Krzysztof Pacześniowski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Krzysztof Pacześniowski has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Andrzej Pytlik
Central Mining Institute , Katowice , Poland
2 shared publications - Pavel Marsalek
VSB—Technical University of Ostrava
2 shared publications - Piotr Kalisz
CENTRAL MINING INSTITUTE, PLAC GWARKOW 1, 40-166 KATOWICE, POLAND
2 shared publications - Karolina Nurzynska
Algorithmics and Software Division, Silesian University of Technology, 44-100 Gliwice, Poland
1 shared publication - Magdalena Zięba
Department of Geology and Geophysics and Surface Protection, Central Mining Institute–National Research Institute, 40-166 Katowice, Poland
1 shared publication - Marcin Grygierek
Department of Geotechnics and Roads, Faculty of Civil Engineering, Silesian University of Technology, Akademicka 5, 44-100 Gliwice, Poland
1 shared publication
Latest Publications
- Open Access
- 9 April 2018
- Published by EDP Sciences
- Vol. 36, 03001
Assessment of burned coal shale properties based on cyclic load
Road surfaces that are subjected to cyclic loads generated by vehicle wheels must meet the requirements concerning the durability in the assumed period of use. The durability of the layered pavement construction systems depends on the value and frequency of the load as well as on the mechanical features of its individual layers. Layers of unbound, mechanically stabilized mixtures are a significant aspect of surfaces that are susceptible. Mixtures of this type can be applied both to the subgrade layers as well as to the bottom pavement layers, including the improved course. Considering the cyclic nature of the load on the surface of the entire system, mechanically stabilized layers are subject to continuous, but slow, densification during the period of use, which results in the formation of permanent deformations and so-called structural ruts. Post-mining waste is frequently used in road construction. which is the so-called burned shale that can be used for the bottom layers of the surface and layers of the improved subgrade (soil replacement). This material was the subject of the analysis. The evaluation was based mainly on the results of pilot studies covering cyclic loads of the layer/course made of the so-called red shale. The applied research method was aimed at preliminary assessment of its suitability for the assessment of the behaviour of the disintegrated medium under the conditions of test loads simulating the movement of vehicles.
- 9 April 2018
- Published by EDP Sciences
- Vol. 36, 03001
Open AccessAssessment of burned coal shale properties based on cyclic load
Road surfaces that are subjected to cyclic loads generated by vehicle wheels must meet the requirements concerning the durability in the assumed period of use. The durability of the layered pavement construction systems depends on the value and frequency of the load as well as on the mechanical features of its individual layers. Layers of unbound, mechanically stabilized mixtures are a significant aspect of surfaces that are susceptible. Mixtures of this type can be applied both to the subgrade layers as well as to the bottom pavement layers, including the improved course. Considering the cyclic nature of the load on the surface of the entire system, mechanically stabilized layers are subject to continuous, but slow, densification during the period of use, which results in the formation of permanent deformations and so-called structural ruts. Post-mining waste is frequently used in road construction. which is the so-called burned shale that can be used for the bottom layers of the surface and layers of the improved subgrade (soil replacement). This material was the subject of the analysis. The evaluation was based mainly on the results of pilot studies covering cyclic loads of the layer/course made of the so-called red shale. The applied research method was aimed at preliminary assessment of its suitability for the assessment of the behaviour of the disintegrated medium under the conditions of test loads simulating the movement of vehicles.
- Open Access
- 1 March 2017
- Published by Walter de Gruyter GmbH in Archives of Mining Sciences
- Vol. 62 (1) , 163-176
Simulation of Laboratory Tests of Steel Arch Support
The total load-bearing capacity of steel arch yielding roadways supports is among their most important characteristics. These values can be obtained in two ways: experimental measurements in a specialized laboratory or computer modelling by FEM. Experimental measurements are significantly more expensive and more time-consuming. However, for proper tuning, a computer model is very valuable and can provide the necessary verification by experiment. In the cooperating workplaces of GIG Katowice, VSB-Technical University of Ostrava and the Institute of Geonics ASCR this verification was successful. The present article discusses the conditions and results of this verification for static problems. The output is a tuned computer model, which may be used for other calculations to obtain the load-bearing capacity of other types of steel arch supports. Changes in other parameters such as the material properties of steel, size torques, friction coefficient values etc. can be determined relatively quickly by changing the properties of the investigated steel arch supports.
- 1 March 2017
- Published by Walter de Gruyter GmbH in Archives of Mining Sciences
- Vol. 62 (1) , 163-176
Open AccessSimulation of Laboratory Tests of Steel Arch Support
The total load-bearing capacity of steel arch yielding roadways supports is among their most important characteristics. These values can be obtained in two ways: experimental measurements in a specialized laboratory or computer modelling by FEM. Experimental measurements are significantly more expensive and more time-consuming. However, for proper tuning, a computer model is very valuable and can provide the necessary verification by experiment. In the cooperating workplaces of GIG Katowice, VSB-Technical University of Ostrava and the Institute of Geonics ASCR this verification was successful. The present article discusses the conditions and results of this verification for static problems. The output is a tuned computer model, which may be used for other calculations to obtain the load-bearing capacity of other types of steel arch supports. Changes in other parameters such as the material properties of steel, size torques, friction coefficient values etc. can be determined relatively quickly by changing the properties of the investigated steel arch supports.
- 29 July 2016
- Published by Taylor & Francis
- p. 897-899
Total load-bearing capacity of yielding steel arch supports
- 29 July 2016
- Published by Taylor & Francis
- p. 897-899
Total load-bearing capacity of yielding steel arch supports
- Open Access
- 29 October 2012
- Published by Polish Academy of Sciences Chancellery in Archives of Mining Sciences
- Vol. 57 (1) , 107-119
Application of trenchless methods for pipelines renovation on mining areas / Zastosowanie metod bezwykopowych do renowacji rurociągów na terenach górniczych
Several trenchless methods are currently applied to repair damaged pipelines of territorial development networks. There exist many technologies of pipelines renovation no always useful to repair pipelines on mining and post-mining areas. In the paper influence of mining exploitation onto pipelines was presented with special regard of pipelines after accomplished renovation with use of trenchless methods. An evaluation of these methods application possibilities to the renovation of pipelines on mining areas was also carried out.
- 29 October 2012
- Published by Polish Academy of Sciences Chancellery in Archives of Mining Sciences
- Vol. 57 (1) , 107-119
Open AccessApplication of trenchless methods for pipelines renovation on mining areas / Zastosowanie metod bezwykopowych do renowacji rurociągów na terenach górniczych
Several trenchless methods are currently applied to repair damaged pipelines of territorial development networks. There exist many technologies of pipelines renovation no always useful to repair pipelines on mining and post-mining areas. In the paper influence of mining exploitation onto pipelines was presented with special regard of pipelines after accomplished renovation with use of trenchless methods. An evaluation of these methods application possibilities to the renovation of pipelines on mining areas was also carried out.
- 1 January 2012
- Published by Springer Nature in Lecture Notes in Computer Science
- p. 588-596
Analysis of Deformation of Mining Chains Based on Motion Tracking
- 1 January 2012
- Published by Springer Nature in Lecture Notes in Computer Science
- p. 588-596
Analysis of Deformation of Mining Chains Based on Motion Tracking