Salvatore Garozzo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Salvatore Garozzo has a total of 223 co-authors. Here are the top co-authors by number of shared publications:
- Giuseppe Romeo
INAF Osservatorio Astrofisico di Catania
31 shared publications - G. Bonanno
INAF-Osservatorio Astrofisico di Catania (Italy)
29 shared publications - Davide Marano
INAF - Osservatorio Astrofisico di Catania (Italy)
28 shared publications - Alessandro Grillo
INAF - Osservatorio Astrofisico di Catania (Italy)
22 shared publications - Sergio Billotta
INAF - Osservatorio Astrofisico di Catania (Italy)
17 shared publications - Osvaldo Catalano
Istituto Nazionale di Astrofisica (Italy)
15 shared publications
Latest Publications
- Open Access
- 1 August 2026
- Published by IOP Publishing in Publications of the Astronomical Society of the Pacific
- Vol. 138 (8) , 085001
The ASTRI-Horn Cherenkov Telescope: Technical Assessment and Calibrations Following its Refurbishment for the ASTRI Mini-Array and CTA-SST Pathfinder
The ASTRI-Horn telescope is a prototype Imaging Atmospheric Cherenkov Telescope (IACT) developed within the Astrofisica con Specchi a Tecnologia Replicante Italiana (ASTRI) project. It represents the first implementation of a dual-mirror Schwarzschild–Couder (SC) optical configuration for ground-based gamma-ray IACT observations. It also served as a testbed for the Small-Sized Telescopes (SSTs) of the Cherenkov Telescope Array Observatory (CTAO) that will host at least 37 SSTs at the Paranal site in Chile, and for the forthcoming ASTRI Mini-Array. Installed in 2014 at the INAF “M.C. Fracastoro” observing station on Mount Etna, the telescope is equipped with a SiPM-based Cherenkov camera and a complete control and data acquisition system. Between 2020 and 2022, after the demonstration of the validity of the SC configuration in observing gamma-ray sources, ASTRI-Horn underwent refurbishment activities that included mirror replacement, new optical coatings, camera upgrades, and software improvements. The telescope has since been re-validated through calibration campaigns and observational tests, including the detection and spectral characterization of the Crab Nebula at TeV energies. The results confirm the correct operation of the optical system, camera electronics, and data processing chain, providing a consolidated basis for the design and development of the ASTRI Mini-Array and future CTAO-SST telescopes.
- 1 August 2026
- Published by IOP Publishing in Publications of the Astronomical Society of the Pacific
- Vol. 138 (8) , 085001
Open AccessThe ASTRI-Horn Cherenkov Telescope: Technical Assessment and Calibrations Following its Refurbishment for the ASTRI Mini-Array and CTA-SST Pathfinder
The ASTRI-Horn telescope is a prototype Imaging Atmospheric Cherenkov Telescope (IACT) developed within the Astrofisica con Specchi a Tecnologia Replicante Italiana (ASTRI) project. It represents the first implementation of a dual-mirror Schwarzschild–Couder (SC) optical configuration for ground-based gamma-ray IACT observations. It also served as a testbed for the Small-Sized Telescopes (SSTs) of the Cherenkov Telescope Array Observatory (CTAO) that will host at least 37 SSTs at the Paranal site in Chile, and for the forthcoming ASTRI Mini-Array. Installed in 2014 at the INAF “M.C. Fracastoro” observing station on Mount Etna, the telescope is equipped with a SiPM-based Cherenkov camera and a complete control and data acquisition system. Between 2020 and 2022, after the demonstration of the validity of the SC configuration in observing gamma-ray sources, ASTRI-Horn underwent refurbishment activities that included mirror replacement, new optical coatings, camera upgrades, and software improvements. The telescope has since been re-validated through calibration campaigns and observational tests, including the detection and spectral characterization of the Crab Nebula at TeV energies. The results confirm the correct operation of the optical system, camera electronics, and data processing chain, providing a consolidated basis for the design and development of the ASTRI Mini-Array and future CTAO-SST telescopes.
- Open Access
- 6 May 2022
- Published by Elsevier in Journal of High Energy Astrophysics
- Vol. 35, 52-68
The ASTRI Mini-Array of Cherenkov telescopes at the Observatorio del Teide
- 6 May 2022
- Published by Elsevier in Journal of High Energy Astrophysics
- Vol. 35, 52-68
Open AccessThe ASTRI Mini-Array of Cherenkov telescopes at the Observatorio del Teide
- 24 December 2016
- Published by Springer Nature in Experimental Astronomy
- Vol. 43 (1) , 1-17
Procedures for the relative calibration of the SiPM gain on ASTRI SST-2M camera
- 24 December 2016
- Published by Springer Nature in Experimental Astronomy
- Vol. 43 (1) , 1-17
Procedures for the relative calibration of the SiPM gain on ASTRI SST-2M camera
- 1 October 2016
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 833, 169-180
Front-end electronics for the Muon Portal project
- 1 October 2016
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 833, 169-180
Front-end electronics for the Muon Portal project
- 27 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9906, 990645-990645-12
Temperature characterization of the CITIROC front-end chip of the ASTRI SST-2M Cherenkov camera
- 27 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9906, 990645-990645-12
Temperature characterization of the CITIROC front-end chip of the ASTRI SST-2M Cherenkov camera
- 27 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9906, 99063D-99063D-12
ASTRI SST-2M camera electronics
- 27 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9906, 99063D-99063D-12
ASTRI SST-2M camera electronics
- 18 February 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 16 (10) , 3620-3626
A New Simple and Effective Procedure for SiPM Electrical Parameter Extraction
Silicon photomultipliers (SiPMs) are emerging semiconductor-based photosensors, addressing the challenge of low-light detection down to the single-photon counting level. A design of high-performance front-end electronics for SiPM readout requires the development of accurate electrical models. Numerous SiPM reliable models have matured in recent years; however, circuit parameter extraction is rather cumbersome and involves extensive measurement steps to be performed. Starting from a recently developed model of the SiPM device coupled to the conditioning electronics, a new effective analytical procedure is, here, devised for extracting the SiPM model parameters from experimental measurements. The proposed extraction technique is applied to a 3 × 3-mm 2 SiPM sensor, and is validated by comparing SPICE simulations and measurement results. Independent cross-check validation based on experimental tests corroborates the effectiveness of the adopted extraction procedure.
- 18 February 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 16 (10) , 3620-3626
A New Simple and Effective Procedure for SiPM Electrical Parameter Extraction
Silicon photomultipliers (SiPMs) are emerging semiconductor-based photosensors, addressing the challenge of low-light detection down to the single-photon counting level. A design of high-performance front-end electronics for SiPM readout requires the development of accurate electrical models. Numerous SiPM reliable models have matured in recent years; however, circuit parameter extraction is rather cumbersome and involves extensive measurement steps to be performed. Starting from a recently developed model of the SiPM device coupled to the conditioning electronics, a new effective analytical procedure is, here, devised for extracting the SiPM model parameters from experimental measurements. The proposed extraction technique is applied to a 3 × 3-mm 2 SiPM sensor, and is validated by comparing SPICE simulations and measurement results. Independent cross-check validation based on experimental tests corroborates the effectiveness of the adopted extraction procedure.