Christophe Combastel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Christophe Combastel has a total of 69 co-authors. Here are the top co-authors by number of shared publications:
- Ali Zolghadri
University of Bordeaux, CNRS-IMS Lab, Institut Universitaire de France (IUF), France
9 shared publications - Tarek Raïssi
Conservatoire National des Arts et Mtiers (CNAM), Paris, France
8 shared publications Ali Zolghadri
University of Bordeaux, IMS lab, Automatic control group, 351 cours de la libération, 33405 Talence, France
5 shared publicationsRihab El Houda Thabet
University of Bordeaux, IMS lab, Automatic control group, 351 cours de la libération, 33405 Talence, France
5 shared publications- Denis Efimov
Inria, Univ. Lille, CNRS, UMR 9189 - CRIStAL, Lille, France
4 shared publications - Nacim Ramdani
Laboratoire pluridisciplinaire de recherche en ingénierie des systèmes, mécanique et énergétique
4 shared publications
Latest Publications
- 19 September 2026
- Published by Elsevier in European Journal of Control
- Vol. 92
Robust estimation for continuous-time parameter-varying persidskii systems
- 19 September 2026
- Published by Elsevier in European Journal of Control
- Vol. 92
Robust estimation for continuous-time parameter-varying persidskii systems
- 7 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 70 (11) , 7189-7200
Robust Stability and Stabilization of Continuous-Time Parameter-Varying Persidskii Systems
This article investigates analysis and design problems for a class of parameter-varying generalized Persidskii systems. A model within this class is simultaneously linear in time-varying parameters as in the linear parameter-varying (LPV) framework, and contains sector nonlinearities of the state, as in Persidskii systems. The conditions for (integral) input-to-state stability and input–output-to-state stability are established. These results are developed using both, parameter-dependent and independent, Lyapunov functions. To formulate these conditions, parameterized matrix inequalities are used, which are reduced to linear ones under additional assumptions concerning the model's dependence on the time-varying parameters. Finally, a new robust nonlinear control design method is also developed. The efficacy of these results is illustrated through a numerical academic example and a more complex model describing the nonlinear dynamics of aircraft longitudinal motion.
- 7 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 70 (11) , 7189-7200
Robust Stability and Stabilization of Continuous-Time Parameter-Varying Persidskii Systems
This article investigates analysis and design problems for a class of parameter-varying generalized Persidskii systems. A model within this class is simultaneously linear in time-varying parameters as in the linear parameter-varying (LPV) framework, and contains sector nonlinearities of the state, as in Persidskii systems. The conditions for (integral) input-to-state stability and input–output-to-state stability are established. These results are developed using both, parameter-dependent and independent, Lyapunov functions. To formulate these conditions, parameterized matrix inequalities are used, which are reduced to linear ones under additional assumptions concerning the model's dependence on the time-varying parameters. Finally, a new robust nonlinear control design method is also developed. The efficacy of these results is illustrated through a numerical academic example and a more complex model describing the nonlinear dynamics of aircraft longitudinal motion.
- 30 December 2024
- Published by Elsevier in Ocean Engineering
- Vol. 319
Practical identification approach for the actuation dynamics of autonomous surface vehicles with minimal instrumentation
- 30 December 2024
- Published by Elsevier in Ocean Engineering
- Vol. 319
Practical identification approach for the actuation dynamics of autonomous surface vehicles with minimal instrumentation
- 13 July 2022
- Published by Elsevier in Automatica
- Vol. 143
Functional sets with typed symbols: Mixed zonotopes and Polynotopes for hybrid nonlinear reachability and filtering
- 13 July 2022
- Published by Elsevier in Automatica
- Vol. 143
Functional sets with typed symbols: Mixed zonotopes and Polynotopes for hybrid nonlinear reachability and filtering
- 11 March 2022
- Published by Elsevier in Control Engineering Practice
- Vol. 123
Fault tolerant multi-sensor data fusion for autonomous navigation in future civil aviation operations
- 11 March 2022
- Published by Elsevier in Control Engineering Practice
- Vol. 123
Fault tolerant multi-sensor data fusion for autonomous navigation in future civil aviation operations
- Open Access
Functional sets with typed symbols : Mixed zonotopes and Polynotopes for hybrid nonlinear reachability and filtering
Verification and synthesis of Cyber-Physical Systems (CPS) are challenging and still raise numerous issues so far. In this paper, based on a new concept of mixed sets defined as function images of symbol type domains, a compositional approach combining eager and lazy evaluations is proposed. Syntax and semantics are explicitly distinguished. Both continuous (interval) and discrete (signed, boolean) symbol types are used to model dependencies through linear and polynomial functions, so leading to mixed zonotopic and polynotopic sets. Polynotopes extend sparse polynomial zonotopes with typed symbols. Polynotopes can both propagate a mixed encoding of intervals and describe the behavior of logic gates. A functional completeness result is given, as well as an inclusion method for elementary nonlinear and switching functions. A Polynotopic Kalman Filter (PKF) is then proposed as a hybrid nonlinear extension of Zonotopic Kalman Filters (ZKF). Bridges with a stochastic uncertainty paradigm are briefly outlined. Finally, several discrete, continuous and hybrid numerical examples including comparisons illustrate the effectiveness of the theoretical results.
