Xingyu Ren
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xingyu Ren has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Michael J. Gollner
Department of Mechanical Engineering, University of California, Berkeley, USA
4 shared publications Xiaoyu Ju
4 shared publications- Wu Xu
State Key Laboratory of Fire Science, University of Science and Technology of China, Hefei 230027, China
3 shared publications Kun Zhao
State Key Laboratory of Fire Science University of Science and Technology of China Hefei Anhui 230026 China
2 shared publicationsLizhong Yang
2 shared publications- Yong Jiang
State Key Laboratory of Fire Science, University of Science and Technology of China, Hefei, Anhui 230027, China
2 shared publications
Latest Publications
- Open Access
- 13 June 2022
- Published by Elsevier in Combustion and Flame
- Vol. 242
Scaling analysis of downstream heating and flow dynamics of fires over an inclined surface
- 13 June 2022
- Published by Elsevier in Combustion and Flame
- Vol. 242
Open AccessScaling analysis of downstream heating and flow dynamics of fires over an inclined surface
- 1 February 2022
- Published by Elsevier in Combustion and Flame
- Vol. 240
Flame attachment and downstream heating effect of inclined line fires
- 1 February 2022
- Published by Elsevier in Combustion and Flame
- Vol. 240
Flame attachment and downstream heating effect of inclined line fires
- 1 February 2022
- Published by Elsevier in Combustion and Flame
- Vol. 236
Effect of freestream turbulence on the structure of boundary-layer flames
- 1 February 2022
- Published by Elsevier in Combustion and Flame
- Vol. 236
Effect of freestream turbulence on the structure of boundary-layer flames
- 30 July 2019
- Published by Wiley in Fire and Materials
- Vol. 43 (8) , 936-948
Impact of flat roof–integrated solar photovoltaic installation mode on building fire safety
Summary: This paper quantifies experimentally the fire‐induced reradiation to roof surface created by flame extension on the back of the flat roof–integrated photovoltaic (PV) array. A gas burner underneath the tilted PV panels was employed as the fire source. The effects of the PV tilt angle, distance from PV panel to roof, and fire heat release rate (HRR) were investigated. The flame extension geometries and flame reradiation heat flux distribution were recorded. The results show that the flame extension length and vertical thickness (ie, the vertical distance from the back surface of the PV panel to the extension flame profile) are reduced with the increase of PV tilt angle and panel‐roof distance but are increased with increases in the fire HRR. A unified nondimensional HRR coupled with all these factors is proposed to quantify the flame extension geometry. Furthermore, a general equation based on the physical relationship between flame radiation and flame geometry is developed to characterize the distribution of reradiation heat flux on the roof surface with the nondimensional local flame thickness. Finally, suggestions regarding PV installations on flat roofs and the selection of roofing materials are given to decrease the possibility of flame propagation underneath the PV arrays.
- 30 July 2019
- Published by Wiley in Fire and Materials
- Vol. 43 (8) , 936-948
Impact of flat roof–integrated solar photovoltaic installation mode on building fire safety
Summary: This paper quantifies experimentally the fire‐induced reradiation to roof surface created by flame extension on the back of the flat roof–integrated photovoltaic (PV) array. A gas burner underneath the tilted PV panels was employed as the fire source. The effects of the PV tilt angle, distance from PV panel to roof, and fire heat release rate (HRR) were investigated. The flame extension geometries and flame reradiation heat flux distribution were recorded. The results show that the flame extension length and vertical thickness (ie, the vertical distance from the back surface of the PV panel to the extension flame profile) are reduced with the increase of PV tilt angle and panel‐roof distance but are increased with increases in the fire HRR. A unified nondimensional HRR coupled with all these factors is proposed to quantify the flame extension geometry. Furthermore, a general equation based on the physical relationship between flame radiation and flame geometry is developed to characterize the distribution of reradiation heat flux on the roof surface with the nondimensional local flame thickness. Finally, suggestions regarding PV installations on flat roofs and the selection of roofing materials are given to decrease the possibility of flame propagation underneath the PV arrays.
- 1 June 2019
- Published by Elsevier in Combustion and Flame
- Vol. 204, 1-12
Downstream radiative and convective heating from methane and propane fires with cross wind
- 1 June 2019
- Published by Elsevier in Combustion and Flame
- Vol. 204, 1-12
Downstream radiative and convective heating from methane and propane fires with cross wind
- 1 August 2017
- Published by Elsevier in Combustion and Flame
- Vol. 182, 1-13
Influence of halon replacements on laminar flame speeds and extinction limits of hydrocarbon flames
- 1 August 2017
- Published by Elsevier in Combustion and Flame
- Vol. 182, 1-13
Influence of halon replacements on laminar flame speeds and extinction limits of hydrocarbon flames
- 27 July 2016
- Published by SAGE Publications in Journal of Fire Sciences
- Vol. 34 (5) , 416-430
Numerical investigation of the chemical and physical effects of halogenated fire suppressants addition on methane–air mixtures
Previous experimental and numerical studies have demonstrated the unwanted promotion effect caused by potential halon replacements added to hydrocarbon–air mixtures. To explore this abnormal phenomenon, the chemical and physical contributions of the addition of C6F12O (Novec 1230) and C2HF5 (HFC-125) on the laminar flame speeds of the CH4–air mixtures are numerically investigated. Numerical simulations are conducted using the CHEMKIN-PRO software with newly developed fluorinated compounds’ mechanisms. Based on the interaction between the chemical effect and the physical effect, the equivalence ratio zone is divided into synergistic zone and antagonistic zone. Furthermore, the fuel-like characteristics of C6F12O and C2HF5 are also studied. In the lean CH4–air condition, the agents contribute to increasing the equivalence ratio, thus increasing the flame speeds chemically but cooling the mixture physically. When the actual equivalence ratio of the agent–CH4–air mixture is larger than 1.10 (for the C2HF5 addition) or 1.20 (for the C6F12O addition), the agents create an over-rich fuel mixture, thus decreasing the flame speed chemically. The contribution of the chemical effect is studied under different initial temperature and pressure conditions. The results indicate that increasing the temperature slightly lowers the chemical contribution, whereas increasing the pressure largely increases the chemical contribution. Additionally, a sensitivity analysis is conducted to interpret the large chemical component increase under high pressure conditions.
