor. After calcination and etching of the gibbsite template, uniform hollow platelets, which were made of a sandwich‐like assembly of partial graphitic carbon and two‐dimensional layered MoS2 flakes, were obtained. The platelets showed excellent dispersibility and stability in water, and good electrical conductivity due to carbon provided by the calcination of polydopamine coatings. The hollow nanoplate morphology of the material provided a high specific surface area of 543 m2 g−1, a total pore volume of 0.677 cm3 g−1, and fairly small mesopores (≈5.3 nm). The material was applied in a symmetric supercapacitor and exhibited a specific capacitance of 248 F g−1 (0.12 F cm−2) at a constant current density of 0.1 A g−1; thus suggesting that hollow carbon–MoS2–carbon nanoplates are promising candidate materials for supercapacitors.
- 1 June 2018
- Published by Elsevier in Current Opinion in Electrochemistry
- Vol. 9, 87-94
Polycationic oxides as potential electrode materials for aqueous-based electrochemical capacitors
- 1 June 2018
- Published by Elsevier in Current Opinion in Electrochemistry
- Vol. 9, 87-94
Polycationic oxides as potential electrode materials for aqueous-based electrochemical capacitors
- 1 September 2016
- Published by Elsevier in Journal of Power Sources
- Vol. 326, 695-701
Electrochemical study of aqueous asymmetric FeWO4/MnO2 supercapacitor
- 1 September 2016
- Published by Elsevier in Journal of Power Sources
- Vol. 326, 695-701
Electrochemical study of aqueous asymmetric FeWO4/MnO2 supercapacitor
- 1 July 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 206, 458-463
Improving the Volumetric Energy Density of Supercapacitors
- 1 July 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 206, 458-463
Improving the Volumetric Energy Density of Supercapacitors