Abdolhossein Saáedi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Abdolhossein Saáedi has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Farid Jamali-Sheini
Advanced Surface Engineering and Nano Materials Research Center, Department of Physics, Ahvaz Branch, Islamic Azad University, Ahvaz, Iran
13 shared publications - Mohsen Cheraghizade
Advanced Surface Engineering and Nano Materials Research Center, Department of Electrical Engineering, Ahvaz Branch, Islamic Azad University, Ahvaz, Iran
12 shared publications - Ramin Yousefi
Department of Physics, Masjed-Soleiman Branch, Islamic Azad University, Masjed-Soleiman, Iran
8 shared publications Nay Ming Huang
Low Dimensional Materials Research Center, Department of Physics, Faculty of Science, University of Malaya, 50603 Kuala Lumpur, Malaysia
6 shared publicationsRamin Yousefi
6 shared publicationsMohammad Amin Baghchesara
4 shared publications
Latest Publications
- 2 March 2018
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 20 (12) , 1716-1730
Synthesis, crystallography, microstructure, crystal defects, and morphology of Bi x Zn 1−x O nanoparticles prepared by sol–gel technique
This study was allocated to synthesis Bi x Zn 1−x O (0.00 ≤ x ≤ 0.06) nanoparticles. In addition, to study the microstructural properties, crystal imperfections and the morphology for these samples.
- 2 March 2018
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 20 (12) , 1716-1730
Synthesis, crystallography, microstructure, crystal defects, and morphology of Bi x Zn 1−x O nanoparticles prepared by sol–gel technique
This study was allocated to synthesis Bi x Zn 1−x O (0.00 ≤ x ≤ 0.06) nanoparticles. In addition, to study the microstructural properties, crystal imperfections and the morphology for these samples.
- 11 December 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 122 (22)
Improvement of gas-sensing performance of ZnO nanorods by group-I elements doping
In the present work, a comparative study of gas sensor performance of group-I-doped (Na- and K-doped) ZnO nanorods to ethanol was carried out for the first time. The nanorods were grown on SiO2/Si substrates by a thermal evaporation method, using a tube furnace. X-ray photoelectron spectroscopy (XPS) results confirmed that the K and Na were doped in the ZnO nanorods. Furthermore, the XPS spectra indicated that the K-doped ZnO nanorods were grown by more oxygen vacancy compared with the Na-doped ZnO nanorods. Room temperature photoluminescence results confirmed the XPS results about oxygen vacancy level of the doped samples. The doped ZnO nanorods showed excellent gas-sensing performance against ethanol in comparison with the undoped ZnO nanorods. The K-doped ZnO nanorods revealed a high gas sensing at the operating temperature of 300 °C, while the operating temperature of the Na-doped was 280 °C. Moreover, the response and recovery time of the doped samples were shorter than those of the undoped sample. The enhanced gas-sensing performance of doped ZnO nanorods is attributed to the larger amount of oxygen vacancy in the doped ZnO nanorods. Furthermore, group-I-doped ZnO nanorods performed good selectivity compared with the undoped ZnO nanorods.
- 11 December 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 122 (22)
Improvement of gas-sensing performance of ZnO nanorods by group-I elements doping
In the present work, a comparative study of gas sensor performance of group-I-doped (Na- and K-doped) ZnO nanorods to ethanol was carried out for the first time. The nanorods were grown on SiO2/Si substrates by a thermal evaporation method, using a tube furnace. X-ray photoelectron spectroscopy (XPS) results confirmed that the K and Na were doped in the ZnO nanorods. Furthermore, the XPS spectra indicated that the K-doped ZnO nanorods were grown by more oxygen vacancy compared with the Na-doped ZnO nanorods. Room temperature photoluminescence results confirmed the XPS results about oxygen vacancy level of the doped samples. The doped ZnO nanorods showed excellent gas-sensing performance against ethanol in comparison with the undoped ZnO nanorods. The K-doped ZnO nanorods revealed a high gas sensing at the operating temperature of 300 °C, while the operating temperature of the Na-doped was 280 °C. Moreover, the response and recovery time of the doped samples were shorter than those of the undoped sample. The enhanced gas-sensing performance of doped ZnO nanorods is attributed to the larger amount of oxygen vacancy in the doped ZnO nanorods. Furthermore, group-I-doped ZnO nanorods performed good selectivity compared with the undoped ZnO nanorods.
