LLLi Liu

Li Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Li Liu has a total of 39 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Modeling of the Influence on Effective VTH From Interface States, Short Channel Effects, and Contact Resistance in SiC MOSFETs

    by Junze Li, Qing Guo, Ce Wang, Zijian Hu, Qianhui Wu, Li Liu, Jiangbin Wan, Hongyi Xu, Hengyu Wang, Na Ren, et al.

    The poor interface of silicon carbide (SiC)/SiO $_{\text{2}}$ combined with the short channel effects (SCEs) and source contact resistance, collectively impacts the effective threshold voltage in SiC MOSFETs. In this work, a physical discrete channel model was proposed to analyze the influence of the combined effects of varying channel lengths, as well as applied drain and gate voltages. The proposed model was validated through TCAD simulation and by the fabricated SiC power MOSFETs. This model was applicable to MOSFETs with both symmetric and asymmetric channels considering various interface state density distributions. The influence of these factors on effective threshold voltage was also discussed considering variations in source contact resistance and channel doping concentration. Through the analysis of the model results, it was found that the interface states significantly impact the effective threshold voltage through different mechanisms while the SCEs are mitigated by the unsaturated interface states.


  • 1.43 kV 4H-SiC Lateral Junction Barrier Schottky Diode With High BFOM (390 MW/cm2)

    by Li Liu, Jue Wang, Na Ren, Qing Guo, Kuang Sheng

    In this letter, 4H-SiC high-voltage lateral junction barrier Schottky (LJBS) diodes are optimized by simulation and demonstrated experimentally. With the utilization of the DOUBLE-RESURFs structure, the devices have a more balanced electric field distribution, thereby enhancing the blocking ability. For three design values of the drift region length LD (10μm, 12μm and 15μm), the devices exhibit the maximum breakdown voltages ( BVMAX ) ranging from 1210 V to 1650 V. Moreover, Baliga’s figure of merit ( BFOM ) of 390 MW/cm 2 with a specific ON-resistance ( RON,sp ) of 5.25 mω·cm 2 has been achieved for the 1430 V device, which is the best performance compared to the reported SiC lateral power devices. Such an improvement brings enormous potential to the development of SiC monolithic power integrated circuits.


  • Design and Experimental Demonstration of 4H-SiC Lateral High-Voltage MOSFETs With Double-RESURFs Technology for Power ICs

    by Li Liu, Qing Guo, Jue Wang, Miaoguang Bai, Junze Li, Na Ren, Kuang Sheng

    This work demonstrates 4H-SiC high voltage lateral MOSFETs with double-reduced surface fields (RESURFs) technology. The device design has been performed to balance electric field distribution and to enhance the blocking capability. Consequently, the experimental results show a significant improvement in breakdown voltage (BV), with the highest BV reaching 1800 V. A Baliga’s figure of merit (BFOM) of 128 MW/cm $^{\text{2}}$ has been achieved, which is the best performance among the reported SiC lateral MOSFETs. Detailed analysis are, furthermore, conducted to study the effects of the p-top RESURF length and the drift region length on both on-and blocking-performance. The device capacitance characteristics are also presented. These 4H-SiC lateral MOSFETs can be attractive candidates for power IC applications.


  • 1.2-kV Planar SiC MOSFETs With Improved Short-Circuit Capability by Adding Plasma Spreading Layer