- 27 July 2016
- Published by SAGE Publications in Journal of Fire Sciences
- Vol. 34 (5) , 416-430
Numerical investigation of the chemical and physical effects of halogenated fire suppressants addition on methane–air mixtures
Previous experimental and numerical studies have demonstrated the unwanted promotion effect caused by potential halon replacements added to hydrocarbon–air mixtures. To explore this abnormal phenomenon, the chemical and physical contributions of the addition of C6F12O (Novec 1230) and C2HF5 (HFC-125) on the laminar flame speeds of the CH4–air mixtures are numerically investigated. Numerical simulations are conducted using the CHEMKIN-PRO software with newly developed fluorinated compounds’ mechanisms. Based on the interaction between the chemical effect and the physical effect, the equivalence ratio zone is divided into synergistic zone and antagonistic zone. Furthermore, the fuel-like characteristics of C6F12O and C2HF5 are also studied. In the lean CH4–air condition, the agents contribute to increasing the equivalence ratio, thus increasing the flame speeds chemically but cooling the mixture physically. When the actual equivalence ratio of the agent–CH4–air mixture is larger than 1.10 (for the C2HF5 addition) or 1.20 (for the C6F12O addition), the agents create an over-rich fuel mixture, thus decreasing the flame speed chemically. The contribution of the chemical effect is studied under different initial temperature and pressure conditions. The results indicate that increasing the temperature slightly lowers the chemical contribution, whereas increasing the pressure largely increases the chemical contribution. Additionally, a sensitivity analysis is conducted to interpret the large chemical component increase under high pressure conditions.
- 29 April 2016
- Published by SAGE Publications in Journal of Fire Sciences
- Vol. 34 (4) , 289-304
Combustion promotion and extinction of premixed counterflow methane/air flames by C6F12O fire suppressant
Along with the phase-out of CF3Br (Halon 1301), several agents have been proposed as halon replacements for use in suppressing fires in aircraft cargo bays. However, these potential drop-in replacements were found to have a promotion effect on the explosion of an aerosol can, which tested by the US Federal Aviation Administration. Motivated by this problem, we measured the laminar burning velocity of premixed methane/air flames with added one of these agents, C6F12O (Novec 1230), in the counterflow configuration, for fuel/air equivalence ratios of 0.63, 0.68, 0.74, and 0.82. C6F12O was added at levels up to 3.5% by volume fraction to each mixture. Numerical simulations were performed using the detailed kinetic mechanism. The predicted results were in good agreement with the experimental measurements. The burning velocity for the very lean flames ( Φ = 0.63) was increased with C6F12O added at low concentrations due to the additional heat release from C6F12O reaction, whereas for higher equivalence ratios ( Φ = 0.68–0.82), it always decreased with all added agent concentrations. The extinction stretch rates have also been measured using the counterflow technique to gain further insight into the promotion/inhibition behavior of C6F12O in ultra-lean ( Φ < 0.63) flames. The results showed that C6F12O has larger promotion effect for the ultra-lean conditions. Sensitivity analyses showed that lean flames are more sensitive to the fluorinated reactions compared to the rich. In addition, direct images of hydrocarbon flame inhibition by fluorinated ketone were provided for the first time to help interpret the experiments.
- 29 April 2016
- Published by SAGE Publications in Journal of Fire Sciences
- Vol. 34 (4) , 289-304
Combustion promotion and extinction of premixed counterflow methane/air flames by C6F12O fire suppressant
Along with the phase-out of CF3Br (Halon 1301), several agents have been proposed as halon replacements for use in suppressing fires in aircraft cargo bays. However, these potential drop-in replacements were found to have a promotion effect on the explosion of an aerosol can, which tested by the US Federal Aviation Administration. Motivated by this problem, we measured the laminar burning velocity of premixed methane/air flames with added one of these agents, C6F12O (Novec 1230), in the counterflow configuration, for fuel/air equivalence ratios of 0.63, 0.68, 0.74, and 0.82. C6F12O was added at levels up to 3.5% by volume fraction to each mixture. Numerical simulations were performed using the detailed kinetic mechanism. The predicted results were in good agreement with the experimental measurements. The burning velocity for the very lean flames ( Φ = 0.63) was increased with C6F12O added at low concentrations due to the additional heat release from C6F12O reaction, whereas for higher equivalence ratios ( Φ = 0.68–0.82), it always decreased with all added agent concentrations. The extinction stretch rates have also been measured using the counterflow technique to gain further insight into the promotion/inhibition behavior of C6F12O in ultra-lean ( Φ < 0.63) flames. The results showed that C6F12O has larger promotion effect for the ultra-lean conditions. Sensitivity analyses showed that lean flames are more sensitive to the fluorinated reactions compared to the rich. In addition, direct images of hydrocarbon flame inhibition by fluorinated ketone were provided for the first time to help interpret the experiments.