M. Pakniat
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
M. Pakniat has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Afsaneh Safavi
Department of Chemistry, Faculty of Sciences, Shiraz University, Shiraz 7194684795, Iran
4 shared publications N. Maleki
Department of Chemistry, Faculty of Sciences, Shiraz University, Shiraz 71454, Iran
2 shared publicationsA. Daneshfar
Chemistry Department, Ilam University, Ilam, Iran
1 shared publication- Javad Tashkhourian
Shiraz University
1 shared publication L. Moradi Abdoluosofi
1 shared publication- Mehrorang Ghaedi
Department of Chemistry, Yasouj University, Yasouj, 75918-74831, Iran
1 shared publication
Latest Publications
- 1 March 2011
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 187 (1-3) , 75-81
Sodium dodecyl sulfate coated alumina modified with a new Schiff's base as a uranyl ion selective adsorbent
- 1 March 2011
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 187 (1-3) , 75-81
Sodium dodecyl sulfate coated alumina modified with a new Schiff's base as a uranyl ion selective adsorbent
- 1 March 2006
- Published by Pleiades Publishing Ltd in Journal of Analytical Chemistry
- Vol. 61 (3) , 289-294
Permanent length of a stain detector with nonimmobilized reagent
A length of stain detector for reproducibly performing a variety of colorimetric analysis was designed and constructed. Hydrochloric acid and sodium hydroxide solutions containing methyl red were exploited as representative reagent and analyte for evaluating the performance of the detector. Injection of a known volume of basic solution into the acidic reagent flow generates a yellow stain at the display part of the detector. The behavior of the stain area (or length) was studied during its passage through the detector for quantitative estimation of the analyte concentration. As the area of the stain strongly depends on the sample volume rather than on analyte concentration, a mathematical method for comparing the analyte concentrations at different sample volumes is suggested. The operational principles and mechanism of the detector are simple, and anyone can easily extract analytical information from the resulting stain shape and length. The system is amenable to extension to a variety of colored chemical reactions based on the lack of a need for reagent immobilization. Up to one sample per 5 min can be analyzed with an RSD of about 4%. As low as 1 × 104 M of NaOH can be detected and measured.
- 1 March 2006
- Published by Pleiades Publishing Ltd in Journal of Analytical Chemistry
- Vol. 61 (3) , 289-294
Permanent length of a stain detector with nonimmobilized reagent
A length of stain detector for reproducibly performing a variety of colorimetric analysis was designed and constructed. Hydrochloric acid and sodium hydroxide solutions containing methyl red were exploited as representative reagent and analyte for evaluating the performance of the detector. Injection of a known volume of basic solution into the acidic reagent flow generates a yellow stain at the display part of the detector. The behavior of the stain area (or length) was studied during its passage through the detector for quantitative estimation of the analyte concentration. As the area of the stain strongly depends on the sample volume rather than on analyte concentration, a mathematical method for comparing the analyte concentrations at different sample volumes is suggested. The operational principles and mechanism of the detector are simple, and anyone can easily extract analytical information from the resulting stain shape and length. The system is amenable to extension to a variety of colored chemical reactions based on the lack of a need for reagent immobilization. Up to one sample per 5 min can be analyzed with an RSD of about 4%. As low as 1 × 104 M of NaOH can be detected and measured.
- 1 June 1998
- Published by Taylor & Francis in Analytical Letters
- Vol. 31 (8) , 1297-1310
Length of Stain Detector for High Alkalinity Measurement
4-dimethylaminoazobenzene is covalently bonded to a transparent triacetylcellulose film. Using a flow system, the dynamic range of pH, response time and pka of the immobilized indicator were studied. Since the colour change of the membrane from its acidic to its basic form is very distinct, a length of stain detector in the shape of strips containing the modified membrane as the display part, was designed. The design is simple and inexpensive and free from all accessories needed for operation of such detectors (such as pumps, densitometers, etc……). Sodium hydroxide concentrations as low as 0.1 M can be measured with a relative standard deviation of about 5%. The membrane is stable for months.
- 1 June 1998
- Published by Taylor & Francis in Analytical Letters
- Vol. 31 (8) , 1297-1310
Length of Stain Detector for High Alkalinity Measurement
4-dimethylaminoazobenzene is covalently bonded to a transparent triacetylcellulose film. Using a flow system, the dynamic range of pH, response time and pka of the immobilized indicator were studied. Since the colour change of the membrane from its acidic to its basic form is very distinct, a length of stain detector in the shape of strips containing the modified membrane as the display part, was designed. The design is simple and inexpensive and free from all accessories needed for operation of such detectors (such as pumps, densitometers, etc……). Sodium hydroxide concentrations as low as 0.1 M can be measured with a relative standard deviation of about 5%. The membrane is stable for months.
- 20 December 1996
- Published by Elsevier in Analytica Chimica Acta
- Vol. 335 (3) , 227-233
Dipicrylamine-modified triacetylcellulose membrane for optical pH and potassium ion measurement
- 20 December 1996
- Published by Elsevier in Analytica Chimica Acta
- Vol. 335 (3) , 227-233
Dipicrylamine-modified triacetylcellulose membrane for optical pH and potassium ion measurement
- 1 December 1996
- Published by Elsevier in Analytica Chimica Acta
- Vol. 335 (3) , 275-282
Design and construction of a flow system for determination of Cu(II) ions in water by means of a chemically modified carbon paste electrode
- 1 December 1996
- Published by Elsevier in Analytica Chimica Acta
- Vol. 335 (3) , 275-282
Design and construction of a flow system for determination of Cu(II) ions in water by means of a chemically modified carbon paste electrode
- 1 February 1994
- Published by Elsevier in Analytica Chimica Acta
- Vol. 286 (2) , 225-232
Construction and design of a gas-sensing detector capable of handling and determining sulphur- and phosphorus-containing gaseous samples
- 1 February 1994
- Published by Elsevier in Analytica Chimica Acta
- Vol. 286 (2) , 225-232
Construction and design of a gas-sensing detector capable of handling and determining sulphur- and phosphorus-containing gaseous samples