    by Chaobiao Lin, Na Ren, Hongyi Xu, Li Liu, Zhengyun Zhu, Kuang Sheng

    In this article, a structure design concept plasma spreading layer (PSL) has been introduced into planar silicon carbide (SiC) MOSFETs. Devices’ static characteristics, gate–drain capacitance ( $\textit{C}_{\text{gd}}\text{)}$ , and short-circuit (SC) robustness are studied with experiments. The PSL structure can increase the breakdown voltage (BV) and reduce $\textit{C}_{\text{gd}}$ of the devices. The MOSFETs with the PSL exhibit an 11.6% higher Baliga’s figure of merit (BFOM) and a 75% higher 1/high-frequency figures-of-merit (HF-FOM). Moreover, they have better SC robustness by 60%, 67%, and 33% under 400-, 600-, and 800-V dc bus voltage than that of the traditional one. Combined with the experimental data and the 3-D simulation results, the MOSFETs with the PSL have enhanced JFET effects, which reduces the electric potential, SC current density, and electric field in the JFET region during the SC process, so as to enhance the SC robustness. The SC failure mechanisms are studied with emission microscope (EMMI) analysis, focused ion beam (FIB) observation, and simulations.


  • 4H-SiC Trench Gate Lateral MOSFET With Dual Source Trenches for Improved Performance and Reliability

    by Hengyu Wang, Baozhu Wang, Lingxu Kong, Li Liu, Hu Chen, Teng Long, Florin Udrea, Kuang Sheng

    The SiC trench gate lateral MOSFET featuring dual source trenches is proposed in this work. 2D numerical simulations by TCAD are conducted to study the performance and the reliability of the proposed structure and the conventional ones. With the trench gate, the device specific ON-resistance is reduced by more than 50% compared to that of the planar gate device. The device with proposed dual source trenches can also prevent the Pwell punch through problem that occurs in conventional lateral LMOS. As a result, a blocking voltage over 1200V can be achieved with the proposed structure. The proposed devices have two types of configurations. Compared with the configuration of double shallow trenches, the configuration of deep and shallow trenches can mitigate the curvature effect near the P+ source region by increasing the effective curvature radius. As a result, the RESURF doping and epi thickness windows are both expanded by 1.5W. Furthermore, as the deep source trenches push the electric field away from the gate trench, the off-state oxide field is effectively reduced to below 3MV/cm. Thus, the long-term reliability is substantially improved. In addition, the deep and shallow source trench configuration provides the enhanced screen effect and hence lowers the gate charge by 50%. Faster switching can be achieved with this structure.


  • The Impact of the Hexagonal and Circular Cell Designs on the Characteristics and Ruggedness for 4H-SiC MPS Diodes

    by Li Liu, Jiupeng Wu, Hongyi Xu, Zhengyun Zhu, Na Ren, Qing Guo, Junming Zhang, Kuang Sheng

    In this article, SiC Merged PiN Schottky (MPS) diodes with hexagonal and circular cell designs are investigated and compared in terms of characteristics and ruggedness. It is demonstrated by experimental and simulated methods that the circular cell design brings better performance than the hexagonal one. Owing to the almost simultaneously triggering of the P+ island and the P+ ring of the circular cell under high current stress, the current distribution is more balanced, which significantly reduces forward voltage ( $V_{F}$ ) and lower energy-dissipated heat, and further enhances the surge current capability. Moreover, the circular shape can relieve the curvature effect and electric field crowding under reverse blocking conditions, thereby improving breakdown voltage (BV) and avalanche capability. These results suggest that circular cell design can be employed to improve the performance and ruggedness of the SiC MPS diodes.


  • Open Access

    A novel 4H-SiC ESD protection device with improved robustness

    by Shuai-Jun Chang, Hai-Lun Ma, Hao Li, Shu-Ji Ou, Jian-Fei Guo, Ming-Hao Zhong, Li Liu

    2020年,韩国学者以4H-SiC材料为基底提出了一种新型ESD防护器件HHFGNMOS (high holding voltage floating gate NMOSFET),此结构显著改善了4H-SiC GGNMOS (grounded-gate NMOSFET)因SiC材料特性导致的剧烈回滞现象。但是在HHFGNMOS结构中仍存在电流分布过于密集的问题。在本文中首次将Comb-like结构用于HHFGNMOS防护器件,将器件的漏区底部进行梳型改造,充分利用电流集边效应使电流分布变得均匀,并通过TCAD仿真给出了Comb-like结构的设计变量对结构性能的影响。基于4H-SiC的GGNMOS、HHFGNMOS、Comb-like HHFGNMOS在TLP脉冲下的瞬态仿真结果显示,Comb-like HHFGNMOS的二次失效电流IT2相比GGNMOS以及HHFGNMOS由17A提高到22A,提高了29%;此外Comb-like HHFGNMOS回滞相比GGNMOS及HHFGNMOS减小了55.2%和5%。因此在面积不变、工艺相兼容的情况下较大程度改善了器件的鲁棒性,减小了回滞效应。

