Michael Stuckings
Research Subjects
Michael Stuckings has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Andrew Blakers
Australian National University
7 shared publications A. Cuevas
6 shared publications- Klaus J. Weber
School of Engineering The Australian National University Canberra Australian Capital Territory 2601 Australia
4 shared publications D. Gordeev
Origin Energy
2 shared publicationsG. Matlakowski
2 shared publicationsM. J. Stocks
Centre for Sustainable Energy Systems, Department of Engineering, FEIT, The Australian National University, Canberra, ACT 0200, Australia
2 shared publications
Latest Publications
- 1 November 2006
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 90 (18-19) , 3422-3430
Sliver® solar cells: A new thin-crystalline silicon photovoltaic technology
- 1 November 2006
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 90 (18-19) , 3422-3430
Sliver® solar cells: A new thin-crystalline silicon photovoltaic technology
- 10 August 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1007-1010
Update on SLIVER solar cell technology and modules
- 10 August 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1007-1010
Update on SLIVER solar cell technology and modules
- 24 December 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 24-28
Efficient thin epilayer multicrystalline silicon solar cells
- 24 December 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 24-28
Efficient thin epilayer multicrystalline silicon solar cells
- 8 November 2001
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 9 (6) , 409-416
Gallium Contacts onp‐type silicon substrates
A significant reduction in contact resistance of palladium/silicon contacts was realised by the use of a thin intermediate gallium layer. The contact resistance of the palladium/gallium/silicon contact was found to be similar to aluminium/silicon contacts on 0.5 Ω cm silicon. Solar cells processed on 1 Ω cm substrates with this structure demonstrated better contact properties than conventional aluminium/silicon contacts. The improved characteristics are believed to be a result of gallium/silicon alloying at low temperature (400°C). The palladium layer is critical as aluminium/gallium/silicon layers show dramatically increased contact resistance. The palladium silicide may interact with the aluminium layer to form a stable ternary compound, preventing aluminium from penetrating deeper into the silicon. Copyright © 2001 John Wiley & Sons, Ltd.
- 8 November 2001
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 9 (6) , 409-416
Gallium Contacts onp‐type silicon substrates
A significant reduction in contact resistance of palladium/silicon contacts was realised by the use of a thin intermediate gallium layer. The contact resistance of the palladium/gallium/silicon contact was found to be similar to aluminium/silicon contacts on 0.5 Ω cm silicon. Solar cells processed on 1 Ω cm substrates with this structure demonstrated better contact properties than conventional aluminium/silicon contacts. The improved characteristics are believed to be a result of gallium/silicon alloying at low temperature (400°C). The palladium layer is critical as aluminium/gallium/silicon layers show dramatically increased contact resistance. The palladium silicide may interact with the aluminium layer to form a stable ternary compound, preventing aluminium from penetrating deeper into the silicon. Copyright © 2001 John Wiley & Sons, Ltd.
- 1 October 1999
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 59 (3) , 233-242
A study of shading and resistive loss from the fingers of encapsulated solar cells
- 1 October 1999
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 59 (3) , 233-242
A study of shading and resistive loss from the fingers of encapsulated solar cells
- 24 February 1997
- Published by AIP Publishing in Applied Physics Letters
- Vol. 70 (8) , 1017-1019
High minority carrier lifetime in phosphorus-gettered multicrystalline silicon
The electronic quality of multicrystalline material produced by directional solidification has been evaluated by means of photoconductance techniques. Very high minority carrier lifetimes, in the vicinity of 200 μs, have been measured in p-type 1.5 Ω cm material that had received a phosphorus diffusion gettering treatment. The measurements correspond to an effective lifetime averaged over an area of 3 cm that includes several grain boundaries and reflects the combined bulk, grain boundary and surface recombination mechanisms. The high lifetime (15 s) also obtained in low resistivity 0.2 Ω cm wafers has allowed the fabrication of solar cells with an open-circuit voltage of 657 mV (AM1.5 G, 100 mW/cm , 25 °C), probably the highest ever reported for multicrystalline silicon.- 24 February 1997
- Published by AIP Publishing in Applied Physics Letters
- Vol. 70 (8) , 1017-1019
High minority carrier lifetime in phosphorus-gettered multicrystalline silicon
The electronic quality of multicrystalline material produced by directional solidification has been evaluated by means of photoconductance techniques. Very high minority carrier lifetimes, in the vicinity of 200 μs, have been measured in p-type 1.5 Ω cm material that had received a phosphorus diffusion gettering treatment. The measurements correspond to an effective lifetime averaged over an area of 3 cm that includes several grain boundaries and reflects the combined bulk, grain boundary and surface recombination mechanisms. The high lifetime (15 s) also obtained in low resistivity 0.2 Ω cm wafers has allowed the fabrication of solar cells with an open-circuit voltage of 657 mV (AM1.5 G, 100 mW/cm , 25 °C), probably the highest ever reported for multicrystalline silicon.- 1 January 1996
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01608371,p. 457-460
Quasi-steady-state photoconductance, a new method for solar cell material and device characterization
This paper describes a new method for minority-carrier lifetime determination using a contactless photoconductance instrument in a quasi-steady-state mode. Compared to the more common transient photoconductance decay approach, the new technique permits the use of simpler electronics and light sources, yet has the capability to measure lifetimes in the nanosecond to millisecond range. In addition, by analyzing the quasi-steady-state photoconductance as a function of incident light intensity, an implicit I/sub SC/-V/sub OV/ curve can be obtained for noncontacted silicon wafers and solar cell precursors.
- 1 January 1996
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01608371,p. 457-460
Quasi-steady-state photoconductance, a new method for solar cell material and device characterization
This paper describes a new method for minority-carrier lifetime determination using a contactless photoconductance instrument in a quasi-steady-state mode. Compared to the more common transient photoconductance decay approach, the new technique permits the use of simpler electronics and light sources, yet has the capability to measure lifetimes in the nanosecond to millisecond range. In addition, by analyzing the quasi-steady-state photoconductance as a function of incident light intensity, an implicit I/sub SC/-V/sub OV/ curve can be obtained for noncontacted silicon wafers and solar cell precursors.