Dimitrios Kalliontzis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dimitrios Kalliontzis has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Sri Sritharan
Department of Civil, Construction, and Environmental Engineering, Iowa State University, Ames, IA 50011, USA
5 shared publications - Arturo E. Schultz
School of Civil and Environmental Engineering and Construction Management, University of Texas at San Antonio, San Antonio, TX 78249, USA
2 shared publications A.E. Schultz
1 shared publicationArturo E. Schultz
Department of Civil, Environmental, and Geo‐Engineering University of Minnesota Minneapolis Minnesota
1 shared publication
Latest Publications
- 5 February 2020
- Published by Wiley in Earthquake Engineering & Structural Dynamics
- Vol. 49 (7) , 633-656
Generalized dynamic analysis of structural single rocking walls (SRWs)
Summary: The investigation of structural single rocking walls (SRWs) continues to gain interest as they produce self‐centering lateral load responses with reduced structural damage. The simple rocking model with modifications has been shown to capture these responses accurately if the SRW and its underlying base are infinitely rigid. This paper advances previous rocking models by accounting for (1) the inelastic actions at or near the base of the SRW and (2) the flexural responses within the wall. Included in the proposed advancements are hysteretic and inherent viscous damping associated with these two deformation components so that the total dynamic responses of SRWs can be captured with good accuracy. A system of nonlinear equations of motion is developed, in which the rocking base is discretized into fibers using a zero‐length element to locate the associated compressive deformations and damage. The flexural deformations of the rocking body are captured using an elastic term, while the impact events are modeled using impulse‐momentum equations. Comparisons with experiments of structural precast concrete and masonry SRWs show that the proposed approach accurately estimates the dynamic responses of different SRWs with and without unbonded posttensioning, for various dynamic excitations and degrees of hysteretic action. Using the proposed approach, a numerical investigation employs different configurations of structural SRWs to quantify the various sources of energy loss, including hysteretic action and impact damping, during various horizontal ground motions.
- 5 February 2020
- Published by Wiley in Earthquake Engineering & Structural Dynamics
- Vol. 49 (7) , 633-656
Generalized dynamic analysis of structural single rocking walls (SRWs)
Summary: The investigation of structural single rocking walls (SRWs) continues to gain interest as they produce self‐centering lateral load responses with reduced structural damage. The simple rocking model with modifications has been shown to capture these responses accurately if the SRW and its underlying base are infinitely rigid. This paper advances previous rocking models by accounting for (1) the inelastic actions at or near the base of the SRW and (2) the flexural responses within the wall. Included in the proposed advancements are hysteretic and inherent viscous damping associated with these two deformation components so that the total dynamic responses of SRWs can be captured with good accuracy. A system of nonlinear equations of motion is developed, in which the rocking base is discretized into fibers using a zero‐length element to locate the associated compressive deformations and damage. The flexural deformations of the rocking body are captured using an elastic term, while the impact events are modeled using impulse‐momentum equations. Comparisons with experiments of structural precast concrete and masonry SRWs show that the proposed approach accurately estimates the dynamic responses of different SRWs with and without unbonded posttensioning, for various dynamic excitations and degrees of hysteretic action. Using the proposed approach, a numerical investigation employs different configurations of structural SRWs to quantify the various sources of energy loss, including hysteretic action and impact damping, during various horizontal ground motions.
- 30 December 2019
- Published by Wiley in Earthquake Engineering & Structural Dynamics
- Vol. 49 (4) , 319-338
Dynamic response and impact energy loss in controlled rocking members
Summary: Unbonded posttensioning anchors a rocking structural member to its foundation and produces its controlled rocking response when the member undergoes seismic action. Unlike rocking of free‐standing bodies, little attention has been given to the dynamic behavior of these controlled rocking members. This paper utilizes experiments of concrete structural members with unbonded posttensioning, varying member geometries, and levels of initial posttensioning force to (a) characterize the associated impact energy loss and (b) improve modeling of controlled rocking motions. Experimental results show that impact energy loss in controlled rocking members can be captured accurately using the coefficient of restitution (r) approach of the modified simple rocking model (MSRM). Based on the MSRM, a controlled rocking model (CRM) is developed that additionally accounts for the variations in contact length at the member‐to‐foundation (rocking) interface. The CRM reproduces the experimental responses of controlled rocking members with good accuracy and is used to investigate controlled rocking motions under horizontal base excitations.
- 30 December 2019
- Published by Wiley in Earthquake Engineering & Structural Dynamics
- Vol. 49 (4) , 319-338
Dynamic response and impact energy loss in controlled rocking members
Summary: Unbonded posttensioning anchors a rocking structural member to its foundation and produces its controlled rocking response when the member undergoes seismic action. Unlike rocking of free‐standing bodies, little attention has been given to the dynamic behavior of these controlled rocking members. This paper utilizes experiments of concrete structural members with unbonded posttensioning, varying member geometries, and levels of initial posttensioning force to (a) characterize the associated impact energy loss and (b) improve modeling of controlled rocking motions. Experimental results show that impact energy loss in controlled rocking members can be captured accurately using the coefficient of restitution (r) approach of the modified simple rocking model (MSRM). Based on the MSRM, a controlled rocking model (CRM) is developed that additionally accounts for the variations in contact length at the member‐to‐foundation (rocking) interface. The CRM reproduces the experimental responses of controlled rocking members with good accuracy and is used to investigate controlled rocking motions under horizontal base excitations.
