Ariadne C. Catto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Ariadne C. Catto has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Luis Fernando da Silva
Federal University of Sao Carlos (UFSCar)
13 shared publications - Elson Longo
Federal University of Sao Carlos (UFSCar)
12 shared publications - Valmor Roberto Mastelaro
University of São Paulo P.O. Box 369
9 shared publications Khalifa Aguir
8 shared publications- Sandrine Bernardini
Aix Marseille Univ, CNRS, IM2NP, Marseille, France
6 shared publications Waldir Avansi
Department of Physics, Laboratory of Nanostructured Multifunctional Materials, Federal University of São Carlos Washington Luiz Road km 235 13565‐905 São Carlos SP Brazil
5 shared publications
Latest Publications
- Open Access
The Role of Zn Ions in the Structural, Surface, and Gas-Sensing Properties of SnO2:Zn Nanocrystals Synthesized via a Microwave-Assisted Route
Although semiconducting metal oxide (SMOx) nanoparticles (NPs) have attracted attention as sensing materials, the methodologies available to synthesize them with desirable properties are quite limited and/or often require relatively high energy consumption. Thus, we report herein the processing of Zn-doped SnO2 NPs via a microwave-assisted nonaqueous route at a relatively low temperature (160 °C) and with a short treatment time (20 min). In addition, the effects of adding Zn in the structural, electronic, and gas-sensing properties of SnO2 NPs were investigated. X-ray diffraction and high-resolution transmission electron microscopy analyses revealed the single-phase of rutile SnO2, with an average crystal size of 7 nm. X-ray absorption near edge spectroscopy measurements revealed the homogenous incorporation of Zn ions into the SnO2 network. Gas sensing tests showed that Zn-doped SnO2 NPs were highly sensitive to sub-ppm levels of NO2 gas at 150 °C, with good recovery and stability even under ambient moisture. We observed an increase in the response of the Zn-doped sample of up to 100 times compared to the pristine one. This enhancement in the gas-sensing performance was linked to the Zn ions that provided more surface oxygen defects acting as active sites for the NO2 adsorption on the sensing material.
Open AccessThe Role of Zn Ions in the Structural, Surface, and Gas-Sensing Properties of SnO2:Zn Nanocrystals Synthesized via a Microwave-Assisted Route
Although semiconducting metal oxide (SMOx) nanoparticles (NPs) have attracted attention as sensing materials, the methodologies available to synthesize them with desirable properties are quite limited and/or often require relatively high energy consumption. Thus, we report herein the processing of Zn-doped SnO2 NPs via a microwave-assisted nonaqueous route at a relatively low temperature (160 °C) and with a short treatment time (20 min). In addition, the effects of adding Zn in the structural, electronic, and gas-sensing properties of SnO2 NPs were investigated. X-ray diffraction and high-resolution transmission electron microscopy analyses revealed the single-phase of rutile SnO2, with an average crystal size of 7 nm. X-ray absorption near edge spectroscopy measurements revealed the homogenous incorporation of Zn ions into the SnO2 network. Gas sensing tests showed that Zn-doped SnO2 NPs were highly sensitive to sub-ppm levels of NO2 gas at 150 °C, with good recovery and stability even under ambient moisture. We observed an increase in the response of the Zn-doped sample of up to 100 times compared to the pristine one. This enhancement in the gas-sensing performance was linked to the Zn ions that provided more surface oxygen defects acting as active sites for the NO2 adsorption on the sensing material.
- 1 June 2019
- Published by Elsevier in Applied Surface Science
- Vol. 478, 347-354
Highly selective ozone gas sensor based on nanocrystalline Zn0.95Co0.05O thin film obtained via spray pyrolysis technique
- 1 June 2019
- Published by Elsevier in Applied Surface Science
- Vol. 478, 347-354
Highly selective ozone gas sensor based on nanocrystalline Zn0.95Co0.05O thin film obtained via spray pyrolysis technique
- 1 March 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 299, 762-771
Investigation on acid functionalization of double-walled carbon nanotubes of different lengths on the development of amperometric sensors
- 1 March 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 299, 762-771
Investigation on acid functionalization of double-walled carbon nanotubes of different lengths on the development of amperometric sensors
- 1 October 2018
- Published by Elsevier in Journal of Rare Earths
- Vol. 36 (10) , 1074-1083
Characterization and electrochemical performance of CeO2 and Eu-doped CeO2 films as a manganese redox flow battery component
- 1 October 2018
- Published by Elsevier in Journal of Rare Earths
- Vol. 36 (10) , 1074-1083
Characterization and electrochemical performance of CeO2 and Eu-doped CeO2 films as a manganese redox flow battery component
- 15 July 2018
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (21)
The Role of Nb Addition in TiO2 Nanoparticles: Phase Transition and Photocatalytic Properties
This paper reports an experimental investigation on the effects of Nb addition on the phase transformation and photocatalytic properties of TiO2 nanoparticles. Differential thermal analysis, Raman spectroscopy, X‐ray diffraction measurements reveal that Nb addition retarded the anatase‐to‐rutile phase transition. Photocatalysis experiments indicate an enhancement of the degradation of methylene blue and rhodamine B dyes with the addition of Nb to TiO2 lattice. This behavior was attributed to the presence of Nb ions acting as active sites formers as well as the removal of organic species, since the presence of hydroxyls groups remained unchanged, as revealed by X‐ray photoelectron spectroscopy.
