Kun Guo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kun Guo has a total of 50 co-authors. Here are the top co-authors by number of shared publications:
- Korneel Rabaey
Center for Advanced Process Technology for Urban Resource Recovery (CAPTURE), Frieda Saeysstraat 1, Ghent, East Flanders 9052, Belgium
10 shared publications Dongsheng Shen
School of Environmental Science and Engineering, Zhejiang Gongshang University, Hangzhou, 310012, China
7 shared publicationsHuajun Feng
6 shared publicationsYuxiang Liang
School of Environmental Science and Engineering, Zhejiang Gongshang University, Hangzhou, 310012, China
6 shared publicationsAntonin Prévoteau
5 shared publications- Sunil A. Patil
Department of Earth and Environmental Sciences, Indian Institute of Science Education and Research Mohali (IISER Mohali), Sector 81, S.A.S. Nagar, Manauli PO, 140306 Punjab, India
5 shared publications
Latest Publications
- 25 September 2017
- Published by Springer Nature in Applied Microbiology and Biotechnology
- Vol. 101 (21) , 7997-8005
The impact of electron donors and anode potentials on the anode-respiring bacteria community
Both anode potentials and substrates can affect the process of biofilm formation in bioelectrochemical systems, but it is unclear who primarily determine the anode-respiring bacteria (ARB) community structure and composition. To address this issue, we divided microbial electrolysis cells (MECs) into groups, feeding them with different substrates and culturing them at various potentials. Non-turnover cyclic voltammetry indicated that the extracellular electron transfer components were uniform when feeding acetate, because the same oxidation peaks occurred at − 0.36 ± 0.01 and − 0.17 ± 0.01 V (vs. Ag/AgCl). Illumina MiSeq sequencing revealed that the dominating ARB was Geobacter, which did not change with different potentials. When the MECs were cultured with sucrose and mixed substrates, oxidation peak P3 (− 0.29 ± 0.015 V) occurred at potentials of − 0.29 and 0.01 V. This may be because of the appearance of Unclassified_AKYG597. In addition, oxidation peak P4 (− 0.99 ± 0.01 V) occurred at high and low potentials (0.61 and − 0.45 V, respectively), and the maximum current densities were far below those of the middle potentials. Illumina MiSeq sequencing showed that fermentation microorganisms (Lactococcus and Sphaerochaeta) dominated the biofilms. Consequently, substrate primarily determined the dominating ARB, and Geobacter invariably dominated the acetate-fed biofilms with potentials changed. Conversely, different potentials mainly affected fermentable substrate-fed biofilms, with dominating ARB turning into Unclassified_AKYG59.
- 25 September 2017
- Published by Springer Nature in Applied Microbiology and Biotechnology
- Vol. 101 (21) , 7997-8005
The impact of electron donors and anode potentials on the anode-respiring bacteria community
Both anode potentials and substrates can affect the process of biofilm formation in bioelectrochemical systems, but it is unclear who primarily determine the anode-respiring bacteria (ARB) community structure and composition. To address this issue, we divided microbial electrolysis cells (MECs) into groups, feeding them with different substrates and culturing them at various potentials. Non-turnover cyclic voltammetry indicated that the extracellular electron transfer components were uniform when feeding acetate, because the same oxidation peaks occurred at − 0.36 ± 0.01 and − 0.17 ± 0.01 V (vs. Ag/AgCl). Illumina MiSeq sequencing revealed that the dominating ARB was Geobacter, which did not change with different potentials. When the MECs were cultured with sucrose and mixed substrates, oxidation peak P3 (− 0.29 ± 0.015 V) occurred at potentials of − 0.29 and 0.01 V. This may be because of the appearance of Unclassified_AKYG597. In addition, oxidation peak P4 (− 0.99 ± 0.01 V) occurred at high and low potentials (0.61 and − 0.45 V, respectively), and the maximum current densities were far below those of the middle potentials. Illumina MiSeq sequencing showed that fermentation microorganisms (Lactococcus and Sphaerochaeta) dominated the biofilms. Consequently, substrate primarily determined the dominating ARB, and Geobacter invariably dominated the acetate-fed biofilms with potentials changed. Conversely, different potentials mainly affected fermentable substrate-fed biofilms, with dominating ARB turning into Unclassified_AKYG59.