- 1 May 2016
- Published by Elsevier in Materials Research Bulletin
- Vol. 77, 131-137
A simple method to fabricate an NIR detector by PbTe nanowires in a large scale
- 1 May 2016
- Published by Elsevier in Materials Research Bulletin
- Vol. 77, 131-137
A simple method to fabricate an NIR detector by PbTe nanowires in a large scale
- 1 January 2016
- Published by Elsevier in Ceramics International
- Vol. 42 (1) , 1891-1896
Photocurrent application of Zn-doped CdS nanostructures grown by thermal evaporation method
- 1 January 2016
- Published by Elsevier in Ceramics International
- Vol. 42 (1) , 1891-1896
Photocurrent application of Zn-doped CdS nanostructures grown by thermal evaporation method
- 29 September 2015
- Published by World Scientific Pub Co Pte Ltd in Functional Materials Letters
- Vol. 08 (05)
Large-scale and facile fabrication of PbSe nanostructures by selenization of a Pb sheet
PbSe nanostructures were synthesized by selenization of lead sheets in a chemical vapor deposition (CVD) set-up under a selenium ambiance. The lead sheets were placed in the different temperature zones, between 300°C and 450°C. Field emission scanning electron microscope (FESEM) images showed that, PbSe nanostructures grown on the lead sheets with different morphologies. PbSe nanostructures with flakes shape were grown on the lead sheets that were placed in the lower temperature, while PbSe nanocubes and nanorods, which were grown on the nanocubes, were grown on the lead sheets in the higher temperature. The phase and composition of the product were identified by X-ray diffraction (XRD) pattern and X-ray photoelectron spectra (XPS). The XRD and XPS results showed that, the PbSe phase was started to form after 350°C and completed at 450°C. However, the XPS results showed that the Se concentration was different in the samples. In addition, Raman measurements confirmed the XRD and XPS results and indicated three Raman active modes, which belonged to PbSe phase for the nanostructures. The optical properties of the products were characterized by UV–Vis. The optical characterization results showed a band gap for the PbSe nanostructures in the infrared region.
- 29 September 2015
- Published by World Scientific Pub Co Pte Ltd in Functional Materials Letters
- Vol. 08 (05)
Large-scale and facile fabrication of PbSe nanostructures by selenization of a Pb sheet
PbSe nanostructures were synthesized by selenization of lead sheets in a chemical vapor deposition (CVD) set-up under a selenium ambiance. The lead sheets were placed in the different temperature zones, between 300°C and 450°C. Field emission scanning electron microscope (FESEM) images showed that, PbSe nanostructures grown on the lead sheets with different morphologies. PbSe nanostructures with flakes shape were grown on the lead sheets that were placed in the lower temperature, while PbSe nanocubes and nanorods, which were grown on the nanocubes, were grown on the lead sheets in the higher temperature. The phase and composition of the product were identified by X-ray diffraction (XRD) pattern and X-ray photoelectron spectra (XPS). The XRD and XPS results showed that, the PbSe phase was started to form after 350°C and completed at 450°C. However, the XPS results showed that the Se concentration was different in the samples. In addition, Raman measurements confirmed the XRD and XPS results and indicated three Raman active modes, which belonged to PbSe phase for the nanostructures. The optical properties of the products were characterized by UV–Vis. The optical characterization results showed a band gap for the PbSe nanostructures in the infrared region.
- 1 April 2015
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 32, 152-159
Enhanced visible-light photocatalytic activity of strontium-doped zinc oxide nanoparticles
- 1 April 2015
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 32, 152-159
Enhanced visible-light photocatalytic activity of strontium-doped zinc oxide nanoparticles
- 1 February 2015
- Published by Penerbit Universiti Kebangsaan Malaysia (UKM Press) in Sains Malaysiana
- Vol. 44 (2) , 291-294
Growth and Characterization of PbO Nanorods Grown using Facile Oxidation of Lead Sheet
- 1 February 2015
- Published by Penerbit Universiti Kebangsaan Malaysia (UKM Press) in Sains Malaysiana
- Vol. 44 (2) , 291-294
Growth and Characterization of PbO Nanorods Grown using Facile Oxidation of Lead Sheet
- 1 October 2014
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 26, 704-709
Synthesis and characterization of PbS mesostructures as an IR detector grown by hydrogen-assisted thermal evaporation
- 1 October 2014
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 26, 704-709
Synthesis and characterization of PbS mesostructures as an IR detector grown by hydrogen-assisted thermal evaporation