Payal Rani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Payal Rani has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Ester Piegari
Dipartimento di Scienze della Terra, dell'Ambiente e delle Risorse, Università degli Studi di Napoli "Federico II", Naples, Italy
7 shared publications - Rosa Di Maio
Department of Earth, Environment and Resources Sciences, University of Naples Federico II, Complesso Universitario di Monte Sant’Angelo, 80126 Naples, Italy
7 shared publications - Akhil Mishra
CSIR‐National Geophysical Research Institute Hyderabad India
2 shared publications E. Nagaiah
CSIR‐National Geophysical Research Institute Hyderabad India
2 shared publications- Joy Choudhury
CSIR-National Geophysical Research Institute, Hyderabad, India
2 shared publications K. Lohith Kumar
CSIR‐National Geophysical Research Institute Hyderabad India
2 shared publications
Latest Publications
- 24 June 2025
- Published by Wiley in Near Surface Geophysics
- Vol. 23 (4) , 378-388
Airborne electromagnetic imaging of canal‐induced recharge on groundwater quality improvement in saline‐ affected alluvial region of NW India
Canals have been important structure for transporting water from one place to another for irrigation purposes across the globe. In the present scenario of increasing water scarcity, the significance of canals has increased manifold. Canals also suffer water leakages, which in turn contributes to the groundwater recharge. Thus, there is a strong need to study how the long‐term canal flow impacts groundwater recharge and improves its quality, especially in saline environments. The paper presents a detailed analysis of airborne electromagnetics (AEM) data acquired from a highly saline groundwater zone in the semi‐arid region of northwest India, where most of the irrigation has been met from the canal network for the past several decades. The study focuses on using AEM data, supported by borewell lithology and borehole electrical logs, to analyse the subsurface recharge induced by the canals and its impact on groundwater quality. Over the dense and sparse canal networks, AEM has identified different resistivity signatures. It shows high resistivity over the dunes and low resistivity in the clay‐dominated areas. A crescent‐shaped, 20–100 m thick zone with moderate to high resistivity has been observed below the canals within the low resistivity background, which indicates seepage and discharge from the canal. Moreover, changes in water quality (1994–2019) from borewells near the canal recharge zones show significant improvement in the groundwater quality, evidenced by a lowering of the electrical conductivity of groundwater. This recharge affects approximately 20% of the total study area. The total volume of canal‐induced recharge inferred from AEM resistivity is estimated to be ∼12,000 to ∼18,000 MCM.
- 24 June 2025
- Published by Wiley in Near Surface Geophysics
- Vol. 23 (4) , 378-388
Airborne electromagnetic imaging of canal‐induced recharge on groundwater quality improvement in saline‐ affected alluvial region of NW India
Canals have been important structure for transporting water from one place to another for irrigation purposes across the globe. In the present scenario of increasing water scarcity, the significance of canals has increased manifold. Canals also suffer water leakages, which in turn contributes to the groundwater recharge. Thus, there is a strong need to study how the long‐term canal flow impacts groundwater recharge and improves its quality, especially in saline environments. The paper presents a detailed analysis of airborne electromagnetics (AEM) data acquired from a highly saline groundwater zone in the semi‐arid region of northwest India, where most of the irrigation has been met from the canal network for the past several decades. The study focuses on using AEM data, supported by borewell lithology and borehole electrical logs, to analyse the subsurface recharge induced by the canals and its impact on groundwater quality. Over the dense and sparse canal networks, AEM has identified different resistivity signatures. It shows high resistivity over the dunes and low resistivity in the clay‐dominated areas. A crescent‐shaped, 20–100 m thick zone with moderate to high resistivity has been observed below the canals within the low resistivity background, which indicates seepage and discharge from the canal. Moreover, changes in water quality (1994–2019) from borewells near the canal recharge zones show significant improvement in the groundwater quality, evidenced by a lowering of the electrical conductivity of groundwater. This recharge affects approximately 20% of the total study area. The total volume of canal‐induced recharge inferred from AEM resistivity is estimated to be ∼12,000 to ∼18,000 MCM.