- Open Access
- 1 August 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 1-10
Carbon black as an alternative cathode material for electrical energy recovery and transfer in a microbial battery
Rather than the conventional concept of viewing conductive carbon black (CB) to be chemically inert in microbial electrochemical cells (MECs), here we confirmed the redox activity of CB for its feasibility as an electron sink in the microbial battery (MB). Acting as the cathode of a MB, the solid-state CB electrode showed the highest electron capacity equivalent of 18.58 ± 0.46 C/g for the unsintered one and the lowest capacity of 2.29 ± 0.48 C/g for the one sintered under 100% N2atmosphere. The capacity vibrations of CBs were strongly in coincidence with the abundances of C=O moiety caused by different pretreatments and it implied one plausible mechanism based on CB’s surface functionality for its electron capturing. Once subjected to electron saturation, CB could be completely regenerated by different strategies in terms of electrochemical discharging or donating electrons to biologically-catalyzed nitrate reduction. Surface characterization also revealed that CB’s regeneration fully depended on the reversible shift of C=O moiety, further confirming the functionality-based mechanism for CB’s feasibility as the role of MB’s cathode. Moreover, resilience tests demonstrated that CB cathode was robust for the multi-cycles charging-discharging operations. These results imply that CB is a promising alternative material for the solid-state cathode in MBs.
- 1 August 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 1-10
Open AccessCarbon black as an alternative cathode material for electrical energy recovery and transfer in a microbial battery
Rather than the conventional concept of viewing conductive carbon black (CB) to be chemically inert in microbial electrochemical cells (MECs), here we confirmed the redox activity of CB for its feasibility as an electron sink in the microbial battery (MB). Acting as the cathode of a MB, the solid-state CB electrode showed the highest electron capacity equivalent of 18.58 ± 0.46 C/g for the unsintered one and the lowest capacity of 2.29 ± 0.48 C/g for the one sintered under 100% N2atmosphere. The capacity vibrations of CBs were strongly in coincidence with the abundances of C=O moiety caused by different pretreatments and it implied one plausible mechanism based on CB’s surface functionality for its electron capturing. Once subjected to electron saturation, CB could be completely regenerated by different strategies in terms of electrochemical discharging or donating electrons to biologically-catalyzed nitrate reduction. Surface characterization also revealed that CB’s regeneration fully depended on the reversible shift of C=O moiety, further confirming the functionality-based mechanism for CB’s feasibility as the role of MB’s cathode. Moreover, resilience tests demonstrated that CB cathode was robust for the multi-cycles charging-discharging operations. These results imply that CB is a promising alternative material for the solid-state cathode in MBs.
- 1 July 2017
- Published by Elsevier in Journal of Power Sources
- Vol. 356, 484-490
A novel tubular microbial electrolysis cell for high rate hydrogen production
- 1 July 2017
- Published by Elsevier in Journal of Power Sources
- Vol. 356, 484-490
A novel tubular microbial electrolysis cell for high rate hydrogen production
- 27 February 2017
- Published by Wiley in ChemElectroChem
- Vol. 4 (5) , 1026-1036
Rapid and Quantitative Assessment of Redox Conduction Across Electroactive Biofilms by using Double Potential Step Chronoamperometry
The mechanism of electron transport across electroactive biofilms (EABs) is of high interest and still a matter of debate. Quantitative assessments of their redox conduction take considerable time and require non‐turnover conditions (absence of substrate), which can be detrimental to EABs. Here, we measure the charge‐transport parameters of Geobacter spp. dominated EABs with double potential step chronoamperometry (DPSC) with Cottrell analysis. The DPSC measurement is simpler and much faster than usual techniques and allows the determination of the charge‐transport parameters even under turnover conditions. The electrochemical responses were well‐described by a model of redox conduction driven only by electron diffusion within the EAB. The apparent diffusion coefficient for the electron (Dapp) was measured as approximately 3.2×10−7 cm2 s−1, a value similar to those recorded for pure Geobacter sulfurreducens EABs, or for some redox polymers with comparable redox center concentrations. This method will be valuable for assessing the impact of EAB characteristics and environmental factors on the charge‐transport ability of the biofilm, and for determining the rate‐limiting step(s) for current production.