- 15 July 2018
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (21)
The Role of Nb Addition in TiO2 Nanoparticles: Phase Transition and Photocatalytic Properties
This paper reports an experimental investigation on the effects of Nb addition on the phase transformation and photocatalytic properties of TiO2 nanoparticles. Differential thermal analysis, Raman spectroscopy, X‐ray diffraction measurements reveal that Nb addition retarded the anatase‐to‐rutile phase transition. Photocatalysis experiments indicate an enhancement of the degradation of methylene blue and rhodamine B dyes with the addition of Nb to TiO2 lattice. This behavior was attributed to the presence of Nb ions acting as active sites formers as well as the removal of organic species, since the presence of hydroxyls groups remained unchanged, as revealed by X‐ray photoelectron spectroscopy.
- 1 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 748, 411-417
Improving the ozone gas-sensing properties of CuWO4 nanoparticles
- 1 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 748, 411-417
Improving the ozone gas-sensing properties of CuWO4 nanoparticles
- 1 November 2017
- Published by Elsevier in Applied Surface Science
- Vol. 423, 743-751
rGO-ZnO nanocomposites for high electrocatalytic effect on water oxidation obtained by microwave-hydrothermal method
- 1 November 2017
- Published by Elsevier in Applied Surface Science
- Vol. 423, 743-751
rGO-ZnO nanocomposites for high electrocatalytic effect on water oxidation obtained by microwave-hydrothermal method
- 1 March 2017
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 240, 573-579
UV-enhanced ozone gas sensing response of ZnO-SnO2 heterojunctions at room temperature
- 1 March 2017
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 240, 573-579
UV-enhanced ozone gas sensing response of ZnO-SnO2 heterojunctions at room temperature
- 1 October 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 683, 186-190
Acetone gas sensor based on α-Ag2WO4 nanorods obtained via a microwave-assisted hydrothermal route
- 1 October 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 683, 186-190
Acetone gas sensor based on α-Ag2WO4 nanorods obtained via a microwave-assisted hydrothermal route
- 26 September 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (39) , 26066-26072
Local Structure and Surface Properties of CoxZn1–xO Thin Films for Ozone Gas Sensing
A detailed study of the structural, surface, and gas-sensing properties of nanostructured CoxZn1–xO films is presented. X-ray diffraction (XRD) analysis revealed a decrease in the crystallization degree with increasing Co content. The X-ray absorption near-edge structure (XANES) and X-ray photoelectron spectroscopies (XPS) revealed that the Co2+ ions preferentially occupied the Zn2+ sites and that the oxygen vacancy concentration increased as the amount of cobalt increased. Electrical measurements showed that the Co dopants not only enhanced the sensor response at low ozone levels (ca. 42 ppb) but also led to a decrease in the operating temperature and improved selectivity. The enhancement in the gas-sensing properties was attributed to the presence of oxygen vacancies, which facilitated ozone adsorption.
- 26 September 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (39) , 26066-26072
Local Structure and Surface Properties of CoxZn1–xO Thin Films for Ozone Gas Sensing
A detailed study of the structural, surface, and gas-sensing properties of nanostructured CoxZn1–xO films is presented. X-ray diffraction (XRD) analysis revealed a decrease in the crystallization degree with increasing Co content. The X-ray absorption near-edge structure (XANES) and X-ray photoelectron spectroscopies (XPS) revealed that the Co2+ ions preferentially occupied the Zn2+ sites and that the oxygen vacancy concentration increased as the amount of cobalt increased. Electrical measurements showed that the Co dopants not only enhanced the sensor response at low ozone levels (ca. 42 ppb) but also led to a decrease in the operating temperature and improved selectivity. The enhancement in the gas-sensing properties was attributed to the presence of oxygen vacancies, which facilitated ozone adsorption.