- 19 June 2025
- Published by Wiley in Near Surface Geophysics
- Vol. 23 (4) , 389-402
Unravelling heterogeneities in the coastal basaltic aquifer in Saurashtra, India by airborne electromagnetics
Summary: The Deccan flood basalt in Saurashtra, India, primarily comprises multiple lava flows with a few interbedded sediments in hiatus, underlain by Mesozoic formations. Unlike conventional seismic methods, airborne electromagnetics (AEM) offer the possibility of reliably mapping heterogeneities within basalts and sedimentary strata due to the large variabilities of electrical properties. The dual‐moment heliborne transient electromagnetics data were collected over ∼32,000 sq. km of the Saurashtra region, comprising coastal sediments, basaltic heterogeneities and sedimentary formations. With limited calibration and validation from borewells, AEM modelling results demarcate some electrical heterogeneities, explaining the highly resistive (>100 Ωm) massive basalts, resistive (50–100 Ωm) fractured, amygdaloidal basalts, moderately resistive‐to‐conductive (10–50 Ωm) weathered and fractured basalts/sandstone and shale formations, conductive (3–10 Ωm) limestone and clay and highly conductive (<3 Ωm) saline‐enriched coastal and glacial sediments. The weathered and/or fractured amygdaloidal basalts, dykes and sandstone formations provide the fresh aquifer settings with moderate‐ to high yield. Shallow aquifers (100 m). The results suggest that the east–west aligned water divide for surface flow rivers and/or drainages directly associated with resistive basaltic uplands controls the subsurface conditions for groundwater flow and/or accumulation. This study provides a new dimension of less‐studied coastal basaltic aquifers and the influence of the extent of saline zones/saltwater ingress in them and recommended for limited groundwater extraction and prior assessment of recharge potential for long‐term aquifer sustainability, especially in arid and semi‐arid regions like Saurashtra.
- 19 June 2025
- Published by Wiley in Near Surface Geophysics
- Vol. 23 (4) , 389-402
Unravelling heterogeneities in the coastal basaltic aquifer in Saurashtra, India by airborne electromagnetics
Summary: The Deccan flood basalt in Saurashtra, India, primarily comprises multiple lava flows with a few interbedded sediments in hiatus, underlain by Mesozoic formations. Unlike conventional seismic methods, airborne electromagnetics (AEM) offer the possibility of reliably mapping heterogeneities within basalts and sedimentary strata due to the large variabilities of electrical properties. The dual‐moment heliborne transient electromagnetics data were collected over ∼32,000 sq. km of the Saurashtra region, comprising coastal sediments, basaltic heterogeneities and sedimentary formations. With limited calibration and validation from borewells, AEM modelling results demarcate some electrical heterogeneities, explaining the highly resistive (>100 Ωm) massive basalts, resistive (50–100 Ωm) fractured, amygdaloidal basalts, moderately resistive‐to‐conductive (10–50 Ωm) weathered and fractured basalts/sandstone and shale formations, conductive (3–10 Ωm) limestone and clay and highly conductive (<3 Ωm) saline‐enriched coastal and glacial sediments. The weathered and/or fractured amygdaloidal basalts, dykes and sandstone formations provide the fresh aquifer settings with moderate‐ to high yield. Shallow aquifers (100 m). The results suggest that the east–west aligned water divide for surface flow rivers and/or drainages directly associated with resistive basaltic uplands controls the subsurface conditions for groundwater flow and/or accumulation. This study provides a new dimension of less‐studied coastal basaltic aquifers and the influence of the extent of saline zones/saltwater ingress in them and recommended for limited groundwater extraction and prior assessment of recharge potential for long‐term aquifer sustainability, especially in arid and semi‐arid regions like Saurashtra.