  • Sidewall-Implanted Trench Termination for 4H-SiC Devices With High Breakdown Voltage and Low Leakage Current

    by Li Liu, Jue Wang, Hengyu Wang, Na Ren, Qing Guo, Kuang Sheng

    In this letter, a sidewall-implanted trench termination for SiC devices is proposed and experimentally demonstrated. With the p-type sidewall region implemented by tilted ion implantation, the electric field crowding at the edge of the main junction can be alleviated. Compared with the conventional trench termination, devices with the fabricated sidewall-implanted trench termination exhibits a higher breakdown voltage ( BV ) exceeding 1800V, as well as lower leakage current. Moreover, the minimum trench width for over 1800V blocking is significantly reduced from $14~\mu \text{m}$ to $5~\mu \text{m}$ . In addition, the sidewall-implanted trench termination shows stronger robustness as the dominant current path is relocated from the trench sidewall to the whole active region.


  • Plasma Spreading Layers: An Effective Method for Improving Surge and Avalanche Robustness of SiC Devices

    by Na Ren, Li Liu, Jiupeng Wu, Kuang Sheng

    This article investigates the reliability issues of silicon carbide (SiC) merged p-i-n Schottky (MPS) diodes. Aiming at the current imbalance issue in surge event and electric field crowding issue under avalanche shock for MPS diodes, plasma spreading layer (PSL) structure is proposed and its performance in alleviating such issues are studied via simulation and experiments. From the simulation, the PSL structure can provide an interconnection between P+ hexagonal islands and P+ rings, and allow bipolar current to spread from the wide P+ region to the other parts of the device during the surge pulse. Under avalanche shock, the PSL structure can relieve the electric field crowding at the corners of the P+ hexagonal island/ring. In both cases, it can relieve the current crowding issue and increase the effective energy dissipating area. It is demonstrated by the experimental results that adding PSL structure can improve both surge and avalanche reliability. Different configurations of PSL (i.e., P+ cross lines and P+ diagonal lines) are studied. The P+ cross-line configuration is proved to have ~20% improvement in surge capability, and the other one achieves ~11% improvement in avalanche capability. The PSL concept can also be applied to optimizing P well/P+ layers in SiC MOSFET for its robustness enhancement.


  • Methodology for Enhanced Surge Robustness of 1.2-kV SiC MOSFET Body Diode

    by Hongyi Xu, Na Ren, Zhengyun Zhu, Jiupeng Wu, Li Liu, Qing Guo, Kuang Sheng

    In this work, the influences of P-well design and turn-off gate-to-source bias on the surge robustness of SiC MOSFET’s body diode are studied. Devices with high and low P-well doping concentration designs are stressed with surge current pulses when the gate-to-source is biased with 0 or −5 V. The gate-to-source bias is found to have effects on the surge capability of the low P-well doping-designed device. In the case of 0-V bias, the channel is prone to turning on and acquires a higher surge capability than the devices under the −5 V. On the other hand, the surge capability of high P-well doping-designed device is found less influenced by the gate-to-source bias. Furthermore, threshold voltage instability after repetitive surge pulses is also investigated. The device with low P-well doping shows better threshold stability due to its lower interface trap density. Based on the results above, a design methodology is proposed from the view of device mechanism and operation condition. Relatively low P-well doping design and negative gate bias are recommended for SiC MOSFET, as they can improve the single-pulse surge robustness of body diode and minimize the threshold voltage instability in repetitive surge pulse events.