- 27 February 2017
- Published by Wiley in ChemElectroChem
- Vol. 4 (5) , 1026-1036
Rapid and Quantitative Assessment of Redox Conduction Across Electroactive Biofilms by using Double Potential Step Chronoamperometry
The mechanism of electron transport across electroactive biofilms (EABs) is of high interest and still a matter of debate. Quantitative assessments of their redox conduction take considerable time and require non‐turnover conditions (absence of substrate), which can be detrimental to EABs. Here, we measure the charge‐transport parameters of Geobacter spp. dominated EABs with double potential step chronoamperometry (DPSC) with Cottrell analysis. The DPSC measurement is simpler and much faster than usual techniques and allows the determination of the charge‐transport parameters even under turnover conditions. The electrochemical responses were well‐described by a model of redox conduction driven only by electron diffusion within the EAB. The apparent diffusion coefficient for the electron (Dapp) was measured as approximately 3.2×10−7 cm2 s−1, a value similar to those recorded for pure Geobacter sulfurreducens EABs, or for some redox polymers with comparable redox center concentrations. This method will be valuable for assessing the impact of EAB characteristics and environmental factors on the charge‐transport ability of the biofilm, and for determining the rate‐limiting step(s) for current production.
- 1 February 2017
- Published by Elsevier in Journal of Power Sources
- Vol. 342, 98-104
Enhancement of anodic biofilm formation and current output in microbial fuel cells by composite modification of stainless steel electrodes
- 1 February 2017
- Published by Elsevier in Journal of Power Sources
- Vol. 342, 98-104
Enhancement of anodic biofilm formation and current output in microbial fuel cells by composite modification of stainless steel electrodes
- 29 November 2016
- Published by American Chemical Society (ACS) in Environmental Science & Technology Letters
- Vol. 3 (12) , 420-424
TiO2 Nanotube Arrays Modified Titanium: A Stable, Scalable, and Cost-Effective Bioanode for Microbial Fuel Cells
- 29 November 2016
- Published by American Chemical Society (ACS) in Environmental Science & Technology Letters
- Vol. 3 (12) , 420-424
TiO2 Nanotube Arrays Modified Titanium: A Stable, Scalable, and Cost-Effective Bioanode for Microbial Fuel Cells
- 1 October 2016
- Published by Elsevier in Water Research
- Vol. 102, 428-435
Hybridization of photoanode and bioanode to enhance the current production of bioelectrochemical systems
- 1 October 2016
- Published by Elsevier in Water Research
- Vol. 102, 428-435
Hybridization of photoanode and bioanode to enhance the current production of bioelectrochemical systems
- 1 July 2016
- Published by Elsevier in Bioresource Technology
- Vol. 211, 664-668
Pyrolytic carbon-coated stainless steel felt as a high-performance anode for bioelectrochemical systems
- 1 July 2016
- Published by Elsevier in Bioresource Technology
- Vol. 211, 664-668
Pyrolytic carbon-coated stainless steel felt as a high-performance anode for bioelectrochemical systems
- 1 December 2015
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 300, 607-614
Addition of nitrite enhances the electrochemical defluorination of 2-fluoroaniline
- 1 December 2015
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 300, 607-614
Addition of nitrite enhances the electrochemical defluorination of 2-fluoroaniline
- 1 November 2015
- Published by Elsevier in Bioresource Technology
- Vol. 195, 46-50
Heat-treated stainless steel felt as scalable anode material for bioelectrochemical systems
- 1 November 2015
- Published by Elsevier in Bioresource Technology
- Vol. 195, 46-50
Heat-treated stainless steel felt as scalable anode material for bioelectrochemical systems