Open AccessFunctional sets with typed symbols : Mixed zonotopes and Polynotopes for hybrid nonlinear reachability and filtering
Verification and synthesis of Cyber-Physical Systems (CPS) are challenging and still raise numerous issues so far. In this paper, based on a new concept of mixed sets defined as function images of symbol type domains, a compositional approach combining eager and lazy evaluations is proposed. Syntax and semantics are explicitly distinguished. Both continuous (interval) and discrete (signed, boolean) symbol types are used to model dependencies through linear and polynomial functions, so leading to mixed zonotopic and polynotopic sets. Polynotopes extend sparse polynomial zonotopes with typed symbols. Polynotopes can both propagate a mixed encoding of intervals and describe the behavior of logic gates. A functional completeness result is given, as well as an inclusion method for elementary nonlinear and switching functions. A Polynotopic Kalman Filter (PKF) is then proposed as a hybrid nonlinear extension of Zonotopic Kalman Filters (ZKF). Bridges with a stochastic uncertainty paradigm are briefly outlined. Finally, several discrete, continuous and hybrid numerical examples including comparisons illustrate the effectiveness of the theoretical results.
- Open Access
- 14 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4188-4193
Critical-Time Analysis of Cyber-Physical Systems subject to Actuator Attacks and Faults
A novel quantitative criterion, namely critical time, is investigated to characterize the degree of resilience of controlled cyber-physical systems. Resilience is defined as system’s ability to contain the maximal impact of anomalies and recover to a nominal mode. Anomalies are understood as any kind of attack or fault that leads to abnormal behavior of the controlled system. The critical time is the maximal time-horizon for which a system is considered to be safe after the occurrence of an anomaly. An increase of critical time will leave more time for defense mechanisms, including human operators, to detect and mitigate anomalies. While most of the literature focuses on the impact part of resilience, this criterion is tied with the recovery part. In this work, it is shown how the computation of the critical time can be done for discrete-time LTI models. To achieve this, sufficient conditions in the form of iterative LMI-based algorithms are established. A numerical example is provided to illustrate the theoretical results.
- 14 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4188-4193
Open AccessCritical-Time Analysis of Cyber-Physical Systems subject to Actuator Attacks and Faults
A novel quantitative criterion, namely critical time, is investigated to characterize the degree of resilience of controlled cyber-physical systems. Resilience is defined as system’s ability to contain the maximal impact of anomalies and recover to a nominal mode. Anomalies are understood as any kind of attack or fault that leads to abnormal behavior of the controlled system. The critical time is the maximal time-horizon for which a system is considered to be safe after the occurrence of an anomaly. An increase of critical time will leave more time for defense mechanisms, including human operators, to detect and mitigate anomalies. While most of the literature focuses on the impact part of resilience, this criterion is tied with the recovery part. In this work, it is shown how the computation of the critical time can be done for discrete-time LTI models. To achieve this, sufficient conditions in the form of iterative LMI-based algorithms are established. A numerical example is provided to illustrate the theoretical results.
