Sepideh Kashefi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sepideh Kashefi has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Abbas Shahrabadi
Research Institute of Petroleum Industry (RIPI)
2 shared publications Ahmad Bagheri
2 shared publicationsHossein Beydaghi
2 shared publications- Mohammad Nader Lotfollahi
Faculty of Chemical, Petroleum and Gas Engineering, Semnān University, Semnan, Iran
2 shared publications Parisa Salarizadeh
2 shared publicationsAbbas Shahrabadi
Exploration and Production Division, Research Institute of Petroleum Industry (RIPI), Tehran - Iran
1 shared publication
Latest Publications
- 1 February 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 295, 875-890
The effect of adding sulfonated SiO2 nanoparticles and polymer blending on properties and performance of sulfonated poly ether sulfone membrane: Fabrication and optimization
- 1 February 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 295, 875-890
The effect of adding sulfonated SiO2 nanoparticles and polymer blending on properties and performance of sulfonated poly ether sulfone membrane: Fabrication and optimization
- Open Access
- 12 January 2018
- Published by EDP Sciences in Oil & Gas Science and Technology – Revue d’IFP Energies nouvelles
- Vol. 73, 2
Investigation of Asphaltene Adsorption onto Zeolite Beta Nanoparticles to Reduce Asphaltene Deposition in a Silica Sand Pack
Zeolite beta nanoparticles were used as a new asphaltene adsorbent for reducing asphaltene deposition during fluid injection into a silica sand pack. At first, the asphaltene adsorption efficiency and capacity of zeolite beta nanoparticles were determined by UV-Vis spectrophotometer. It was found that the proper concentration of nanoparticles for asphaltene adsorption was 10 g/L and the maximum asphaltene adsorption onto zeolite beta was 1.98 mg/m2. Second, two dynamic experiments including co-injection of crude oil and n-heptane (as an asphaltene precipitant) with and without use of zeolite beta nanoparticles in the sand pack was carried out. The results showed that the use of zeolite beta nanoparticles increased the permeability ratio and outlet fluid's asphaltene content about 22% and 40% compared to without use of nanoparticles, respectively. Moreover, a model based on monolayer asphaltene adsorption onto nanoparticles and asphaltene deposition mechanisms including surface deposition, entrainment and pore throat plugging was developed to determine formation damage during co-injection of crude oil and n-heptane into the sand pack. The proposed model presented good prediction of permeability and porosity ratios with AAD% of 1.07 and 0.07, respectively.
- 12 January 2018
- Published by EDP Sciences in Oil & Gas Science and Technology – Revue d’IFP Energies nouvelles
- Vol. 73, 2
Open AccessInvestigation of Asphaltene Adsorption onto Zeolite Beta Nanoparticles to Reduce Asphaltene Deposition in a Silica Sand Pack
Zeolite beta nanoparticles were used as a new asphaltene adsorbent for reducing asphaltene deposition during fluid injection into a silica sand pack. At first, the asphaltene adsorption efficiency and capacity of zeolite beta nanoparticles were determined by UV-Vis spectrophotometer. It was found that the proper concentration of nanoparticles for asphaltene adsorption was 10 g/L and the maximum asphaltene adsorption onto zeolite beta was 1.98 mg/m2. Second, two dynamic experiments including co-injection of crude oil and n-heptane (as an asphaltene precipitant) with and without use of zeolite beta nanoparticles in the sand pack was carried out. The results showed that the use of zeolite beta nanoparticles increased the permeability ratio and outlet fluid's asphaltene content about 22% and 40% compared to without use of nanoparticles, respectively. Moreover, a model based on monolayer asphaltene adsorption onto nanoparticles and asphaltene deposition mechanisms including surface deposition, entrainment and pore throat plugging was developed to determine formation damage during co-injection of crude oil and n-heptane into the sand pack. The proposed model presented good prediction of permeability and porosity ratios with AAD% of 1.07 and 0.07, respectively.
