Hanaa Mohamed Ali
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hanaa Mohamed Ali has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
A.G. Gadallah
Natl Res Ctr, Chem Engn & Pilot Plant Dept, Cairo, Egypt
1 shared publicationA.I. Waly
Preparingand Finishing Department, National Research Centre, Cairo, Egypt
1 shared publication- Azza Hafez
Chemical Engineering and Pilot-Plant Department, National Research Center, Cairo, Egypt
1 shared publication B.Y. Riad
ChemistryDepartment, Faculty of Science, Cairo University, Egypt
1 shared publicationEnas El-Faramawy
El-Azhar University
1 shared publicationFatma Taher
Azhar University
1 shared publication
Latest Publications
- 30 December 2019
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 63 (7) , 2783-2802
Preparation of conductive polymer nano-composite with chitosan and its application in the removal of hexavalent chromium
The conductive polymer, polyaniline (PANI) and its grafting with chitosan (chitosan-grafted polyaniline, CS-g-PANI), were synthesized and analyzed by means of FTIR, TGA, TEM and XRD. The two resins were subjected for the adsorption of hexavalent chromium from aqueous solutions. The factors affecting the adsorption processes were tested, such as pH, time, temperature, and the initial concentrations of chromium. Also, both kinetics and equilibrium isotherm models were studied. The results indicated that the optimum conditions for the preparation of poly aniline are: APS to aniline ratio is 1.5, the HCL concentration is 2.5 M, the reaction time is 1.5 h and the optimum ratio for the preparation of CS-g-PANI is 1.2. It was also found that the prepared nanoparticles of PANI may reach a size of 23–32 nm and the CS-g-PANI is 26-37 nm. The adsorption of chromium VI by the two resins were found to follow Langmuire’s isotherm with maximum adsorption capacity of 526 mg/g for PANI and 370 mg/g for CS-g-PANI at 60 oC. The adsorption mechanism was found to follow the second order model for the two resins.
- 30 December 2019
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 63 (7) , 2783-2802
Preparation of conductive polymer nano-composite with chitosan and its application in the removal of hexavalent chromium
The conductive polymer, polyaniline (PANI) and its grafting with chitosan (chitosan-grafted polyaniline, CS-g-PANI), were synthesized and analyzed by means of FTIR, TGA, TEM and XRD. The two resins were subjected for the adsorption of hexavalent chromium from aqueous solutions. The factors affecting the adsorption processes were tested, such as pH, time, temperature, and the initial concentrations of chromium. Also, both kinetics and equilibrium isotherm models were studied. The results indicated that the optimum conditions for the preparation of poly aniline are: APS to aniline ratio is 1.5, the HCL concentration is 2.5 M, the reaction time is 1.5 h and the optimum ratio for the preparation of CS-g-PANI is 1.2. It was also found that the prepared nanoparticles of PANI may reach a size of 23–32 nm and the CS-g-PANI is 26-37 nm. The adsorption of chromium VI by the two resins were found to follow Langmuire’s isotherm with maximum adsorption capacity of 526 mg/g for PANI and 370 mg/g for CS-g-PANI at 60 oC. The adsorption mechanism was found to follow the second order model for the two resins.
- 1 March 2019
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 62 (3) , 451-468
Synthesis and Characterization of Ion Exchanger Based on Waste Cotton for Dye Removal from Wastewater
GLYCIDYL methacrylate (GMA) polymerization with waste cotton fabric by utilizing co-initiator of ferrous cellulose thiocarbonate-hydrogen peroxide redox system was first studied under various conditions. These include the polymerization time, temperature, liquor ratio, pH and concentrations of the initiator and monomer. The product cellulose-poly(glycidyl methacrylate) graft copolymer (CPGMA) produced at best polymerization conditions was then functionalized with triethylammonium chloride (TEAC), aiming to obtain a low-cost adsorbent for dye removal from wastewater. Also, factors that affecting the amination reaction, which include; reaction time, temperature, liquor ratio, pH, and aminating agent/epoxy molar ratio were studied. The prepared amino-functionalized cellulose-poly(glycidyl methacrylate) graft copolymer (AM-CPGMA) was further characterized by the FT-IR, thermal gravimetric analysis (TGA) and surface area measurement based on Brunauer-Emmett-Teller (BET) and Barrett-Joyner-Halenda (BJH) theories. The dye adsorption capacity of the anion exchanger was also evaluated.
- 1 March 2019
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 62 (3) , 451-468
Synthesis and Characterization of Ion Exchanger Based on Waste Cotton for Dye Removal from Wastewater
GLYCIDYL methacrylate (GMA) polymerization with waste cotton fabric by utilizing co-initiator of ferrous cellulose thiocarbonate-hydrogen peroxide redox system was first studied under various conditions. These include the polymerization time, temperature, liquor ratio, pH and concentrations of the initiator and monomer. The product cellulose-poly(glycidyl methacrylate) graft copolymer (CPGMA) produced at best polymerization conditions was then functionalized with triethylammonium chloride (TEAC), aiming to obtain a low-cost adsorbent for dye removal from wastewater. Also, factors that affecting the amination reaction, which include; reaction time, temperature, liquor ratio, pH, and aminating agent/epoxy molar ratio were studied. The prepared amino-functionalized cellulose-poly(glycidyl methacrylate) graft copolymer (AM-CPGMA) was further characterized by the FT-IR, thermal gravimetric analysis (TGA) and surface area measurement based on Brunauer-Emmett-Teller (BET) and Barrett-Joyner-Halenda (BJH) theories. The dye adsorption capacity of the anion exchanger was also evaluated.
- Open Access
- 1 December 2017
- Published by Elsevier in Desalination and Water Treatment
- Vol. 98, 66-77
Techno-economic evaluation of forward/reverse osmosis hybrid system for saline water desalination
- 1 December 2017
- Published by Elsevier in Desalination and Water Treatment
- Vol. 98, 66-77
Open AccessTechno-economic evaluation of forward/reverse osmosis hybrid system for saline water desalination