- 1 May 2018
- Published by Wiley in Earthquake Spectra
- Vol. 34 (2) , 843-866
Characterizing Dynamic Decay of Motion of Free‐Standing Rocking Members
Rocking is likely the primary dynamic mode of vibration during the earthquake response of free‐standing structural members. Previous research has routinely described the dynamic behavior of these members using a coefficient of restitution ( r ) modeling approach, which is shown in this paper to be insufficient for accurately capturing their decaying motion characteristics. Utilizing experimental testing and analytical investigation of concrete members, this study concludes that free‐standing members dissipate energy in both a continuous manner and instantaneously at impacts at the rocking interface. Accounting for these two energy dissipation components is necessary to accurately produce rocking dynamic responses of free‐standing blocks.
- 1 May 2018
- Published by Wiley in Earthquake Spectra
- Vol. 34 (2) , 843-866
Characterizing Dynamic Decay of Motion of Free‐Standing Rocking Members
Rocking is likely the primary dynamic mode of vibration during the earthquake response of free‐standing structural members. Previous research has routinely described the dynamic behavior of these members using a coefficient of restitution ( r ) modeling approach, which is shown in this paper to be insufficient for accurately capturing their decaying motion characteristics. Utilizing experimental testing and analytical investigation of concrete members, this study concludes that free‐standing members dissipate energy in both a continuous manner and instantaneously at impacts at the rocking interface. Accounting for these two energy dissipation components is necessary to accurately produce rocking dynamic responses of free‐standing blocks.
- 1 September 2017
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 143 (9)
Characterizing the In-Plane Rocking Response of Masonry Walls with Unbonded Posttensioning
Unlike the use of bonded reinforcement to anchor a masonry wall to its foundation, the use of unbonded posttensioning may result in a controlled rocking response of the wall. Considering that conventional analysis techniques routinely employed for monolithic structures are inadequate to describe a controlled rocking response, this paper introduces analysis methods that are able to predict the monotonic force-displacement responses of masonry walls with unbonded posttensioning. These methods include (1) an iterative procedure that employs sectional analysis and accounts for the confinement effects attributable to lateral friction at the wall-to-foundation interface and (2) a simplified procedure that is based on equivalent stress block analysis. The two methods are compared against experimental data from three past research studies, and high-fidelity finite-element models are used to verify predictions of the wall responses, including the neutral axis depth (NAD) at the wall-to-foundation interface. Comparisons show the proposed analysis methods to adequately capture the experimental force-displacement responses and produce NAD variations that agree well with the finite-element models.
- 1 September 2017
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 143 (9)
Characterizing the In-Plane Rocking Response of Masonry Walls with Unbonded Posttensioning
Unlike the use of bonded reinforcement to anchor a masonry wall to its foundation, the use of unbonded posttensioning may result in a controlled rocking response of the wall. Considering that conventional analysis techniques routinely employed for monolithic structures are inadequate to describe a controlled rocking response, this paper introduces analysis methods that are able to predict the monotonic force-displacement responses of masonry walls with unbonded posttensioning. These methods include (1) an iterative procedure that employs sectional analysis and accounts for the confinement effects attributable to lateral friction at the wall-to-foundation interface and (2) a simplified procedure that is based on equivalent stress block analysis. The two methods are compared against experimental data from three past research studies, and high-fidelity finite-element models are used to verify predictions of the wall responses, including the neutral axis depth (NAD) at the wall-to-foundation interface. Comparisons show the proposed analysis methods to adequately capture the experimental force-displacement responses and produce NAD variations that agree well with the finite-element models.
- 1 August 2017
- Published by Elsevier in Engineering Structures
- Vol. 145, 83-96
Improved estimation of the reverse-cyclic behavior of fully-grouted masonry shear walls with unbonded post-tensioning
- 1 August 2017
- Published by Elsevier in Engineering Structures
- Vol. 145, 83-96
Improved estimation of the reverse-cyclic behavior of fully-grouted masonry shear walls with unbonded post-tensioning
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 142 (12)
Improved Coefficient of Restitution Estimation for Free Rocking Members
In 1963, a geometry-dependent approach to estimate the coefficient of restitution (COR) was proposed for free rocking structures. Since then, this estimation has been reported as being consistently lower than results obtained from experimental data. An assumption used by the original model is shown to be the cause of this underestimation. Identifying that the rocking takes place over a contact region, this study introduces a modified formulation for free rocking bodies and proposes an improved COR estimation to accurately quantify the energy dissipation of these structures. Using experimental data, it is shown that the improved CORs consistently provide better correlation to those established from tests than the COR obtained from the original approach.
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 142 (12)
Improved Coefficient of Restitution Estimation for Free Rocking Members
In 1963, a geometry-dependent approach to estimate the coefficient of restitution (COR) was proposed for free rocking structures. Since then, this estimation has been reported as being consistently lower than results obtained from experimental data. An assumption used by the original model is shown to be the cause of this underestimation. Identifying that the rocking takes place over a contact region, this study introduces a modified formulation for free rocking bodies and proposes an improved COR estimation to accurately quantify the energy dissipation of these structures. Using experimental data, it is shown that the improved CORs consistently provide better correlation to those established from tests than the COR obtained from the original approach.