- 8 November 2016
- Published by Springer Nature in Korean Journal of Chemical Engineering
- Vol. 33 (11) , 3273-3280
A new polymeric additive as asphaltene deposition inhibitor in CO2 core flooding
- 8 November 2016
- Published by Springer Nature in Korean Journal of Chemical Engineering
- Vol. 33 (11) , 3273-3280
A new polymeric additive as asphaltene deposition inhibitor in CO2 core flooding
- 1 November 2016
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 38 (24) , 3647-3652
Investigation of the performance of several chemical additives on inhibition of asphaltene precipitation
The inhibition effects of several chemical additives on asphaltene precipitation were investigated by the microscopic method. The additives consist of a synthesized deep eutectic solvent (SDES), a commercial inhibitor, and three surfactants, namely lauric acid, octyl phenol, and dodecyl amine. The results showed the octyl phenol with 500 mg/L concentration is similar to commercial inhibitor and later SDES had the maximum effects on delaying the asphaltene precipitation onset point. The mean particle size of asphaltene using octyl phenol, SDES, lauric acid, and dodecyl amine decreased about 55%, 41%, 24%, and 18%, respectively, compared to the oil sample without any chemical additives.
- 1 November 2016
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 38 (24) , 3647-3652
Investigation of the performance of several chemical additives on inhibition of asphaltene precipitation
The inhibition effects of several chemical additives on asphaltene precipitation were investigated by the microscopic method. The additives consist of a synthesized deep eutectic solvent (SDES), a commercial inhibitor, and three surfactants, namely lauric acid, octyl phenol, and dodecyl amine. The results showed the octyl phenol with 500 mg/L concentration is similar to commercial inhibitor and later SDES had the maximum effects on delaying the asphaltene precipitation onset point. The mean particle size of asphaltene using octyl phenol, SDES, lauric acid, and dodecyl amine decreased about 55%, 41%, 24%, and 18%, respectively, compared to the oil sample without any chemical additives.
- 21 August 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (90) , 74054-74064
Novel nanocomposite membranes based on blended sulfonated poly(ether ether ketone)/poly(vinyl alcohol) containing sulfonated graphene oxide/Fe3O4 nanosheets for DMFC applications
In this study, sulfonated graphene oxide (SGO)/Fe3O4 nanosheets were synthesized by hydrothermal method and incorporated into blend sulfonated poly(ether ether ketone) (SPEEK)/poly(vinyl alcohol) (PVA) matrix with different weight percent of (SGO)/Fe3O4 nanosheets. The performances of prepared membranes were investigated by water uptake, membrane swelling, mechanical and thermal stability, proton conductivity, methanol permeability and DMFC test. It was found that the water uptake and tensile strength of SPEEK membrane increased and proton conductivity and power density decreased by blending with PVA. Incorporation of SGO/Fe3O4 nanosheets into SPEEK/PVA matrix enhanced mechanical stability, proton conductivity and methanol barrier properties of membrane. The SPEEK/PVA/SGO/Fe3O4 nanocomposite membrane with optimal nanosheets content (5 wt%) exhibits low methanol permeability (8.83 × 10−7 cm2 s−1), high tensile strength (51.2 MPa), high proton conductivity (0.084 S cm−1 at 25 °C) and high power density (122.7 mW cm−2 at 80 °C) and suggests its potential application in DMFCs.
- 21 August 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (90) , 74054-74064
Novel nanocomposite membranes based on blended sulfonated poly(ether ether ketone)/poly(vinyl alcohol) containing sulfonated graphene oxide/Fe3O4 nanosheets for DMFC applications
In this study, sulfonated graphene oxide (SGO)/Fe3O4 nanosheets were synthesized by hydrothermal method and incorporated into blend sulfonated poly(ether ether ketone) (SPEEK)/poly(vinyl alcohol) (PVA) matrix with different weight percent of (SGO)/Fe3O4 nanosheets. The performances of prepared membranes were investigated by water uptake, membrane swelling, mechanical and thermal stability, proton conductivity, methanol permeability and DMFC test. It was found that the water uptake and tensile strength of SPEEK membrane increased and proton conductivity and power density decreased by blending with PVA. Incorporation of SGO/Fe3O4 nanosheets into SPEEK/PVA matrix enhanced mechanical stability, proton conductivity and methanol barrier properties of membrane. The SPEEK/PVA/SGO/Fe3O4 nanocomposite membrane with optimal nanosheets content (5 wt%) exhibits low methanol permeability (8.83 × 10−7 cm2 s−1), high tensile strength (51.2 MPa), high proton conductivity (0.084 S cm−1 at 25 °C) and high power density (122.7 mW cm−2 at 80 °C) and suggests its potential application in DMFCs.