- 27 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 5 (4) , 1297-1302
Symbolic Observer-Based Controller for Uncertain Nonlinear Systems
Symbolic control is an approach to the control of continuous or hybrid systems with specifications expressed in a logic form. This approach is based on the use of symbolic models describing the dynamical system behavior with a finite description of the transition relation between its states. In the literature, many results using this approach assume the availability of full and exact information about the system states to compute the control actions. In this letter, we consider a more realistic scenario where only partial information about the plant states is available. This letter proposes an abstraction that makes it possible to synthesize output-feedback controllers. The presence of disturbances and output noise is also considered. A direct path between observer designs in the classical theory and control synthesis in formal methods is established and a numerical example is provided to illustrate the results.
- 27 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 5 (4) , 1297-1302
Symbolic Observer-Based Controller for Uncertain Nonlinear Systems
Symbolic control is an approach to the control of continuous or hybrid systems with specifications expressed in a logic form. This approach is based on the use of symbolic models describing the dynamical system behavior with a finite description of the transition relation between its states. In the literature, many results using this approach assume the availability of full and exact information about the system states to compute the control actions. In this letter, we consider a more realistic scenario where only partial information about the plant states is available. This letter proposes an abstraction that makes it possible to synthesize output-feedback controllers. The presence of disturbances and output noise is also considered. A direct path between observer designs in the classical theory and control synthesis in formal methods is established and a numerical example is provided to illustrate the results.
- Open Access
- 1 January 2020
- Published by University of Zielona Góra, Poland in International Journal of Applied Mathematics and Computer Science
- Vol. 30 (4) , 629-639
On distributed symbolic control of interconnected systems under persistency specifications
This paper presents an abstraction-based technique to solve the problem of distributed controller design enforcing persistency specifications for...
- 1 January 2020
- Published by University of Zielona Góra, Poland in International Journal of Applied Mathematics and Computer Science
- Vol. 30 (4) , 629-639
Open AccessOn distributed symbolic control of interconnected systems under persistency specifications
This paper presents an abstraction-based technique to solve the problem of distributed controller design enforcing persistency specifications for...
- 30 December 2019
- Published by Taylor & Francis in International Journal of Control
- Vol. 93 (11) , 2596-2612
A distributed Kalman filter with symbolic zonotopes and unique symbols provider for robust state estimation in CPS
The problem addressed in this paper is that of robust state estimation in Linear Time-Varying (LTV) systems in a noisy environment and within a distributed and networked architecture. Both bounded disturbances and random noises are considered. A Distributed Zonotopic and Gaussian Kalman Filter (DZG-KF) is proposed where each network node implements a local state estimator using symbolic Zonotopes and Gaussian noise Mergers (s-ZGM), a class of Set-membership and Probabilistic Mergers (SPM). Each node communicates its own state information only to its neighbors in the network. The proposed system includes a dedicated service called Unique Symbols Provider (USP) giving unique identifiers. It also includes Matrices with Labeled Columns (MLC) featuring column-wise sparsity, and symbolic zonotopes (s-zonotopes). This significantly enhances the propagation of uncertainties through the network and preserves global dependencies that would otherwise be lost (or impeded) by the peer-to-peer communication through the network. Moreover, a number of other network-related constraints can be managed within this framework. Numerical simulations show the significant improvement granted by the proposed scheme compared to a non-symbolic approach.
- 30 December 2019
- Published by Taylor & Francis in International Journal of Control
- Vol. 93 (11) , 2596-2612
A distributed Kalman filter with symbolic zonotopes and unique symbols provider for robust state estimation in CPS
The problem addressed in this paper is that of robust state estimation in Linear Time-Varying (LTV) systems in a noisy environment and within a distributed and networked architecture. Both bounded disturbances and random noises are considered. A Distributed Zonotopic and Gaussian Kalman Filter (DZG-KF) is proposed where each network node implements a local state estimator using symbolic Zonotopes and Gaussian noise Mergers (s-ZGM), a class of Set-membership and Probabilistic Mergers (SPM). Each node communicates its own state information only to its neighbors in the network. The proposed system includes a dedicated service called Unique Symbols Provider (USP) giving unique identifiers. It also includes Matrices with Labeled Columns (MLC) featuring column-wise sparsity, and symbolic zonotopes (s-zonotopes). This significantly enhances the propagation of uncertainties through the network and preserves global dependencies that would otherwise be lost (or impeded) by the peer-to-peer communication through the network. Moreover, a number of other network-related constraints can be managed within this framework. Numerical simulations show the significant improvement granted by the proposed scheme compared to a non-symbolic approach.