- 1 March 2019
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 162, 152-163
Quantitative interpretation of multiple self-potential anomaly sources by a global optimization approach
- 1 March 2019
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 162, 152-163
Quantitative interpretation of multiple self-potential anomaly sources by a global optimization approach
- 1 January 2017
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 136, 315-325
Source depth estimation of self-potential anomalies by spectral methods
- 1 January 2017
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 136, 315-325
Source depth estimation of self-potential anomalies by spectral methods
- 1 September 2016
- Published by Elsevier in Computers & Geosciences
- Vol. 94, 86-95
Self-potential data inversion through a Genetic-Price algorithm
- 1 September 2016
- Published by Elsevier in Computers & Geosciences
- Vol. 94, 86-95
Self-potential data inversion through a Genetic-Price algorithm
- 26 May 2016
- Published by Oxford University Press (OUP) in Geophysical Journal International
- Vol. 206 (2) , 1204-1220
Self-Potential data inversion through the integration of spectral analysis and tomographic approaches
An integrated approach to interpret Self-Potential (SP) anomalies based on spectral analysis and tomographic methods is presented. The Maximum Entropy Method (MEM) is used for providing accurate estimates of the depth of the anomaly source. The 2-D tomographic inversion technique, based on the underground charge occurrence probability (COP) function, is, then, used to fully characterize the anomalous body, as the MEM is not helpful in delineating the shape of the anomaly source. The proposed integrated approach is applied for the inversion of synthetic SP data generated by geometrically simple anomalous bodies, such as cylinders and inclined sheets. This numerical study has allowed the determination of mathematical relationships between zero lines of the COP distributions, the polarization angles and the positions along the profile of the causative sources, which have been of great help for interpreting the related SP anomalies. Finally, the analysis of field examples shows the high potential applicability of the proposed integrated approach for SP data inversion.
- 26 May 2016
- Published by Oxford University Press (OUP) in Geophysical Journal International
- Vol. 206 (2) , 1204-1220
Self-Potential data inversion through the integration of spectral analysis and tomographic approaches
An integrated approach to interpret Self-Potential (SP) anomalies based on spectral analysis and tomographic methods is presented. The Maximum Entropy Method (MEM) is used for providing accurate estimates of the depth of the anomaly source. The 2-D tomographic inversion technique, based on the underground charge occurrence probability (COP) function, is, then, used to fully characterize the anomalous body, as the MEM is not helpful in delineating the shape of the anomaly source. The proposed integrated approach is applied for the inversion of synthetic SP data generated by geometrically simple anomalous bodies, such as cylinders and inclined sheets. This numerical study has allowed the determination of mathematical relationships between zero lines of the COP distributions, the polarization angles and the positions along the profile of the causative sources, which have been of great help for interpreting the related SP anomalies. Finally, the analysis of field examples shows the high potential applicability of the proposed integrated approach for SP data inversion.
- 19 August 2015
- Published by Society of Exploration Geophysicists
- Vol. 1, 1596-1601
High-resolution spectral analysis methods for self-potential data inversion
Summary: In the last few decades, the spectral analysis approach has been successfully applied for depth estimation of gravity and magnetic anomaly sources by analyzing the signal power distribution as a function of spatial frequencies. In the present work, application of high-resolution spectral methods is proposed for inversion of self-potential (SP) data. In particular, Periodogram Method (PM), Maximum Entropy Method (MEM) and Multi Taper Method (MTM) are used to invert synthetic SP data generated by cylinder and sheet sources. From analysis, MEM was found to be better in providing more accurate estimates of the source depth as compared to PM and MTM. Finally, the application of the proposed methods to field data is presented and the estimated depths are compared with those obtained by other numerical methods.
- 19 August 2015
- Published by Society of Exploration Geophysicists
- Vol. 1, 1596-1601
High-resolution spectral analysis methods for self-potential data inversion
Summary: In the last few decades, the spectral analysis approach has been successfully applied for depth estimation of gravity and magnetic anomaly sources by analyzing the signal power distribution as a function of spatial frequencies. In the present work, application of high-resolution spectral methods is proposed for inversion of self-potential (SP) data. In particular, Periodogram Method (PM), Maximum Entropy Method (MEM) and Multi Taper Method (MTM) are used to invert synthetic SP data generated by cylinder and sheet sources. From analysis, MEM was found to be better in providing more accurate estimates of the source depth as compared to PM and MTM. Finally, the application of the proposed methods to field data is presented and the estimated depths are compared with those obtained by other numerical methods.